I am wondering if there is any way when I turn my car off that the cig/12v? outlet will still work? I have a 19 month old and we have a portable dvd player that he watches in the car and it is plugged in, when we stop for something and one of us run in a store for something we like to keep him entertained, but if I turn the car off it kills the power. How to keep it on, vag-com?
View 4 RepliesThe DRLs in my 13 are 12v or a lesser power supply? Planning out my retro fit and wanting to do something different DRL wise but need a 12v supply, I know the headlights themselves are turned down some and can be adjust via VagCom.
View 4 RepliesWhat might be causing this transmission fault code?...It is the only one I get and makes it unable to see what gear I'm in when using the tiptronic mode. I can clear the code while I'm driving and it will be ok until I turn the car off then again it comes back up. Car is a 2002 Passat GLX 4 motion
View 1 RepliesOn a trip I managed to pop both the fuse in the rear of my 07 B6 Variant and also the one in the rear of the center console. Checking the manual indicates a 20A fuse in both position 33 and 35 in the right hand fuse panel. Following the numbering scheme in the manual there were no fuses of that value there.
What are the correct position numbers. Also following the other threads my power outlets were switched with the ignition.
I have a 2006 VW Passat 2.0T 6spd and it has the electronic rear parking brake with auto-hold. Recently needed rear brake pads, but hadnt had the 3 updates for the system, so i could not retract the e-brake through the computer. Got the update done, got the car back with two codes that i cannot get cleared:
53 - Parking Brake
02433: Supply voltage for right parking brake motor (sporadic) - V283
01087: Basic setting not carried out (sporadic)
Every time the codes are cleared, they come back immediately, therefore the scanner will not allow me to operate the system and do the brake job. I am using the Launch x-431 scanner with a vag-com emulator, so there should be no equipment problems if there is anything i can do. Is there an adaptation or relearn that needs to be carried out for the caliper?
Volvo850 turbo year94 I'm a lot like I do most of the repairs. But now I have a problem with the ABS code 444 No power supply to valves in hydraulic unit.
View 5 RepliesWiring up my Clearance lights for top of the cab, and for my running boards.
According to my diagrams there is a brown wire running along the passenger kick panel and down the gutter to the rear of the X.
I have a 2004 Prius. I purchased a used brake control power supply and installed it. Do I have to reflash it?
I tried to relearn the Linear valve offset. I've tried to INITIALIZATION OF LINEAR SOLENOID VALVE AND CALIBRATION with the factory scan tool. I have both. The older one seems to work better when working on Gen II Prius. I also tried to reset the YAW rate sensor.
I was driving (about 800 km), when suddenly I realised that some strange smell is going out from my car's boot. When I checked, I found out that Vehicle Power Supply Battery was hot, making some strange noise (like hissing), plus I saw that the battery exterior wall (towards to the trunk) was waved like it was overheated. But because all these stuff happened in the middle of my way, I could do nothing, so I continued my driving.
After 300 km I felt huge impact, I realized that I lost my 6th and 5th gears, after some time I realized that I lost 4th gear. That I stoped just in case not to break something. When I tried to start the engine, It didn't started, so I understand that all problems was besause Vehicle Power Supply Battery was drained.
As I mentioned before, all these stuff was in the middle of highway, therefore I took the wires (crocodile), connected Starter battery with Vehicle Power Supply Battery and managed to start the car's engine and get to the City of Prague. I took out the Vehicle Power Supply Battery, opened battery cells and found out that all of them were dry, no acid at all.
My question is - could it be that the Vehicle Power Supply Battery was overcharged (overheated) because of some mistake of battery charge controller and all acid just go away in some way?
My truck had power to the Brake Controller until a recent road trip and now there is no power to the controller. All fuses are good. Which circuit the power comes from?
View 4 Replies
I do a lot of diagnostic and keys programming but my mechanical knowledge isn't' that good. I had a minor accident last week and a car hit my Prius from the passenger front corner, Areand left a small dent, check the red X in the pic.
I noticed after the accident that the engine noise was much higher, I checked all ECUs with Techstream, I found only one error on the Transmission ECU:
C2318 Low Voltage Error(Power supply Malfunction).
Cleared it and didn't show again even after driving 200 milesIs
there anything behind this area that can cause that noise? or something responsible of reducing the engine noise might be damaged or broken?
My friend has a 2008 Elantra, and she had me jump start the car the other day. The car jump started just fine, but then when it was idling, the headlights would flicker, as if there was an uneven of inadequate power supply. Then, when driving the car, turning the wheel and taxing the power steering would cause the headlights to almost turn off momentarily. After driving for 30 or more minutes, the car did not improve at all. I turned the car off, then went to start it, and immediately it was too dead to turn over again. I'm lost with the electrical, I don't think its the alternator.
View 2 RepliesWent to go and start my truck this morning and noticed after it was running that it sounded like a misfire, then i seen the smoke... I shut the truck down and lifted the hood and seen that somehow i had a high pressure fuel injector supply line on the Lh side break off. The line that goes from the fuel rail to the injector port on the valve cover (theres 4 of them on a side). There doesn't seem to be an o-ring or anything on them, they are just pressed over and tighten down.
View 6 RepliesI am rebuilding the oil cooler and noticed since its removed I have great access to this fuel line pair from fuel bowl to soft lines below. How these disconnect at the soft lines? I happen to have a new set waiting to be installed. Is there a tool required ?
View 3 RepliesI have been noticing that the ballasts have been making buzzing sounds a lot lately. Is this something normal that is suppose to do? I have the slim ballasts from xenon supply.
View 19 RepliesWhen temperature is lower than 15 degrees windshield wiper fluid freezes in supply line or squirter. Is this because of the cover at top of inside of the hood? Does that cover prevent engine heat keeping the system operable at lower temperatures. We need this system operable in the mountains of CO where ice melt is spread on the roads.
View 4 RepliesI tried to go to work this morning and the car just didn't want to crank. I thought it was the door lock (immoviliser), checked the starter wires everything seems ok.... I'm totally lost here.
View 4 RepliesI have a 100% bone stock passat, except for APR stage 1 tune at 91 octane.
I was giving it some nut today racing a volvo, and i noticed at around 5500rpm, the rpm gauge stopped climbing so fast, and it felt like most of my power was gone, the earliest this happened was 5000rpm and I had some gears where it didn't seem to happen at all.
Like I said, bone stock, less that APR stage 1 91 octane, and an aftermarket head unit XD but if that caused any problems with my motor.
My daughter just called and said her power steering went out on her 2000 1.8. She check the belt and it is broken. I have done quite a bit of work on the car so if I can save her the money on a tow and fix I will try to do it.
View 2 RepliesCame out of day of work to find my passat dead. Couldn't unlock it with the remote..no lights...no power at all. Hooked up my friends car to jump it...got the lights to come on but could never get the car to get past the clicking/lights flickering stage.
Never had battery problems before this, so I am confused as to how it just totally died. Tried for a long time to jump it....no luck. As soon I as I would unhook the other car, mine would die completely and I would have no lights, locks, anything.
New to VW and to the Vortex. Last night I leased a 2012 Passat V6 SE, which is my first-ever DSG equipped vehicle. I am getting a significant hesitation on take off and also on rolling starts- almost like the power is being cut for half a second or so, accompanied by a little shudder. After that, it goes like gangbusters with fast and smooth shifts.
I understand the DSG functions differently than a conventional auto, but the delay is enough to affect my judgment in terms of pulling out into traffic. My salesperson told me that "they all do that" but I don't recall the issue in the others that I test-drove (may be due to limited driving time, last night was my first extended trip with the car). I also don't recall reading about this issue in any of the reviews of the V6 Passat.