I have an 07 with the AFS lighting. bulb error on dash- as I understand it, this has to do with a faulty shield for the high beam on the passenger side. Can this be repaired? Or should I just shell out the 300 for a used one on ebay.
View 3 RepliesLast night I have noticed that my Bi-xenon are not working. I check fuses and both fuse 15 AMP were melted. I don't what happened but after I have replaced fuse still no light at all. BTW I'm thinking to replace ATF in my tranny. I did check post history and I couldn't find any post about this,
View 3 RepliesSo about a 2 weeks ago my drivers side headlight went out. I figured it was the bulb (even though I had just replaced them about a month prior). Got new bulbs and nothing. I checked the fuse and it was not blown. I made sure the electrical connections to the bulb weren't dirty and were connected properly.
Then last night my passenger low beam went out. I had changed the bulb when the other side went out 2 weeks ago. Its still brand new and not blown. I did the same thing, the fuse is not blown and the electrical connectors are clean and secure.
I just took my car into the dealer about a week before the driver's light went out and did their "Major Service". They did tell me that I would need to replace my battery soon. Could this be the cause?
I drive a 2011 Hyundai Sonata SE 2.4L
Where's the fuse for the DRL ...both my DRL and high beam isn't working ...I checked the bulb and is seem fine. I did check the fuse box on both locations ( under the hood and steering wheel) none of them says DRL fuse in there ...
View 14 RepliesI have a b6 Passat and the high beams are not working. I am going to be installing HIDS in the next week or so so I located a vag com disabled the drls and enabled Xenon without the shutter. now no high beams. they will only work with the car off and pull back the switch instead of pushing it forward.. I'm sure there are ppl on here with HIDs and there high beams working on a b6.
View 9 RepliesI've ran into an issue with my high beams on my 07 Camry SE. All lights are working except high beams. When you switch to high beams the lows only stay on. The dash light comes on and shows high beam indicator, but no brights! Fuses look good, and so do both bulbs. Going to go buy a bulb later today just to try. Like I noted they both just suddenly stopped. I'm leaning towards dimmer switch on column now.
View 11 RepliesMy 2007 Dodge Caravan has only one working headlight, the passenger side does not work on high or low beams.
At this time I'm wondering if the problem is in the headlight plug itself, because there are no other complications other than the passenger side not working.
The light did work at first on high beams but now not at all. replacing bulbs makes no difference. There is some brown discoloring on the white strip on the plug face, nothing like this on the driver side.
Also hoping that the problem is not the relay or front control module.
This morning a dash light informed me a headlight bulb was out. It was my DTR light on the passenger side.
I purchased Sylvania H7 high intensity, installed it and it failed to work properly. Daytime light on only drivers side works.
High Beam on , both lights works.
I checked my manual and it said to check fuse in the 5 slot on the driver side dash/door panel and there actually is no fuse in there. I checked the driver side and there was no fuse there either.
I replaced my driver side bulb last year and it took 5 mins....i am already 4 hours into this!
My left headlight stopped working..
00978 - Lamp for Low Beam; Left (M29)
010 - Open or Short to Plus
and xenon range..
01328 - Convenience System Data Bus
013 - Check DTC Memory - MIL ON
I'm a new owner of an 05 Toyota Prius. Im loving the car so far, however, i am having an issue with my high beams not working. After doing lots of research it looks like the high beams on the Prius comes from the same bulb, what controls the high beams is the reflector.
My low beams and all other lights are working fine. After removing my bumper and looking through all the wiring I have noticed that their are two plugs that are not attached to anything. The lights look brand new, so my thoughts are that this car had HID lights and they were then replaced to non-HID lights.
How to get the high beams working. I don't see any HID ballast anywhere, so converting it back to HID would be costly since i would need new headlight plus ballast and bulbs.
I tried looking for wiring diagrams but can seem to find any.
Here is the link to some images: Prius Photos by Izzy25323 | Photobucket
I replaced the high beam headlight bulbs in my 09 Sonata, resulting in no high beams working at all. Took out the new and put the old ones back in. Still not working. Checked all the fuses, and the relays. No problems there.
View 3 RepliesTroubleshooting a headlight problem on a 2004 V8 Touareg. Driver's side xenon low beam flickered rapidly and then quit working. I replaced xenon bulb with OEM part, still not working. Swapped in known good bulb from passenger's side, still not working. Took to dealership, who said it needed new ballast, which dealer would be happy to install for a mere $900 in parts and labor. Declined dealer's offer, ordered new replacement OEM ballast (from Chrysler dealer for several hundred less than VW), installed new ballast, still not working. Cleared all fault codes using VAG-COM, still not working. Swapped in known good ballast from passenger's side headlight, still not working. Auto-leveling is still working in both lights. So...not the bulb, not the ballast. Wiring harness, perhaps?
View 3 RepliesDriver side low beam was burnt out. I replaced the bulb with a new one then no low beams would work, high beams work. Turning on manual switch and I checked fuse 7 & 10 fuses which were okay still no lights.
Could it be the low beam relay? The passenger side was working. Do they only come on when it is dark enough as I can't remember if they are running lights and worked in daylight?
So I pullled into a reststop to relieve myself and when I drove off none of my lamps (high,low,or fog) worked. Along with them my blower fan does not work nor the rear defoggers, wipers, spray with wipers, turn signal (hazards do work though). Is there a fuse or relay that connects them together?
View 2 RepliesLow beams work fine. When I push the Multi-Function lever on the column forward to activate the high beams, I have no lights at all. When it is in low beam (middle) position, low beams work fine. When I pull back for click to pass, only the low beams are active. No high beam indicator in instrument cluster. I have:
1. Replaced both headlight bulbs
2. Replaced the multi-function switch on the column. Checked test pins on switch (MF) they are hot when in either high beam position or click to pass position
3. checked fuses (interior)
#8 - power on both sides of fuse
#16 (15a) High beam headlamps, instrument cluster. ***NO POWER ON EITHER SIDE***
4. checked fuses (engine compartment)
#10 - power on both sides
#21 - Power on both sides
#23 - power on both sides of fuse
My High beams for a 2003 cavalier are not working. I checked the bulbs and they are good, The Low Beams Work and my drls work. I switch from low to high and the blue indicator on the cluster panel comes on.
View 5 RepliesSo I bought an 01 GTI last week with a decent amount of things pre-modified including a Jetta front end swap? Anyway the guy I bought it from knew absolutely nothing about what had been done to the car other than the fact that there was an HID kit installed and it was set up to run high beams only.
I figured I'd remove the HID's until i drop some cash on a pair of nice projector housings. I removed them and plugged up some nice sylvania bulbs as per the OEM standard 9007, and figured I'd have no issues... They are still stuck on high beam only... What could be causing this?
I just had my car coded for aftermarket HIDs and i have no high beams and a bulb out indicator on. did i miss a step in the VAG coding or will the high beams work when i put the HIDs in?
View 6 RepliesMy regular beam light stopped working today. If i pull back on the high beams, both come on and work, however, if i push the lever forward to leave them on permanently, they don't come on at all. Is this because the regular bulb is out, or is something else wrong?
View 6 RepliesLike on most Chevrolet's or other cars, when you unlock your car with the remote, your headlights come on for awhile. I've tried to 'unlock' this feature with a scanner but the only option I was able to change was the auto lock door function. Is there any way to activate this feature (if possible)? If its not possible with a scanner. I have a '09 Santa Fe Limited, w/ Auto Lights w/o DRL.
View 10 Replies08 SANTA FE, NO HI OR LOW BEAMS. Daylight running lites work, fog lites work, checked all fuses, relays, and bulbs,& connectors.
View 9 Replies