Passat (B7) :: Activate Parking Lights With Blinker / High Beam
Jan 3, 2012
How do you activate the parking lights with the blinker/high beam stalk. It has the P....
View 7 Replies
Jan 3, 2012
Advertisement
Jeep - Cherokee :: 1996 - Dashboard Blinker And High Beam Lights Come On
My 1996 jeep cherokee is having a problem with the lights when I pull the plunger switch my dashboard blinker lights and high beam light come on but none of my outside lights come on besides my tail lights.
View 4 RepliesPrius (2010-12) :: Parking Lights Only On When High Beam Is Activated
I have a 2010 prius. I bought the car used a month ago. at the time of purchase both parking lights were on when my headlight is turned on. Now it won't turn on unless I turn on my high beam. Should I take it to Toyota dealer and have them take a look at it. It is certified preowned.
View 4 RepliesGolf IV / Jetta IV :: Blinker And One High Beam Not Working
I have 2000 golf with a gli front end. Recently just did the swap and now I'm having issues with one blinker and one high beam not working. The running lights work on both sides. The headlights work on both sides. I checked the bulbs and they were good. I check for power it was all good. I checked the fuses and they were fine.
View 7 RepliesPassat (B6) :: 2007 1.8T - Low Beam On Passenger Side Not Working But High Beam Does
This morning a dash light informed me a headlight bulb was out. It was my DTR light on the passenger side.
I purchased Sylvania H7 high intensity, installed it and it failed to work properly. Daytime light on only drivers side works.
High Beam on , both lights works.
I checked my manual and it said to check fuse in the 5 slot on the driver side dash/door panel and there actually is no fuse in there. I checked the driver side and there was no fuse there either.
I replaced my driver side bulb last year and it took 5 mins....i am already 4 hours into this!
Subaru - Legacy :: Low Beam Lights Do Not Work And Dash Parking Break Light Will Not Go Out
I have a 2000 legacy wagon (245k miles) that has a light issue. The running lights and low beam lights do not work and the dash parking break light will not go out. Earlier I had just the low beams not working. They were both blown and I replaced them about two weeks ago. Now they are out again and the dash parking break light stays on. I checked the fuzes and they look good.
View 8 RepliesLumina :: Left Blinker / Break Lights Will Not Come On Unless Pull Blinker Switch Forward A Bit?
I also have a problem with my left blinker and my break lights. My right blinker works just fine, but my left blinker and break lights will not come on unless I pull the blinker switch forward a bit- as if I'm going to turn my brights on.
View 14 RepliesGolf/GTI VI :: Fog Lights To Come On With High Beam
I have a 2012 gti with oem bi-xenon head lights. What code or setting do you use on vagcom to bring on the fog lights when I turn on highbeam?
View 3 RepliesTrailBlazer :: 03 - High Beam Relay Squeals Lights Come On
Last week my wife's battery in her 03 Trailblazer was dead in the morning. I jumped it and it seemed fine all day. That night I tried to start it and it was dead again so I replaced the battery. The next day, she looked out at the parking lot at work and her lights were on after it sat for a while. She could not turn off the headlights no matter what. She said she heard a squealing noise under the hood.
I could not duplicate it when I got home, so I replaced what I think was the lowbeam relay. Later that night I looked, and her headlights were on. I got under the hood and the highbeam relay was squealing. I removed it and the lights went out. I replaced the relay with a new one, but the relay immediately squealed and the lights went on. I have the relay out now and the problem is gone, but we have no highbeams.
What is causing the relay to squeal and turn on the highbeams?
Ford F-150 (2009-2014) :: 2012 - How To Keep Fog Lights On With High Beam On
I have a '12, F150. Is there a fix to keep the fog lights on while on high beam?
View 6 RepliesCamry :: 2006 - Key Fob, High Beam, Interior Lights Stopped Working
I have an '06 Camry, which has lost all power functionality. The follow items just stopped working
1. Key fob -- keyless entry and alarm stopped working
2. high beam doesn't come on when headlight is on. However, when headlight is off, it comes on--go figure
3. Power door lock also does not work, even from driver side door. Have to lock all doors manually
4. Interior lights don't come on when door is open.
Passat (B6) :: Upgrading R36 High Beam
I have an MY10 R36 wagon, and just looking to upgrade the High Beam only for night time driving.
View 1 RepliesPassat (B6) :: HIDs Go Out When Using High Beam
I installed an aftermarket HID's on my 06 B6 2.0T, used VAG-COM to disabled DRL's. They work great no issue, expect when I use my high beam.....both HID's go out and I get warning light/message on the dash. I can get them to come back on by turning the lights off and back on.
View 7 RepliesPassat (B6) :: HID High Beam Out On One Side
My right sided high beam stopped working and my dash "bulb" warning light is on. Low beams working normally and still swivel around on startup and when turning. Is there actually a separate bulb for the high beams? I ask because when you flick on the high beams I hear mechanical movement inside the headlight housing, making me think high beams may be just a redirecting of the light. Having computer issues so haven't tried VAGcom yet. Also haven't checked fuses...
View 9 RepliesPassat (B5) :: 1998 - How To Make Front Fog Lights Available In Euroswitch City Lights (Parking Lights) Mode
1998 Passat 1.8t B5 sedan. OEM fog lights up front. No rear fog lights.
I recently upgraded to a "Euro" light switch to get more flexibility with my lights. Put tape on the TFL pin to disable DRLs in OFF Mode. Put tape on the 56d pin to disable DRLs in CITY LIGHTS (Parking Lights) mode. Completely successful -- no DRLs, just as taping the TFL pin on the original light switch accomplished long ago.
BEFORE I did any taping this time, I installed the Euro switch AS IS and tested all of its modes and physical positions:
(1) OFF: No fog light position available (switch knob will not pull out). As expected and okay.
(2) FULL ON Fog lights come on (but who the hell can see them?!?) when switch knob is pulled out one stop into the fog light position -- and the little front fog symbol on the switch lights up. Again, expected and just fine.
(3) CITY LIGHTS (Parking Lights): The fog lights position is physically available by pulling the switch knob out one stop... BUT THE PARKING LIGHTS DO NOT COME ON (regardless of ignition switch position, emergency hand brake position, etc., etc.) And the little fog light symbol on the switch does not light up. (Not surprisingly, pulling the knob further out to the REAR fog light position does nothing either.)
THIS IS NOT GOOD - since with a Euroswitch one ought to be able to manually select and de-select the fog lights while in CITY LIGHTS (Parking Lights) mode!
How to make my FRONT FOG LIGHTS available in Euroswitch CITY LIGHTS (Parking Lights) mode...?
Toyota :: How Resistor Makes High Beam Bulbs Dim For Daytime Running Lights
How do they make the high beams dim for Daytime Running Lights?
View 6 RepliesFord 6.7L Power Stroke Diesel :: 2011 - High / Low Beam And Fog Lights Won't Working?
2011 f350 king ranch... I have DRL, turn signals and tail lights. I have checked all fuses ( don't know if there's a relay) under hood and in cab. Still do not have any headlights, high or low beam nor do I have any fog Lights.
View 5 RepliesFord Super Duty (1999-2016) :: 2001 - Fog Lights On With High Beam?
I have a 2001 f250 with factory fog lights. ive been researching to see if I can make my fog lights turn on with the high beams without pulling them out. My broke and cant pull it or it comes off, but will still work to turn head lights off and on. How to make them come on with the high beams?
View 14 RepliesFord Wiring/Electrical :: 1997 - Headlights / Brake Lights Cut Off When Hit High Beam Switch?
So I recently bought a 1997 7.3l F250. It is in fairly good condition, but it has some problems with the lights working. The turn signals and hazards all work, as do the tail lights and headlights. However, when I hit the high beam switch, the headlights cut off entirely. Also, the brake lights do not work at all. Ive checked the bulbs and since they all work Im not sure what the issue is.
View 3 RepliesPassat (B5) :: Passenger Side High Beam Replacement?
Any tips for replacing the passenger side high beam? I can get my hand in there by there is no way to turn the bulb. Any easy tool to grip and turn the bulb?
View 5 RepliesPassat (B7) :: High Beam Not Working - Switched Fuses To New Ones
My high beam doesnt work. I have a Euro Passat with H7. I bought new H7 yesterday but still no luck.
I have switched fuses to new ones.
Is there anything else I can check?
Is there relays on this model for the high beams?
Low beams works fine and everything else in lights.