Phaeton :: Actual Computer Error Code From TPMS (Module Or Sensors?)
Feb 26, 2008
I took the car to be inspected today (for extended warranty purposes) and asked for the mechanic to run the car through their code reader and print out all error codes. They did and this is the error code it gave for TPMS (FYI- They couldn't reset the error display either, and I've done the 'learning' procedure several times as suggested in these forums, but it doesn't work and the display eventually shows Tire Monitoring Pressure Fault) NONE of the tires show in the TPMS screen. I have no flats, nails, and all the pressures are up to level.
So here is the actual code from the Phaeton:
CODE001:
01325 Type pressure sporadic monitoring
Open contr.unit-j5-0 circuit 2
So what I am wondering is whether the Module has gone bad or perhaps the sensors? What the above means?
View 20 Replies
Advertisement
Ever since I bought my 04 V8, the TPMS warning light has been on due to dead sensors and a disconnected controller (G model controller), and I had just learned to live with the alert and the icon on the display for the time being. Last weekend I installed a 6 button cruise control switch and recoded per Michael's instructions. The switch works fine and everything was good. After a couple of drives with the new switch I noticed that the TPMS was not giving me the usual failure message or the fault icon anymore. If I hit the Vehicle button I still get the same fault message in the J523 screen but no warning in the cluster, and no warning upon startup. Ran a VCDS scan and the errors for the TPMS module not being there are still present as they always were.
View 4 Replies
My TPMS control module stop,working after resetting it.. Is there a way to fix it or do I need to buy a new unit.
View 2 Replies
2007 Suzuki XL7 luxury 6 cyl 3.6l - Error code reads p0122 and the computer in the dash reads Engine Hot- A/C off. It turned over earlier but Car wont start now. Battery is new, all fluid levels, fuses ok. So... looking for
1) PART NUMBER to search for to replace the TPS? or
2) SIMPLE STEP BY STEP instruction on how to ADJUST it?
View 1 Replies
So got this P0A93 code when I was driving on the highway about 65mph, scared to me death when big yellow warning light came on so I returned home and turn the car back on after 30 mins the code and all the warning lights were gone I checked under the hood felt the pump everything was good. I just got done 90k maintance on the car from dealer. So my question is that could be computer error or it could be water pump malfunction? On warranty manual the warranty for inverter with converter covers under 100k so dealer should be able to cover the water pump if it's broken? I driven the car today again at normal temperature and full blast AC on, then again no engine check light on and warning light no message.
View 4 Replies
I have a '97 XLT, 5.0 and the error code for the O2 sensors has popped up, when checking it shows there isn't voltage for the heater circuits. I see there are 3 different heater circuits, 1ea for the left & right O2 sensors and a common one for the catalytic converter O2 sensors, so I ordered another PCM.
View 14 Replies
I recently purchased a used 2000 Explorer Eddie Bauer and the previous owner did not have the factory set 5 digit number for keyless entry soooo I accessed your forum thru Google and got some sketchy ideas on where this module might be located and wanted to share my experience to others that, may in the future, have the same problem. The computer module is located in the tire jack access panel, rear storage left. When you remove the panel the computer module is the white plastic module slightly forward. This module is held in place by a brass hanger with one holding bolt visible but removing this bolt does not free up the module so forget about trying that. In this compartment there is one other black plastic module held in place by two accessable bolts, remove the bolts and lower the module to give you a better area of vision. Now, and you'll need someone with good eyes, take the jack and GENTLY pry the plastic interior storage trim away from the white computer module and look into the space with a bright lite, this will only give you at most a couple of inches of space. Taped on the side is a label with the 5 digit code printed in the middle of the label in bold digits...that's your code. I wear glasses and was able to see the numbers, it's not easy though, but be patient.
View 6 Replies
Car is year old, 20k. Replacing tires because of bubbles. I expect to run new tires for about 3-4 years. Do I need to replace the TPMS sensors?
View 2 Replies
I have someone with a VAG-COM coming into town to disable TPMS, but I cant get my tpms module disconnected. I can feel the wire harness, but I cant figure out how to release it.
View 7 Replies
In the past few weeks I have seen an intermittent "Level Error-Workshop". However every suspension function has worked perfectly, and no height was lost even while sitting at the airport for a week.
How to track down the leak. I can see a tank pressure of about 13 PSI. Is that about right. I did a raise / lower while VCDS was connected and there was a pressure drop to about 11.7 PSI but no level error. What is the correct range of tank pressure settings?
Address 34: Level Control Labels: 3D0-907-553.lbl
Part No: 3D0 907 553 C
Component: LUFTFDR.-CDC- 3C3V0 1122
Coding: 0005521
Shop #: WSC 01065 000 00000
VCID: 2757057592F60B6
1 Fault Found:
01583 - Leak in System Detected
000 - - - Intermittent
View 4 Replies
Got my OZ wheels on, with a new set of TPMS sensors. The old sensors stayed with the OEM wheels for winter tires. How do I reset the system to recognize the new sensors? I have a VAG-COM kit, is this required or is there a method to do this through the MFD?
View 2 Replies
I purchased a set of Scion FRS wheels. I assume these have TPMS sensors installed. I found the reset button under the dash and followed the directions in the manual. The light still hasn't gone off.
Is there a different method to get the TPMS sensors to relearn? Or did I make the wrong assumption that stock FRS wheels have sensors.
View 19 Replies
The dealer tells me my batteries in my low tire sensors are bad. The low tire light on the dash won't go out. So I need to replace the TPMS sensors in my '06 type 5 Prius. I know I can pick them online much cheaper than at the dealer. My question is, is there some reprogramming that will need to be done. I'm assuming it will be some convoluted sequence with buttons on the dash similar to turning off the backup alarm, etc.
View 3 Replies
My 2007 ES350 had a problem with the TPMS where it would flash for the first minute and then stay solid. After checking all 5 tire pressures and resetting the system by using the button under the drivers side dash, I determined that it was probably a bad sensor. Seeing as how they are 7 years old, this seemed reasonable. (I also checked to make sure the passenger side button for the second set of tires was not pushed).
I just had new tires installed at Costco, and brought 5 new sensors for them to install. They supposedly did whatever sensor registration magic is required, but I am still having the same issue. The light blinks for the first minute then goes solid.
What is interesting is that when I try to reset using the button, the light flashes slower (about 1 per second) 3 times, then goes faster (about every half second or so) for the rest of the minute. Is this some code that the system is trying to display?
Also, is there any trick to getting this system re-initialized that I can pass on to the Costco techs when I take it back up there?
View 14 Replies
I would like to know where's the tpms control module located ... I got a camry se v6 ...
View 2 Replies
Not the sensors themselves, but the actual control module in the car?
View 1 Replies
I just purchased a 2014.5 Camry and winter is around the corner. I was going to buy a set of oem 17in SE rims and put snow tires on with out the tpms sensors. The question I have to ask is once the light comes on can you disable the traction control. Reason I ask is because on my 2011 accord it forces the traction control on and is sucks. Snow tires without the sensors.
View 5 Replies
My understanding, and it seems logical to me, that if you rotate the tires and do not reset the TPMS, the pressure and alarm would come from the wrong location. I have been told that the TPMS sensors are, serial number unique and the car needs to know what serial number is at what location.
Anyway, for a do-it-yourself guy to rotate the tires and have the alarms come from the correct location??
[URL] ....
View 31 Replies
I have a 2004 vw toureg 3.2l v6 and i have two questions. first is where are the brake pad sensors located in the pad or outside of the break pad? Second question is TPMS light is on due to a dead battery in one of the tires how do i kill the whole system?
View 1 Replies
02 LSV8. 174k miles. Today it threw a Fuel Data Computer Error on the computer readout and the fuel gauge parked at E as if the engine was off. I am sure I have over 1/2 tank of gas.
View 14 Replies
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
View 2 Replies
