Passat (B7) :: Beep Sound After Clutch Has Been Released
Aug 25, 2015
It happened again this morning while putting the tranny into reverse and backing into my slanted/graded driveway about 60'. After the clutch has been released all of the way, a BEEP...BEEP...BEEP. aural sound comes from either the engine bay or under the dash. It's not happening when driving out fresh in the morning. It only occurred when I was backing up and on a grade. First, I had thought that it was my clutch telling me - Or, maybe it was the Hill Assist actuator in conflict when the car is actually moving. No smoke or burning coming from underneath nor any idiot lights flashing on the Dash.
I left a message for the Service Manager at the VW Dealer that I purchased the car from. I haven't heard back yet if he has ever heard of or witnessed this freak of nature event. Today was the second time in a week that this "Anomaly" has occurred.
View 11 Replies
Advertisement
I just bought my mother's 2004 GX470 and I tried the voice command button on the steering wheel but no beep sounds and nothing happens. I tried looking up the information in the manual and seems like I'm doing everything right.
Second, when I brake I feel a thump as I release from the brakes, is that normal?
View 3 Replies
My car makes a clunking sound when the clutch is released, it's not the throw out bearing or the pressure plate, as they have been replaced twice already???? Have dual mass flywheel go bad, what were the symptoms?????
View 10 Replies
2000 v6 manual wagon with +-90k. Brutally lowered with KW coils. First thing I noticed was the clutch pedal slowly getting lower and lower to the floor when fully released. Besides the pitch getting shorter, it seems to work fine, no slipping at all. It now sits a couple inches closer to the floor than the other pedals.
I am also getting a couple other things that may or may not relate to the clutch. It started out as a vibration under acceleration, getting worse over about a month or so. Now it is also starting to clunk when pressing or releasing the gas while the clutch is released. It also clunks when moving from a stop, although I can regulate this with the clutch.
I am thinking it is a motor mount causing the clunking and vibrating, and maybe the engines movement has caused the clutch to come out of alignment?? I am unsure where to start, which mount to check, etc.
I also just had my oil pan replaced after slamming the ground recently. Although the problems were starting before this, I am sure this wasn't exactly good for the motor mounts....
View 5 Replies
After I have been driving and turn the engine off there is one 'Beep' sound and the light above the left visor turns on. The only thing that will turn the light off is if I put the visor back up. It stays on in all other positions. Opening the little mirror window on the visor does neither turn on or turn off the light. I posted this before but forgot to mention the 'Beep' that sound when I turn the car off. what does that mean?
View 2 Replies
I've done a bit of research both here and on other sites. I originally thought that I had a bad flywheel but I'm not convinced. First I'll give a little backstory. I just installed steel shift forks because one broke and got jammed in the gears. None of the gears are damaged and I assumed that when it slammed to halt, the flywheel got messed up. So anyways, the complaint is that when the clutch pedal is released I start to hear a knocking sound which becomes more rapid with RPM. When the pedal is depressed the sound goes away. This sound seems to be coming more from the driver's end of the trans. The car still moves in all gears so I can't imagine that I put it together wrong.
View 6 Replies
I was sitting at a red light and the car shuttered and the rpms dropped but went back to idle. Then when the light turned green I released the clutch to start like normal and the rpms dropped and stalled. It cranks but won't start. I'm getting fuel to the fuel rail and I replaced the coil pack about a year ago.
View 2 Replies
In every other manual transmission vehicle I have ever driven, the clutch pedal engages/disengages within an inch of the floor. Is it normal that the clutch in my 2002 Hyundai Elantra engages when the pedal is so far away from the floor? When I say far away from the floor I mean within an inch of the pedal being fully released.
View 21 Replies
I have an 00 Accent 1.5 liter 5 speed with about 192000 miles on it. I have put about a tank of gas through it since I've owned it, so I can't give a lot of background on it. When I got it the previous owner told me it was popping out of fifth gear and the clutch fluid leaked.
Upon driving it around a while I noticed it would pop out of fifth and third gears almost at random, but seemed to happen more when I applied throttle. I assumed it was an issue with the shifter not fully engaging the gears, and checked out the bushings under the hood and in the console. All looked good, and I didn't see any extra play.
I drove the car for about 30 miles straight and had to downshift and wasn't able to get the car to go into any gear but fifth. I was moving about 20 mph when this occurred. I was able to limp along to a parking lot where I let the car sit for about ten min and I shifted through the gears when stopped. I headed back home with this problem throughout the trip. There is a sound that happens on occasion (that stops when I press the clutch pedal) that sounds like a bad bearing in the clutch area.
When I'm stopped with the car in neutral and I release the clutch the car stalls like it's in gear. I was able to get the car to move some, but it really doesn't want to it acts like there is something jammed in the gears and popped really loud when I backed it up.
There is fluid for the master cylinder, and I can see the slave cylinder moving when the pedal is pressed. I jacked it up and removed the plug to check for gear oil, and it came pouring out, so I think it has fluid in the gearbox. I'm pretty sure it needs a clutch at the least. I think there may be some internal damage in the tranny, and I'm only into the car for the time it took to power wash a house and don't want to get involved in a big mess.
View 5 Replies
Last night when I turned my car on (cold engine start so let it warm up) and by accident when i was starting off on 1st i released the clutch to fast and not adding much gas causing the rpms to drop down and the car jumped and not sure if it shut off cause when it turns on it beeps once due to my tpms needing service and i heard the same beep but instead of shutting off the rpms jumped to 2k as if i was revving the engine and i began driving. What gives?
View 4 Replies
My Grandpa has an 88 Ranger 2wd with the 2.9l V6 and a 5 speed, I believe, M5od. I was driving down the highway when I heard a noise. I tried throwing the tranny in neutral but when I pressed the clutch pedal in, I had no pedal whatsoever. Engine took awhile to restart. It'd turn over a little almost as if a rod was bent or something of the sorts. Eventually the engine started and would stay running as long as the clutch was pressed in (disengaged).
The engine dies no matter what range the transmission is in,neutral included unless the clutch pedal is depressed. It Will die when the clutch is released in any gear with no forward movement that is noticeable. I can spin the tail shaft with the driveshaft installed and all gears in neutral but the input does not spin at all. Input shaft wont spin at all, period. I originally thought the slave cylinder was KIA but now I am very confused on what the problem could be? Is there a bearing the input shaft rides on that may of seized?
I pulled the tranny last night and took the top cover off. Yes, I made sure it was in neutral when I removed the cover. I can manually shift the collar to all gears by hand, 5th and reverse included. I'm stuck between a rock and a hard place here and where to go from here. I have bought a new clutch assembly and slave cylinder. This truck was bought by my Grandpa brand new in 1988. It has 98,000 miles and everything is original. I did forget to mention that there was very little oil in the trans when I drained it and it appeared to be gear oil vs ATF.
View 3 Replies
On my way back from the coast today, the trucks RPM's started going up and the engine was reving up, but I was losing steam. It started only when I was climbing long steep hills, but by the time I got home, it was doing from a dead stop in first gear, barely moving when I applied gas and released the clutch..
View 19 Replies
Title should say Throw-out bearing aka Release bearing.
I have a 2010 5 speed Corolla CE. Having problems with their Throw-out bearings. At around 8000 miles the sqeaking/chirping noise of the bearing was too much so I brought in it to the dealer to fix. They agreed and made the repair.
Now it is only at 10000 miles (22000km) and I can hear it starting again. Just wondering if it is a common problem?
Noise comes and goes as the clutch pedal is released. If you push it in it will go away. It also will happen in all gears but easiest to hear in neutral.
View 14 Replies
Been having trouble shifting into any gears on these chilly mornings in VA now... The clutch has been sticking on its way out when I release it and the gears don't want to engage unless I really push hard on the shift knob.
View 11 Replies
Ok just like the title states, when the hood latch (inside of car) is pulled the hood does not spring up. it does unlock but it does not show that it was released. the hood when closed properly does not open without pulling the hood latch handle.
View 1 Replies
When I release the brake pedal too fast, the brake pedal bounces back with sound which is a little bit loud to me. I feel the sound is from the spring if there's one. It's annoying so I have to remove my foot from the brake very slowly. Is it normal?
View 20 Replies
My car is a 2011 Golf TDI....
Ok so yesterday I was getting onto the highway under normal acceleration and all of a sudden I heard sound that I can only describe as pressure being released. Immediately after, the cars shuts off and is just coasting. I have a standard transmission. I turn the car off, put it in neutral while still coasting, and restart it to see if it will start back up. It works but I have no power what so ever. Like it was in limp mode. So I pull over and turn it off and try to restart again and it just keeps stuttering and not turning over or starting up. I had it towed to my dealer.
So toady being Saturday, the dealer had a half day and didn't really get to diagnosing my car. Well I drove there and talked to the mechanic and he said when he drained the fuel it was clear as water, and that diesel should be yellowish. The service advisor then started asking me if I put gas in it or any additives. I never in my life have used additives and I have every single receipt from the start. He is saying that if they find out its gas, that it will not be covered by warranty. What should I do? Where do I go from here to ready my self to defend I didn't put gas in it.
View 2 Replies
Ive got a 2011 Sonata GLS with 111k miles. I purchased the car new. For the past several months the brakes make a crunch or creaking sound when the pedal is being pressed OR released. The funny thing is it only happens when driving forward. When I apply the brakes while reversing, the brakes are silent. I did a pad slap at 68k and have taken everything apart, cleaned and re-lubed to no avail. The sound can be heard at the front wheels when someone else works the pedal while the car is parked. Pads have about 50% thickness. Pads? Calipers, master cylinder?
View 27 Replies
Ok first of all i know this sounds really stupid. I got curious of the intake system and I unbolted the tube that does down to the (turbo i think) anyways I figured it was the intake for the engine. Anyways I went for a quick little drive, and it was not the intake for the engine it was the for the turbo. The turbo sounded pretty loud and made a whoosh when the throttle was released. Cool. 2 min later the car shut off i started it back up drove home, and put every back the way it was suppose to be! and there is a check engine light. My question is... How do I reset the light myself instead of the dealer doing it, I thought i remembered how to do it somehow without anything. Btw was doing that anyway harmful?
View 4 Replies
Just got the 2010 passat two days ago. As you know, when you press the accelerator, the E brake releases. When i do this, the back of the car rises up just a bit as the brake hasnt fully released, but can this wear out the brake quicker, since im effectivly driving with the e brake half on for that half second. Im pretty sure it wont as I think it uses the rear disk brake for the E brake, but curious what others think.
View 13 Replies
I got my GTI exactly one week ago. I brought it to the car wash today. When I got home and hit the lock with the remote, the car did not make the "beep" sound with the horn. I unlocked it and checked all the doors and the hatch to be sure they were properly closed, and they were. Then, I hit the lock from the remote and the doors locked, but no "beep".
View 7 Replies
