Passat (B5) :: Whine When Turning Coming From Just In Front Of Pedals?
Sep 16, 2012
new water pump and tensioner pulley, power steering hoses have been tightened yet still making this whine. It did stop for a while after i topped up the p/s reservoir but its fallen below the required amount again and garage has apparently tightened the hoses so shouldn't be leaking.
Don't know if its relevant or not but when i make a left turn and begin to straighten up I hear a clunk sound (sounds like coming from just in front of pedals, not 100%)
View 2 Replies
Advertisement
First off, I just traded another vehicle for a 97 mountaineer, 5.0 v8 AWD with about 171k miles on it. Runs and drives real nice, but on occasion under normal acceleration i get a slight shudder when it shifts into high gear. The tranny fluid does look and smell a bit old, but not burnt. I plan on changing it if you think it would fix the problem and not cause more.
Also, I think the ball joints are shot. The camber is in on the front tires and i get some pretty good clunks when I go over bumps in the road. Steering wheel is tight. I jacked it up and tried wiggling the tires but i couldn't get them to move like that. I'm assuming ball joints still though right? And if so, how hard of a job is that for a DIY'er?
Also i noticed a bit of a whine coming from under the truck when turning into my driveway. Transfer case I'm assuming? What could cause a slight whine and how do i fix it? I plan on changing the fluid in that too.
View 14 Replies
Noticed a clicking noise when only turning left out of a parking lot today? What this could be? Sounds like it was coming from the driver side front wheel?
View 2 Replies
Have a moderate pitch whine in front end only when steering or turning to right. Gets louder w higher speeds but pitch is about the same. Thought it was a left front wheeling bearing. Also needed new pads and rotor. While doing the job noticed grease all over the lower ball jt. Discovered a tear in the outer axle boot. Net net replaced pads, rotor, axle hub assembly and axle complete. To my chagrin the noise has changed one bit. The noise also doesn't change when I put the car in neutral while traveling downhill. With the hope that I replaced the wrong bearing I have ordered a new one for the right passenger side. When I tried the 6-12 wheel rocking test on the right there did not appear to be any looseness.
View 5 Replies
About 3-4 months ago, I noticed a low-pitched "roar" or whine coming from the front of my 07, especially at 35mph and above. The pitch of the sound gets higher the faster I go, but its never a high-pitched squeal or anything, just a roaring whine that has gotten somewhat more noticeable as time has gone on. 184,500 miles on the car, Goodyear Assurance tires that will probably need to be replaced fairly soon but are certainly not bald, reasonable tread left. I bought the car with just under 160K, I've put about 25K miles on the tires, but don't know the car mileage when the tires were originally installed.
I had the tires rotated during an oil change about 6 weeks ago, which made little if any difference in the sound. I asked a mechanic I know (and trust) at the non-dealer where the oil change and tire rotation was done, he said to turn slightly left and right while driving to see if the pitch changes, which may indicate a front bearing problem. There was maybe a slight pitch change in the whine when I did that, if any. He said it might be the start of a bearing problem. I also don't notice any change in the pitch or unusual behavior when making turns.
So is this a tire problem or front/rear bearing issue? I'm going to take it to the mechanic for him to test drive, would I be better served going to a dealer? Given the car mileage, it could very well be a bearing problem, it would certainly be due.
View 19 Replies
Sometimes I wonder why I have this car serviced....I have a 2000 Passat V6, just had the timing belt, water pump and infamous ABS control module replaced. Also had problems with the secondary air system (I think that's what it's called??) - another mechanic identified a couple of blocked areas and repaired. So now, all of the flashing lights are gone, but there is a very high pitched whine that is pronounced when I'm turning and sounds like it's coming thru the steering column? Goes away after about 20 minutes driving - should I take the car back??
View 4 Replies
I have the most annoying high-pitched squeak/whine coming from my front left tire. For those who cant see the video, its making a high pitched, metal on metal noise... at all speeds... especially when making slight turns... my foot was not on the brake when the video was taken (coasting around the parking lot at around 10 mph)...
View 4 Replies
I have some whine coming from my front wheel bearings so I'm going to replace them both. I'm not sure if this had been done on my truck before, but I'm thinking so since I have Moog greaseable ball joints.
Truck has 250k miles on it. I'm going to check the pads, rotors and slide pins. Anything else that might need work? I'm sure the half shaft could use a once over, but I don't keep my hubs locked so they don't turn much in regular driving.
View 7 Replies
So I went to the car wash this morning and when I pulled into the stall I heard a somewhat loud rattle coming from my front drivers side wheel. It sounded like there were a couple stones in the cap that covers the lug nuts. That wasn't the case. It did it in reverse also. Before I take it to the dealer Monday morning. Its a 2011 F-350 6.7 Lariat 4x4 w. 32,000 miles. I also have have a little whine coming from the rear when I take off from a standstill.
View 4 Replies
I gotta a roaring noise coming from my right front while turning. Planning on replacing just the wheel bearings tomorrow & not the whole hub assembly(2008 2wd). Is there a thread that lays out the steps and other parts I may need? I've seen alot different stories on the net on how to do it. Everthing from I can press new bearings to I have to do 4x4 hub conversion. Seems to be some confusion.
View 2 Replies
I noticed over the last week that there was a pretty loud whine associated with turning the steering wheel. I checked the fluid level and it didn't seem low. I added a touch just to make sure. Took it into the dealership today and they called back and told me there's a bunch of fluid on the bottom splash pan. They haven't said what the culprit is yet. 46k miles on the car.
View 6 Replies
I have a vibration problem on my 2006 passat. while driving, i noticed that there is a knocking/rattling vibration on my gas pedals and sometimes i feel it inside the car during 60 mph at round 2000 RPM. I have been trying to figure it out but i couldn't seem to find the problem. Also, I hear a metallic knocking noise when i start my engine.
View 2 Replies
I have recently started hearing a knocking sound coming from the front of the car when i am turning. It does not happen with every single turn, but i notice it mainly when i am at a standstill and go to make a relatively sharp turn and give it a good amount of gas. Now I am not trying to do a burnout or fly off the line, but its not a grandma start either. slightly more enthusiasm than your normal daily drive start.
View 5 Replies
Experienced the crazy sounds coming from the front end when making a turns, like a squealing sound, 2000 Ex 4wd, truck in 2wd high axles are unlocked. replaced steering box.
View 3 Replies
I have a 2010 Mountaineer Premier AWD V8 47k miles. On acceleration there is a hum/vibration in the steering wheel and the gas pedal between 30-50 mph. This is my third Mountaineer and I have never noticed it on the others, I just got this one about 2 months ago. The others were V6 models but were AWD. When I turn the 4x4 to the lock mode there are various noises/vibrations coming from the front of the car while it accelerates and also when turning.
View 1 Replies
When I'm turning left or right I'm hearing a click-clack from the front, what this may be?
View 2 Replies
I originally own an mk4 r32 but my friend owns a 20th.. He recently lowered his car about an inch or 1.5 of an inch he might have a finger gap.. He is on jam coilovers all the way down in the rear and about 20 threads left up front.. There is a nasty sound coming from the front driver side when he is turning or going straight.. he still didn't do an alignment idk if that matters.. and he also miscounted the threads so his driver side is about two threads higher but he fixed that now.. he also doesn't have camber plates up front does this matter? he has 8mm spacers up front so he cant be hitting the coil.. also he never replaced his front strut mounts/bearings ...
View 1 Replies
Heard an noise coming from the front of the car when in reverse turning wheel and braking only happens when im braking and make some turns not all turns.
View 9 Replies
2001 F 150 5.4 V8 4WD. I have a weird creaking sound coming from the front end, sounds like the passenger side, whenever I turn right at any speed. What it is?
View 6 Replies
I have a clicking sound coming from the front right wheel, happens while driving straight or turning. My guy checked the cv boots, axle bolt, various other connections that seem fine. Then he takes a phrase out of Satan's handbook and says "take it to the dealer". I saw the horns on his head and the red eyes while he was saying it. So I made apt for next week. I don't think it's anything serious , Orr maybe it's something to do with the rotor, caliper, break pads ? Everything else seems tight.
View 3 Replies
I originally own an mk4 r32 but my friend owns a 20th.. He recently lowered his car about an inch or 1.5 of an inch he might have a finger gap.. He is on jam coilovers all the way down in the rear and about 20 threads left up front.. There is a nasty sound coming from the front driver side when he is turning or going straight.. he still didn't do an alignment idk if that matters.. and he also miscounted the threads so his driver side is about two threads higher but he fixed that now.. he also doesn't have camber plates up front does this matter?
View 3 Replies
