Passat (B6) :: CEL Comes On / Codes P0441 And P0171
Jul 25, 2011
So one day when I was driving, the CEL comes on, and then I go to autozone to get my free diagnosis. I got codes: P0441 and P0171
My engine is running fine and everything else seems to be in order. However, I have to get a new canister purge valve and new oxygen sensors, in order to be in the clear.
For the Oxygen sensors, I have AN IDEA of where they're located; somewhere underneath the car, by the catalytic converter (the converter is in between the two connectors, apparently). I have yet to do this and would like some opinions on what to do for it.
For the Canister Purge Valve, I have no clue where to look. I pop open the hood and I notice a diagram with labels. Great, but there are just too many other pieces to look at...I do not know if it is visible as soon as I pop open the hood, or if I have to dig deeper, or even if I have to remove the fancy plastic thing that covers the engine.
View 12 Replies
Advertisement
I just bought a used Toyota Corolla 2002 CE with 120K miles two months ago. the car seemed fine and drives fine too. After a while I found out that the seller had removed the "check engine" light, so I read the error code by a instrument and I got these errors. 171,420,441. And I noticed that the engine burn a quarter oil every 200 miles on long drives!I checked the VSV valve and connected hoses but no problem there. Since the car has just 120K miles, I'm not sure that the piston rings are worn out! I'm wondering what could cause all of these errors?
View 19 Replies
Shop said o2 sensor and they just want to replace one. I can get universals for around 80 each, will they work if this is in fact the problem?
View 1 Replies
Check engine light is driving me crazy, comes and go depending on weather conditions.
When "ON" the code I get is P0441 and P0171. The engine hesitates for a second or two,then stabilizes.
View 6 Replies
Check engine light came on yesterday evening. Advance read the codes as P0100 and P0171. The guy said something that it may be related to the mass air flow sensor. The car seems to run fine.
View 2 Replies
2007 Passat 2.0T ... I just purchased this vehicle and after about two weeks of driving it has gone bananas. I found a ton of oil in the spark plug holes, and installed a new valve cover gasket...It no longer leaks. I am getting P0171, P0507 codes and multiple misfire codes from all cylinders...
View 6 Replies
Just bough a new (to me) Touareg yesterday...2008, 75k miles, good service history. Drove home from the dealer no problems. Driving that same night (last night) the CEL comes on. Ok, I've had VWs before, CELs don't really make me panic.
Get home and scan the car and it comes back with P0327 (knock sensor 1 circuit low) and P0441 (evaporative emissions system incorrect purge flow).
I have a feeling it's got less than premium gas in it....I'm gonna throw some octane booster in the remaining 1/2 tank and see what happens. Anything else I should do?
View 5 Replies
I recently picked up a 2001 Prius to learn more about it. I've been trying to resolve the following codes: p0440, p0441, p0446. I used a new OEM gas cap & did a smoke test and smoke is coming out of the perimeter of the filler mouth and what seems to be a plastic ring with slots around the mouth.
My question is this:
1. Is this normal?
2. Does this indicate that the filler neck is bad?
3. Does this indicate that the charcoal canister is bad?
4. A bad VSV by charcoal canister?
5. Is it something else?
View 7 Replies
Car - 2004 Accent auto.- 1.6l - 97K miles
After battling a few months to get my check engine light - fault code P0304 to go off I finally remedied the problem with 3 bottles/fill ups of STP Gas treatment. This was about 1500miles ago. I go to DMV Inspection station and sat for an hour then wait anther 20minutes for the test to end and was given the big fat rejection sticker, she failed because the check engine light came on with fault codes P0304 & P0441.
Now what the heck happened here? Just bad luck and coincidence or did their test set it off? Anyway the P0441 code is new and researched it is the Evaporative Emission Control System Purge Valve. Okay where is it, the HMA manual is not specific? In relation to the intake manifold where is it? Easy fix? And will this solve my P0304 code?
View 13 Replies
2003 Camry LE, 4 cyl, 165k miles – Got all of the above codes. Obviously checked gas cap and no issues there. Checked both VSV underhood and had clicking. Checked VSV at canister under vehicle and no clicking. Used a Dremel oscillating tool with flat metal blade to cut off rusted Philips head screw. Removed VSV and checked by jumpering to battery. No clicking, but did draw a tiny arc. That told me it was “trying” to actuate. Sprayed PB Blaster into hose fittings of VSV and mowed the lawn. Came back to VSV and it now actuated – but very slowly and delayed. Sprayed electrical contact cleaner in hose fittings with the VSV jumpered and open. Activated VSV several times and sprayed contact cleaner through the hose fittings several times – both directions. VSV began to active quickly. Put VSV back on vehicle. SES light went out by itself after it ran the EVAP test.
View 3 Replies
I've been having P0441 & P0455 codes showing up on my 2007 Corolla CE. My code reader tells me the areas that need checked. But, I can't find the vacuum switching valve on it so that I can check it for problems. Somebody said it's under the hood, but I can't seem to locate it.
Is is possible that it's mounted on the vapor canister (which I have located above the rear axle)?
View 9 Replies
Just tried to leave for work and my check engine light came on. Luckily I just got a scangauge and the error codes are P0441 and P0445. I checked online and for regular Prius is says it could be the fuel system, fuel cap, etc. I'm scared to drive it now and wonder if I should call Toyota Care to tow my car to service.
View 6 Replies
I have a 2000 Toyota Camry with 90,300 miles. Last week check engine light came on and mechanic said it was P0440 and charcoal canister needed replacement. Did the repairs and 20 miles and two days later CEL is on again. Take it back to mechanic and codes this time are P0441 and P0446. I'm told I need a new gas cap, so it's replaced with new one from dealer. 15 miles later, CEL comes back on and I return to mechanic. This time it's reading all three codes, but they can't find anything wrong. The only parts not replaced are the vacuum seal valves, which mechanic says test as good. They reset lights and 15 miles later, the check engine light is back on. My mechanic is baffled. What the problem could be or what they should check? Car drives fine, but light coming on is annoying.
View 16 Replies
Currently throwing both P0441 and P2096, just prior to this I was also throwing P0442.
Read around on web and decided the simplest thing it could be would be the fuel cap, may as well start there. Owners manual even recommends changing at 90k. Got a replacement from advanced (which is supposed to be built to OEM specs), re-set battery light stayed off, attempted to pass emissions but a few systems were "not ready". Was good for 80ish miles. Light came back on throwing P0441 and P2096. I re-tightened fuel cap and re-set battery, light went off.
Did some maintenance; spark plugs, air filter, oil/filter change and replaced the leaky oil pan. Keep putting on miles hoping to get to the recommended 200 mile mark before stopping by the emissions testing facility, 105 miles after re-set same codes came back. I'm almost positive I replaced a o2 sensor 2ish years ago for emissions. Also there is an obvious exhaust leak which could be a culprit. I seem to remember reading somewhere that a weak battery can cause problems with fuel pressure... not sure if it's true or not but for what it's worth I do know my battery is on it's last leg.
I'd like to avoid unnecessary fixes, it's only my winter car so as long as it's nothing major I'm not going to dump money in it. I'm going to take a guess and say the check engine light is coming on when these systems become ready. Plan is to try this re-set one more time hope for the best and if not replace exhaust or at least repair leak. Not sure on my next step for P0441 though. Vehicle is a 2004 Hyundai accent with 86k on it.
View 1 Replies
I have a 2002 Echo with 185K miles on it and i have a 2003 Echo with 101K miles on it, Both have P0446 P0440 P0441 codes coming up on them, the 2002 I replaced the gas cap, VSV valve and the rubber hoses from the throttlebody to the hard plastic line in the engine bay, and the 2003 I only replaced the rubber lines in the engine bay.
View 14 Replies
So the check engline light came on, and i hooked up a basic OBD II reader to the car. Out came codes P0171 and P0174 and it read "system too lean (bank 1)" and (bank 2) respectively. What does they mean?
View 4 Replies
I just did an oil change at my vocational school on my grandpas car, 2008 LE V6. On the way back it threw a CEL. Codes are listed in the title. Now googling those codes i found info on other car manufacturers i.e ford, dodge etc.. But i found nothing in regards to a gen 6 camry. It seems like this code has something to do with the engine running lean. Bank 1 and bank 2. What could cause these codes and what could be a possible remedy. P0174 and P0171 were both pending and setting a cel don't know if maybe they were pending before i did the oil change.
View 14 Replies
I have a 1996 ford taurus lx dohc v6 3.0.. I keep getting codes p0171 & p0174 System Too Lean (Bank 1 and bank 2. I check for air links and i did not find any..I never got that code tell i replace the MAF sensor..
View 7 Replies
Not real familiar with this code, given that my check engine light came on a couple weeks ago and they detected some errors and these codes appeared.
View 2 Replies
My 2002 Chevy Tracker recently has been running poorly after consuming a 1/4 tank of gas. The check engine light comes on the scan tool reports P0171 and P0174 bank 1 and 2 lean(it's a 2.5 liter V-6). If I remove and replace the gas cap it runs better but not perfect. Once I use another 1/4 tank the symptoms return. I have noticed the cap is hard to remove lately. This has been going on for two weeks It's been to 2 garages one of them told me my catalytic converters are plugged up and wanted 2500 to fix .
View 8 Replies
Ok, so this past week i towed my 72 f250 to IL from CA. 2100 Miles. 6100#s with the trailer. No problems at all. Got about 9 MPG too the whole way. Ok, so here is my problem now. As some of you may know, IL just got about a foot of snow. Its all slush at this point. I am living in the country right now so i drive thru alot of it. Ok, now you know the back story, today i drove the truck to my brothers house, put it in park and bam! check engine light came on. About a half hour later i drove it to AutoZone and had them check the codes. Here is what they pulled.
P0705
P0171
Need to know what to replace. I have to drive it back to CA in 4 days.
View 1 Replies
