Phaeton :: Starter Is Not Engaging / Change Procedure?
Aug 21, 2016
I have determined that my starter is not engaging on my car 4.2 phaeton. I removed the 433 starter relay and tried to jump the contacts to engage the starter. I get a small flow of current when I do this but no engagement of the starter, only a very faint click. Not a click like when you engage a normal solenoid. It may be a bad solenoid or a bad starter motor. I cannot reach the terminals on the solenoid to check my connections. I have read somewhere that the manual states that the engine removal is required. I tried knocking on the solenoid with no results.
View 12 Replies
Advertisement
My 05 Powerstroke X has a coolant filter installed by the previous owner.
I have no directions for the kit. To change the filter is it as simple as close the valves and spin off the filter and put a new one on?
Any need to bleed the system?
View 6 Replies
I have a 91 RS 3.1 with a 5 speed that is not starting.
The problem started with the key not engaging the starter at all, a friend who is much better at electrical and we found the security relay switch behind the kick panel is not engaging on it's own. we manually engaged the switch and now the key will spin the starter but the engine is not firing up only spinning.
does the security relay switch control anything other than the starter engaging.
There is gas in the car. using a screwdriver and spark plug wire we have verified that we are getting spark.
View 4 Replies
2012 Santa Fe all of a sudden won't engage starter. First thing in morning it usually cranks. But once I turn it off it won't crank again. When I turn the key I have full power so it's not the battery or terminals. There's no cracking or popping sound, just a whine like the starter's not engaging. Never had any problems with this car so far. I'm thinking maybe it's the starter solenoid.
View 5 Replies
2003 santa fe, automatic, front wheel drive, 4 cylinder.
I had problems with the starter not cranking. took it off to the auto parts store and tested bad. I bought a new one there from called a tough one brand name. put it in, and it grinds the flywheel and sounds like it does not engage the flywheel enough. to it back to the auto parts store, and tested it, and it seemed like the gear did not shoot out like it should. they replaced it with a second starter now that tested good before i left the store, put it in and it does the same thing.
1. Can this type of starter not throw the gear far enough into the flywheel ?
2. Can a voltage drop to the starter cause the same thing. Basically is it possible my wires are bad not throwing enough juice to throw the gear all the way forward.
I pulled the starter out and jumped it with the battery and it seemed to work fine, but on the car it just grinds.
View 16 Replies
Driving home in my 04, and it just died, no caution lights, still have battery power, and starter is engaging but engine wont catch, like no fuel or spark. Found no burnt out fuses, and checked the fuel pump relay. Pulled out the back seat, turned key and heard the fuel pump, so that is working, replaced the crackshaft position sensor, still no engine start.
Over 130k miles, 1.6l
View 1 Replies
ZERO problems except that car consumes oil.
I drove around a corner and hit a minor pothole.
Engine rpms went to zero. I pulled over and car would not start. Starter is so quiet I thought it was not engaging.
I put a chalk mark on serpentine belt and it is turning but the engine shows no sign of wanting to start...no spark I suspect.
I see no blown fuses.
The car has been well maintained and has 250k miles mostly highway. 2.4l LE...
View 10 Replies
I have a Toyota 87 pickup that have been working great for the longest time. Now there is a problem and I need to fix it. It is a problem with the ignition switch I think but I am not sure. When I put the key in and turn it to 1st position I can hear the electrical system turn on, as in the little hums and noises that the electrical system does on a car this age. The next position where the starter motor would engage is however silent and non working. If I where to have a bad battery this is where the relay would go tic-tic-tic but there is no sound what so ever. So Im thinking maybe bad switch, or bad relay? How do I test this the easiest. Toyota got a r22 in it.
View 9 Replies
1996 SILVERADO TRUCK. Starter solenoid doesn't engage when temperature is below freezing....
View 11 Replies
I have a 2007 Jeep Compass. Driving on the freeway heard loud whine - like the starter engaging. It stopped then started again. The jeep then died. Had it towed to the shop. Starter was "melted" and was replaced. Two days later the same thing happened.
View 2 Replies
My 09 LS w/ 65k on it wont start. last night i drove the car around to several places, and on my last stop of the day i couldnt get the car to start. finally after several tries, it fired right up. but today, no such luck.
All the lights come on (and I have charged my batery with a tender to be sure its not the battery), the steering wheel moves in to position, and I either get a click, or a buzzing sound.
Sounds like starter, any other opinions?
View 3 Replies
I just bought a 99 F350 to replace my 01 F250 5.4 and I'm pretty stoked. There are several problem (some i knew about, some were surprises) 1 of which is the starter. The guy I bought it off said that every 100 starts or so (more like every 4-5) the starter sounds like it free-wheels but you just wait for it to stop, turn the key again (sometimes twice) and it engages and starts (although it takes a few seconds of turning over before it fires up).
I have a buddy with the same truck and he has had to replace his starter many times and I read in an old log book from the original owner that he had replaced the starter every 25,000kms (15,000miles). I am not the kind of guy who likes to fix things to have them break again.
SO my question is, WHY do the starters on these trucks keep breaking? What is the weak link? Is it possible to re-build one with better parts at home?
Is the problem partially because my batteries are only 650CCA and 750CCA and it takes more to turn this beast over? Could it be a bendix issue?
View 6 Replies
Truck was running fine up until now. After the WTS light goes out, I crank it and.... nothing. It doesn't even try. It's not a battery problem. I have 12.6 V from each battery before and after cranking. The lights are bright, the horn works, the dash lights are strong and bright all both before and after cranking. It just doesn't want to engage the starter. I tried my backup key as well, thinking it might be a problem with the PATS. No dice. Where to start looking?
View 6 Replies
I Have a 1998 f150 4.6 XLT and recently it has been starting on and off. sometimes i will try and start it and wham! it starts right off. then other times I just here the starter hitting and engaging but nothing. Replaced the starter, solenoid and still nothing. It does have an alarm system but the alarm light doesn't come on, also had battery charged and its working fine. I am really fed up with this beautiful looking POS. Oh and the wiper motor needs replace.
View 5 Replies
So about a week ago I noticed that my 2006 6.0 with 240k miles smelled like antifreeze. I popped the hood and noticed my dega tank was empty. I added coolant to halfway between max and min. A couple days later discovered coolant had dropped to just below min fill. Went to start it this morning and the starter won't engage the flywheel. I hear the relay click and the starter is making a whirling noise. I figure I will try to manually crank it to check if it's the fly wheel. If it's not that I guess I will take the starter to get tested. And if that's not it.. I guess a mechanic.
View 1 Replies
My 88 2.3l 5 speed ranger was running fine then i went to start it up again and it wouldn't turn any of the cylinders or none of the belts move. i can hear the fuel pump turn on for about a second every time, there is weak fuel pressure at the rail. Why wouldn't the engine crank? the starter does not turn the belts and all i hear is a whizzing sound. it sounds as if the starter is spinning but not engaging.
I have had problems with the fuel pump relays but those are all taped up pretty good. I am leaning towards a clogged fuel filter or bad fuel pump. but even with a bad fuel pump or clogged filter wouldn't the engine try to crank even with low fuel pressure? I have a new battery in there. I checked all the fuses in the kick panel. I will check the inertia switch wires as the inertia switch has been disabled.
View 7 Replies
I just put a brand new engine in my 2004 f-150 4X4. Truck ran fine for two days. Yesterday I started the truck as usual put it in reverse. As I was backing up it just stopped running no warning nothing just stopped. All electrical still working fine gauges radio etc. When I turn the key I get nothing no starter nothing. The security light continues to flash slowly even when the key is turned on. Basically the best way I can describe it is. The truck is acting like it is in gear when I turn the key. And the odometer reads check gauges.
View 4 Replies
So I just bought a E99 f350 lariat. I wrecked the truck on the test drive and felt like the right this to do was to buy it. Finally have everything fixed and replaced on the truck and have run into other issues now.
While flushing the coolant system I started noticing that the starter was engaging randomly. After doing some research I found out it could be the GEM under the dash. Looked under the dash and I could here a sizzling sound and seen "smoke" /water vapor something coming off the GEM. And there is water coming through from the window/cab lights.
So. All the post I seen where from like 6 - 10 years ago. Where is the best place to buy a GEM? Will having the window replaced take care of the leaking issues on the window? What's the best after market cab lights? Cause I think they are leaking too.
View 6 Replies
1999 XTL 4.0 auto, was doing fine, replaced Interior light bulb, now wont crank over!!! i suspect the anti theft system... how do i fix or ByPass the security system, i can start the truck by Manually engaging the starter Relay under the hood.
View 1 Replies
I had my starter replaced today and now am hearing some weird rattling sounds coming from front tires. Do you need to remove any of the tires to get to the starter? I thought I read that somewhere.
View 2 Replies
I tried to jump my phaeton and it would click but not completely turn over and i absolutely cant get it to start. the radio, lights, windows, and things of that nature are still working. So i need to know how to replace the battery i.e. (disconnecting it and can i replace it with a battery from an auto store?) If not, how much should i expect to spend and what else could it possibly be??
View 6 Replies
