Phaeton :: 2005 - Fuel Level Gauges Are Not Working
Nov 29, 2014
I have a 2005 VW Phaeton V6 TDI, with a couple of problems.
Oil temp and Fuel level gauges are not working. Range remaining displayed as "---". Ride height button activates a screen in the infotainment and shows that vehicle is in normal height ride but it won't let me change it to high. Dampening button doesn't activate anything at all. However the button itself works, I've tested it using measuring blocks.Volume and cruise control buttons on the steering wheel don't work although they are illuminated. Buttons that control the MFD work absolutely fine.
I've noticed that my vcds cable cannot connect to the following controllers and they are missing from the autoscan:
Address 07: Control Head
Address 09: Cent. Elect.
Address 17: Instruments
Address 19: CAN Gateway
Address 37: Navigation
Address 47: Sound System
Maybe they all have something in common ? I have no problems connecting to other vehicles or other controllers in this car. Previous owner fitted an instrument cluster from a 2011 VW Phaeton, but it seems to work fine except for the problems stated above.
View 7 Replies
Advertisement
For some time now, probably the past 3-years my 05 V8 has made this clunk/jolt when stopping the car on level surface. It very faint, but noticeable. When the car is in S, it doesn't happen. When stopping on a hill, it doesn't happen.
View 8 Replies
My 98 dodge ram 2500 was running and now the gauges don't work and the fuel pump isn't working either, I have checked and replaced fuses and relays with no luck ...
View 3 Replies
I have a 2010 Sonata. The fuel and temp gauges stopped working. Tank is full and engine temp is good. Both dont move when you turn the key on. Tried to find a fuse that they may be on but couldn't find it.
View 2 Replies
My '04 Passat 4Motion (station wagon) engine coolant temperature gauge, fuel gauge, and outside temperature display all stopped working in the same time. Interestingly enough, car has 32K miles and just ran out of manufacturer warranty 2 months ago.
What could be happening? Should I be checking fuse box or this may be related to some more serious failure?
View 1 Replies
It's a 2005 Chrysler Sebring with a 2.4 DOHC. A couple weeks ago I tried to use the wipers and nothing happened - at all. The next day the gauges inside the car went hay wire, started flashing on and off. Turned out the car needed a new battery and alternator. Replaced both and the car has been perfectly fine - except for the wipers. I checked the wiper fuse and it wasn't blown so I pulled the cowl, unplugged the motor, turned the key on, turned the wiper switch to full speed and then tested for voltage at the plug and got almost 12 volts when testing several terminal combinations.
I thought for sure I had it figured out so went ahead and bought a remanufactured wiper motor but nothing happened when I plugged it in. I thought maybe since I didn't mount it it wasn't grounded so went ahead and did that and still nothing. Thinking maybe it was defective I returned it and went to a different auto parts store and bought another one, hooked it up and got the same results. So then I tested all nine relays in the relay control center and they all passed. So now I'm thinking the only thing left to test is the wiper switch. Am I correct?
And also I'd love to bench test the original motor just to verify that it works but don't know which terminals to connect to. I've searched the internet with two different browsers and came up with nothing. The motor in question is a Bosch 05-02-14 41. And then underneath it has 0390 241 7411 12V 058 written on it. The terminals are labeled: 31b, 31, 53 and 53b. And since the OE replacement motor for this car is a Cardone 40-3026, which terminals to use to bench test that one, I could then figure out which terminals to use on the Bosch.
View 19 Replies
I know the code is fuel level sensor, but i can't find the parts online. nothing comes up with the part name fuel level sensor. What is the part number for this or the number for kit because i believe there are 2 sensors?
View 1 Replies
2005 V-10... I've found some info on the "fuel level data error" but thought there must be more on this. In the last month or so I get the error on the message center and the fuel gauge goes to E. Happened a couple times here and there and then the CEL has come on. Have nto been able to get the CEL to go out because it happens too often now.
Have tried a couple bottles of Techron because that is suppose to fix it but no luck after about 150 miles. Can't find any loose wires/connectors. Am ready to give up and drop the tank. Is the sensor separate or part of the pump assy? Also don't see alot on dropping the tank on SDs. Any tips?
View 14 Replies
The backlight for my fuel level and oil pressure dash gauges are out. Would that require a simple bulb replacement or if there is something more difficult to replace, i.e. entire panel? The red needles illuminate, it's just the gauges themselves that are dark. The truck is my 05 Super Duty in the siggy.
View 3 Replies
My rotary push button, the big round button in the middle of the infotainment system stopped working a day ago. It was working one day and stopped working the next. If freely rotates without any resistance, but doesn't carry out any of the previous functions that it performed. All the other buttons on the infotainment system work perfectly.
I have a 2005 W12
View 1 Replies
How much gas do you put in your tank when your gas gauge's yellow light comes on (Low fuel indicator) in the Prius v (Yes, I am asking specifically concerning the Prius v)?
Would 9.25 US Gal or 35 L sound right to you?
View 8 Replies
I have a 2005 mk4 gli and the other morning I went out to start my car for work and all I got was crank no start. I then realized my fuel pump wasn't priming when I opened the driver door. After work I came back and checked the fuel pump fuse and swapped the relay with another I had, still nothing. A buddy of mine decided to check the connector at the fuel pump for power, using a power probe I believe he hit all or the majority of the wires with 12v of negative and/or positive power. He then unplugged the connecter and plugged it back in and the car fired right up. But I noticed that my fuel gauge, engine temp gauge, and outside air temp readout were all not functioning. I've searched and searched without being able to narrow down a solution.
View 19 Replies
I have a 2005 mk4 gli and the other morning I went out to start my car for work and all I got was crank no start. I then realized my fuel pump wasn't priming when I opened the driver door. After work I came back and checked the fuel pump fuse and swapped the relay with another I had, still nothing. A buddy of mine came to me and decided to check the connector at the fuel pump for power, using a power probe I believe he hit all or the majority of the wires with 12v of negative and/or positive power. He then unplugged the connector and plugged it back in and the car fired right up. But I noticed that my fuel gauge, engine temp gauge, and outside air temp readout were all not functioning.
View 1 Replies
I haven't been able to find a discussion about failure or replacement of the oil level sensor. I'm getting a error message displayed each time I start the car. I took it into the dealer for an oil change. After they completed the change, they recommended replacing the sensor. I'm inclined to wait another 5k for the next service to do that. Diagnostics did not show any error codes. Doesn't make sense to me. just replace the sensor...
View 7 Replies
My '04 with 47K on the clock just announced 'Level Workshop'. The warning does not come on right away and takes several minutes to re appear after the car has been turned off and restarted. The car is level, the ride height adjustment functions perfectly, the damping selection functions as before and the jacking control is working the way it is supposed to.
View 24 Replies
I recently had my front axles replaced and a week or two after I'm getting this code for level fault workshop. Do you think it could be something they did when they replaced the axles. I also had the secondary radiator replaced.
View 11 Replies
I have been knocking my head against the wall trying to get an appointment for an ATF fluid and filter change with no success. The odometer reads 67000 miles.
Those VW tech don't want to touch it unless there is something wrong. Hard to believe. Changing ATF fluid and filter as preventive maintenance?
View 1 Replies
I have 2004 V8 Phaeton ,the message LEVEL FAULT WORKSHOP. keeps appearing ,then disappearing, sometimes it will stay until the car is turned off,. When it comes some times even on long highway journeys I wont see it at all!. When it comes on nothing seems to change.
View 6 Replies
Noticed the vehicle was riding low on the passenger sign, and then received a fault code on the driver's screen "Level Fault Workshop" what is this? I can't find in the faq section...
View 9 Replies
I have a 2004 Phaeton which has been having multiple problems with error codes. I keep getting Level Fault Work Shop. When this code comes on the ABS and EPS also fail and can only be reset by restarting the car. My VW dealer is having significant trouble finding the problem. Thus are they have repalaced the batteries, and the control module for the ABS. I think an option could be the battery control module.
View 9 Replies
While driving my 04 w12 a few months ago i noticed a "stutter" or brief jerk while driving. the next morning i had a "coolant level" warning. i took the car to a mechanic i use who diagnosed the problem as a broken coolant line involving the transmission cooler, with the result that coolant migrated to the atf. indication was that the tranny was toast, along with the atf cooler. I authorized a repair (not inexpensive), keeping costs down by installing a used tranny. since the car was "fixed" i still got a "jerk" usually in fourth gear, sometimes in third. i took the car back and was told that the tranny was flushed numerous times and the transmission was reflashed. i picked the car up yesterday, but i still get the "jerks", now usually in third gear.
View 3 Replies