Passat (B6) :: Droning Tire Noise And Excessive Wear On Inside Tread Blocks On All 4 Wheels
Jul 29, 2009
About 5K miles after putting on 18x8.5 rims with 235-40 tires noted bad reverberating droning tire noise and noticed stairstep pattern of excessive wear on inside tread blocks, equal on all 4 wheels. Is this just from going from OEM ET47 to ET35? Is camber adjustment indicated and is camber adjustable also on the rear wheels? (Of course, noise and reverberation gone when OEM wheels put back on)
View 5 Replies
Advertisement
Having issues with excessive front tire wear? I have had the alignment checked by two VW garages and a third party garage and all of them confirm that the alignment is good.
The VW garage also confirmed that as far as they can see there is no suspension issues, but the excessive wear on the front tires indicates that something is wrong.
I have owned the car since new in 2008 so know it has a clean history no accidents.
Both front tires look like this.....
View 18 Replies
Right Front Tire has excessive wear on Right INSIDE and car was pulling to the left. I rotated (or is it revolved?) my tires, and now the pulling has stopped......
OPINION: Bad tire that just wore poorly? Slight alignment issue that caused tire wear that then caused car pull? Wheel bearing issue causing tire wear? Or something else?
View 6 Replies
I noticed the passenger front tire wearing on the inside, I have no camber plates. Presuming alignment is still good could this be from a worn strut mount?
View 1 Replies
So on my wives Prius which is an 2007 the rear tires are wearing more greatly on the insides that the outsides and they are wearing evenly on both the rear left and rear right inside. So not one is more worn than the other..
The tires are heavily worn, with that said the car rides extremely bumpy to the point the entire car is shaking on the freeway at 75 mph or higher. So much so it induces motion sickness which is odd for me. So also besides the alignment question, what else could be causing the insane amount of bumpiness? I balanced and rotated them yesterday but that didn't solve the issue.
View 6 Replies
I realize that is vague. I realize it could be anything from a wheel bearing to a ball joint, tie rod, control arm/control arm bushing, etc.
Are there any very common front-end steering or suspension issues on 2012 escapes? When tires are inflated to 32-34psi, the car tracks straight, gets great mileage --but almost sounds/feels like it's got a CV or wheel bearing issue on the front right. Every time I hit the brakes while backing out of the driveway I can hear a slight bump or pop. When the car is parked (flat, tires straight) there is slight play left-to-right in the steering wheel.
I'm a German car guy. Have never touched this car. (Wife's car) Right tire is wearing bad on inside. Looking for some direction so I can assess. Car has 88k miles. This will be a DIY fix. Don't have any manuals or anything so just looking for a heads up where to start. Also is Haynes the best way to go? Is there a Bentley? Anything online/CD/DVD?
Play in steering wheel makes me think tie rod (fine because easy/cheap) but such excessive wear on the inside right front makes me think wheel bearing. Could it be both? This is AWD. Is this (like a Subaru) a CV joint where the front spindle passes through a strut base that everything attaches to --so there's an inner and outer wheel bearing?
Does anything up front require a press or can it all be done without a press?
View 3 Replies
I have a 99 F-250 extended cab superduty 4 wd with the 7.3. I also plow during the winter. Recently I've noticed wear on the inside of the left front tire. Brought it to a tire shop and had them check the front end and alignment. They told me that the specs were "within" tolerances" for my truck. I'm stumped as to why the abnormal wear if everything is supposedly good with the alignment.
View 5 Replies
I notice that my front passenger tire is getting some inner wear on it. The tire doesn't even have 5k on it. I know I should get an alignment that's a must but is there something that might be wrong with it anyways since its just the front passenger?? Balljoint, tierod end and etc?? I don't really have a local auto shop that I trust 100% so I don't want them to be like, there is 3 balljoints out and etc. I had the inner tierods (both) and a few balljoints fixed last year and then got an alignment done. Any tips??
View 4 Replies
Proud new owner of a 2001 Excursion with 7.3. The gentleman I bought the X from had four Michelin LTX M/S2's. 285/75/R16. Looks like they had plenty of tread left so I was happy, until I got home and noticed a large slice in the side wall of the right rear.( approx 2" long and 1/4"deep.). I will be towing a 8000 lb trailer with three kids. Went to big tire store and they replaced one tire. They said it would be fine with different depth. (Exact same tire). When I got home I looked at tread, has noticeable difference in depth. Looks like 3.5MM diff from what I measured. My question is this, will this be ok or will this possible damage the rear end having slightly diff overall size?
View 5 Replies
Have a 2005 Camry, had tire wear issues in front and strong bearing noise as well as cv issues. I've changed out the rotors, breaks, cvs' on both sides, had new bearings pressed, new struts and new tires, balance and alignment. All was well leaving the tire shop for about 10 miles. After that, the car began to pull to right and has a wobble at all speeds. Had car realigned again and balance checked, same result- alignment was out again. The one thing I haven't changed was the rack and pinion and the tie rods looked good. The rack and pinion passenger side boot is weeping and, this is the side the car keeps wanting to pull to.
View 3 Replies
I've been using the EV mode - the EV portion of the curve without pushing the EV button - to run around town and to maintain speed once I've accelerated to traffic speed. It really boosts the mpg numbers and I'm able to get 55-60mpg on my 47mi. Roundtrip mostly highway commutes (hills included). Without the running in EV it's probably 42-48mpg.
View 8 Replies
I replaced the front brake pads and rotors on a 99 Bonneville about a year ago. The outside pad on the passenger side has worn completely out and has ruined the rotor. The inside pad on the same side looks fresh. Everything on the driver's side looks good. What the heck happened? I am not an expert but I have replaced many of these GM brakes and have never seen this result.
View 11 Replies
I have a 1.5 year old Forester. I have rotated the tires twice now, and each time I notice some excessive tire noise after the rotation, for the next hundred miles or so. The tires look OK. Is this a sign that I need alignment? That is, the rotation is equalizing some uneven wear due to a misalignment?
View 19 Replies
My 18 inch Conti Contacts have approximately 20,000 miles on them. The tires are not wearing evenly and have excessive wear on the outside portion of the tires. The dealer says that they spoke with VW and VW says that it is "normal" for the tires to wear this way because of the "turning radius" of the vehicle. I smell BS. I don't know much about this subject but it would seem to me that the tires should wear somewhat evenly if the vehicle is balanced and aligned properly.
View 6 Replies
Ok haven't been on here in a LONG time. Sold my '12 and bought a DRW '14 F350 to tow our fifth wheel. Just got back from a 775 mile round trip pulling our fifth wheel. My dad noticed my passenger front tire was going bald on the outside. I said yeah it was pulling to the right and thought my tire was low but when I checked it was the right psi.
Turning to the left I was starting to get a grinding type noise. If I rolled my passenger window down you could here something just grinding away but when you straightened out nothing.
So I took it into the dealer and they tell me the outside tire wear is normal. I said it has 22,000 miles and the passenger tire will be bald on the outside in 4,000 more miles or less. Said they can't hear any noise, yet my wife can hear it, kids can hear it and people outside the truck can.
It's not normal for the passenger or drivers tire for that matter to go bald in less than 25,000 miles? Tires have always been kept to proper psi, I've towed only about 5,000 miles total with it. They are also taking the worthless rancho rebranded shocks off and going with bilstiens. I should have replaced them 10,000 miles ago. They are horrible shocks.
It really torques me that they have it for a week and can't find anything wrong. When turning to the left it's almost like bump steer in 4wd just not quite as bad but with also a grinding sound that you can hear inside the cab and can feel it in the floor board. Nothing evident but just looking under the truck.
View 14 Replies
I have a 06' Ranger 2WD with General Grabber tires that have about 30,000 miles on them and still show significant tread remaining.
Within the last 2 months, I have experienced excessive tire noise - like I am driving a Humvee or something. Also, when I turned right or left the tires would make even MORE noise - it seemed to be coming from the right front tire mostly. 2 weeks ago I had the tires rotated and the sound seems to have reduced while turning but I still have the howling Humvee noise while driving down the road. There is no vibration coming from the wheel, so I don't think it's a balancing issue. Could it be the bearings?
I also checked the PSI all around and one tire does have a slow leak but I try to keep to topped off.
View 1 Replies
I have had a Clicking noise on my 2000 x 4x4 since 6 months coming from the front right side tire noticeable over rough roads or over bumps and I went on a journey starting with ford dealer to almost all well recognized service centers and every body says your front suspension is ok and no one seems to know where it is coming from. I thought it was my hub bearing since it fails almost every year but when I was changing the bearing, I noticed a big Excessive play in axle.
See video : My AXLE Shaft - YouTube
Also I noticed oil mixed with grease the grease is prawny with a reddish sort of color or that is some thing else.
See photos ....
Any way after replacing the hub Bearing with a used one and butting every thing together I went on a test drive. Noticed that the vehicle drive line is not right the car seems to wonder and the noise still there so i didn't get far i came right back and park my x then a funny burned oil smell was present.
Is it some thing i did wrong or is it bad situation gone worst ?
Items Checked Or Replaced In The Last 4 Months ( trying to fix)
Tie Rods. Ok
ball joints. Ok
suspension front and rear. Ok
Front stabilizer bar. Ok
control arm bushings. Ok
stabilizer bar bushings Ok
steering linkage. Ok
brake pads. A new front set installed
Rotors . Both front changed with oem parts
body mounts + sub-frame mounts. Some replaced
shock absorbers . New 4 set installed
- Rear Monroe 911176 Reflex Light Truck Shock Absorber
- Front Monroe 911175 Reflex Light Truck Shock Absorber
tires. Replaced with a new set off four
Hub Bearing. Second hand (that's when I saw it)
Spare Parts waiting list (Ordered):-
O ring ord part # 4C3Z-1K106-AA
(knuckle seal) (F81Z-3254-CB).
and some other dust seals which i can't recall.
I am looking for how to fix axle play and get red of the noise. (this is a video from you tube for clearance)....
F250 wheel bearing, is this bad or not? - YouTube
View 8 Replies
I had 235/40/19 that came with my Passat, now I put on 245/40/19 I think i am rubbing on something inside by the suspension, how can I know for sure, would I need to lift the car?
View 24 Replies
I got in my car Toyota Avalon 97 and I heard a small pop like I ran over a pop can. Then as i began driving I hear a noise that sounds like it is coming from the wheels. It seem like ever time it make a full rotation I hear a flap. Almost like a flat tire.
View 6 Replies
My W8 has a noise problem that's getting worse. I've had the tires replaced and had the dealer look at it. My dealer thought the rear rims were bent, but the noise definitely comes from the front end - I'm pretty sure the passenger side. What this could be? I'm thinking bearings but when I jacked the car up there was no play in either front wheel. Had the tires rotated and the noise didn't move.
View 5 Replies
Feel there is excessive road noise on the highway? (not wind noise)
Seems as though it can be worse depending on the surface. Comparing the B7 to the wife's Q5 is painful. Heck, even my MKVI GTI was silent compared to this. What do you all is a good fix?
Tires? If so, what would be a good upgrade? The P Zero Neros on the GTI seemed pretty good. I'm new to car tires. Long time Jeeper. Dynamite under all carpet?
View 24 Replies
