The summer has come and the ADR's radar overheats. I receive a massage : DEFECTIVE! . All cruise control functions are disabled. That means I don't have cruise control in the summer, Too bad. I just want to know if it is possible to deactivate ADR while keeping the regular cruise control on using VAG-COM without any hardware change.
View 24 RepliesCame back from car wash (probably no significance) pulled in garage turned off ignition and the title message came up in the center display. Car will not start. At this point I have no Vag Com and the car will not start.
View 2 RepliesI started my T-Reg this morning and got a "defective wheel on board" message in the MFI. It when away after about 10 minutes of driving. It was 16 degrees outside. I think that the cold weather does something weird to the wheel sensors. I've been getting tire pressure faults also, but they go away after a few minutes.
View 8 RepliesWhen I was in the touareg a few minutes before everything was fine. Then I unlocked it got in and inserted key and the steering will not unlock, ignition will not turn on, or starter crank. The battery voltage is fine all accessories work. I tried to disconnect the ground strap and reconnected, no change. When I closed the door I saw the red message come on stating "Steering Defective Workshop". The message doesn't always reappear.
View 11 RepliesI recently took my Passat to the dealer because I got a message on the MFD saying that the steering column lock was defective. The car is still under warranty so I wasn't worry about the cost but I was expecting the dealer to have to change the entire steering column since I had read that the column lock is integral to the steering column.
When I picked up the car they told me that they only had to change the column lock. It appears that they have found a way to change the column lock only rather than the entire steering column. However what really through me for a loop was that they asked me for my second key and told me that they had to reprogram it.
Now I am wondering how the whole immobilizer, ECU, steering column lock and keys work when it comes to the programming. I want to understand this in the event that it happens again after the warranty expires so I can repair it myself. How the SKC code works and how to go about it if I need to swap the immobilizer or column lock module again in the future or even adapt a new key?
Just had this error come up in the MFD sat nite. Steering column locked up, had to pull key out and re-start. Everything was fine after that. I did have the same error about 2 years ago when I first bought it. Should I bring it up to the dealer, or just forget about it since it hadn't come back.
View 11 RepliesI just put hid fogs in the B6 passat, everything is up and running fine. However, i keep getting "fog light defective front/right" in the info panel. I'm assuming its because they are HID. Any other coding needed to be done with Vag-com?
View 5 RepliesI started my car and this error comes up, along with the bulb failure notice????
2006 2.0t 36K miles
I got a "Defective Wheel" warning from my TPMS system today. I haven't had a chance to check the pressures today, but they look fine. I had gotten a couple intermittent "Flat Tyre" warnings over the last few weeks. Those would appear briefly then go away. This warning came on and stayed on. I doubt it is simply a pressure drop from cold weather, because I would get the "Check Pressures" warning when that happens. I had never seen either of these two warnings before (Flat Tyre or Defective Wheel). Should I assume that one of the sensors has failed in a wheel?
View 22 RepliesCame out of church this morning to a "Defective Wheel on Board" warning - of course these warnings only happen on weekends or when I am far from home.
From searching the boards and reading the manual, this seems to tell me that I have a tire that is going flat. I checked the air pressure in each of my tires (including the spare). I was down about 2 psi in the right front, but all others were right on. I went to add air to the right front.
I checked the pressures before going out later in the day and they were all still up. While turning in to a parking lot, the "Flat Tyre" warning displayed. I parked the car - nothing looked flat. Checked the pressure in all tires (including the spare) and they were still at the set intervals.
Went to do my shopping and 30 minutes later I was back to the Defective Wheel warning, but not the Flat Tyre warning. Drove home, checked all the pressures - everything still fine.
Just wondering about everyone's experience with this warning. What is the possibility that I have an issue with a monitoring system versus the tire? I bought the Phaeton used at 20k miles and now have 26k total on the odometer.
Does the warning code need reset by a VW tech if I go elsewhere to replace the tires? Although I think given the lack of any apparent issues with the tires, I probably need to take in to the dealer.
Now that I have VCDS, I see a problem I never knew I had ... An error on the Air Con. I am not aware of any issue, it appears to do what I ask it. I cleared the error and it appears to appear again on a scan.
On reading the self study guide this looks like it might be an obstructed flap for the recirculation. I will have a close look next weekend.
Address 08: Auto HVAC Labels: 3D0-907-040.lbl
Control Module Part Number: 3D0 907 040 J
Component and/or Version: Climatronic D1 2031
Software Coding: 0000001
Work Shop Code: WSC 01065 000 00000
VCID: 254B0F7DE8FA196
1 Fault Found:
01274 - Air Flow Flap Positioning Motor (V71)
014 - Defective
The outside temperature gauge and park distance system on my Phaeton isn't working. In place of the temperature reading on the dash it just says --.-C I've had it scanned at my local Bosch diagnostic garage and it showed a fault on all six front parking sensors. I can't recall whether he mentioned the temperature sensor as well but I put a new one on anyway as they are cheap and easy to get at. It made no difference. They were very busy so didn't have an opportunity to do any further investigation or dis-assembly and I was in no rush so am taking it back next week.
I have checked the two block connectors which the wires from the parking sensors and temperature sensors go in to and that seems properly connected. Is there another connector somewhere or is there a fuse that protects these somewhere as there isn't a fuse described in the manual as being related to these?
I've had a Phaeton since January and love it. I noticed yesterday that the "distance remaining" figure in the small nav screen in the instrument cluster has disappeared: it now shows "---" instead of, say, "150 mi." Refilling the gas tank hasn't made a difference. Why the car has started refusing to estimate? Since that's the display that shows all the time while driving, it's particularly noticeable.
View 4 RepliesThe cruise on my 2013 LS460 SWB RWD sucks big time! Both Dynamic and Normal cruise modes are WAY too sloppy in speed regulation. I was out today on a 55mph PSL two-lane with set speed of 59mph. On a long SLIGHT downhill, the indicated speed topped out at 70MPH!!!
BTW, tranny shifting was weird during this episode with a prolonged run at over 3k RPM. At any rate, that's 11mph over the set speed for the arithmetically challenged. So instead of tooling along at a maximum of 5 over the PSL as my 2007 LS would have done (set speed 59 + overspeed 2 = 61 indicated = 60 actual, so 5mph over PSL), I'm flying at 10mph over the PSL ripe for the picking by any county sheriff (and I saw THREE of them on that road, all with their radar on).
I figure my car's speed regulation (in both Dynamic and Normal cruise) is +11mph/-2mph for set speed of 59mph. That is crazy!
Twice this week, when I went out to start my car after dark, the lights did not come on automatically, even though the switch was set to auto. The headlights were on, as in DRL, but none of the dash or interior lights came on. I could turn them on by turning the switch to the on position, but then they would go back out when switched back to auto. If you shut the car off and restart it appears to correct itself. This is not a big deal by any means, but it never happened before and now it has occurred twice in a matter of a couple days. I tried to search the forum before posting, but it appears the search function is not working.
View 3 RepliesI have been knocking my head against the wall trying to get an appointment for an ATF fluid and filter change with no success. The odometer reads 67000 miles.
Those VW tech don't want to touch it unless there is something wrong. Hard to believe. Changing ATF fluid and filter as preventive maintenance?
1986 S10 blazer automatic transmission won't go into reverse OR neutral! It goes fwd in both reverse and neutral. It goes into park just fine. The fluid is full and not burnt. It will drive forward when in reverse and in neutral. I turned the engine off and checked neutral, it was not in gear but tried to go forward as soon as I started the engine.
View 16 RepliesI have since purchase of the car for 9 months ago enjoyed the use of the rsap functionality with my S6 connected over the Bluetooth.
Now without any knowable change of settings or update or hardware I got a no network message after connecting to the car.
The phone and the car are still connecting over BT and the phonebook is transferred and all the adjustments within DIS are working as before, I can even make a call but without connection to a network it won't work.
I know GP2s rsap is restricted to 2G networks and if I search networks manually with DIS , the car finds 2 of them, but can not connect none of them.
My service provider Comviq is telling me that there has not been any changes on the SIM card accessibility or newly implemented improvements or updates to Android.
They could anyhow confirm the 2G net being rather weak in the area and this could be the possible reason.
This morning when I went to start my car i got a Service Now message. Once the car was started it went off and didn't come back on. I have no warning lights present on the dash what so ever. I've never seen this before.
What does it mean? I have an 04 W12 with 60,120 miles. BTW I've had all service work done for the 60,000 service. Car is beyond up to date with it's service.
Today after leaving office I switched on the ignition and for the first time I see this massage "Immobilizer activated". I went out to look at the car and found some finger prints on the driver side window.
Is the car so sensitive to touch? Or the alarm was activated for some reason and some one tried to look inside the car?
Lately I've been getting the Stop! Car too low! message when I start the car if it has been sitting more than 6 hours or so. the front appears to be too low. After 20-30 seconds, the front end raises up high enough and the message goes away. It didn't do this when I first got the car. I'm going in for my 80,000 mile service soon.
View 17 Replies