Tried to start it, it just cranks for a long time, it can't even hold an idle. After 5 minutes of cranking and trying to get it running, it starts up just fine like there isn't even a problem. It just started to happen today. I have a 2004 v6 2.6 glx, completely stock.
View 3 RepliesI have a 2002 v8 lse with 92000. When i go to start it after it has been sitting for 20 minutes or more it cranks for a long tome before starting. When it does start it idles fine but has a strong fuel smell. There are no codes and no problems once it starts. However it starts up right away in cold weather. It seems like a flooding issue. The fuel pressure is within range but it does seem to bleed off quicker than most cars i work on when the engine is no longer running..
Unfortunately I don't have the specs on on fuel pressure runoff. I suspect the fuel pressure sensor/regulator. I don't believe it would be an injector due to the fact it never runs rough or misses once started and if it was the pump it wouldn't give off a fuel smell in the exhaust once started.
Mine is toyota corolla - 2001 VE model. It has 116K miles in it.
It hesitates nowadays to pickup after a long idle time, say in morning when i start to work or when i leave from work to home(idle time of 8 to 10 hrs). I noticed this problem only during very high temp, say atleast 80F.
Hesitation will be there for 4 or 5 secs and will not move even if i give full acceleration, but after that it moves normally.
Car has automatic transmission and i only see this i put it to Drive(D or D2) and not when i do reverse.
So it often just cranks for 15 seconds before it fires. I put the fuel pressure guage on it and you turn the key on but don't engage the starter it goes to 30 psi then back to 0 in a 2 second time frame. It then stays at zero. when you engage the starter pressure slowly goes up and it starts running while running its a consistent 60 psi.
I presume its the fuel regulator but why does it not go up to 60 psi and why does it just stop with the KOEO? Is it reasonable to just replace the regulator? or should I be replacing the fuel pump to at the same time? I will be doing this from under the truck since there is a lot of hard mounted equipment in the bed.
The problem I'm having with this vehicle is that, it will start up just fine most of the time if I just hop in my after and haven't drove it for a while, however after I drive lets say 20 min+ and then decide to turn the car off and go back to turn it on, it just wont, it will turn over and its getting power but it won't follow through to start the engine, took it to a place by my house for 3 days and they said its probably the fuel filter but they couldn't give me a straight answer, what it most likely is? Its a 2001 Ford Taurus...
View 6 Replies2003 Ford Escape V6 ... So . . . my car runs fine almost all the time and I love it. But every couple of weeks when I start her up she won't hold a steady idle. Unless I hold my foot on the accelerator pedal she dies right out. I have had to limp home as she dies at each stop light. I have tried disconnecting the battery to reset the computer but it never seems to work. On the drive home, there will be episodes of misfiring after which the computer will reset itself. (The dash instruments go to zero and then back into normal range while I am driving down the road!) After a couple of resets, the car drives fine the rest of the way and continues fine for a couple of weeks (except for some misfiring at idle).
And at cruising speed there is a chatter behind the dash which sounds like its from the computer--very intermittent and only at around 45-60 mph--it only lasts a few seconds and goes away when I changed speed. The car is great in every other way after 104,000 miles. In the past 12 months, I have changed the thermostat, the plugs, the PCV, the fuel filter, and the air filter. A year ago both Brake Sensor rings cracked so I replaced both CV shafts. The crankshaft position sensor code came on twice and I replaced it twice. I do all my own work but I am stuck in a rut right now.
So my 2002 ford explorer with the 4.0 L V6, has been cranking along time before it starts. I thought i had this figured out already, i put a brand new fuel pump in it from the ford dealer. That seemed to work, but the problem came back.
Especially when it is cold, it cranks a lot longer than normal to start. and when it does start RMPS go way up briefly and come back down. Seems to only act up when its cold out, say 35 degrees and lower.
So the remote start wont work because it only cranks for a few seconds and then stops. it tries this three times and it gives up. i go out there to start it and cranks for 10 seconds it seems like, sometimes i have to feather the fuel pedal.
Grandson 1991 Ranger 3.0 v6 69,000 miles We have a long start issue after it has sat for 30 mins. plus. If you open the throttle part way while cranking it will start fairly easily. Fuel pressure comes up instantly when you turn on the key. It runs at 39 psi pull the vac line off regulator it jumps to 49 psi. Fuel pressure does drop to about 30 psi after setting an hour. It kinda acts like it is flooded when it starts. so far we have done a complete tune up plugs wires cap and rotor. The ignition module has been replaced twice last one a real Motorcraft. New fuel pump and filter. Cleaned the fuel injectors with Ford cleaning system. I will replace the coil next and maybe clean the iac.
View 14 RepliesA/C takes a long time to start cooling, but after it starts it gets as cold as it should. Seems to do okay while highway driving after it starts cooling. Is this a low refrig problem or do I have bigger issues?
View 3 RepliesI have a 2001 Ford Escape XLT V6 4X4. About 3 months ago I started to experience rough idle in the morning. It went a away for a month or so, but it is back now. I noticed that it occurs primarily after the vehicle has sat for long periods of time. More than 10 hours, give or take, and it happens, less than 10 and it generally doesn't. When the issue does occur it sometimes almost stalls. I can tell the computer attempts to make up for it usually. The check engine light came on originally but hasn't since, a mechanic could not pull any code and could not reproduce. The issue disappears within 3 to 5 minutes usually after everything seems to warm up. I'm had regular maintenance and I am an 75k. I've even tried using gas additives and tried a high grade of gasoline to no avail.
View 17 RepliesWhy when I am in hot weather it takes a long time for the a/c to start cooling off the car...
View 19 RepliesMy wife's Pathfinder (a 2002) has developed a problem with slow starting. The car cranks well (even at -20F, so it's not a weak battery) but takes a long time to start. It might crank for 5 seconds before sputtering to life. After being driven and shut off, most of the time, it will start up instantly again, just like it used to before the problem started. The problem is intermittent in that it sometimes starts pretty quickly in the morning, although it's not the instant start that it used to be, it might only crank for 1 second or less. I know that sounds like a normal time for a car to crank before starting, but the Pathfinder used to start, almost literally, instantly after the key was turned. So, even 1 second is an uncharacteristically long time.
What I've done:
-- Replaced spark plugs
-- Swapped the starter relays with identical relays under hood
-- Replaced fuel filter
What I haven't done:
--Replaced fuel pump
--Replaced fuel pressure regulator
Both of these are somewhat big jobs (I think I can handle both of them) and more expensive than what I've already done, so I'd like to get some input on where the fault could lie before picking one. Or, am I completely off base thinking it's fuel system?
Car does not have to get wet, just be in humid air. Problem going on 2 years now, mechanics tried disconnecting a (?) ground/sensor from computer, major tune up, new fuel pump. Until recently, it just took keeping it in crank position for a long time for it to finally start. Recently, in crank position for 30 seconds does nothing and has me worried I'm doing damage. In dry weather, it starts first time every time.
View 12 RepliesRemoved my oil rail to replace standpipes/dummies (04 Wavy rail) and now I have huge crank times to start. This is after the initial Huge crank to get it started. Do I have air in the system, or did I bugger something. I did the whole deal very careful. I lifted the rail up very carefully, pipes removed. I lined up the rail nipples with the injectors and evenly pressed it back in place, and then inserted my dummies/standpipe. Tightened the rail to 120 inch lbs then the dummies/standpipe to 60 ft lb. I did my son's '06 a month ago with no troubles. (didn't remove rails though). Once running it sounds perfect, turn it off and re-start and it's a long crank (30 seconds or more). I have not monitored ICP/IPR while running, will try that today.
View 8 RepliesI've noticed that after sitting over night my battery for the hybrid system is not charged enough to operate the car in EV or for the first mile or two it does not seem to use as much electric power to supplement the car. After a couple miles it is charged or near charged and I see more use.
View 5 RepliesAbout how long do batteries hold up in this truck? I ask because in my 06 6.0 it was an annual event 2 batteries and an alternator.
View 14 Replies2005 5.4L She would have a hard time starting before but after I replaced and fixed everything below she was running really good. Now back to sputtering, taking a long time to start and now not starting at all.
I have replaced; Fuel Pump, Fuel Filter, FPDM, Plugs and COP's, FRP Sensor, followed the power wire from the FDPM and found it corroded bad so I replaced it, also changed the ground location on the FDPM, I have checked all the wires from the FDPM to the drivers seat, checked all fuses.
I have power to FPDM and I have the diagram for the plug but how can I test (hotwire) the Fuel Pump without lowering the fuel tank? What should be the voltage coming from the FPDM plug? not sure about pin 1 & 6.
How can I test the FRP sensor? what are the specs for voltage?
The starter cranks, fired a couple of time but will not start. Mechanic blames the key interlock ... Apparently the key contains a microchip that blocks starting... Does this sound right ?
View 3 RepliesI recently got my Mk7 1.8T manual brand new and have been wondering about the long cold start idle. It usually takes around a minute or two before the revs drop below 1000. Coming from a '04 Mercedes and '11 TDI Jetta, I can say those cars the idles dropped much faster. Is this normal with the golf?
View 11 RepliesI don't know what's going on maybe some body can shed a little light on this. If you hold the brake pedal down for a long period of time you can feel the pedal slowly go to the floor. So no problem I'll change the master cylinder bleed everything brand new fluid. Don't drive it much we let the sister in law drive it we'll I jump back into it the other day to go to Home Depot and once again I notice it still does it. Could the hydra brake booster be bleeding by or what's else could be causing this it's driving me insane. I really can't imagine the hydra booster causing a problem but it's new to me. I was thinking about bleeding the brakes again thinking there maybe there's air but I have run 2 bottles of brake fluid through how much more??
View 8 RepliesThe radio does not hold the time, resets to 12:00. Any answers/solutions?
View 5 Replies