My car has a short to plus or open circuit on the drivers seat back heating sensor G371.
Looking for a diagram or picture of its location?
I have taken the hard seat back cover off, but cant find it.
Are these easily accessible? I have to replace both sensors in my 04 4.2 and was curious if they are easy to replace. I could not find and detailed info. Also any tips when replacing these and purchasing 2 sensors?
View 3 RepliesWhere is the ambiant outside air temp sensor located on the Phaeton? I know it is located under the outside left or right mirror (based on model year) on a Volvo but not sure where it is on the Phaeton. No problems, just curious.
View 6 RepliesI have a problem with the TPMS of my '04 Phaeton.
Sensors have already been exchanged, still the car seems to have a problem with the tires of one axis. It displays a number in the middle reflecting the tire's pressure, but there is no "OK" or caution label in the boxes right and left to the car symbol.
This problem can also not be solved by (proper) calibration.
My check engine light came on over the weekend. It was not blinking so I am hoping for just a sensor fault or some other inexpensive issue. I am trying to remain hopeful but after having to replace 2 coils and both catalytic converters about 40K miles ago I am really nervous...
I took the car to the shop this morning for diags but what might be causing the problem? It is a 2004 V8 with about 142K miles.
My Phaeton displayed a check engine light this past week.. I plugged-in my buddies VAG-COM and I have a bad O2 sensor in the front driver side.. Gas mileage is suffering, and really really bad.. . I have 68,847 miles on the clock..
I plan on sourcing the part this week, I was wondering if this is something I can do or is this a dealer item to replace?? I am mechanically inclined.. I even have the "special slotted" deep socket to remove the O2 sensor..
Also, should I replace both fronts since I'll (we'll) be doing one side?? I don't want to replace all 4, if I don't have too.
So the saga of getting my 2006 Phaeton fixed after an interaction with a deer continues ..... The car has been put back together and fixed, but now there is a new warning light linked to the steering wheel angle sensor.
View 10 RepliesWhere the Crank Shaft Position sensor is located on a 2004 4.2 phaeton... Dealership want 360 to install it ...
View 14 RepliesI went to my dealer to tell them that I had the sensor light showing "check brake pads" after the normal service at 75000km I left the dealer and the same problem showed.
I returned and was told everything was fine with the pads but to fix the sensors was "not worth it".
A few days later the screen showed I had a flat tire and after trying everything it would not go away after resets etc etc..
My CEL came on and the code said Coolant Temp Sensor High Voltage. Since there are 2 sensors, and my gauge isn't reading off, about 200F constantly, I assume the bad sensor is the water pump sensor. Also, is there a diagram of the sensorny locations and the easiest way to access them to swap them out. I have already purchased the sensor and gasket, just don't want to replace the wrong one or screw something else up in the process. It appears to be an easy job.
View 7 RepliesMy Phaeton is experiencing issues with the temp sensor. After running the car for a while, then a brief stop (10 minutes or less) it refuses to start. (It cranks but does not start) After a while, it starts fine. No check engine light comes up.
A quick Vagcom read (not the dealer's Vagcom) does show the temperature sensor is reading really low temperatures where it shouldn't. We think this temp sensor gone awry is messing with the fuel mix.
So in the parts book, we see only one temp sensor coming off the radiator, is this a 'easy' fix or do I need the dealer involved?
I have one TPMS sensor that incorrectly tells me I have a flat when I do not. I presume the sensor is faulty because the wheel was moved to the rear as part of a recent service and the problem moved with the wheel.
What I find peculiar is that the flat tire warning comes at virtually the same time when I drive, about ten or so minutes into the journey, and leaves about five minutes later, usually not to return. Indeed, when I occasionally drive the car to work, I know when the signal will come on, within about .25 mile.
I have a 2010 Toyota Corolla 1.8L, the base model.
I recently had a check engine light, VSC off light (blinking) and traction control light come on. I took it to Autozone and had a p0037 code ring up for a new Bank 1 Sensor 2 oxygen sensor (downstream). I believe I have found the correct sensor (located under car, approximately near drivers seat) and it looks simple to replace, aside from the fact that the wires go through the car body.
Can confirm that I have located the correct sensor? And if so, what is the best way to get to where the wires connect?
Is it located under the drivers seat? What should I do about the rubber grommet located under the car where the wires appear to pass through?
1999 Ranger 4x4 4.0 - P0135 O2 Sensor Heater Circuit (Bank 1 Sensor 1)
I have replaced the 02 Sensor, Passenger Side (Pre-Cat), with a Motorcraft DY831...
I reset the Check Engine fault codes, and took it out for a 50 mile journey... Check Engine light is back on, with the same exact code... What next?
I understand that it may be a fuse, and/or it may be a short in the wiring... Exactly how to test the wiring from the connector at the 02 Sensor all the way back to wherever I need to test?
I really need detailed directions, like wire colors, voltage required, or ohms, or whatever is included in this process...
I just had an OBD code pulled on my 2010 Camry and it turns out that my Heated O2 sensor for Bank 1 Sensor 2 is failing. I'd rather do this myself if I can but I can't figure out where this thing is. Is this something I can access myself and swap out? Or does this need to be fixed by a mechanic?
View 9 RepliesThe service truck threw a CEL, and i pulled oxygen sensor performance bank one sensor one code. That would be driver side sensor between the manifold and cat, rite? Don't want to change the wrong one...
View 11 RepliesSo I just replace my Cat. Converter with all new sensors in them. I just replaced my spark plugs. (I'm knocking out these check engine light problems) and I think I'm getting close to the root as to why these other parts went bad. Why my o2 sensor would be stuck on "lean" ....
View 5 RepliesMy Bank 2 Sensor 2 oxygen sensor is faulty and I need to replace it. The guys at the parts store were pretty certain it is downstream driver's side, but I just want to make sure before I PB Blasted and removed it. 2008 F250 SD v10 ....
View 1 RepliesI took the car out for a little spin about 8 miles. We where about .5 of a mile from the house and there is a section where you have to stop on a little bit of a hill. I stalled the car due to the new Dm clutch then headed to the house and the car started to run like crap. I hooked up VAGCOM and had this code:
17748.P1340 camshaft position sensor-G40/ Engine speed sensor-G28: incorrect allocation(#1)
I swapped out the 2 cam position sensors and cleared the code and started the car and it still ran like crap. I just happen to have a new Cam position sensor(hall sensor) so I swapped it out in both cam positions one at a time and cleared the code and the car still runs like crap.
Is there a way to check(test) with vagcom to see if its one of the engine speed sensors?
I recently picked up a 2000 jetta vr6 for a very good price its a glx I have owned a vr6 before and done timing chains myself on it this one is a glx , I am having 5 fault engine codes on my vagcom they are cam position sensor , knock sensor, secondary injection pump, and mass air flow it ran fine 100 miles yesterday this morning the epc came on then went off and ran bad can these codes all be related or do I have to replace each sensor individually..
View 9 RepliesI own a 1998 Mitsubishi Mirage with about 190,000 miles on it. The engine light has started coming on and I get three codes:
P0170 Fuel Trim Bank 1P0136 Oxygen Sensor Bank 1 Sensor 2P0301 Cylinder 1 misfire
Read more: [URL] ....