Is there something I can do about this? Is it normal for it to come on every time I start the car. Even if I turn it off before I turn off the car it always turns onto 72 degrees and the front vents come up. I tried to change to another profile , but that does not work. There must be a setting that I miss to have it totally shut off.
View 6 RepliesI bought mine new in 2005, it is a high gloss black exterior with black interior. The wealth of knowledge pouring out from this site about this car is amazing. Recently, tonight actually, I noticed that the light for the passenger rear seat heat/cool control is out. I was wondering if this is something that I can replace myself - or I should go to the dealer for.
View 4 RepliesI just bought 2003 king ranch with a 5.4 it started burning coolant and the heat was coming on then while the engine was at operating temp would blow cold air. Then the temp gauge would start to rise,once it got to the top the heat would start to come on and the temp gauge would then go down to normal.I started by changing the thermostat which didn't work.
Then i figured it was air in the system I kept burping the truck at idle but it never worked, it kept burping while driving all the coolant out that i put in back out finally i took that cap off the one that clicks when you tighten it and replaced it with a cap that tightens down all the way and doesn't click. Every morning I check the reservoir fill it up to the proper level and so far so good.
I have a 2004 Toyota Corolla, with about 175,000 miles, and recently the heating system has been acting up. About three weeks ago the heat started to be slow coming, even when the engine was warm, but after a bit of driving it would kick in. The blower would work the whole time, but it would blow cold, instead of hot. However, no even that amount of heat has subsided, and the blower only blows cold air. On top of that, within the last week or so the engine has begun to almost overheat early in driving, but settles down a bit after driving a few miles. What might be happening?
View 7 RepliesMy beloved 2005 Phaeton has started beeping when turned off both with and without the security system engaged. This has never happened before.
View 1 RepliesVW has issued a TB (technical bulletin) with information about the camshaft on the 4.2 liter V8 engine. The gist of the TB is as follows:
The camshaft adjustment is hydraulically actuated and controlled by the engine oil pressure. If the vehicle has been sitting, with the engine turned off for a period of time, the oil accumulation inside the camshaft adjusters partially bleeds off and the oil flows back into the oil sump.
To ensure an efficient camshaft adjustment after an engine cold start, the oil pressure inside the camshaft adjusters must be built up as quickly as possible. During this time a slight rattle or knocking noise may be audible. This noise is normal at engine start and will last until the oil pressure is fully reinstated.
Was driving my truck I have a 97 f150 4x4 4.6L, btw. The heater started blowing cold air and I looked at the temp gauge but it was showing lower than it normally does and then, after a couple of miles or so I looked at the temp gauge again. By this time I was in my driveway. And it was overheating it might have been that way before I looked at the temp gauge again. But any way I opened the hood didn't see any leaks, all my hoses were hot except the top heater hose. Also checked the oil it was full and coolant was too, what this could be? Sounds like a t-stat to me? But could be worse. Also forgot to mention that the oil had no signs of water in there nor the expansion tank cap !
View 3 RepliesMy lower beams started to flicker, red as hell, too. Can I change them myself? I've got a 2004 V8 Bi Xenon car. Is it possible to be serviced without removing the front bumper? If not, does a manual exist on how to remove that damn bumper and the lamp module to get access to those lower beams?
View 1 RepliesVW has issued a TB (technical bulletin) with information about the camshaft on the 4.2 liter V8 engine. The gist of the TB is as follows:
The camshaft adjustment is hydraulically actuated and controlled by the engine oil pressure. If the vehicle has been sitting, with the engine turned off for a period of time, the oil accumulation inside the camshaft adjusters partially bleeds off and the oil flows back into the oil sump.
To ensure an efficient camshaft adjustment after an engine cold start, the oil pressure inside the camshaft adjusters must be built up as quickly as possible. During this time a slight rattle or knocking noise may be audible. This noise is normal at engine start and will last until the oil pressure is fully reinstated.
My power steering started to make noise. I checked the power fluid and it was empty. I refilled it and noticed a leak.
View 5 RepliesCar now unexpectedly jumps to high fan speed when first started. Doenst matter what the temp is set to or if it was previsouly on Auto or Manual when last shut off. Did I change some custom setting? or has a gremlin appeared after so many years and care free miles? (05, 78K)
Its not a big deal but rather is annoying to get in and hear that immediate rush before I can turn the dial down.
I plan on taking my (new to me) 2004 V8 Phaeton in for some CPO work - already.. A couple days ago all my Driver Side air vents (front, back, even ventilated seat) started blowing non-cooled air while the passenger side seemed to be working fine. You can literally stick your hand up and feel the difference between the left and right side of the clock.
The question is, are there 2 compressors - one for the left and one for the right? or is this some weird fuse that has blown and only affected the driver's side? The fan functions just the same - just not cooling the air on the driver's side. I have all the zones connected together and at the lowest setting for the test.
All the interior white lights that come on when the doors are opened started pulsating today. It's a very rapid pulsing that's pretty rhythmic and constant not like what I would expect from a short. What might cause this?
View 16 RepliesI turned the key and it started to crank and slowly started to whine down. Tried it a 2 more times and it did the same thing only with less strength and on the third try all I hear is the starter clicking. Both batteries read 12.57 on my multimeter while not cranking. Does this sound like an alternator? All my electronics seem to have plenty of power.
View 14 RepliesMy '98 4.0 has 213k on it and the other day I started the engine and the jeep started shaking like crazy. Eventually the engine quit and refused to turn over so I looked under the hood and quickly discovered the problem, a deteriorated rubber elbow on the left manifold. The elbow connects to a threaded breather type valve in the manifold and has a thin piece of black plastic routing to the purge solenoid next to the left fender/air box.
When I removed the rubber elbow from the manifold the engine eventually turned over and idled fine, I then headed to autozone and found replacements of the same diameter, I cut them down a bit to match the length of the originals. Since its been a while I changed the plugs and wires, coil pack along with cap and rotor while I was at it. I replaced one plug and wire at a time to ensure I didn't mix things up, same goes for the cap. Now the jeep seems to take a few more seconds to get started but once it does it idles fine.
Now when I hit the gas hard the jeep will hesitate and then backfire. If I'm smooth on the gas the jeep drives good, whether city or highway. When coming to a stop the jeep will sometimes buck slightly like it wants to cut but doesn't. The backfire sounds like its coming from the air box and oddly enough, my aftermarket radio no longer plays in the accessory position, probably a separate issue. So far there's been no check engine light.
I really need to keep this jeep for a few more months and I would hate to put big money into at this stage.
I have an 01 SuperCrew with the 4.6L and it's idling really rough. Last summer, the idle started to flux pretty bad with the a/c on and eventually, it started to spray coolant mix through the vents and I lost heating about the same time. So, local dealership changed out the heater core and that is working again.
Well...I still have the idle flux, it fluxes from between 400-1000rpm at idle with the a/c on, it's a constant flux....up/down/up/down/up/down. A/C off and the idle is rock-solid steady. Dealership has changed 4 ignition coils over the last couple of years along with an EGR or PCV (whatever it's called) valve as well, none of which was for the idle problem, but somewhat associated. Where I should be looking?
so on my way home the interior lights started to dim then out of no where the abs and traction light came on as soon as i pulled up to my house the headlights started to flicker radio shut off gauges flickered off and climatronic shut off now the cars dead would this be the alternator? Car is vf stage 2 supercharged....
View 22 RepliesTraded in my 2006 mustang gt for a 2006 2.0T passat last week. As I was driving the car to work today the check engine light started blinking and the car started to vibrate as if it were about to shut off. The light eventually stayed on, I took it the the dealer and there not sure what the problem is, they say they've never seen this before.
View 15 RepliesI have a '06 2.0T Auto, and the first cold day since I purchased the car was a week ago (I live in North FL) and turned on the heat, to find out that little to no heat was getting let out, so I brought it to my local guy, and said that the thermostat was probably stuck open, so he replaced the thermostat and housing for a couple hoses , and tested out the heat just now (55 degrees out), have it on 80 degrees and full blast, and still nothing. Also, usually I hear the cooling fan kick on after I shut off the car for about 5-10 secs, but haven't heard it since its not 90+ out. Its in the 70s.
View 6 RepliesMy neighbors brother has a 2000 Passat v6 4 motion. (Climatronic) Here's the issue... the car has NO HEAT!!! and its cold out side. Last night we tore the lower dash part down to see the air box, when you adjust from hot to cold the servo is moving but were not getting any heat at all. The hoses going into the heater care are hot... there are no leaks.... also tried changing the climatronic unit itself and got no where.... I have a 3 hr drive home later this afternoon.
View 9 Repliesworking fine the other day then all of a sudden both seats don't heat up? I havent had the time to start investigating so i thought id post something here first...
View 1 Replies