Chrome Side Molding coming loose on passenger back door. I tried a clear silicon and clamped for 3 hours. Unclamped and trim is lifting back up ?
Looks like clip behind trim snapped. Any kind of glue or adhesive can be recommend that will work?
While clamping trim to door I put a crimp mark in trim. Somewhere down the road I will replace this crimped trim.
The chrome strip on the passenger side door handle has dropped off somewhere along the road.
View 1 RepliesHow do I remove side chrome door molding? Do they clip off?
View 3 RepliesI have a 2005 V8 Phateon. The molding on the driver side and rear passenger side door molding is coming off. Any clips you have to buy or can you just slide it off and put it back? Don't want to break anything trying to take the molding off.
View 2 RepliesChrome trim on passenger side near headlight popped out some of it broken (only the pieces on the inside) any way I could salvage this trim without having to buy a new 1?...
View 4 RepliesHow to install the rear door glass chrome molding? Do I need any special instructions?
View 14 RepliesMy car is Lexus Rx 400h, 2008, AWD, European version.
Looking for installing this chrome "molding" under the doors?
I recently discovered that my lower side molding on my front passenger side door was loose while cleaning away some of the salt stains from the winter storm . how to fix it or do I need a replacement.
View 11 RepliesI've noticed on both rear doors, the Lower Moulding (black cover at the bottom of the door) #12 in the attached diagram (Light Blue Circle), is very much separated from the body of the car, it's like bended toward the outside, but it seems to be exactly the same on both sides, I am not sure if this is normal or mine has a defect
Both front doors are OK, not 100% perfectly aligned with the body of the car, but MUCH better than the rear doors....
I would like to remove the chrome window molding around the front and rear doors of my 2010 Camry. Is it difficult to remove? More importantly, when I go to reinstall it - is it difficult to get straight like OEM fit and finish?
View 3 RepliesLooking for a DIY for this part? It is part number 5 in the illustration.
View 5 RepliesI just replaced the drums, shoes and hardware.
Everything went together with out issue but now when I put on the brakes there is a clicking noise coming from the passenger side, kind of like something is hanging up. sounds like one of the springs are loose. But when I took the drum off everything is tight and nothing is out of alignment.
Do drums need a break in period? Wondering if maybe there is a sharp edge and its making the shoe uneven on the drum and causing if to hang up when I put on the brakes.
Just picked up a new to us 2004 GX470 for my wife.
One of the things wrong with the GX470 is the passenger door exterior molding is unclipped at the bottom. I ordered new clips from eBay and they just came in. Now I just need to figure out how to get the molding off without making the problem worse so I can replace all the clips.
Car is 2006 SWB 3.0 Tdi.
I've recently noticed a sloshing noise coming from the rear passenger door - I would estimate between 1 and 2 litres in there! I can't find any other post with these faults, so I've a couple of questions.
Firstly, I'm guessing the ingress is from the seals at the bottom of the window. I can't find a procedure to replace them...
Secondly, how to get the water out... It seems the water will be trapped in there - there's no natural way for the water to escape. If so, I'm tempted to drill a hole to let it escape.
Where would be best to drill the hole? Where water ingress is likely to accumulate?
I have a 2002 Rav4, no key fob, just use a regular key. The driver's side door started to have unlocking issues and finally wouldn't unlock at all. The other two outside locks - passenger side and back door - were fine and were the only way I was getting into my car for a couple of weeks. Repair shop pulled the driver's side lock, pulled out the non-functioning tumbler, and had it replaced and re-keyed at a lock shop. Got the car back and driver's side door was working great, but that very day, I all-of-a-sudden couldn't unlock the passenger or the back door from the outside using the key (both will lock from the outside using the key). The shop (which I've been going to for a long time) thinks it is just a coincidence that both the other locks stopped working right after fixing the driver's side door, but that makes no sense to me. Is there anything in the driver's side door that could have been disturbed and is now preventing both the other doors from being unlocked from the outside? The repair shop solution is to just pull the other two locks and do the same thing as the driver's side door - pull any bad tumblers and re-key. I just cannot believe that this is a coincidence.
View 4 RepliesI've noticed some wind noise that seems to be coming from somewhere around my drivers door. It has probably been there for a while, but my previous tires were so damn noisy I couldn't hear it. Replaced tires a few weeks ago (much quieter tires!) and now I notice it again. The door doesn't leak water. Maybe it's normal.
View 24 RepliesThere is non-stop rattling coming from the rear passenger side, near the seat belt return opening, it seems. It has rattled since I got it, but since it'll be a bit before I take it in for service, I thought I'd ask in case there was a TSB for this.
View 23 RepliesMy 2008 460 has the damn peeling drip molding on the passenger side. I found a wrecked 07 gs of the same color in a local wrecking yard and I was wondering how hard it is to pull off the drip molding myself. Do I need any special service tools? Don't want to damage my car.
View 2 RepliesI've recently bought an 09 Passat Estate, which so far I love - even the bits others complain about like the handbrake etc.... however, I do have a slightly annoying rattle occasionally at the back of the car - its not bad, but seems to be coming from the passenger side rear, maybe around the parcel shelf area.
Mean time, its a case of trying the car with shelf out, seats up/down etc to see if they are the cause.
I've only started noticing this recently. I have a 2004 W12 with roughly 75k miles. It seems to only happen after the engine warms up, but even then its seemingly randomly. I'll notice a clicking sound coming from the front passenger side of the engine. The sound increases in frequency as I rev the engine. I have no check engine lights and no noticeable loss of power. Its not a radiator fan since the sound is still audible when the hood is open. I'm getting no CAN errors with my generic OBDII scanner (I know its not a VAG-COM but hey).
I've been reading up on the possibility of it being a bad valve lifter. I don't know much about them and was hoping to get some advice here before I go about asking my dealership to diagnose the sound. I found this random article through google vaguely talking about replacing the lifter. The person says its "reasonable and inexpensive".
I also stumbled across this thread here describing what sounds similar. Although the thread provides no closure it seems towards the end people are hinting that the engine needs to be pulled? This is contradictory to the first source I found. My question is, say it was a bad lifter, whats the extent of work required to fix it? The Parts seem to be really cheap if I'm looking at the correct stuff?
My driver side door molding is missing a clip. This is the bottom half of the mold and one of the clips snapped off. I've checked junk yards and they never have any GX's. Just to elaborate the clip I'm missing is on the exterior side of the door, down by the bottom edge.
View 2 Replies