Passat (B6) :: Bulb Failure Or Malfunction In Adaptive Front Lights System
Dec 17, 2007
So I'm driving home from work today, when I notice a new little light in the instrument cluster (looks like a little sun with a ! in the middle). So I dig out the manual and read..."Bulb failure or malfunction in the adaptive front lights system."
I drove up close to see which DRL light is not on...so....at 15k miles my right front head lamp was out. I called my local dealer...the bulb is covered and will be replaced at no charge (4 yrs/50k miles). They said I could stop by anytime and get it replaced. So, no problem there...
But....question: Why do VW bulbs blow so often?? My old '99 Golf and '01 GTI both blew no less than 5 head lamp bulbs starting at about 15k miles (same as my current Passat now). I see VW's all the time with one "eye" out - just an observation - why is this?
View 15 Replies
Advertisement
As in the title, mine went this weekend. Searching shows other VW models have had issues with wiring connectors leading to AFS failure. Is this still a problem for VW (many of the threads on Vortex about this go back 5 years or so), and specifically the Golf R?
View 16 Replies
I have been to the dealer 3 times so far because of something to do with the lighting system. The MFD says "AFS Inoperative" and the indicator light flashes for bulb failure or malfunction in the adaptive front lights system.
The dealer has replaced a bulb and power module thus far, but it hasn't fixed the malfunction. The indicator light and warning comes on 4 out of 5 times I drive the car and usually within the first few minutes of driving. It occurs with our without the lights on.
The lights do work at all times, but I don't think the adaptive steering/lighting is working when the error occurs.
View 6 Replies
Out of curiosity, why would to turn off the Adaptive Front-Lighting System (AFS)? There is an option on my panel menu to do so; I just can't think of a situation where I would want to. Why Lexus makes this option available, other than they can? Otherwise, it just takes up space in my scrolling menu; how 'bout they replace that with the outside temp displayed?
View 3 Replies
One morning I took the car out to the mall. Right away I had the ESP light on and stayed on the whole time. Tried turning it off with the ESP button to no avail. Got to the mall and let her sit for a few hours. Came back out and started the car and now two light are on. The ESP and Exhaust system malfunction. Found a thread that had the exact same problem as I did. He said the Mass airflow sensor must be bad. So the next morning I popped my hood to find out that a little mouse had made its nest in the engine and had bitten into the wiring harness that lead the the Mass airflow sensor.
I tore apart the tape and found that only the red wire had been chewed all the way through . I soldered the wire back together and re-wrapped the tape. Couldn't find any else around the whole car that was tampered with so I thought I was good to go. Started the car and both light are still on..Drove it around a couple more times to see if that would take them warning light off, and still no go. So I am guess this has to be removed by the dealer is the only way to go?
View 5 Replies
2004 f150 fx4 w/ 5.4 .I have a code that read " system adaptive fuel to lean bank 1 " and the same for bank two. So, I got on here and did some research. Cleaned the throttle body, maf sensor, air filter, looked for vacuum leaks, changed the fuel filter and it still is running very poor at idle and it seems to be getting progressively worse...
View 2 Replies
I just bought a 2013 Hyundai sonata (this is my first car) and I found a wired thing happening when I just turn on the car (without turning on the engine) that Malfunction indicator light, Changing System warning system warning light, EPS and Check Engine Light are ALL on but after I start the engine, these lights will be off. Is this normal or there is something wrong with it?
View 2 Replies
I will be picking up my new 06' V10 in a few days ...after searching desperately for an 07' in the colors I wanted it was a no-go. Anyway, one of the features I wanted in the 07' was the adaptive (turning) bi-xenon headlamps. Is it possible to upgrade to them?
View 5 Replies
I start car today morning and I got message at display: STOP CAR BRAKE SYSTEM FAILURE MANUAL. Message was gone after 3 seconds. Happened 3 times and I don`t see it again. I was still driving. Nothing is wrong. Brakes are working. What is it?
View 4 Replies
My MIL came on the other night so I brought it to the dealer today for diagnosis.
Per tech, "Found 1 DTC P2181 for cooling system malfunction, checked measuring values, found thermostat sticking open.
Recommendation is to replace thermostat with housing." I have 95K miles on the car, original owner...first time in a long time to have an issue.
The SA indicated the thermostat replacement. The tech indicated the thermostat is in the front of the engine which is hard to access.
View 4 Replies
2004 prius. I change the brakes on various cars all the time, and never had this problem. After I changed both sides, I started the car, and saw 4 lights:
- Red brake light
- The yellow exclamation light
- ABS light
- VSC light
The car now stops funny, and reading the service manual, it says that if there's a failure detected, that it will revert back to very basic braking (no abs, only fronts, etc..)... As I was exiting off the fwy, I realized this when one of my front wheels locked up, even and I was not stopping very well. Scared the crap out of me.
In any case, I can't see what I may have done which would cause a failure. The only thing I could think of is to bleed the brakes again, but I did this and think it's ok. Is there anything else I can check or is this something I have to get serviced? I saw another thread where they suspected the actuator, but it is somewhat a coincidence that it would go bad after I replace the pads? I'm not sure how the regenerative brakes works on a prius, and whether there's anything I could visually inspect to see if I bumped something???
View 19 Replies
I have a 2006 prius I got used and in good condition about 3-4 years ago. I never had any problems until a cop pulled me over and it turned out my parents had decided not to notify me they hadn't renewed my registration and my insurance they've been paying had ran out. I've since learned my lesson on keeping up with the dates.
I "luckily" got to go home with just some tickets. It sat about 2-3 months until I could get the money to line everything out. I ran it at least once a week but apparently that wasn't enough? Now that everything's up to date I started driving it and the yellow circle with the (!) in it is on. The Master system light, the check malfunction light, and the hybrid system light is on.
It seems like it applies the brake when I'm driving constantly now. It stalls when I first try to speed up. And the fan? on the passenger side of the back seat is always running for some reason. I tested my battery volt and it's at 9.2.
I took it to an auto shop today in town. I live in WV in the backwoods. And they wouldn't hook it up to check for codes and referred me to a dealer about 30 min. away... I've never had any problems with this car before.
View 19 Replies
I've recently started popping up a random P2181 performance malfunction in cooling system.
It's so random and shows no signs of any other problems that I'm confused. Temp gets hot, stays exactly where it should be, 200. Never gets a tick hotter, or even close to above 200. Air works, heat works fine. No loss of power. It only seems to come on when I really put my foot down.
View 5 Replies
The MIL came on and I scanned for codes. First was P0118, Engine Coolant Temp Circuit High Input. Reset it and then received P1296 -Cooling System Malfunction. Temp gauge needle is positioned where it always is.
View 15 Replies
Replacing the daytime running lights on 2005 passat. Can I purchase the bulb from an Autozone or the like.
View 3 Replies
This code came up on my car, what it means or what part needs to be replaced.
008577 - Performance Malfunction in Cooling System
P2181 - 008 - Implausible Signal - MIL ON
Freeze Frame:
Fault Status: 11101000
Fault Priority: 0
Fault Frequency: 2
Mileage: 84971 km
[Code] .....
View 2 Replies
One of my interior bulbs had blown and all of the others was still working ! I replacement the blown bulb and now none of the work!!
I've had a look thought the manual and cannot find a fuse for this, how to sort this.
View 1 Replies
I installed some aftermarket HID lights in my 08 passat. I took it to a local shop to have the drls turned off and the bi xenon turned on. All the warnings and bulb out lights went off, the lights fire up perfect. but for some reason now the lights (all of them, rear, dash, parking all come on with the ignition whether or not the lights are switched on or off.
I am sure a code got changed that causes that, but which code would activate all lights all the time? It's not DRls it all lights are on just like you turned the lights on manually.
View 2 Replies
How to replace a front parking light bulb?
View 2 Replies
Been about 3 months now trying to figure out my issue in my 2006 passat 2.0t the front passenger low beam bulb keeps going out no matter what kind of bulb I use. They last for a week or two then burn out .When the do burn out they actually blow into pieces the only thing left are the wires in the bulb checked into everything I could think of looked at the plug of where the bulb plugs in checked the wires that connect to it ran as far as I could follow in the engine compartment all the wires seemed fine. And there's no moisture getting into the headlamp assembly.
View 9 Replies
I have a 2003 W8 wagon and my front turn signal bulb went out. I need to replace it, but am having some problems. I removed the high beam cover to get to the turn signal socket, but I am having problem removing the socket. I was able to turn the socket slightly and was hoping I could just pull it back, unfortunately it doesn't seem to want to move. Is there a trick to remove the turn signal socket so I can remove the bulb? I don't want to force anything in fear of breaking something. there has to be a way.
View 1 Replies
