Passat (B6) :: After Fill Up Car Would Crank But Will Not Start
Nov 19, 2006
Well, this is the second time this has happened. After filling up the car I went to start her and she would crank, but wouldn't start. I waited about 30 second tried again and gave it some gas and it cranked for about 3 or 4 seconds after giving it the gas and it finally started. I've only filled up twice now and this is the second time it has happened. Took the car into the dealership for a check engine light last week and it said there was a large leak. They believe it was the gas cap (because I also had the gas cap light come on).
View 8 Replies
Advertisement
As I said before I thought my emissions valve was bad because the car wouldn't start after a fill up but the coils were bad too so I took them in to be replaced first since I didn't have a CEL for the valve. The CEL went away till today and when I pulled them I got these 3
P 0441 EVAP emission purge flow fault (why it wouldnt start after a fillup)
P 0171 System Too Lean (Bank 1) (probably from when it started like crap)
P 0299 Turbo underboost
The third one is the one that's getting me. Ive had the evap core go bad in nearly all of my VW's so im familiar with the codes that go along with it, is the 0299 a part of it as well?
View 2 Replies
2000 B5 Variant V6 4motion / tip .. Randomly experiencing " no crank " when trying to start , sometimes after a few re-tries the dash icons re-appear and motor cranks & fires up. At other times no joy , leave it for 1 or 3 hrs. , re-starts normally . Also tried starting in "N" instead of "P" , and have cleaned battery terminals and load tested the battery ( all good )..
View 1 Replies
My 03' Passat 1.8 won't start. It turns over and cranks. When I'm doing that, all the lights on the dash flash off and on (including hazards), the overhead light flashes and I can hear a click, click in the same time as the flashing. Seems like it must be some sort of electrical problem. Maybe a bad relay or fuse.
View 1 Replies
well for a few days the car woudln't start every 10 times or so , i'd turn it back and forth a few times and it would kick over , then tonight wife took it and it just wouldn't start so i went and picked her up and tried it about a 100 times and called a tow truck
so what does everyone think it is, everything else is normal but the no crank. ignition switch maybe? I'm going to try and pop the clutch after it gets here, i didn't have the room or distance to try it where it was
View 7 Replies
I have a 1999 4DR V6 Passat and today was not my day. I got to work around 8am this morning, and parked. Forgot my window was down, so I turned the ignition on to roll up the driver's side window like normal, and the window does not go up. In fact, no window will go up or down. I have full power, from what I can tell. All lights work, radio works, AC works, etc... Door locks and my alarm doesn't work either.
This also boggled my mind; the car wont start?!? The car won't even crank. It doesn't even want to try to start. This all happened at the same time. What could have happened? The battery has 12.8 volts and the car drove fine on the 1 hour commute. I disconnected the battery and reconnected hoping to reset anything that may have happened. But that didn't work.
View 8 Replies
As description says no start and crank . when tested battery is good . automatic trans push button starter??
View 2 Replies
My problem is on my gf's 99 Passat. Its the 1.8t and runs and drives fine. The abs/brake light is blinking which from reading seems common and I have to send that module out to be rebuilt. The issue I am having right now is every once and a while it wont start. It will crank and crank and finally start like a minute later. She's convinced pumping the gas pedal works but I don't think its fuel related at all as it smells flooded when it finally starts. Ive replaced the plugs, air filter and still does same thing.
View 4 Replies
I have a 2007 Passat 2.0t Sedan. My wife broke the front engine mount this morning and now it will crank, but will not start. Put my code reader on it and it is throwing camshaft position sensor, misfire cyl. 4, fuel rail pressure low, and Mass Air Flow sensor codes. It looks like the insert of the mount is wedged against the belt. Would the engine mount being broken cause any of these codes for some reason? and would the mount against the belt cause it to not start?
View 6 Replies
I have a 2008 Volkswagen Jetta, which usually runs well. About a month ago the check engine light came on. I didn't notice any other problems until I went to fill up the car with gas and tried to start the car afterward and it took multiple tries to get the car started. I took it into the garage and they did a diagnostic, and said the leak detection pump needed to be replaced. So they replaced that, and the check engine light went away and I thought all was well. However, I took it to the gas station yesterday and had the same problem trying to start the car after filling up. What could this be? The leak detection pump ran me $500 so I hope I didn't have it replaced for no good reason!
View 4 Replies
Having problems with the fuel indicator not reading full after a fill up. I have slowly filled my 2012 Passat TDI SEL till I can see diesel in the filler neck and the gauge still only shows 7/8 full?
View 9 Replies
When filling the gas tank, the pump shuts-off (as it should) unless the tank filled very-very slowly. It has overflowed/spilled before the pump even shut-off in some cases.
CEL is not on. DTC 16826 stored: "EVAP Emission Contrl.Sys (small leak) Leak Detected". I just got a VAG-COM cable but haven't got the software going
yet.
Bentley has some diagrams for the fuel vapor recovery system but that's about it. Seems like there's something with the fuel vapor recovery / venting system going on. How to further diagnose?
'01 Passat 1.8T ....
View 3 Replies
Background: My 02 camry (155k) ran great but I noticed grease/oil on the front of the engine so I had a local mechanic take a look. He replaced the front valve cover gasket, timing belt, and while he was in there, the water pump. He made me take it to the dealer to reset/recalibrate the stability control sensor because after disconnecting the battery to perform the work my "VSC", "trac off" and check engine lights were on. I got it back along with a list of work they thought I needed (replace the rear valve cover gasket, dog bone engine mount, and a bunch of bs I don't need).
Problem: Quickly my check engine light is back on. I fill up gas and I can't get it to turn over. The owner of the shop gets it to turn over by gassing it a bunch while turning the key. My mechanic later tells me the check engine light is due to a bum gas cap. He replaces that and the dog bone mount. Next day check engine is back on AND the next time I get gas the same thing happens - it won't turn over until I gas it, then it turns over and stalls a few times until I really gas it and it turns over and takes. Every other time I try to start the car it turns over first try. Both times I filled up I wasn't close to running out of gas or anything. I don't think the gas cap or the fuel injectors went bad coincidentally the same day the dude had his hands in the engine.
View 8 Replies
At many, but not all, gas stations, as I try to fill up the gass flow cuts off very shortly after I start. No matter how I position the nozzle it cuts off. if I squeeze the trigger just barely so the gas flows slowly, then it will remain on, but takes forever to fill up.
Again, doesn't happen at every gas station, but a lot. Based on that, I'd assume it's not a malfunction in a valve, filler neck, evap canister, etc.
View 10 Replies
Ok, 04 Passat, 1.8T AWM
CEL is on for po456 (very small evap leak) and every time I fill up on fuel, I can smell a STRONG fuel odor, from near the fuel neck, and inside the car. Stops after it hits around 3/4 area. No leaks, and the car runs fine. Gas cap, and N80 valve were just replaced, both parts are from the dealer. I'm going to bring it in for a smoke test soon. All recall notices have been done too, I just did the timing belt.
View 1 Replies
My 07 has difficulty starting, only after adding fuel, or a fill up. I thought at first it was due to over filling, but it occurs after adding any amount of fuel. If I leave the car running while attempting to fill up, it sputters and dies. I have to press the gas pedal to the floor to start it, and it sputters for a few minutes, then runs fine, and starts fine until fuel is added once again. I searched and found where the General mentions a Vapor hose, but could not find more.
View 2 Replies
I have a 2005. 2.7L 168,000 miles ... Twice in a row, right after putting gas in the truck. It had trouble starting. It took about 3 to 4 cranks to get it started. Runs and starts fine after that. It's only when trying to start after a fill up. o2 sensor?
View 4 Replies
This is for my previous car that I used to own in 2005. It was a 1992 Honda Accord and the issue it had was anytime I went to the gas station to fill up the gas, the car refused to start and I would need to jump start the vehicle every time. I used to take the DC metro to work everyday, so I did not have to use the car as much, but it was a hassle. This happened all through the year and I was just used to carrying a Jump Starter Box with me in the car. There were no other issues with the car. I do not recall needing a jump start any other time. This one time, I forgot to keep my car in the garage and it was out in the snow all weekend. Come Monday morning, I started the car without any issues. I went to a friends place about 10 miles away and then tried to fill gas at a gas station near his place and it died at the gas station. I do not have the car with me now, having totaled it in an accident couple of years ago. But I was always amazed at this and would like to know what would cause something like this.
View 1 Replies
I am trying to fix the pesky hard start that I have. My car doesn't start right up anymore unless it is frozen cold. Other than that it takes 2-3 cranks sometimes 4 to turn over. That's annoying and embarrassing and I am trying to remedy it ASAP.
I have a check valve and Purge valve on hand right now. In my research it seems this is where I need to focus. I do have an engine code it was P0456 this time. I also have a gas cap.
I have a check valve because of the all too familiar cutting off early at fuel pump problem. I wanted to start there first since I am sure something needs repairing down by the fuel tank and since the problem is common. And hopefully the valve will work with the fill up and MAYBE with the start, if not that is where the purge valve comes in.
I got as far as get the 2 12mm bolts off and then couldn't make it any further.
View 2 Replies
Every time i stop for gas..my 01 santa fe is hard to start..it would take 4 to 5 start before she goes, then i have to keep the rpm up, bring her to idle..after that shes ok, till the next fill up.. the only way around this is to keep her running while gassing up..while filling up she run rough idle, some time engine shuts off..then its hard to start..
View 5 Replies
It is on random times that after I fill up at a gas station, my truck decides it does not want to start. In fact 99% of the failure to start issues only happen after a fill-up. I am typing this now on just such a non-starter issue. Waiting 20 min and it fires right up. During regular driving, runs like a champ, great power good milage (for a 7.3) ...
I have tried random "tests" such as driving to the store, waiting for the duration of time it would take to full up my tank and it starts no problem. Anytime I try to make it happen I cant. The fuel filter is clean, CPS is new, the fuel pump is working. Don't know if it is a temp sensor thing sending wrong info glow plug issue, or? Ghost in the machine?
its 2002 7.3 with 125000 miles. I have had the truck for four years and this issue just started last fall (oct 2016). It happens infrequentaly enough to forget about it until it happens again.
View 6 Replies
