Passat (B6) :: 2006 - Check Engine Light Came On / Fault Codes?
Mar 7, 2012
I have a 2006 passat and the check engine light came on so I performed a scan, the results are below. fault codes... which ones would need to be repaired immediately?
VCDS Version: Release 805.1
Data version: 20080823
Tuesday,06,March,2012,18:12:35:26365
Chassis Type: 3C0
Scan: 01 02 03 08 09 15 16 17 19 1C 25 42 44 46 52 53 56 62 65 72
VIN: WVWAK73C86P106340 Mileage: 107910km/67052miles
00-Steering Angle Sensor -- Status: OK 0000
01-Engine -- Status: Malfunction 0010
[Code] ....
View 6 Replies
Advertisement
I picked up a 2007 GS350 AWD with a little under 60K miles a few weeks ago, I've been absolutely loving the car, but noticed the check engine light/check VSC came on this morning on a cold start; it also sounded a bit rough on idle. I have an Android to bluetooth OBDII scan tool for my other cars so I pulled the codes, and it's showing P0300, P1600, P1700, and P1800.
Searched the forums and nothing comes up for those specific codes. But the first couple of things that came up as culprits for check VSC were the gas cap and brake fluid; went out and bought an OEM gas cap and made sure the brake fluid was topped off this afternoon. I reset the faults and drove the car around, but the lights came back on about 15 miles later. It drives and shifts fine, but I still think it's a bit noisy at idle.
A little background on the car: The previous owner only drove it on weekends and for events here and there, hence the relatively low mileage. The car was sitting in his garage for almost a year before I bought it, he finally got rid of it because he wasn't using it. I grabbed it despite a higher asking price because of the mileage and how clean it looked, but now I'm a bit worried. Is this bad gas? Should I flush all of the fluids? MAF or other sensors? I'm a bit lost.
View 12 Replies
Car dumbie back again with another question.The diagnostic for my check engine light indicates numerous cold start misfire codes. The cylinders are OK. That was checked during the diagnostic.The fuel intake is carboned up. It is recommended that I clean the intake manifold. Does this mean cleaning the fuel injectors, the throttle body or both? 2006 Passat VW....
View 1 Replies
Check engine light is on and my code reader is giving me a P0000 code that is not listed in the Bentley's list of OBD II codes. My nose is telling me it's emissions related as the exhaust smells too rich. And the car is nearly stalling at idle. Suspect #1 is the MAF but the OBD II code does not support this.
View 13 Replies
Earlier this week on my way back home from the gym I got my first check engine light . I scanned the car and got the fault below. What may be causing it?
About the car: 2008 LUX Wagon2.0T FSI50,2XX miles
Scan:
Address 01: Engine Labels: 06F-907-115-AXX.lbl
Part No SW: 3C0 907 115 S HW: 8P0 907 115 B
Component: 2.0l R4/4V TFSI 0020
Revision: 5BH16--- Serial number: VWZCZ000000000
Coding: 040C010A19070160
Shop #: WSC 25129 444 59131
VCID: 3041DE6FDAB3
1 Fault Found:
008583 - Bank 1; System too Lean at Idle
[Code] ....
View 2 Replies
Encountered this check engine problem > 16805 and 16815 < I replaced the 02 sensors, problem solved for 1000 kms, and now the dreaded light is showing its face again ! Possible secondary air system at fault? Cat about to go, or already gone?
View 5 Replies
2002 Passat 2.8L... I am averaging 11.8 mpg in city driving I do not know what the problem is... My check engine light just came on fault P0114 something like that secondary air hose could this be the cause of me getting 11.8mpg and I use grade 91 and higher of gas...
View 6 Replies
Just got a check engine light last night. Pulled the code and got a P202a fault. Some digging indicates its the Ad-Blue tank heater module. TDI forum indicates its anywhere from $850 to 1K to fix. Also that it's not covered under any extended warranty (now there's a shock!) The cars going back to VW so that's not happening.
Is this one of the conditions that will cause the car to go into limp mode at some point? I know that happens when the ad-blue runs low. I'm in Florida so the heater isn't really a big deal. I need to use it another couple of months and I don't want to have this thing leave me stranded. If I have to I'll park it.
View 2 Replies
The light just came on in my 06 Sonata 3.3L, showing many codes... P0171B, P0172B, P2187, P2188, P0174B, P0175B, P2189, and P2190. All of these just came on at once, within the last hour. Everything that is stated is regarding Too Lean or Too Rich on Bank's 1 & 2. Where to start on this...
View 9 Replies
My check engine light popped up the other day and when ran, 3 codes popped up: p2414, p2195, and p0170. From what I could gather it looks to be the O2 sensor is bad. This would be the one on the exhaust manifold, correct?
Also, what would cause the o2 sensor to go bad in the first place? My 09' has roughly 65k miles.
View 13 Replies
Our second car is a 2007 Accent, 125KM's (70 miles). Today the engine light came on, I drove it very slowly to my indy mechanic and she is not throwing any codes. Engine temp was fine and she just had an oil change.
Engine light turned itself off so I drive it home and on the way it's all good then suddenly .... she dies. She starts again and I get home, i idle in the driveway and she stays on but a little rough as she is sitting at 800RPM, is this right or a little low?
View 2 Replies
Check engine light came on yesterday evening. Advance read the codes as P0100 and P0171. The guy said something that it may be related to the mass air flow sensor. The car seems to run fine.
View 2 Replies
Ok so we have yet again the engine light on...we did a test and we have the codes P2004 and P0642. What can it be the problem this time??? what can cause this codes and is it expensive to fix? We just fix the care a couple of weeks ago( codes P0507 and P0171) and we are sooo tired of having problems.
View 4 Replies
I just bought a 2000 VW passat with 63k. I had it for a week and check engine light came on. 30 v engine ....
p0431 /16815 bank 1 below threshold??
p0421/16805 bank 2 below threshold??
Cat? or 02 sensors???
View 3 Replies
We have Elantra - 4 Door sedan 2006 model. We have not driven much; about 23000 miles. All of a sudden we got Check Engine Light ON. I took the car and got it tested at Pep Boys to get codes. It came out as PO700 and PO885.
View 2 Replies
Car keeps tripping P0885 P0890 codes and sets engine light on. I've tried swapping ATN relay and cleaning connector in TCM and Relay box. It's intermittent comes on at least every other day. Shifts fine when engine light reset. But when the P0885 comes up it goes into limp mode. Just bought this car We bought an after market warranty but shop say they won't cover Engine light codes or intermittent.
View 5 Replies
Kia rio 2006 130461 today I went and got gas right when I pulled out light began to flash and car shaking went to auto zone codes p0302 and p0326. I had knock senor changed 2 months ago . What could be the problem the guy said I just need a tune up . Is this true ? Is my car safe to drive car not shaking now and no changes in function of my car. There no way I can any one to look at it for couple begin tomorrow sunday.
View 19 Replies
The check engine light on my 1999 1.8T Passat is on. It started with a little miss right after startup. Then in neutral, after revving the engine to say 1,500 rpm and letting off the gas, it would nearly stall. I plugged in an OBDII analyzer and came up with codes P0102 MAF or VAF circuit low input and P0304, Cylinder #2 misfire. I replaced the spark plugs, as they were old anyway. Still the same symptoms. Then I replaced the mass air flow sensor.
The check engine light still went on after it was cleared, except this time it was P0302, Cylinder #2 misfire, P0102, P1613, Auxiliary inputs aux. outputs control, and P1426 Mfg. Control/auxiliary emission controls. Soon after, the car started running fine on it's own and I again cleared the codes.
Then a day later, the check engine light is on. This time, it is only the P1426 - Manufacturer control auxiliary emission controls. The Bentley manual calls it Tank Vent. Valve Open, which doesn't mean anything to me and the Bentley manual is of no luck. (The error code almost implies that it is the famous loose gas cap, but I have checked that - unless the gasket is bad). FYI: I have 99K miles on the car.
View 5 Replies
I was just driving and the engine check light appeared. The screen says Emission workshop. its a 2001 B5 passat V6 Manual. I used a code reader and it read P1120 and P0154. Are these codes serious? Can I still drive around? What should I do?
View 4 Replies
This morning I started my car and it was idling a little rough. The the Check Engine light began flashing - I immediately turned off the car and consulted this forum and my father the mechanic. After talking with my Dad and telling him that the car had sat for a week, he thought the issue was probably NOT the catalytic converter and thought it was probably related to the car sitting and possibly getting moisture in the gas. I started the car again (the roughness at idle seemed to have gone away) but the check engine light/malfunction indicator light (MIL) did not flash, it did come back on after a few seconds, but as a solid light . And as we've all read, it's OK to drive with a solid MIL.
I took the car over to Autozone and had the codes checked - P0300 (multiple cylinder miss fire) and P0301 (cylinder 1 misfire). I asked them to clear the codes. I has just put in new NGK spark plugs last month, so I didn't think it would be the plugs. I looked at a new coil pack for one of the cylinders. I decided to see if clearing the codes alone would work and drove home. No issues so far, no MIL, no rough idle, no hesitation (fingers crossed).
When I called the stearleship - they recommended I have the car towed, but would not speculate as to what the flashing MIL could be (catalytic converter or bad coil pack(s))...
View 3 Replies
I just picked up my 'new'/used 2006 sonata! unfortunately, about 11 months in now, i have a check engine light and some codes; a local store told me what the codes were (i haven't got a code reader yet) and as i was researching them it sounds like either a bad O2 sensor or just the wiring going to it.?.? Codes are P0160, P2273, P0158. How can i tell what is actually bad? I am 'ok' at 'fixing'; just trying to save from an expensive garage repair if at all possible.
View 4 Replies
