Passat (B6) :: 08 - Center Bar And RHS Clip Cracked In Half In Hot Sun
Jun 6, 2008
Yesterday, I tried to use my rear window roll-up sun shade while parked in the hot sun, pulled gently up on the center bar, and the RHS clip ---which rides in the tracks along the C-pillars---cracked in half!
08 Passat Owners, the rear roll-up sun shade (NOT the rear door shades) on your car is very fragile! VW uses some kind of lexan plastic molded insert which fits into the tracks. Any out of plane stress on the fittings will damage them, rendering the entire shade useless. Luckily my dealer had a new fitting in stock and the repair was made in less than 10 minutes.
View 19 Replies
Advertisement
I am putting steel wheels all around on my 99 dually. I want to look like police crown Vic's with black wheels Crome center caps. My current caps will not clip to steel wheels.
Is the center caps that will clip over the lugs on a dually?
View 3 Replies
I replaced the radius arm bushings on my truck about a year and a half ago and about 6 months later I found that the nylon spacer on the driver's side cracked in half and only half remained on the truck so I replaced it (under warranty) and I found the same thing again today. I torqued it to factory specs and the passenger's side is fine. What gives?
View 4 Replies
What is involved in fixing TCM system and ECM (I could not start my '04 Phaeton, had it towed twice, only to find I needed a switch, frame, and a mechanism [shifter]).
Now I notice the center vent door that goes over the clock has two cracks in it and I also noticed some other scratches on the so-called wood area on the console. What is a TCM, and an ECM, and what would have to be removed to replace brake switch, PRNDL sensor, and shifter mechanism? Before work was done, service writer said the steering column and the center console would have to be removed. I know when I go back to the dealer Monday (2.8.10) there will probably be denial, so I would just like to know in advance what had to be removed.
View 4 Replies
Cracked rear window from bottom center (on the driver's side just past the Dole light). Dealer says that they would have to sub out the install. That worries me a little, given antennae & other items hooked up on/near rear window.
View 4 Replies
I am in middle of "trying to" change the wheel bearing and I have the hub out but I can't figure out how this bearing needs to come out.
I have done it on MKIV Golf and like most other cars there is a C clip, but i can't see a clip in this knuckle.
Is this thing press fit in there without a clip? I have seen a guide for MKIV Jetta and people say Passat is almost the same, but not until I find this C clip.
View 2 Replies
Alright so, the oil pan in my 1999 Passat V6 cracked in about March, and then it cracked again today. I am wondering, is there suppose to be some sort of protective sheet that goes over the oil pan so that it's not just hanging out there to get mauled by any bumps in the road that come it's way.
View 23 Replies
I have a CEL. I don't have any special tools or experience but am not afraid to try something.
View 8 Replies
first, it was a crack. then not too much later a pop. a piece of glass fell out of the cracked lens. water in the housing = blown bulb.
I love the info screen that tells me the right fog light is out!
[URL]
but I HATE that when I went to my dealer to get a lens,
I learn that it's an enclosed fog light and it's $114.XX to replace?
[URL]
Any leads on where I should be looking for a replacement for less?
View 6 Replies
I'll be back to post the whole situation if the dealer doesn't make right on what I'm going through right now, but wanted to ask as I didn't find much searching, any issue with a cracked oil filter housing? I took car in for 30k service and came back leaking oil. Apparently part is back ordered and may take weeks. I spoke with ECS tuning and they said they don't have their aluminum filter housing yet for this model.
View 12 Replies
I was bleeding my brakes today and when I took off the wheel on the driver side, I found grease on my rim. I can't believe that my outer cv boot is cracked for a car with less than 57K miles.
View 16 Replies
My passenger-side motor mount is cracked out. Is this a common failure? The aluminum part that connects the "frame" to the engine mount is cracked, the hydraulic rubber mount looks almost new, not sure how the previous owner missed the crack in the aluminum. Car has 140K miles on it. I'm thinking about just having it welded up.
View 8 Replies
So the flexpipe on my exhaust is cracked and completely broken, so my passat sounds like a Mack truck. I've been looking into getting it fixed and I've been told i need to buy an entire new down pipe. Should i attempt to just get it fixed or buy a new down pipe.
View 4 Replies
New owner for a 2002 SC, Made mistake when lowering top to hit trunk button, top has stopped half open half closed Light on lose button is solid red and if pushed blinks red but nothing happens.
View 14 Replies
New to VW and to the Vortex. Last night I leased a 2012 Passat V6 SE, which is my first-ever DSG equipped vehicle. I am getting a significant hesitation on take off and also on rolling starts- almost like the power is being cut for half a second or so, accompanied by a little shudder. After that, it goes like gangbusters with fast and smooth shifts.
I understand the DSG functions differently than a conventional auto, but the delay is enough to affect my judgment in terms of pulling out into traffic. My salesperson told me that "they all do that" but I don't recall the issue in the others that I test-drove (may be due to limited driving time, last night was my first extended trip with the car). I also don't recall reading about this issue in any of the reviews of the V6 Passat.
View 13 Replies
My car has been acting up lately I don't know what's wrong with it but everytime I turn it on the sun roof will open half way I don't know y or sometimes interior lights wont work or ill have trouble opening the gas tank ... but the worse is that it just started raining a couple days ago and now my sun roof started doing, why?
View 5 Replies
2000 Passat windshield was replaced yesterday by an independent service station after being hit by a rock on Rt 22 in New Jersey. The new windshield is made by XYG (Made in China). The lower half of the windshield has incredible distortion -- looks like a fun house mirror. I've never had any kind of problem like this with any vehicle I've ever owned. I will, of course, call the repair shop tomorrow morning.
View 1 Replies
About half the engine is thin coated in oil, At least that's what it appears. It seems as though it it coming from the oil cap, and some long bar looking thing also on the top end of the motor. Is this a dealer visit about to happen? How bad is it at this point and should it even be driven??
View 21 Replies
I was checking the oil this morning before getting ready to drive (for an hour) to the in-laws for Christmas, and the Effing orange plastic dipstick tube broke about halfway down. Now I'm afraid to drive for an hour at highway speeds, for fear that a lot of oil might come out of that compromised Effing orange plastic dipstick tube part -- would you all agree that I should not drive the car? Figures this would happen on Christmas Eve when nothing is open.
View 6 Replies
I was checking the oil this morning before getting ready to drive (for an hour) to the in-laws for Christmas, and the Effing orange plastic dipstick tube broke about halfway down. Now I'm afraid to drive for an hour at highway speeds, for fear that a lot of oil might come out of that compromised Effing orange plastic dipstick tube part -- would you all agree that I should not drive the car? Figures this would happen on Christmas Eve when nothing is open.
Effing orange plastic dipstick tube!
View 6 Replies
So we were getting the annoying check engine light pretty religiously when we got to a half tank or less of fuel. In the trouble shooting I guess maybe there was a bad ground or something that required a little work then they told us the the intake flap motor was bad. Or at least was not returning the correct values.
So they ordered a new one and replaced it on Friday. I was looking at the paperwork, seemed like a fun job, pull the intake manifold, replace the part, put back together.
In the end, the experience with Emich VW in Denver was great. The service writer was awesome and you can even pick a tech to work on your car. I think that's a fine idea.
View 8 Replies