Passat (B6) :: 2007 - Crunching / Rattle Sound From Front Right End?
Dec 8, 2009
I'm hearing a crunching/rattle sound from the front right end of my 2007 B6 Wagon, 3.6L, Auto, Sport Pkg, FWD w/ 45k miles. I'll try to characterize what I'm hearing and when I hear it...
In the morning, when I've driven less than 2-3 miles and I go over a speed bump (i creep over the bumps) I hear what sounds to be like an un-oiled/worn out spring like sound coming from the front right side of the car. I don't think I hear any other sort of noise at all while driving (or if I do, it's very faint and barely noticeable).
After I've driven 25 miles or so at highway speeds (at the end of my daily commute), when I'm around 25 mph (independent of accelerating / decelerating / applying brakes) I hear what sounds to be a metal on plastic-like loose wobbling rattle (great description, right??) coming from the front right end. It gets pretty loud. However, if I go over a speed bump after having driven a good distance...guess what...no "worn out spring sound", just the rattle @ 25mph.
The rattle sound definitely 'peaks' in loudness at 25mph. If I listen carefully, I can hear it at other speeds, but it is less noticeable. I don't feel like I hear it at all at 40+ mph. I'm pretty sure the rattle is rotationally dependent (e.g. the faster wheel turn, the higher frequency of the rattle).
My tires are worn pretty unevenly, so there is a very annoying wobble/hum at all speeds, but I don't think it has to do with the tires. So to recap, it sounds like a rusty spring when going over a speed bump when the car is 'cold'. After driving a long time, no rusty-spring sound going over speed bumps, but I hear a pretty significant rattle around 25mph.
View 9 Replies
Advertisement
I have started to notice a crunching sound seams to be coming up thru the front wheels only when turning tight corners this seams to be related to outside wear to both front tyres.....
View 7 Replies
So I got my 2004 Grand Am about 2 months ago and noticed after about a week that the front right tire was low. I put air in it, came back to check it in the morning and it was down again. I had it looked at and was told that the tire was pulling away from the rim because of the rim eroding. He put some bead sealant on it and got rid of the erosion on the rim. Everything was fine. But then about 2 weeks later I started to notice a slight crunch when I went over bumps. Over the past month and a half the sound has gotten progressively worse.
It sounds extra bad when I am making a right turn. My brother put it on a lift, took the tire off, pushing some things around and couldn't figure out the source of the sound. Everyone who drives in the car with me can hear it. Other than that annoying sound the car is beautiful but the sound makes it seem like a junky car and it's not. It doesn't crunch when I break or at high speeds (maybe because I can't hear it). I'd hate to bring it to another mechanic and pay dollars for him to tell me he can't figure out the sound either. The car had it's suspension checked etc.
View 5 Replies
01 Excursion V10 4x4 230000 miles
When making slow left turns, and sometimes hitting bumps going straight at low speeds 15-35 mph I hear and feel a crunching noise right below the gas pedal floor board area. I;ve had it checked out on a lift plus sitting on the ground and no none can figure out where the crunching (or banging) noise is coming from. Ball joints & tie rods are good, had them checked.
I bought the truck a yr ago and do not know much history of the vehicle. Is does still have the stock wheels, michlin tires and suspension. Ball joints and tie rods were replaced some time ago, not sure when...
View 9 Replies
I've got a 2011 santer fe auto with a foot hand brake. i park the car on my drive which is on a slight incline, when i put it in reverse and then release the hand brake there is a crunching sound and the rear offside wheel locks. It eventually releases after a number of revolutions but it sounds very mechanical clunky.
View 5 Replies
My 1998 Forester suddenly began pulsing / crunching sound, from the front brakes. I had just performed full brake inspection 2 weeks before. So I removed the ABS fuse (20 amp), and the problem disappeared. Of course the ABS light is also on now, but I can drive the car. I disconnected the 4 wheel sensors from the car harness, connected an oscilloscope to each, and spun the wheels pretty fast. I get 150 MV peak-to-peak from each sensor. Must I replace the "tone rings", or just wire-brush them? Replacing the rings are a BIG job, and the wheel bearings & seals must be replaced, since they don't survive pulling out the axles from the steering knuckle (front), or strut assembly (rear).
View 3 Replies
It's been almost 6 months since I dropped 1.2" and added 17" OEM Monte Carlo wheels. On a smooth road, it's a splendid ride, but on uneven roads it is pretty horrible. Add to that a "crunching" sound from the springs when I hit the road in the morning. That tends to go away as the car warms up.
The car looks great, but I wonder if I should have kept the supple ride I was getting before the mods. Is 24lbs. A little heavy for a 17" wheel? That's what the Monte Carlos weight. My understanding is that a lighter wheel will soften some of those bumps.
View 3 Replies
My 07'Passat 2.0T has this annoying loud rattle sound coming from somewhere behind dash board whenever the car was left outside ( under ~55F) overnight. The problem was gone after the car sit under the sun for hours. Is it cause by cheap material VW used in 07 model or assembly ?
View 5 Replies
I have a front end noise when I go over a speed bump or hit a pot hole. It is kind of a crunching nise like something needs grease.
The Hyundai dealer charged me $54 to diagnose the problem and told me I needed both upper control arms replaced to the tune. They did force some grease in the bushings.
The car only has 63000 miles.
View 27 Replies
So recently my car has been making almost a crunching noise in the front end of my car usually pulling out of the driveway or hitting any type of bump. But it doesn't seem to always happen. It's a louder crunch when it's colder out. It almost sounds like a rusty door being closed/opened rather then a crunch. My car has just about 77k on it and this is the only issue I have with it.
View 16 Replies
I know that VW's are known for funky problems. Sometimes when it has recently rained heavily, the brakes will make a crunching sound when I press the pedal down, and there is also increased pressure, as if there is water stuck somewhere. It will drive fine for a few minutes and then will start shuddering, spewing exhaust, and nearly stalling. The engine light will often flash, and for this reason I brought it into my mechanic who is a VW specialist. It was first diagnosed as a faulty engine coil, and that was replaced. The problem came back repeatedly and he said I would have to wait until it "got worse" for him to figure it out. I've been riding it out since then, and once I get to my destination and the car sits for a little bit (usually 4+ hours), it runs fine again. The rainy season has started so I'm a little worried about this happening on a regular basis. This has never happened in dry weather.
View 12 Replies
My 2010 SF has 36000 km and I've noticed a "crunching" type sound every time I go over a steep ramp or a speed bump. The sound comes from the rear and never happens on smooth road. I took the car in for service last week and the dealership has ordered two rear replacement shocks -- they say it's premature failure.
View 16 Replies
What I have happening is clunking that can be felt in the pedals and dead pedal at random time. Bad vibration can be felt through the cabin but this is hard to quantify since I already had VF mounts, I'm lowered on PSS9's, have camber plates, etc etc. It just seems to me that the vibration has gotten worse than the "normal" vibration these mods would introduce. Whirring/rotational noise that comes and goes and seems to be right in front of the the driver's seat. It also sometimes seems to go away if I am cruising down the road and I push the clutch in.
Crunching noise (almost like a CV joint which is shot) but this noise appears randomly at various speeds and when driving straight. All of this is pointing me more and more towards a tranny problem which is not what I want to hear but I also don't want to keep driving my car without knowing what is wrong with it. One note is I did install the trans shim, replaced black cap on end of trans in Feb and didn't notice anything out of the ordinary at that time
I have pulled the driver's axle 3 times in the last month and can find nothing wrong with it. I have pulled the suspension apart on the entire front end and found/see nothing. I have pulled, twisted, shaken, etc everything looking for bad or worn parts/bushings and can find nothing.
View 2 Replies
I have an 07 Passat 2.0T with 48,000+ on it. I tend to overthink any little sound my car makes that doesn't seem normal and this one has me perplexed. When I am driving at low speeds, windows down, I hear what amounts to a "psst" sound come from my front shocks only. I understand I have gas shocks on the front but it doesn't seem like any other car makes this sound.
The ride is comfortable and the sound does not seem to affect the suspension feel. Is this a normal sound? Do you think there is an issue with the shocks? I have been searching high and low for someone with a passat that has written about this sound from the shocks.
View 8 Replies
My 98 honda civic (automatic) makes a rattle sound from the front of the car when it shifts (accelerating) it doesn't seem to cause any problems but I would like to know if it's a problem and should get it checked out?
View 5 Replies
I have a bit of a question about my 2007 Ford F-150 w/ the 5.4 3V. I don't know how long it's been doing this, I just happened to notice it not long ago. Whenever I rev the truck (doesn't matter if it's in Park or Drive) in between 800-1,000 RPMs it makes a "rattle" type sound - like a "rat-tat-tat-tat" I guess is one way of putting it. It only does it when the engine is hot, it won't do it when it cools down some. The truck has 63,000 miles and I've always ran the recommended 5W-20 weight oil. Engine runs good, no power-loss or anything like that. I have posted a video on YouTube of the sound. If you want to skip my talking in the video to get to the sound, then skip to 1 minute and 40 seconds of the video.
2007 Ford F-150 Lariat 5.4L Triton V8 Rattling/Ticking VCT Phaser Noise?
View 14 Replies
My c4 when new made a rattle noise only in the front drivers side tire . Can be heard while the window is down and while hitting bumps on the road or the lane dividers reflectors. botts dots i believe.
View 19 Replies
I've been getting some "heat shield like" sounding rattle from the underside of the car when taking off. It seems to be coming from under the engine area, I don't think it's the heat shield over the cat since I've had that before and that was the first thing I checked, it's all tight. Is there another shield under the engine that can cause this?
View 3 Replies
I get this noise, AT TIMES, on cold starts which sounds similar to a knock. It lasts for maybe a couple of seconds at most. It's not the FI ticking that is generally always present. I see where other models (engines) have reported start up noise but nothing on the 460.
View 2 Replies
I have a 2007 XC90 3.2 RWD with around 112,800 miles.
On acceleration, there is a rattle (not a valve knocking) that gets quieter once a steady cruise is achieved. At idle in gear, a very quiet rattle can be heard. When transmission is slipped into neutral, the rattle goes away. The engine shifts normally, accelerates normally and gas mileage is steady at around 20.5 mpg (mixed city and highway). I am using 93 octane gas. This week the check engine light came on.
View 1 Replies
It's a metal on metal rattle sound when I'm going slower speeds and paved residential streets that are a little rough. passenger front is where it seems to be coming from. I can almost know when it's going to do it when I'm coming up on a rough spot on the road. super frustrating. Started noticing if after my mechanic replaced both front springs when my driver side spring broke. Took it back to him and he couldn't hear it and made sure everything was tight. What it could be. Thought maybe stabalizer link but not sure how to tell if it's bad.
View 1 Replies