2013 tdi 6mt. I am noticing that my clutch clicks when the pedal is depressed. it does not happen when I first start driving in the morning, but it seems that once the cabin is warmed slightly it starts then clicks each and every time. It is annoying and it appears to be related to the different temps outside vs the cabin. I did not notice it during summer or early fall but it is cold here now.
View 24 RepliesI have a 2014 Passat TDI with a 6 speed manual. When the clutch pedal is depressed between upshifts, there is an audible groaning sound and a vibration in the clutch pedal. The dealer replaced the throwout bearing but the problem persisted. They then replaced the entire transmission and the noise/vibration is still there. The noise follows engine RPM. Is this normal for the TDI powertrain? The dealer had never encountered the noise but they did find another car on the lot with the same noise.
View 2 RepliesI have another small issue with my 2004 Prius. I just noticed yesterday that the second I very lightly depress the brake pedal, a little clicking sound is made down below. It sounds like it might be coming from the brake pedal itself or somewhere underneath the hood. It's only when I depress the pedal slightly and it makes pretty much the same sound when I release the pedal. I just had a 5000 mile service done to the car and there were no issues then.
View 14 RepliesWhen I am stopped (at a red light, for example), the car wants to lurch when in 1st gear, even though I have the clutch pedal fully depressed. I know this is not a problem with the clutch master cylinder leaking by where you lose pressure on the pedal. Car has 245,000 miles and still has original clutch. Car/transmission work fine so long as I put it in neutral when I stop. Doesn't seem to do this w/reverse. Clutch also passes the "stall test" where you let it out in 4th gear with the hand brake on. What's going on here?
View 8 RepliesSometime the car is fighting to move forwards when I start to depress accelerator pedal and it sounds like "click click CLICK..." the sound changes from lower to louder depending on how I depress accelerator pedal... (like the car is trying to hard to move)...
View 3 Replies2002 camry. The car will not accelerate. The throttle body makes a clicking sound when pedal is depressed.
So.. I took it apart and cleaned the contacts in it. In the mean time located a spare throttle body from a 2003 from a local yard. The old throttle body has a part number 22030-28030 and the replacement has a part number 22030 0H010. The replacement throttle body wouldn't even move when the pedal was depressed.
I put the old one back on.. and now it doesn't click anymore but the car in Park only revs to 2000 rpm's. Its not sticking or having any mechanical issue.
I checked the parts site for Toyota and the replacement is the new number. Superseded. Does the throttle body after replacement need to be reprogrammed? Or whats the deal. I wish I was more Toyota literate when it comes to this.
But when I take my foot off the brake pedal , its just seems rather noisy (clunky). As if VW forgot to put some rubber or something to prevent this clunky sound. (it just sounds cheap)
My jetta and tiguan never seemed like this. Have to stick my head under there and see whats up
I have a 2003 Passat GLX 4Motion that was fine Monday...Having heavy rain Monday and with brake pedal depressed unable to get out of park..I have brake lights but when I got into car and started it I have airbag light and esp light on as well as check engine light...Is there a way to by pass the shift lock solenoid so I can move car into my garage...
I cleaned connections as was suggested and had a tough time as Bentley Manual states to remove console one must put lever into 3 which as lever is stuck in PARK was impossible...I tried pulling out the shift knob button as described and when I still couldn't get any response found that when I pushed the button back in that I was finally able to get shift lever to respond and finally come out of park...
I now get code for no TCM Signal P1626 No Powertrain Data Bus Signal Missing Message from TCM which now triggers ABS , Airbag ,ESP , and Check Engine light all with the cause no TCM Signal .... Now wondering if any easy way to test for data bus signal ?
M/T 2010 Sonata. I'm just out of warranty at 102,000 mi. No issues before with clutch. I noticed a clicking or crunching sound when pushing the clutch pedal down. I took a gander and noticed the pedal was traveling farther than it used to because there were indentations in the carpet. So this happens for about 3 days. Then I start the car and cant get it into gear. If I shut it off, it easily goes into gear and I can drive. Usually it is ok after that point but is getting worse. Mechanic briefly tried to bleed it but the pedal stayed on the floor. He was able to get it to its original problem but said if he replaces the master & slave cyl then might as well do a new clutch. Because I had no slippage, no pedal issues or anything prior to clicking. Is 102k miles and 6 years usual time for these components to fail?
View 2 RepliesI started having a strange clicking sound when pushing down the clutch pedal. I have 43,000 miles on it and I have driven the clutch well(I really don't believe I already worn it up). It goes away and then it comes back. There is no problem on shifting from gear to gear, it works just fine. It is only when I push the pedal that it starts clicking like it pushing against something. The car dealership was so useless, they said I need a new clutch and that warranty does not cover it because I may have been using the clutch badly. Also do you think that they have the right to tell me it is my fault even though I have the extended warranty for 100, 000 miles.
View 6 RepliesMy B5's clutch started not returning by itself when the really cold weather started. When it gets warmer it starts to spring back up. I called the dealership and the initial cost of looking at it takes me somewhat aback. I've already spent quite a bit on it last year. Reading some of the threads on other car models I've seen mention of clutch master/slave and fluids.
View 10 RepliesI have had everything related to the clutch changed, and I even had a dealership bleed the clutch line. The problem is the clutch pedal is soft and will sometimes work good and sometimes won't. If I prop the pedal to the floor for a few hours, it works fine for the day. what gives?
View 1 RepliesI have a co-worker that is having trouble with his 06 passat. He explained that the clutch pedal has no resistance and is on the floor. The dealer he took it to is saying he needs a new clutch and pressure plate claiming that the "pedal doesn't have pressure on it is because the clutch discs won't engage" which sounds backwards if you ask me. Anyway, what could this be? Where could we start tracking this down?
View 13 Replies I read all of the threads regarding clutch vibrations and other problems but I have 1,500 miles on my R and since day 1 I have been feeling a very slight ticking on my foot when the clutch is depressed. It gets more pronounced when I rev the engine a bit but nothing you can hear. Is this a normal feeling or should I not feel this at all.
I'm getting the APR tune next week and will do HPFP/intake soon but I need to be convinced that the Carbonio Intake is actually an upgrade from the stock intake with just a K&N filter, it doesn't look much different, the intake area looks the same as stock. I don't want to have to modify the engine cover or else I'd get the VWR intake. Any experience with the K&N vs stock vs Carbino?
Not sure if it was just the hot/humid weather yesterday but the car felt a little boggy when starting in 1st gear like it was running too rich or something. Any history of this?
This is regarding my 96 BMW 328i. It has approximately 177,000 miles on it. Over the past year, I've replaced the cooling system, fuel pump, alternator and trans fluid for kicks. So, I'm understandably frustrated with it. Anyway, to my story:
On my way into work, whenever I pressed in on the clutch, it would make a loud clunk/pop and freak me out. I turned around after 1/4 of the way and swapped cars.
My mechanical skills are maybe 3 on a scale of 1 to 10. I'm not afraid of changing oil, brake pads, transmission fluid, changing an alternator, etc. But I want to have someone to blame for anything that involves anything within the engine block/head/transmission continuum.
I noticed that a heat shield was loose between the driveshaft and the exhaust. I rapped it with a hammer, and the heat shield didn't make a noise anything like I'm hearing. So, it doesn't sound like that's the real culprit here.
2006 Passat, 6 speed manual,113,000 kms. Driving to work this morning and I noticed every few shifts that the clutch pedal rebounded slowly when released. Then in traffic stuck to the floor and I had to physically pry it back with the side of my foot. Worked fine for a few more shifts then same thing again.
View 4 RepliesFacts: 1999 Vw passat 1.8t
1 year ago, clutch pedal would not come up off the floor, no life in the pedal.
Problem: Clutch master cylinder, replaced.
6 months ago, clutch finally went bad. Took car to clutch shop, replaced clutch kit(found out after i payed that they only turned the dual-mass flywheel... ). Get car from clutch shop, the clutch pedal came up only 2-3 inches off the floor by itself but you could lift the pedal with your hand or foot, and it would come back up all the way, but it was life-less. It was not pulling fluid in. It was catching extremely low. I called the shop, they said that it was just because it was a new clutch and it would get better. I didn't believe them.
Two days ago, I got into my car and couldn't get it into gear. Clutch pedal would go down with the same amount of force as before. Took it back to the clutch shop and explained the history with the clutch master and then them doing the clutch kit. They said it wasn't bleeding properly and they're not sure if its going to have problems again. Car is working now, but I am concerned that it will have similar problems again.
The tech who fixed it said he pumped fluid into it extremely hard, and that's what made the pedal come up all the way (no longer stops 2 inches off the floor) and its going into gear just fine now. What the problem might have been? Block in the hydraulic lines? If this is the case, does forcing fluid through it fix it?
My clutch pedal went all the way to the floor. The engine was missing first and then that problem happened with the clutch. I had the car towed to my business, I checked it the other day and the pedal was up. The clutch still doesn't engage.
View 6 RepliesI've been driving manual transmission vehicles - from my '72 Pinto to big trucks - for 40 years. This happened recently in a VW Golf I had rented: While driving down a mountain in a tunnel in Norway, with the clutch depressed, there was a loud POP noise.The clutch became engaged, and the clutch pedal did nothing. I'll spare you the details of the harrowing aftermath, the language barrier issues in the sticks of Norway and such. In the end, the rental company is charging us a couple thousand bucks for breaking their car. I maintain it was not Driver Error. My local VM service manager indicated that the Slave Cylinder on the Golf has been a problem for years, and is probably what went bad, but - as a rep of VW - is not willing (allowed) to put that in writing. The garage that fixed the Golf indicated it was Driver Error. I'm guessing everything tranny-wise got beat up when the Slave gave out, making it look like I'm a bonafide Clutch Masher.
View 19 RepliesI bought my Hyundai new in late 2011. No problems with the car (other than no spare tire???) until just out of the warranty (63,000). Had a noticeable drop in power on the highway. No warning lights. Drove another 100 miles with power intermittently dropping. Next day engine light comes on. $800 later I have a new high pressure fuel pump. All seems well. after a few weeks, I notice that the car seems to be revving when I depress the clutch to change gears, like up to 4000 rpm's. If I leave the clutch in for a few seconds it will begin to decrease. But if I shift right into gear as I have done for the last 35 years of driving, it is not smooth, jerky. This seems to happen mostly going into 2,3, and 4th gear, always going up. It never happens when downshifting. I tried tapping the brakes when shifting up, and sometimes it does seems to drop the rpm's. What it might be. It probably is related to the work that was done, but I don't really trust the dealer and want to have a little info going in.
View 1 Replies2009 Accent 5 speed 66K miles. This is something which I recently noticed with the onset of winter. When I depress the clutch pedal, I have a very audible squeak. Think old door hinge squeak. So metal is rubbing against metal somewhere inside the bellhousing without enough lubrication.....not good. I pulled off the dust boot on the side of the bellhousing and tried my best to push moly grease around the clutch fork stud, hoping that was the origin. The noise went away for roughly a half a day but is back in full force....funny how cars do that.
Space seems EXTREMELY limited on lubricating the proper area. Or....is this a warning mechanism built into the clutch pressure plate assembly to warn of replacement soon? While I am asking these questions, what is a good time to look into replacing the clutch? The parts for the car seem relatively cheap, if I replace the clutch assembly, I may consider replacing the flywheel and clutch hydraulics as well as a whole system replace/refresh.
That aside, is there anyway to eliminate the squeaking without having to crack open the bell housing?