Phaeton :: 2004 V8 - Creaking From The Front Wheel Wells At Low Speed
Jun 7, 2016
My 2004-V8 has developed some creaking sound that seems to come from both front wheel wells when going at low speeds. Going over bumps does not produce them but hard braking and corners tend to produce them. My suspicions are either brakes or steering. Had all the suspension bushings done about a year ago and the dealer did not tell me about worn steering parts. Steering tracks well and suspension is taught. Vagcom shows nothing as this most likely is completely mechanical or even structural.
View 2 Replies
Advertisement
I've noticed a creaking sound coming from the left front wheel when I go over a couple of particularly large speed bumps. I have had a lot of problems with the suspension in this car, and have replaced the front struts, the front right control arm, and the sway bar links and bushings. My best guess is that this noise is coming from the front left control arm, as it has not been replaced, although my current mechanic says that the front left control arm is fine. Also, it has been under 10 F here the past few days, so this could also just be a result of the cold weather.
Video of the noise: [URL] ....
View 7 Replies
I just went to Steamboat this weekend which requires driving over two mountain passes in a snow storm...I only go if it is snowing. This was the first trip with my new 2013 FX4 and the front wheel wells filled up with so much ice that the wheels would rub after a bump in the road. The mountain roads do have lots of frost heaves so this would happen fairly often. The ice was all around the wheel well with a huge build up behind the wheel. It also covered the step rails. Would mud flaps do anything to preovent this build up? Or any other tricks?. Otherwise the truck did fine...
View 12 Replies
When I park, the climate system adjusts to send air down to the foot wells. The climate system keeps the air running long enough to drain the left side battery. I replaced both batteries two days ago. This morning my, brand new, left battery was dead again. The first two weeks I owned the car I never noticed the climate staying on, only the last 6 days.
View 9 Replies
have an 04 f150 that is starting to show some rust in the rear wheel wells. Right now there is just a bit of rust where the painted panel is seamed to the inner panel around the arch, but I can see small spots where the paint is starting to bubble about an inch out on the outside of the panel. I want to keep this thing looking nice for a few more years; what should I do?
I'm a very good welder, can hold my own when turning wrenches, have done lots of metal fabrication as well as painting with a cup gun, but I have very little autobody experience.
I am thinking there is rust between the inner and outer panels and that removing the surface rust and repainting would be a very temporary repair, correct? Could I cover it up with some sort of wheel well liner? If so, how to I slow the existing rust? Is there any sort of partial preformed steel panel/well that allow you to cut off the rusty stuff and weld new stuff on? I'm a little leary of the last thought- I could do the fabbing, but not sure how I'd do getting it back to 'smooth'
View 3 Replies
MY '07 SuperCab just started making a strange rhythmic sound as I drive. It is coming from the drivers side front wheel area. It is like a short creaking sound. It stays the same if I am turning the tires. Seems to go away if I put the brakes on hard, but I slow down so much I am not sure. Front CV Joint?
View 1 Replies
Having issues with rear wheel wells rusting, mine is a 2004 f-250. I wax at least 10 times a yr. Can't believe I have rust there...
View 13 Replies
Just recently I've been hearing a slight creeking sound coming from the front end when going over bumps. I don't have a lot of suspension knowledge so I'm not sure where to start looking and wanted to see if others had the problem, and what the outcome was? The car is at 60k miles.
View 20 Replies
Getting a creak sounds like near struts at slow speeds and turning , it stopped when it got cold, but on the first warm day today its back . I did replace the struts, bearings and seats, but have to admit I used the cheapos . I just cant find where its creaking from...
View 2 Replies
I have a 2007 Passat 2.0T and I had the following problems
1)i had heard some creaking noise when going over speed bump
2)some rattling/ creaking noise from the front dash.
3)check engine light appeared
4)gas cap warning light appeared intermittantly.
VW dealer done the following jobs.
1)2328 Verified Creaking noise from both from lwer control arm bushings As per TB 40 08 01 noise coming from both front bushings.
40205653 Wishbone mounting replace.
40172003 Lower wishbone remove + reintall
2 1K0-406-182 Rubb Mount
6 N-103-320-02 Nut
2 N-101-410-03 Bolt
4 N-107-063-01 Screw
2) 2327 Found noise coming from trim piece surrounding radio
68221900 instrument panel trim remove + reinstall.Installed anti rattle tape to trim backing and mounting surface.
3)&4) 01320021 Technical check
2324 possible loose gas cap 01320021=0.2 Performed DTC Readout
P0456 EVAP System very small leak detected. Checked fuel tank sealing several times in basic settings 71. Passes.
Inspected gas cap and adjacent seal. OK. Raised Vehicle inspected fule tank and lines. OK. Operating to specification at this time. Erased DTC's.
With all that done above, I got back my car and i am yet to see if there's any noise coming from the radio rattling and the suspension creak. What the heck did they do to my car on the item #3 #4? What is Erased DTC's and TB 40 08 01?
View 4 Replies
My front passenger wheel began creaking when driving over uneven surfaces after work was done on 12/29/14 to replace the wheel bearing, stud, and nut for the right front. I've been dealing with this noise for 1.5 years, but to my luck, when I take a test drive with a mechanic, it does not reveal itself, so they will not take a detailed look at it and open it up. It is more prominent in cold weather. Pushing down on the front of the car for a strut test does not produce the noise.
View 9 Replies
I get a creaking/clicking noise coming from my front wheels when braking at slow speed. can be rhythmic at times which makes be think it may be a ball joint or bearing.
Also it may be related or unrelated... Between 70-80km/h my front driver side wheel gives off a "Hum". I thought it may have been unbalanced wheels since it started when I put the summer rubber on, but the tire shop said they are balanced and thats not it. The Hum goes away when driving at any other speed.
Just last month I had my brakes done (a couple weeks prior to changing my rubber).
Front: New Rotors, Pads, Shims
Rear: Machined rotors, New Pads & Shims
Brake Flush Performed.
View 9 Replies
My parents have a 2007 hyundai santa fe AWD and recently there is this creaking noise from the front end when you have the car in reverse and you're foot on the brake and turn on the wheel, I had someone in the car and I stood outside it sounds like its coming from the center of the wheel near the hub it has that sound like a rusty door hinge, is there a problem with front wheel bearings on these cars we had the two rear ones replaced under warranty because of a humming thrumming noise and now there is a humming thrumming noise again but hard to tell if front or rear and the tires are in good condition no cupping.
Is there an easy way to check the hubs on these cars besides the normal move the tire up and down for play. By the way the car has 105000 kms on it...
View 9 Replies
I have a 1991 Toyota Corolla Wagon (150,000 miles) with noise coming from right front wheel well. My car is making groaning and creaking noises like the hinges of an old wooden door. CV joints serviced <5000 miles and the boots are clean and intact. There is no clicking noises during a turn Left or Right. Bouncing the right front corner does not replicate the sounds, tho' there is some slight squeaking noise not heard from the shocks/struts in the other corners. The sound is NOT heard in the morning going to work, but is very noticeable driving home at 5pm. I notice the sound going downhill at 35 mph, but goes away with light braking, Going over railroad tracks does not affect the noises. I'm thinking this could be worn bushings, strut mounts or who knows what?
View 1 Replies
Quick question : I just noticed a strange "creaking" or "squeaking" coming from my front suspension when I turn the wheel back and forth - while having the car at a stand still in the driveway...
I'm assuming my Strut Mounts (bushings) and/or Strut Bearings have gone and need to be replaced? As the creaking sound really souds like it could be the rubber bushing buckling?...
I just want to be 100% sure this is my issue before ordering the parts. Need to confirm that this noise I'm hearing is bad mounts or bushings? Or is there something else I should take a look at before ordering the parts?
[IMG] [URL]....
View 5 Replies
I have a 2011 Sonata Limited, I'm noticing some heavy rusting in the wheel wells especially in the rear (not sure if wells are the right term), what can I do?
It's very ugly, It has very heavy surface rust, the car is 2011, I don't remember seeing this much damaged when I purchased the car last winter. I took it to the dealership, they said they cant change it because it is purely aesthetic and the components still work.
I'm researching rust proofing, but that seems more like a preventative action than a remedy, what can I do, it really annoys me every time I look at it. I don't know why Hyundai chose such poor material inside the wheels that rusts so easily. I have compared it to other Sonatas I see on the street, mine is a lot worse.
View 25 Replies
I just completed a detailed cleaning of my SF last weekend and I noticed that every plastic screw and plastic nut inside the wheel wells were all loose. (Not the screws on the outside but inside above the tires.) I tightened them only finger tight.
View 3 Replies
Ive had my new Phaeton just over three weeks and have ha to take it back to the dealer with a slight wheel wobble at high speed, I gather the geometry on these is quite complex and the alignment is usually done on all four wheels. Interestingly however the dealer diagnosis is for four new tyres, obviously this is under warranty, but it seems strange to have to fit four new tyres on a brand new car!
View 6 Replies
My 2000 V10 Ex 4x4 (has 146,000 miles) with some rust on rockers and wheel wells runs pretty good. The exhaust needs some work. The transmission shifts pretty well I think, except sometimes from 1st to 2nd its a little jerky (like in a parking lot). I've put powerstop brakes on all four wheels, and have been maintaining it pretty well since I bought it almost two years ago.
Here's my issue. My 3rd son (out of 4) was diagnosed 2 years ago with ALL (Acute Lymphoblastic Leukemia). His End Of Treatment (EOT) date is July 8th 2018. This is relevant because to celebrate his EOT, we are planning on taking a 2 week road trip out west in our new to us hybrid travel trailer we just purchased this past February. We are taking the camper on a few weekend trips this summer and one week long trip to Michigan in July (we're from Ohio).
My concern is this: am I risking a ruined trip out west with such an old vehicle? I don't really trust it for such a long trip, I worry something would fail me and ruin a trip that's supposed to be celebrating my son conquering cancer. Am I being overly paranoid? I see V10 trucks and Excursions all the time with more miles than my own. I just worry that the rust will just be too much and the driveshaft will fall off, or the transmission will fail while we're towing up the Bighorns, or in Yellowstone. You get the picture.
View 14 Replies
I am sick that my 2008 F250 with 107K miles is exhibiting signs of rust this spring.. While filling up the tank saw a bit of a bubble on the left side top of the wheel well. Another one on the passenger side. I've had the truck since new and have tried to keep it as clean as I can being that it is a daily driver in the rust belt. Certainly thought that I'd get more than 6 years before the rot showed up. Don't remember my 1999 F350 exhibiting that, but it was a dually and had the fiberglass fenders that might have hidden it.
Took it to the local body shop and he told me to get used to it, just a matter of time around here. He said he could work on it, but it would never be fixed, rust would eventually return. He suggested sand blasting myself, repairing as I could, oiling the inside behind the tail lights and bolting on some Bushwacker flares. Having driven Ford trucks all my 40 years of driving I'm going to be looking at Dodges next time I buy.
Drivers side ...
Passenger side ...
View 12 Replies
Bought a 2005 FX4 recently, 107k miles, engine and transmission working smooth and quiet. Changed oil in engine, transmission, transfer case and rear axle, filter in engine and transmission, the oil I drained still looked pretty good.
At take-off or when going slowly the truck sometimes makes a really weird creaking/scratching/rattling noise. It appears to come from underneath the truck, I only can hear it when driving close to a building or taking off besides another vehicle with windows down (noise is reflected by building or other vehicle). There is no jerk, the truck drives normal but the noise is really weird (and alarming?). Where to look?
View 5 Replies
