I just received used front side airbag for my Phaeton 06. I plugged airbag in and i was unable to clear trouble codes. I measured my "new" used airbag and my old blown airbag with multemeter between two pins and both gave me the same reading 0.9 ohms. What is the right resistance for working airbag?
View 13 RepliesI was cleaning out the back seat of my car when I noticed the panel that covers the right rear seat belt and goes up to cover the curtain airbag has somehow come loose. I dropped by the VW dealership and they said that a clip broke off from inside causing this and they were asking me how it happened! How I occupy only the drivers seat in my car.
View 4 RepliesThe cruise control switch on my 2000 Ranger just broke. It looks like you have to remove the airbag to access it. How is that accessed? It looks like there are 2 plugs on the back of the wheel that need to be removed.
View 9 RepliesI went to check the oil today. For the second time the end of the dip stick is broken off.
View 24 RepliesThe knob that controls the sunroof has broken or sheared off. Still in place, but spins freely. Can still operate roof by pulling down on knob prior to turning.
View 6 RepliesI have a 2004 Phaeton that the main volume knob has broken on. The dealer tells me that the only way that they can provide a replacement is with the whole unit (nav screen and all) at a cost of over $2000. It seems to me that this part MUST be available somewhere for $20 or so.
View 4 RepliesI was filling my wiper fluid reservoir and could not fill it to the top. After going throiugh a full bottle of fluid, I noticed it was spilling from underneath the car. I assumed it was an overflow, but later realized that this would make no sense as windshield fluid doesn't freeze, at least not for most of the world, and needs nowhere to expand to.
Now I have to start pulling pieces off the car to see if the tank is broken. I'm guessing I'll need a service manual to find the best way to get to it. If it is broken, how the heck would it have happened? I've only had the car for a few months, so I don't know its history. No accidents though.
I noticed that my links for my intake manifold motors were broken i went to the dealer they didn't just sell the link they wanted 450.00 dollars for each one .
View 2 RepliesI have a small single car garage, and all the vehicles that I have parked in here including an suv, I have never clipped my mirror. However, i recently did so with the Phaeton. Not sure what the proper name for the part is, but it is the clear plastic signal cover that has broken in half. the light still illuminates properly, but the cover is broken. What is the part that I need to order so that I can replace?
View 6 RepliesMy '04 V8 had been sitting unused for about a week. As I backed out of my garage the airbag warning chime and symbol illuminated. I have gone through many start cycles and added about 200 miles since its onset but the warning persists. I have a drive by with my VW tech Monday for a code read.
View 16 RepliesMy 05 Phaeton 4 seater was wrecked a while back and everything has been replaced except my local body shop can not get the steering wheel off to replace the clockspring/airbag. Is there a trick in getting it off and or what exactly has to come off to replace these 2 things. My body shop thinks that it might all be one piece but I thought that most are held on by one large bolt. I also need to know exactly where my airbag module is located as well.
View 1 RepliesDoes the car store a code if the airbag lights comes on and then goes off the next time i start it up.
View 4 RepliesIt's really not relevant what brought up this question but do you think a broken dipstick tube can cause an engine to run lean and why do you answer that way?
View 3 RepliesOn our 2005 V8, we had an airbag fault message come up, and the "PASSENGER AIRBAG OFF" light lit up. We had the code cleared, and everything has been fine. Is there any way to prevent this light coming on? Our mechanic said that it can be caused by taking your safety belt off before the vehicle is stopped, but I wanted to know if there is any other causes of this fault. We have decided to not move the passenger seat at all, just in case there is a wire broken or a loose connection.
View 8 RepliesAll of all sudden, my car is complaining a airbag fault, VCDS scan fault code as below, Does it mean all 10 airbags in my Phaeton is no longer working ?!
Address 15: Airbags
Labels: 3D0-909-601.lbl
Part No: 3D0 909 601 E
Component: 0G Airbag 8.4E+ H10 0934
Coding: 0012359
[Code] ....
A few days ago I got an Airbag Fault Warning while driving, since then the orange airbag light has remained on and at start up it gives me a "Airbag Fault" warning. Any remedies? The manual states to just take it in to the dealer.
View 7 RepliesI recently sent for a reset my airbag module, yes my car was in a collision, I replaced passenger airbag(only 1 airbag deployed). And reconnected the module. Using the VAG COM, I scanned the airbag module, shows no fault codes, but i still have a light.. now I'm thinking seatbelts and sensors maybe the problem. Where the sensors for a 2005 passat passenger dash airbag are located.
View 2 RepliesMy van is spouting SRS fault codes 1-3 and 5-1. I had my shop run a diagnosis and it appears the module has failed. I'm having trouble tracking down a replacement. The Module on my van is Ford# F5AF-14BO56-AA. I see modules with -AD or -BD, but none that match this number perfectly. I also see lots of modules for related Ford vehicles from the same era. Looking for a ford parts number reference sheet that will indicate on what vehicles this module was used or if there is any chance that related modules are compatible?
View 14 RepliesI put a double DIN unit in my 98 F150 and now the airbag light is no. N o flashing either. Turn the key on, nothing, start the engine, Airbag light. I've got the dash apart but I'm not seeing anything that I may have disconnected.
View 8 RepliesMy new to me 2001 Prius has a slowly flashing Airbag light. Reading this handy forum I found that by jumping two pins on the OBD port I could read the codes generated by the flashing lights. I did that, and have a 3233 and 4448. The car runs and drives fine, fluids are all good etc. Can the codes be cleared and see if they return?
View 5 RepliesI have a 2000 with a 5.4 and 166K miles. It had multiple exhaust manifold studs broken on both sides. Now that thay is fixed, I am getting the p1131 and p1151 codes. The EGR tube was also replaced at the time of the manifold fix. I checked over all the tubes and electrical connectors to rule out something simple but did not find anything out of place. The intake manifold was replaced with a new Napa one less than 5K miles ago as well.
Could the leaky exhaust manifolds over time set the fuel trim level high and now that they are fixed, the ECM is thinking it is running too rich? Can the ECM be reset to zero? There is also a ticking/rattling noise when you accelerate that seems to be coming from the fuel injectors. I listened with the stethescope and they are the only things that sound like the noise I hear. Could these all be related?