Phaeton :: How To Remove Drivers Footwell Cover
Apr 18, 2015
It frustrates me to have to ask but I can't find what I'm looking for after several attempts. The footwell cover just below the steering wheel appears to have hinges at its bottom so I'm thinking the top merely snaps into place but I've found no literature referencing that. I've pulled what I felt was a safe amount with no release and I don't want to damage the cover if I'm wrong on my assumption. I can't see any screws to remove but I'm just not sure, what does it take to remove?
I've got the Bentley repair manual but it skips by this as it's not worth referencing going straight to the cover behind it.
View 4 Replies
Advertisement
I've fixed one source of water that was leaking into the passenger side footwell via the insulation surrounding the A/D drain line, but I still have a leak on the drivers side after a rain, and it's strange. Unlike the leak on the passenger side, this one is not coming along the firewall - the firewall is bone dry. The water seems to be coming vertically straight down, landing on the floor mat, but I can't tell where it's coming from. Not only is the firewall dry, but so is the carpet on all sides of the puddle that collects in the rubber floor mat.
Also, I haven't been able to create the leak by spraying water on the van - I washed it today, for example, and not a drop came in. But we had a light rain last night, and there was a puddle on the floor mat (good thing it's rubber) when I opened the door this morning. I've stuck my head up under the dash immediately after I had found water on the floor mat, but can't for the life of me see any sign of wetness above the location of the water on the floor mat.
And yes, I've cleaned out the drain lines under the cowl in front of the windshield. Where this mystery leak may be coming from?
View 2 Replies
Thinking of cleaning up the engine bay of my Passat 3.6 V6. How to remove the engine cover of a Passat 3.6 V6? For asian cars, it is fairly straightforward.
View 2 Replies
How can i remove the allow wheel cover off my 2011? i see their are 3 places where u can insert a flat screw driver, but i still cannot get it off. I don't want to break it.
View 5 Replies
I want to have my oil cap sit close to the valve cover rather then have that long funnel.
I want to go from this:
To this:
View 7 Replies
I got a piece of cable tie stuck in there.
View 6 Replies
Exactly how do you remove the cover (facia) below the front of the front seat so the battery can be removed. To my knowledge no one has spelled this out on this board.
View 7 Replies
I need to send my cup-holder cover and trash hook to Clay so he can color match my F650 dash and I can't figure out how to get the damn side clips on the cup-holder to let go!
I got the top clips and the bottom clip to let go but the side clips will not slip through the slots... I've been near the point of breaking them trying to slide them through...
View 1 Replies
I have a 2012 Camry and was wondering how to remove the rear bumper cover? Someone backed into me so I have a shallow dent I want to pop out of the plastic.
View 6 Replies
So I'm trying to remove the rear bumper cover on a '15, but it has been a royal pain. I went in thinking that the procedure would be similar to what it is on the '14, but it is way more involved. The biggest issue I'm having is removing the large plastic triangular side bracket. It has these weird T-nuts fastened to the body, which you cant remove, and the whole thing looks like it would need to slide upwards to get it off, but you wouldn't have enough room because the shape of the body just gets in the way.
View 1 Replies
How do you remove the top steering column cover? This is the plastic piece immediately toward the front of the car from the steering wheel. It covers the steering column and is not part of the steering wheel. Part number is 45286-47040-C0 and the parts breakdown doesn't show any fasteners, it probably has some tabs that need to be released, but where?
View 2 Replies
I'm trying to remove the middle console vent cover to install a kuda mount. It says to pry a bit with plastic tools right to the right of the vent between the plastic and the leather/pleather. Getting nervous and don't want to crack the cover or damage anything.
View 1 Replies
I recently bought the PriusLock and I just cannot figure out how to remove the lower dashboard cover. I remove the 2 screws as directed but cannot seem to get the lower cover to come lose ? Would like to know if there is something else like a tab that I have to press or release before the cover will come lose. My husband and I have tried "yanking" it pretty hard and it's still not working.
I have a 2008 prius with smart key system (not sure if the smart key system changes anything as far as the installation goes).
View 2 Replies
2002 Jetta, how do you remove the cover over the blinker bulb on headlight? There is a rectangular black cover with a tab at the top. I have tried everything, short of breaking it off, to get the tab to release the cover. What is the trick?
View 1 Replies
I took the plastic cover in front of the radiator off to clean the radiator and condenser. It directs air through the condenser before it gets to the radiator and I was wondering if it would cool the engine without it (if you don't need real cold ac air) . Without it the air can go over the top of the condenser and it is still blocked by the flap that stops airflow above the radiator. Also, I am wondering if the fact that the condenser has nothing in it affects the radiator cooling, and is it bad for the AC system to be empty. (My AC doesn't work)
View 7 Replies
How to remove and possibly replace the rear bumper cover on a 2003 camry?
View 4 Replies
I need to pull my front overhead console to make some changes, gonna try to mount my sirius cradle up there to get it out of the way. Can't figure out how it is fastened up there. Also, I need to pull the cover off the rear seat DVD player as I want to solder in some RCA's onto the aux in. Can't figure this one out either, and I'm afraid to break the cover.
View 4 Replies
I need to get the HPOP reservoir top cover off so I can drill/tap a gauge probe into it. I see torque-head bolts, and a few long bolts that go all the way down into the HPOP.
Unfortunately I cannot get two of the torque-head bolts out because they only un-thread several rotations before the heads of the bolts hit the edge of the fuel filter canister/bowl.
View 14 Replies
I am trying to remove the engine cover on the passenger side of the engine bay so that I can access the power steering fluid reservoir. What is the procedure for removing the plastic clips, rivets or whatever they are and also how do you reinstall them? This is a hair brained design if I ever saw one!
View 14 Replies
I have a 2013 FX4 with the 3.5 twin turbo engine. How to remove the right side valve cover to replace the gasket? I have loosened the perimeter bolts and was able to get it to move slightly but nothing more. I also removed the spark plugs thinking that they might be holding the tubes which are connected to the valve cover by round seals. I have not removed the seals since I was concerned that I might damage them. Do they need to come off? If so how do I do it? It's amazing how complicated this job is! Short of calling the dealer service, I have just about exhausted all my usual tech resources.
View 4 Replies
Fixing a jammed headlight washer cover? I know the washer itself works because I see washer fluid on the ground and I can hear the motor whirling. Also when I access the maintenance item on the infotainment center, the left washer cover pops out, but not the right one.
View 1 Replies