Passat (B6) :: 2006 - Supply Voltage For Right Parking Brake Motor Sporadic
Jul 12, 2010
I have a 2006 VW Passat 2.0T 6spd and it has the electronic rear parking brake with auto-hold. Recently needed rear brake pads, but hadnt had the 3 updates for the system, so i could not retract the e-brake through the computer. Got the update done, got the car back with two codes that i cannot get cleared:
53 - Parking Brake
02433: Supply voltage for right parking brake motor (sporadic) - V283
01087: Basic setting not carried out (sporadic)
Every time the codes are cleared, they come back immediately, therefore the scanner will not allow me to operate the system and do the brake job. I am using the Launch x-431 scanner with a vag-com emulator, so there should be no equipment problems if there is anything i can do. Is there an adaptation or relearn that needs to be carried out for the caliper?
View 8 Replies
Advertisement
What might be causing this transmission fault code?...It is the only one I get and makes it unable to see what gear I'm in when using the tiptronic mode. I can clear the code while I'm driving and it will be ok until I turn the car off then again it comes back up. Car is a 2002 Passat GLX 4 motion
View 1 Replies
About two weeks ago I noticed that my parking brake light was not illuminating when I enagaged the brake. Since then it sometimes comes on when I engage the brake but not always (most of the time it doesn't). I can't replicate the conditions and there doesn't appear to be a pattern of temp or time of day.It is an '04 with 146,000 miles.
View 1 Replies
I went skiiing this past weekend in Angel Fire, NM. When it was time to leave on Sunday I started the car and proceeded to undo the parking brake (I was parked on a n incline). As I press the button I get a message saying something like "Electronic Parking Brake Fault. Please Service". Then I press it again and it works. Is this something I can expect more of, or could it be due to the cold weather? It was 13F outside then at the time, and the car is a 2006 with 52K on it.
View 14 Replies
I've read as much info as I'm willing to digest and everything seemed to point at the switch. Replaced switch. I went through a recommended adaption sequence and I'm back to square one. warning light for [P] - traction control light - display says Parking Brake Fault See Owners Manual. And there are codes for Parking Brake Control Head Electronic Malfunction...
View 4 Replies
Had my car parked outside of work for about 12 hours yesterday, and in the NYC cold front, the parking break must have stuck on slightly. When I started to move, despite the fact I'd released the parking break, I received a warning in the MFI that said PARKING BREAK FAILURE TO RELEASE. I pulled the handle again and heard it pop just a little more off. Everything worked great after that. If I hadn't received the alert I probably would have driven off with it on. I'd probably have noticed the hesitation and checked the break again, but the alert was useful. Some of the warnings in the MFI can appear to be a pain at times, but it's amazing how thorough a job VW has done monitoring the cars systems and giving real time information if something doesn't work. You just have to make sure you don't get info overload from it all!!
View 4 Replies
I have a 2004 Prius. I purchased a used brake control power supply and installed it. Do I have to reflash it?
I tried to relearn the Linear valve offset. I've tried to INITIALIZATION OF LINEAR SOLENOID VALVE AND CALIBRATION with the factory scan tool. I have both. The older one seems to work better when working on Gen II Prius. I also tried to reset the YAW rate sensor.
View 6 Replies
My truck had power to the Brake Controller until a recent road trip and now there is no power to the controller. All fuses are good. Which circuit the power comes from?
View 4 Replies
I am wondering if there is any way when I turn my car off that the cig/12v? outlet will still work? I have a 19 month old and we have a portable dvd player that he watches in the car and it is plugged in, when we stop for something and one of us run in a store for something we like to keep him entertained, but if I turn the car off it kills the power. How to keep it on, vag-com?
View 4 Replies
The DRLs in my 13 are 12v or a lesser power supply? Planning out my retro fit and wanting to do something different DRL wise but need a 12v supply, I know the headlights themselves are turned down some and can be adjust via VagCom.
View 4 Replies
Had a lift done (Rough Country, after reading through these forums) on my 04 F150 Newer Body Style 4x4. Now, sometimes the pedal gets harder to push on until it won't go down at all and the brakes (only the front) start dragging. It goes away after awhile (my rotors are shot and I'm going to have to replace them after I figure out what is going on) but always comes back. The brake lines have been bled and I'm having a shop bleed them again tomorrow (that's what they said the issue was) just in case.
View 11 Replies
Just got my hair cut and go to start my car and the damn thing is stuck!! The check engine light is on and there is a P with a circle and a line through is like a no smoking sign. IT says parking brake fault see owners manual. Well I can't find anything in the manual as to how to get this thing to release. The car is on a slight hill, nothing steep. I know for a fact I did not put it on. Manul says it will test itself if not used for a long time. How to get this car moving? Its sitting there about 2 miles down the road.
View 24 Replies
Ok when I stop the car and get out I can hear what sounds like the parking brake engaging even though I have not pushed the button ( i am scared to death of the button) and sometimes when I start out I hear a grinding noise, that happens when i apply the brakes but then goes away??
Is it supposed to be this way? 11K miles on the car and the grinding noise doesn't happen alll the time like it was the brakes or rotors and they look fine, the pads that is from looking at them??
View 7 Replies
I bought a new battery tonight at my local VW dealership and after replacing it in the parking lot I got into my car, started it up, and saw 'Parking Brake Fault - See Owners Manual'. Seeing as I dont have an owners manual as when I bought it used, it didn't come with one - The car is still driveable but does not shift out of gear and when I go to engage (automatic) Drive, Reverse, or Sport, from the Parked position it makes a hard clunk and small jerk before it engages. The MFD is as if I am still parked because I can access all the comfort sections, and all transmission selections are highlighted. Im not sure if it was in Neutral or Park when I engaged the Parking Brake before I changed the battery so maybe and Im hoping when I took the old battery out, and put the new one in, that something wasnt set correctly when the car started up after having no battery power???
I am curious to know what possible ways I can rectify this. Its sitting in the VW dealership parking lot and Im hoping they will be able to take a look at at it in the morning but of course I wanted to check here. Also, what does it say in the Owners Manual about a Parking Brake Fault?
View 5 Replies
I bought a 2006 Sonata V6 3.3L with 137k on it about a month ago. Engine and Trans is great, but I noticed an issue that developed within the past week and a half or so.
I am one to always engage the parking brake when parked, to relieve pressure on the parking paw in the transmission. After about a week of heavy use of the parking brake, I began to hear a slight 'clunk, clunk, clunk' coming from the rear passenger wheel (it actually sounded like something was loose in the trunk, but ruled it out). The 'clunk' sound at first only happened going over rough or bumpy roads, but within the past week or so it's gotten louder and more consistent. It now 'clunks' regardless of speed or road surface.
I used the parking break today for the first time while the car was in motion, and when pulled it sqreached very loud, didn't really stop the car, but the 'clunk' became very loud while the break was pulled - shockingly loud, actually.
A couple of days ago I took the rear passenger tire off while jacked up, and spun the wheel. With neither the parking or regular breaks engaged, the wheel made a 'clunk' sound very similar to that it makes on the road. Took of the Tire/Rim and spun the Rotor, to hear the same sound. Attempted to wiggle the Rotor and found no play at all.
At first, the clunk went away when you pressed the floor board brake pedal, even just a slight bit stopped the noise. Now it doesn't seem to stop it any longer.
My main idea is that the parking brake in the Rotor is the culprit, given that the issues didn't arise until I started using the parking brake - and the fact that brake appears to not work very well. However, my dad tells me he thinks it's a wheel bearing. I don't think it is - as its not making any metal on metal sounds, nor is it very difficult to rotate the Rotor while jacked up.
View 3 Replies
Doing a rear brake job on my 2008 elantra. Left went fine. However, the right rotor is stuck on the parking brake. It is loose, but held on to the springs of the parking brake.
How do you back off the parking brake? Also, how do you remove the parking brake cable?
View 1 Replies
Today, as i had my car in the repair shop for a checkup i got a horrible message. The rear caliper/hand brake motor (?) is leaking brake fluid. Replacing this is close to 1500$ (I live in Norway) So my question is: Is there any way to stop the leak without replacing the whole thing? Also, i suspect the leak is minor as the brake fluid is almost on "max". So, if it doesn't really leak a whole lot, do i really need to do anything about it? I mean, if i have to refill the fluid container every six months its much cheaper.
View 1 Replies
Ok so i get off work and i go to my car, its around 6ish and its reading 36 degrees fahrenheit. On start up the car beeps and the parking brake wont disengage...tried pressing the button a couple times but nothing. So i turn it off and start it again...nothing. Then finally turn it off, let it sit till all the interior lights come off. Turn it on and lo and behold it works! At an ambient air temp of 36 degrees, is it possible that rotors and pads are frozen? Also could it be that the cold temperature is freezing the brake lines? Also the car was parked so that the wind was perpendicular to the brakes. So like a T with the long part being the wind!
View 12 Replies
Happened to me twice today, engine wouldn't start, message on MFD was "Parking Brake Fault" and the engine would not start. I read through he owners manual looking for a solution, and the engine finally restarted and I was off on my merry way.
About two hours later, on another errand, this time I started down the road, the engine died, I tried a re-start, got the same "Parking Brake Fault" message and this time the engine would not start. Tow truck is going after the car right now. This leaves me a bit frustrated why a parking brake issue would kill the engine.
2008 Passat Komfort...
View 8 Replies
owner of a 2007 Passat 2.0T wagon, 6 spd manual, 32k km's. (leased) I'm having repeated persistent parking brake failures (won't engage, or won't disengage).
-About two months ago the parking brake would not disengage, error message on the MFD, yellow warning light and warning tone. Called roadside, finally got it disengaged by removing one terminal from the battery. Took it straight to the dealership, they "fixed" it by resetting the computer.
- The next day I have auto hold engaged, parking brake did not disengage when I turned the car back on. Had to turn engine on/off several times before it disengaged.
- Took it to the dealership again, had to get a rental car over a weekend while they diagnosed the problem. This time they changed some wiring and replaced the parking brake button.
- Next day the parking brake engaged ok but wouldn't disengage. Same routine on/off/on/off to get it to disengage.
- Back to the dealership again, they decided to replace the brake control module but didnt have stock.
- Last week I took the car back in (4th trip for this issue), they replaced the module and said it was fixed. Next day my wife got stuck in a parking lot with the parking brake stuck on.
- Called the dealership last friday and asked them to come pick it up this time, as my wife and I are sick of the inconvenience of this issue. (we share the car, both work, and also have a child's daycare to schedule around)
The problem is intermittent but not difficult to cause a fault. Can be caused when engaging, disengaging, or when the PB kicks in from auto hold when turning the car off. I try not to use it, but sometimes is necessary (parking on hills etc).
The dealership doesnt seem to know the problem and are just throwing parts at it. What recourse do I have for repeated problems? The manual recommends using this parking brake EVERY time the car is parked, so I don't think it's too much to ask to have it working properly.
View 24 Replies
My parking brake light has been coming on and off for 2 days now. went to the dealership today and on my way there my steering light began to flash. So I guess I can join the steering column failure club. However what faults can the parking throw?
View 4 Replies
