Passat (B6) :: 2008 - Installing HID Kit
Feb 21, 2010
Okay, this is my problem. I bought a HID kit for my 08 Passat and did a little searching and found that I need to get into the computer and change the settings to where it thinks I have the Xenon lights already. If I didn't do it, that it would burn my ballast So I spoke to someone who knows about Vw's. Was told to download the software from Ross-tech and instead of paying the $300 for the VAG-COM, that I could get one off Ebay and I would be good to go. But to my surprise, I downloaded everything, got my OBD-II wire but I keep on getting error codes and cant get into the computer to change anything. I have installed and deleted the program, spent hours trying to fix.
View 5 Replies
Can I put 20" staggered wheels on my 08 r32?
View 24 Replies
I'm looking to install a back up camera. When hooking up my boat trailer or backing into a space in a parking lot. Would a factory piece be available? (rearview mirror)....
View 1 Replies
Need to know if this is a bolt on affair or what possible fabrication may be needed?
View 3 Replies
I have an 08 RX350 with navigation and premium sound. I bought a Kenwood DDX8901HD radio along with the TYTO-01 interface and the ASWC-1 to try and keep my steering wheel controls. I removed my old radio easy enough. Installed the TYTO-01 made all the connections and now I have NO NAVIGATION ANYMORE NOR DO I HAVE AC. It says check AC connection.
View 12 Replies
Putting factory bi xenon lights in new 2.0? Is it something that can be done?
View 11 Replies
I just bought this grill [URL].... and it fits great. However, the grill does not come with a emblem so I was just going to put mine from my 06 Passat on but it is a lot smaller than the opening on the new one. Am I just missing something here, or are there different size grill emblems on some cars? Or is my new grill just messed up?
View 3 Replies
I know how to install everything and which pins to connect and all that, but do I really need to use VAGCOM to let my car know it now has foglights?? Can I just use a relay light I did on my 03 Jetta??
View 5 Replies
Seems too coincidental to be unrelated. I installed a new K&N filter into my '04 GLX Wagon and 2 days later my MIL light came on. No blinking just always on. Is there a connection between the two? If I swap out the filters will the light go out on it's own or does it need to be reset? If it's not the filter what's the most common cause of the light coming on? Assuming is doesn't start blinking I have read it's OK to drive until fixed.
View 2 Replies
I've replaced all 8 of my truck's injectors in the hope of curing a rough idle and high long term fuel trims. How long should it take for the ECU to adjust all the fuel trims to account for the new injectors? Or is it best to disconnect the battery for 30min or so in order to reset the ECU and allow it to learn trims from scratch?
View 1 Replies
What were the stock radio options for the Passat?
My 98 came with a JVC aftermarket; don't like the look. I consider putting a stock radio back in.
View 1 Replies
I picked up some Megan coil overs with plans to install them today, but can't figure out where one part goes. It looks like a spring spacer. The instructions are terrible and make no mention of what it is. My guess is it goes with the rear springs but...? [URL]....
View 24 Replies
I'm trying to install my leds on the dome lights. The back one was quick and everything but the front dome light cover doesn't want to come off. Only the passenger side one wants to pop out. While the driver side of the dome doesnt wanna budge. It seems like ts actually stuck to the inside of the compartment. It just doesn't wanna pop off all that i getting is scratches.
View 5 Replies
Installed the factory antenna on a car without one from the factory?Is the wire already in place?
View 8 Replies
I'm looking to install an auxiliary port into my 2006 Passat 3.6L 4motion and I was wondering what plug in converter would be best to get, what other cables I would need, and where I can buy a flush 3.5mm aux cord for installing in a blank plastic piece next to the gear lever. I'm not looking to buy a converter that charges an iPod.
View 3 Replies
After installing my Rosen system hours later my battery was completely dead. Nothing unusual about the install. Used factory harness with rosen harness.
View 19 Replies
So I'm about to install an RNS-510 and I can't figure out where the Sirius module location is so I can install the extension that you need.
It's 2007 with 6 discs in dash changer with Sirius.
View 4 Replies
My DDM HIDs came in the mail today and fellow vortexer D.Passat00 was kind enough to meet up with me and do the needed vag-com adjustments. So firstly a shout out to him, he's a solid dude and really nice
Now: Is there a DIY for headlight removal? I can't seem to find one, and without removing the headlights I'm afraid there just isn't enough room to install the new HID bulbs without dinging/touching them.
I have a 2010 2.0t Passat and I got the 35w 6000k DDM HID kit
View 6 Replies
well installed my new in dash dvd player...everything went smooth...turned the car on....AIRBAG LIGHT IS ON...WHAT DID I DO?!?!?!? WHAT DO I DO?!?!?!?
View 21 Replies
A friend of mine is giving away its head unit (it has video) from a toyota tundra 2008, can it be installed without too much trouble on my corolla 2013 L?
View 1 Replies
I just purchased a donor wheel from ebay... it was the right price, and I'll turn around and sell the shell and the switches when I pull the wires out.
I'm looking forward to the wheel getting here. I expect to be able to swap the wiring harness inside the wheel and then be able to add the redundant audio control switches. This should leave me with the impossible setup of having a black vinyl wheel with cruise and audio controls.
View 14 Replies
