Passat (B6) :: 2008 2.0t - Stutter / Check Engine Light Flashed Probably 4 Or 5 Times Then Went Off
Apr 7, 2013
I had the transmission filter and fluid changed at the local VW dealership had some issues with that but they straightened that out and its been fine for a while well then about 2 or 3 weeks ago i was trying to mess with an audi and hit the gas (has the 6 speed auto tranny) and the car kinda stuttered and the check engine light flashed probably 4 or 5 times then went off, it did that a few times after that then my wife was driving it and it did that stutter again and the light stayed on, the code said misfire on cylinder 2..
So I replaced the plugs today and it did fine at first but when i got to about 55-60 and went to speed up and it started to miss pretty bad then steadied out and sped up. no check engine light or anything but it was missing.
View 1 Replies
Advertisement
Code 0341 (cam sensor?)On my way home epc light flashed about 5-7 times and message saying service engine. 111,000 miles and just had intake manifold replaced and plugs and coils not to long ago. I have been feeling a slight hiccup at cruising speed and twice my gti has just shut off while driving. New fuel filter as well. I searched the forum and didn't come up with anything specific. Can I just replace the cam sensor or is there more to it than that.
View 1 Replies
My question: was there some some OBD code or light I should have expected (that didn't show)? What did the flashing Check Engine Light mean?
At 10:30pm last night, I picked my wife and bro-in-law up from the Logan airport, and on the way to drop BIL at his house, I saw a brief whisp of steam/smoke rise from the passenger side hood/wheel-well when idling at a top-light. I exclaimed that the car was smoking, but BOTH my wife and BIL insisted that we had been stopped over a steam grate. (In 70 degree weather? I puzzled, but since BOTH said that had been the case...).
A few minutes later, the check-engine light flashed (three times, I think) and then went off. I drive with an OBD ScanTool attached on the dash, so I immediately switched it to scan the codes, but it reported "clear" / no codes! Either immediately before or immediately after, the car lost accelerating power for 1 or 2 seconds (at most), but then resumed normal driving. No other dash lights were on, though I did not look at the temp gauge.
I am a former chef and professional cook, and have a VERY sensitive sense of smell-- there was NONE; I watched attentively, and the absence of further smoke/steam seemed to support the unseasonal steam-grate hypothesis. I had also picked up the car within the last 24 hours from THE HONDA DEALERSHIP, who I had asked to look everything over to ensure another 6 months of problem-free driving. (I rejected their offer of a $249.00 "triple flush" of transmission, brakes, and pwr steering.) We have otherwise had zero problems with the transmission or cooling-- the car is old, but maintained reasonably well and driven less that 5000 mi / year. Boston driving, but not aggressive or 19 years old!
No further thought, as all seemed okay except for the brief "blip", and pregnant wife, brother-in-law, two dogs, and I all wanted to get home.Drove the 2ish miles to our apartment, with no further blips. At a stoplight about 3 blocks from home, a LOT of smoke/steam started coming out from the hood. Still no lights or OBD codes! At that point, I pulled over within 5 seconds, and noticed that the temp was pinned or nearly so (If there is supposed to be a light on the gauges, I had it all the way dimmed). Looking under the hood, the spray pattern on the hood insulator made it easy to find the split in one of the hoses connected just under the distributor (about 1.25in OD; I'm guessing coolant or transmission, based on the symptoms??).
While waiting for a tow-truck (since I wasn't even sure if it would do any damage to drive the remaining blocks to my driveway), and after things had a chance to cool a bit, my wife restarted the engine for a second so I could check if any additional fluid came out of that split, but none did. Once the temp was back down towards the low end in 20ish minutes, I drove the car about one block so I could stop blocking traffic-- it drove fine, and the temp didn't visibly rise in that 200 yards. Still, the CEL was not on (or flashing) during startup or while running, and there were NO OBD CODES.
View 4 Replies
Check engine light flashed for a very brief period, car ran very rough, and then check engine light (exhaust system malfunction) stayed lit. Took to dealer this AM and service advisor asked that I bring it back on Monday morning (loaner promised) but in the meantime, I could continue driving it unless the engine light started flashing. Car is now running okay, but last night it seemed to be running on only 6 or 7 cylinders. Only 93 or 94 octane gas is used and I've owned enough German cars to know how the gas cap should be tightened. Seemed like an oxygen sensor malfunction last night but now I'm not certain.
View 15 Replies
I got a 2013 Turbo. This morning I gave it 90% throttle and I got shaking, check Engine light flashed on and stayed on until I layed off the gas. It drives fine under regular throttle, but for ie. Passing someone on the highway.. Yeah ain't happening, idk if it just won't downshift, or the turbo is acting up.
I have an Injen intake and Had it installed since day one or two of ownership. Bought the car brand new, it has 43k miles, and I usually give it WOT a few times a day ()
But it's weird how all of a sudden it's doing this, I tried restarting the car, leaving it to rest for a while and same result. I personally think it's the tranny not being able to downshift, even holding a gear at high RPM, it shakes. Turbo sounds like it's working fine but who knows what's going on under the hood.
View 4 Replies
So, I got in my car this morning, it started fine, no CEL, pulled out onto the main road and while while accelerating, it started to sputter and the CEL flashed several times. I turned back into my neighborhood, expecting it to stall, but it didn't. I sat there for a second, it was running fine, but I felt a few slight rumbles while idling, enough to make me nervous, but not enough to prevent me from continuing to work (I'm out of PTO).
So, I continued on, no CEL, accelerated and the sputtering happened again, slowed down, lightly pressed the gas pedal and it was fine. I made it to work. I just got the APR programming on Monday. I ordered the TT225 diverter valve.
View 3 Replies
I have a 2001 jetta 2.0 engine with only 130k on it. Yesterday I replaced the battery and everything was fine but then today as I started it up to go to work I started moving and the check engine light was flashing for catalyst damage. I heard that sometimes coil packs will pop if you change the battery.
View 1 Replies
2011 eb just turned 36k. Today on breezeway it shuddered like it swallowed a bird, and check engine light flashed on. Went to see customer left and light was off. Back on breezeway and shuddered on entrance ramp so this time I stayed into it so either there's a light that will stay on or just launch it and this time the dealer will have something to fix that they can diagnose. Check engine light is on its fine as long as I stay out of the pedal. Still have 8 months left on power train warranty but what am I looking at for a diagnose, there is definitely a problem now. What the dealership should see?
View 7 Replies
While driving tonight I was making a right turn and I heard two short beeps and my interior light flashed on and off two times. This happened three more times after stopping and when I put my foot on the gas again the interior light came on and then off again, no flashing or no beeps.
I just hit my 16,000 mile mark on my 2014 Prius C two.
View 9 Replies
I was driving my car when suddenly I felt a huge shudder and my engine light flashed on. I turned a corner to head into a parking lot and as I accelerated my car seemed to be jerking like it was cutting out. I parked and tried revving it and it sounds all deep and gurgly not smooth. What could be wrong and is it safe to drive the 5 miles back to my house.
View 4 Replies
I most recently drove my 2006 Prius around on Saturday Feb. 1, with no problems at all. I went out of town for a couple of days, and returned this afternoon to a car that will not start. I stepped on the brake, pushed Power, and things lit up, the "Ready" light flashed a few times but then went off. Power button light stayed orange.
Several warning lights on dash stayed on (!)/ABS/VSC/traction control, and a message came on the screen saying something about a problem with "P" parking, and that it should be parked level and the parking brake applied. It is sitting level with the parking brake applied already. Also, the door ajar warning light and beep start as soon as you open the car door to get in.
I'm thinking from what I've read that my 12v battery has died/is dying. I'm the original owner, bought car in March 2006, and it has just under 61,000 miles on it.
View 19 Replies
I have a 2011 I4 camry. I recently ran out of gas and decided to keep trying to see maybe if the car would turn on. After all that i gave up cranking the car on and decided to push to a gas station. After putting in gas (93 octane) I realized i have my check engine light on and another light which depicts a car with 2 swiggly lines.What that light means but its to the right of of lcd display which shows your mileage. I am taking the car tomorrow to the dealership but I was wondering is there any way i can check the codes without an obd scanner (the thing that checks for codes). Do you think I ruined my engine after trying to start the car multiple times without gas?
View 5 Replies
I own a 2012 Toyota Corolla S w/ 8700 miles on it I am the first owner. Check engine light blinks on and off 8 times. I cleaned the gas cap threads and neck, then I reset the computer by removing the positive terminal for 1 minute. I also checked the oil it's fine. Light still blinks? I have many years of mechanical back ground, without running codes I don't know this one
View 4 Replies
2002 Camry 4 cylinder. I've replace the o2 sensor the one in "Bank 1". I've cleared the check engine light three times now and it still comes on about 30 plus miles. Do I need to reset the ECU? Or replace the catalytic converter?
View 11 Replies
I just bought a 2004 Kia sedona ex, it was running great when I got it, and it has 81000 miles. On the way home it kind of sputtered a couple of times, then the engine light came on. I took it to autozone and they said 2, 4, and 6 was misfiring. I called the dealer and they said that it was probably because I didn't click the gas cap three times. Could that be the cause or do I need to change the spark plugs or coil or something??
View 6 Replies
Today I got the engine light blink a couple of times and then steady on. Parked the car, waited a few minutes, start again just the engine light on (not blinking anymore).
I scanned the car and got this
VCDS-Lite Version: Release 1.2
Tuesday, 06 August 2013, 13:48:09:11637
Chassis Type: 3D - B5 VW Phaeton
Scan: 01,02,03,05,06,07,08,09,11,15,16,17,18,19,23,27,34 ,35,36,37,38,42,46,48,49,52,55,56,57,61,62,65,68,6 9,72,76,77
-------------------------------------------------------------------------------
Address 01: Engine Labels: None
Controller: 07C 906 018 C
[Code] .....
I have a hard time believing that all coil packs went bad. My wife told me that when she was driving the car she could hear a clicking noise coming from the trunk so I think this could the fuel pump not giving enough fuel but I was hoping to get an error for it.
View 11 Replies
I have a o3 sc430 that's driving me crazy I have replaced the 02 sensor on my car three times and the cars vsc and check engine light comes back on after driving less then a mile. If I really step on the gas it'll come on faster. Where should I look for a vacuum leak? The mechanic says it could be electrical problems too...
View 14 Replies
Started having problems with my Chevy Malibu (1999, with 95,000 miles on it) while driving two times this week. Both times an alert warning flashed on my dashboard. The first time, flashed the brake check and ABS warning on the left side of the dashboard, and the second time the check oil and check battery warning on the right side. In both cases, after the warnings flashed, the car was still running, but stepping on the gas pedal resulted in no acceleration, but brakes still worked. The steering wheel also locks-up to the point where I can't turn any more. Both times, I stopped and shut off the engine, waited about 30 seconds and restarted, after which everything is fine and normal. The brake pads were changed recently, but not the rotors which may not be in very good shape.
View 14 Replies
I have a 2000 Toyota Sienna that has had a check engine light for a while. The light would come at times, and go away at others, with prolonged intervals (days, weeks, months) with or without the light.
Suddenly it started losing power, especially on hills (even a small hill). The codes I read are (I include code interpretations from internet search):
P0300: Random or multiple misfire.
P0301: Cylinder 1 misfire.
P0304: Cylinder 4 misfire.
P1130: Air fuel sensor
P1150: I have not found a problem definition for this code.
Might these codes be indicative of a particular problem, or is each problem more likely a problem with its own cause?
View 19 Replies
I have a 2002 VW Golf, with 203,000 miles on it. The check engine light is already on because the cat has worn out. I'm saving to buy a new one. However this morning about 5 minutes into my trip to work my check engine light flashed a few times. After pulling over and turning around to go back home the flashing stopped and the check engine light went back to be solid. Could the worn out cat have caused that? The car seems to run like normal. I did feel a little something when the light started blinking, but then it went away. The dealership and my regular VW mechanic have both said that the car is safe to drive regarding the catalytic converter until this winter when I get my tax return back. I have very little money right now for a repair. I should have more in a couple of months. The only thing that has caused the check engine light to blink in the past was the ignition coil pack. The car is on its third one and I know that feeling, this wasn't it. Plus I just got a new coil pack in June 2014.
View 16 Replies
I've got a '96 Sierra manual transmission with 215K that's been running fine. I just ran it 400 miles without a problem. Recently I downshifted into fourth to go up a hill and I had a sudden loss of power and a rough ride like I had a flat tire. The harder I press the gas the rougher the ride and it idles almost normally. The check engine light came on and blinks 12 times.
View 1 Replies
