so today i removed the radio bezel from my 06 and i left the key on like an idiot and now my airbag fault light is on I reconnected the bezel i make sure that the plug was on and still airbag fault light is on.
View 6 RepliesI have a 2002 Passat wagon glx 4motion & I was driving the other day when out of no where my airbag light came on ... What to do??
View 1 RepliesToday, I got a message on the cluster that said Airbag Fault and then the airbag light has now shown up. Never seen it before...Why I might be now?
View 2 RepliesAfter installing the new head unit in my 06 Passat 2.0T, the "Airbag Fault" error appears on the MFD upon startup and the airbag light on the gauge stays on.
View 5 RepliesAlright just had this light pop up on my 01 passat,
View 1 RepliesStarting a couple of days ago, I am getting the airbag fault light on the dashboard. Can't seem to explain why. I have never changed any wiring on the car, nor installed aftermarket electronics. I have the car for about a year now. At the time when the light came on, the weather outside was very cold.
View 5 RepliesI recently sent for a reset my airbag module, yes my car was in a collision, I replaced passenger airbag(only 1 airbag deployed). And reconnected the module. Using the VAG COM, I scanned the airbag module, shows no fault codes, but i still have a light.. now I'm thinking seatbelts and sensors maybe the problem. Where the sensors for a 2005 passat passenger dash airbag are located.
View 2 RepliesI got a 2006 2.0t komfort. I started the car this morning and got an airbag fault show up on the dash and now the air bag light is on. What this is and the possible fix?
View 11 RepliesWell, I recently had the "Airbag Fault" error message (along with the wonderful amber airbag light) both appear on my dash, and oddly enough, I haven't hit anything or bumped anything or done anything that could cause this error. I drive a 2001 VW 1.8T and she only has 48,000 miles on her.
View 1 RepliesWell like I said, I have an airbag fault light. I recently installed a sound system and ever since I unplugged the "Passenger air bag light" indicator module from the dash trim piece the air bag light has been on. When a passenger is in my car the air bag does indeed activate and deactive when they get out.
My question, why is my air bag light on? Did unplugging the module from the dash trim peice really cause that? I don't really want to take it to my local dealership and get charged diag time.
About 8 to 10 minutes into the drive and....beeeep, I have an "Airbag Fault" on the dash. Just showed up out of the blue.
View 1 RepliesThis morning when I tried to start my passat I got a number of errors. The car was running fine last night. I had to use all of my keys I had to get it started. At first there was a Air Bag Fault message, and the car would turn over but it wouldn't let itself run. After changing keys I got it started, however none of the gears show up on the LCD. At that time I got the stop low oil pressure light.
When I tried to start the car a third time it told me the car was immobilized. Since then I managed to get the car in the driveway, and now it starts up every time, not like it is immobilized, but I still get the air bag fault and the low oil pressure. Further the RPM's go up when the care starts but then the gauge bounces from 0 to around 1,000 when it is started, and the temp gauge is non functional. The engine itself holds a normal even idle.
1st: 00532 Supply Voltage Too Low - Intermittent
2nd: 00592 Seat Belt Switch on Passenger Side -E25
Resistance Too High - Intermittent
3rd: 00592 Seat Belt Switch on Passenger Side -E25
Resistance Too Low -Intermittent
the piece where the passenger side seat belt clicks into has a chunk broken off of it, now im assuming that this is causing most (maybe all?) of the problem here?
I have a 2006 passat and the check engine light came on so I performed a scan, the results are below. fault codes... which ones would need to be repaired immediately?
VCDS Version: Release 805.1
Data version: 20080823
Tuesday,06,March,2012,18:12:35:26365
Chassis Type: 3C0
Scan: 01 02 03 08 09 15 16 17 19 1C 25 42 44 46 52 53 56 62 65 72
VIN: WVWAK73C86P106340 Mileage: 107910km/67052miles
00-Steering Angle Sensor -- Status: OK 0000
01-Engine -- Status: Malfunction 0010
[Code] ....
Put new pads on by 2006 Passat tonight. Disconnected the battery removed the calipers and used a 12 volt battery to retract the pbrake then pushed back the pistons. Buttoned everything up but when I started the car had the park brake fault light and car is now in limp mode (3rd gear only with harsh engagements.
Disconnected the battery again and will let it sit.
My 2006 Passat 2.0T with 63K milage has started showing the airbag warning. I am taking to dealer. What does this mean?
View 7 RepliesMy airbag light won't go away, and everytime i pass 25mph my dash says airbag fault. Is this another sensor that went out?
View 4 RepliesI removed my front seats to steam clean the carpets. After replacement, I get a "Air Bag Fault" warning on the dash. Is that something I can reset?
2000 Passat Wagon V6, 5sp
Came on other day. No ses light or fault codes. What it means?
View 10 RepliesSo the light came on the other day, took the car to the stealers for the 60,000km service and just figured they would just clear the fault code. Turns out i needed a new airbag harness in and under the drivers seat.
View 3 RepliesI have a couple of fun curves I hit daily and most days I push the car pretty hard. So, I hit one the other day on the way home from work and the freaking airbag light came on with a fault message. I immediately suspected that when my seat belt tightened that the sensor in the seat belt connector freaked out. I later scanned with VAGCOM and confirmed that I have the famous high resistance message for the driver side seat belt connector. I remember that some people had luck by cleaning the connections to the bottom of the seat and the switch. Maybe that is all I have to do. Got to love the .:R. I break stuff as fast as I fix stuff.
View 13 Replies