Passat (B6) :: Limp Mode With ECM And Traction Control Light As Well As CEL
Feb 20, 2013
My friends has an 06 3.6 motion sedan and has a problem. His car went into limp mode with the ECM and traction control light as well as CEL. we took it to the local dealer (45 min away) they scanned it and said that the throttle pedal was the only code that wouldn't clear. He ordered a new pedal from ECS and installed it today. The cars still in limp mode we read about a potential throttle body adjustment procedure (not too sure of the validity) any how followed it open hood open door ignition in the "on" position for a few minutes. After that when he started it every warning light came on. Is there a step in pedal replacement we re missing? On a side note the connector on the pedal end was fairly damaged not sure what from maybe the po had a botched replacement attempt? Not too sure what to try next.
View 5 Replies
Advertisement
I have a 2007 Prius and it will be my first car once I get my license. It has a bad traction control computer and is stuck in limp mode. I have a neighbor who has worked on these and will show me how to replace it. Right now I have two questions. I keep coming up with how to disable it not the actual part.
View 1 Replies
Passat 2008/09 TSI engine 16k miles. APR stage 2+
I was driving normally and suddenly EPC light comes on, and the engine goes to limp mode. I turn the engine off and then turn on again. Everything runs fine. Vag shows N276 intermittent fail. I had already this fail, but always when starting engine, and the engine used to run OK. Is this a "sign" that is time to replace the HPFP? Or can I take the chance and keep running?
View 3 Replies
My transmission control module has gone bad, resulting in the car being in"limp" mode. I am advised not to drive the car in this condition as it starts out in 3rd and the transmission will be damaged. Thus far, my local dealer has, on a preliminary basis, been advised that there are none of these parts available anywhere in the world according to the computer and VW may have to manufacture one. This does not sound possible. Meanwhile, the dealer says no rental car will be offered so I am contacting VW North America to escalate. It could be up to a month to get a new part. Meanwhile, the car is in the garage just sitting.
View 7 Replies
I am one of the few that has ADC on my 2004 V10.
Occasionally, 3 times now. I press the ON button and the cruise control does not initialize properly. After a while it will say "Temporarily unavailable" . The problem is that then there is no power any more.
I stop on the hard shoulder of the motorway, engine off, engine on and all is reset, ADC works ok and full power is restored.
View 1 Replies
so i was driving the vw and the car starts surging like its in limp mode but no cel! so i stopped and checked my engine bay to see if maybe my intercooler piping came loose but nothing! so i shut it off for about 5 seconds and turned it back on and it threw a cel! the whole time i was driving it home felt like it was going in and out of limp mode and would not boost past 4 psi! check the cel and came back as this:
P0238 turbo/supercharger boost sensor a ckt high input
p0106 map/baro ckt rng perform
View 4 Replies
I have the problem of over boosting and hitting limp mode. now does that mean i adjusted the actuator wrong when putting it back on? if so how do i adjust it properly. or is there something else i can do to make the car come out of limp mode? also since it is boosting past a certain psi should i put a mbc on it and adjust it down?
View 1 Replies
Wife's Passat went into "limp mode" and will only give me 4th gear. Check engine light came on when it happened. I had a buddy scan the car with OBD scanner and it is saying Sensor A is bad? Which sensor this is, or thought of writing down the code that it was throwing. My guess is the speed sensor for the transmission.
Luckily the car is a W8 and has enough power to pull the car from stop in 4th gear. There aren't any reputable VW dealerships in my town or any neighboring town. I've decided to take the car to a VW/Audi specialist some 60 miles away. They told me they can take a look and replace if needed. I absolutely do not trust VW dealerships/service around here. I've heard nothing but nightmare stories about them.
View 2 Replies
I have a 2004 1.8T AWM auto tranny Passat with APR chip. CIA, Bolt down Coil Packs, Bosch F6DTC plugs, OEM cat to straight pipe to magnaflow muffler, N75J, Forge DV (not the 007).
I installed a MBC bypassing the N75 to keep the spike at 16psi and hold (the n75J i spike at 22psi and hold 12~14), When I did that, the car will go in limp mode from 'over boosting'. I have to turn the MBC down to 9 to keep the car limping out. I love the way the MBC have the boost curve (the N75 is too passive for me). would like to fix this issue.
Also, with the N75 and or MBC, while in the APR 93 oct chip mode, I always get surging in 4th and 5th gear. Any time the boost is over 10psi, it is like I have tons of boost, but the engine is not using it. APR said it is the tranny, the tranny shop said it is the engine or computer, the engine shop said it is the tuning.
View 1 Replies
I got into my car about 5 minutes ago and while driving i noticed a ample amount of power loss. I would go half throttle and my rmp's would go up by my speed seemed lacking even full on it it seemed to be lagging and was a slow climb to 60. Could it be my turbo not putting out or something more serious. Its a 99 1.8t ....
View 10 Replies
We have a 2006 Passat, 30K miles, live in northeast on a Great Lake. We bought it used in 5/07 with 11K miles on it. The other day, a whole mess of warning lights came on, and the car went into "limp mode." The dealership diagnosed corroded wires where they connect to the throttle valve controller. We usually keep our cars for years, and we've never had corroded wires before. Is this a typical problem of VW's? The service mgr said he'd seen about 6 come in in the last year, but I don't know if that's a lot or a few compared to other brands. We're getting ready to shop for cars again, and we'd consider a new Jetta, but not if it can't go out in the rain. Also, if the wires corroded once, what will keep them from corroding again? Should we expect this to keep happening?
View 2 Replies
So on cold mornings my r has been kicking on the epc light and gone to limp mode. The only codes are for the coolant temp sensor and an intermittent accelerator position sensor. Would the temp sensor really cause this? After awhile I can start it up and it runs fine.
View 7 Replies
Own a 2006 Volkswagen Passat 2.0t a/t. My dash board is showing a parking brake fault but as soon as the that comes up my tranny will go into limp mode ???? could the parking brake and tranny be linked together??? My parking brake still engaged and disengaged ??? what can it be ???
View 8 Replies
2001 Jetta 1.8T wolfsburg
When I start my car the ASR light is already on and I cannot turn it off by hitting the button. It's just permanently on. Then as I start to drive and step on the throttle and get above 3000rpm the ECP light turns on and my car goes into "limp mode". Then in idle the engine stutters and RPMs go up and down, up and down. I'll turn off the car and the ECP light disappears but comes right back on again after getting above 3000rpm.
Thing is, these issues only appeared immediately after the following:
-Disconnected and reconnected CCM (checking for faulty wiring, battery was connected during this)
-Disconnected battery terminals for 3 minutes and reconnected them (no key in ignition)
Did I cause an issue by disconnecting battery?
View 3 Replies
So this morning I was driving to work - normal driving no hard accelerations. As I stopped at a trafic light the car felt going into a limp mode? - engine started to misfire - no smoke from exhaust - but felt is was going to stall. Also the idle started fluctuate from low 600 to high 1100. At low RPMs the engine felt stalling but when I drove around 3000 RPM in 4, 5th gear felt fine.
I was able to plug in the APR dongle and got 7 fault codes: 1)DTC Not Found, 2) Idle Air Control System RPM HIgher than Expected; 3) Random/Multiple Cylinder Misfire Detected and 4,5,6 and 7) Cylinder 1,3,4,2 Misfire Detected.
I am APR 1+ with VWR CAI, 20K on 93 oct.
Coil? Injector? Manifold? HPFP?
View 24 Replies
Just set off on a day out, got about 3 miles and the cars gone into limp mode (running smoothly but no power) with the glow plug light flashing. I got back to the caravan so we weren't stuck at the side of the road and tried restarting it. It starts off for about a minute before coming back on. I've noticed that revving it in neutral the revs linger for a second our so after taking my foot off as if its not recognizing that the throttle position has changed.
View 21 Replies
Just to save you all some time.... If your car goes into limp mode, and/or cruise stops working, and the EPC light comes on..... We had over a week of downtime and hundreds of $ out to find out that the literally brake light switch broke - its apparently flimsy and triggers all kinds of electrical faults..
View 1 Replies
2001 Ranger 3.0 liter has developed a transmission casualty. I was driving along at 30 mph and the transmission went into "limp' mode with O/D light flashing and truck will only barely creep along with high engine rpm. When I got the truck home I was able to retrieve a p0720, output shaft speed sensor signal fault. I had hoped that replacing the sensor would solve this casualty.
Of course this was not the case. I have read all the posts I can find for this particular fault and realize that I must electrically trace the continuity of this circuit and also ensure that it's not grounded. I have been unable to find the needed wiring diagrams or pin out information.
Before I have to try and blindly start pawing through the connectors I'm looking for the pinout for the PCM and perhaps the bulk connector above the engine between the PCM and the transmission wiring harness. I am also keen to hear of any diagnostic tips that I may have overlooked.
View 10 Replies
I have a 03 GLI 24V VR6 6 speed and im having an issue with the brake light.. ive checked all the fuses and emergency brake sensor and they are all good, the issue is the brake light flashes 3 times then will stay on almost immediately and whenever it does the entire drive of the car changes.. without the light on the car runs fine but when it comes on its like the car goes to a limp mode and is leaning out on fuel.. it wont rev past 4k it falls on its face and basically jerks along until I get where I am going.. I've replaced ABS speed sensors, MAF, and front brakes and axles recently.. before this was an random issue that would come and go but now its almost every time and it makes it undriveable..
View 1 Replies
My wife and I are driving our 2005 Prius with 130k miles and have experienced some weirdness with the car while driving. We've got the master warning light (red triangle w/ !), and another yellow (!) warning light, plus the center display shows a red car with an !. I've gathered that it means something possibly with the brake controller, so when I parked I put the e-brake on.
The car was driving fine with these lights on (we were in the middle of Canadian highways and couldn't stop anywhere) except that cruise control would not work.
Eventually, it actually went into limp mode, where we would floor the pedal and the car would barely accelerate. Pulled over, turned it off for a few minutes, then back on and it drove fine, warning lights still on.
I just replaced the driver's front wheel hub, and I can hear the passenger front going bad, so I'm suspicious that this may be related. Just replaced the 12v within the last few months with an Optima.
View 9 Replies
I have a 2002 vw golf and its epc light keeps coming on and every time I reach 4000 rpm it goes into limp mode, what is the problem.
View 2 Replies
