Passat (B5) :: V6 5 Speed - Hard Shifting / Slam Between Gears
Dec 12, 2007
Hard shifting from the car. sort of a slam between gears and while in gear.
Possibly a mount?
Hard shifting from the car. sort of a slam between gears and while in gear.
Possibly a mount?
So I put in a Neuspeed torque arm insert, and that has worked with shifting from 1st to 2nd when accelerating hard. But in my '96 Jetta M5 speed I could throw the shifter around into any gear (except 1st if going fast) at any speed.
With the Passat what I find is that I while I can move quickly to a particular gate, I have to enter the gate slowly. I am thinking this is due to having 6 speeds (narrower gates to fit in same space so I have to be more precise), but then I wonder.
When shifting normally, it is very smooth, it is just when I try to shift fast that I notice this. And it happens even when I am shifing fast "but not" accelerating and the engine is not under load. So this happens when I try to downshift from 6th (at 2,000 rpm) to 5th/4th. Notice this when I am doing 50-60 in 6th and then try to quickly drop into a lower gear to get through a yellow light before it changes.
The solution has been to shift fast to the gate and then slowly push it in, but I still have the old reflexs from the Jetta were it was one fast movement.
Lately when shifting gears, there's this clunking noise as I let off the clutch. It happens more often than not when I'm in traffic and I upshift without giving any gas on the clutch release. Currently got 13k km on my car.
View 1 RepliesI have been trying to self diagnose an issue with my pick up for a while now. I have an 01 Silverado 2500HD 6.0 that shifts really hard into all gears. I was told it was the transmission going out, so we replaced the transmission with a rebuilt one and it did nothing for the shifting issues. We then had the transfer case rebuilt which also did nothing for our problems. My father who has some general mechanic knowledge is certain that the free floating rear end is not turning with the correct timing for the transmission shifting. No check engine lights come on at all during these issues. When I took it to a mechanic he told me I needed a new transmission and blew me off when I told him it was just replaced.
View 3 RepliesMy 2004 Forester (73000 miles) with 5-speed manual, is sometimes hard shifting into gears. The Subaru agency says that there's 'not much left' on the clutch and I need a new clutch @ $1300. Does hard shifting , no clutch slipping, indicate new clutch is necessary?
View 5 RepliesThat said my wife bought a 2001 Accent 1.6L Auto while I was overseas and it's been a great car, about 8 days ago it just crapped out. The reverse went out on her so we took it to get the codes read and on the way it went in limp mode, started hard shifting between gears and wouldn't go over 45 she says. Took it in to the stealership today and they said that the trans is shot as well as showing codes for P1527, P0732, and P0734. I know what the two slippage codes are and I can prolly just replace the speed sensors and that will be fixed but I'm not sure about the reverse and P1527.
View 4 RepliesMy sonata 2012 with 71K km on it just started hard shifting in the morning, after first start. It slamming in D from R very harsh and then shifts all other gears for ~3 minutes harshly (upshift / downshift) and then it gets fine and shifts gears with absolutely no problem throughout the day. Dealer of course was not able to reproduce the problem.
View 37 RepliesIssues with the transmission in the 2000 Century. My car shifts perfectly fine cold, but once it warms up it shits hard between all gears. Downshifts are never an issue, just up shifts. To me this sounds like both shift solenoids may be sticking or shot... I have already drained the fluid and changed the filter, added lucas tranny stop-slip, drained that out and replaced fluids again... no codes to go by and no high revs before shifts when accelerating...
View 5 RepliesI have a 1991 bronco with a 351w and the e4od trans.. The transmission is shifting late and hard and sometimes when i let off of the gas to slow down it shifts between gears up and down by itself... The only lights on the dash that are on is the Rear Anti-lock brake light and the speedometer is not working either.. Where to start the trouble shooting to fix it?
View 3 RepliesI have a 2006 Chevy 2500HD with about 180000 miles. All of a sudden the transmission is shifting extremely hard at times. It doesn't shift this way all the time. What could be causing this problem? It doesn't have to be under hard acceleration either when it does shift hard. It sometimes is during hard accelerating and sometimes it is under very little acceleration, but as I said it doesn't do it every time. When it does shift hard, it seems to do it in all gears.
View 1 RepliesI've had 2 Elantra 2012 models 1 a gls the second a limited. As far as transmission issues both Elantra's from a cold start after allowing RPM's to idle down before taking off they both have started shifting hard going from 1st to second gear 1st car was around 8-9 k miles now 2nd started at 3 k miles. Since owning 2 cars same make same year same transmission and many times to dealer 1st car ended with Transmission replaced 2nd has now started doing the same thing they reset adaptive and next day did it again its now back at dealer waiting for them to diagnose again.
View 13 RepliesMy trusty 1994 Ford F150 is starting to show her age, I think. I'm noticing a few issues:
1 - most concerning to me is she jerks pretty hard when shifting through the first few gears during relatively warm weather. The cold snap has abated the issue for now. Had the transmission fluid checked - mechanic said it's fine.
2 - This is a fun electrical issue. I'm driving down the highway when suddenly the cruise control shuts off, as does the speedometer and the digital odometer. The Tach still works, as do the rest of the gauges. Maybe 10 - 15 minutes later, they all come back on. It's done this a couple times.
3# - Really annoying but very minor; when I push down on the foot feed, there's a bit of a squeak in the engine. I'm guessing it's a tensioner pulley on the serpentine belt, but why it would only happen when I give it some gas?
So I have a 1995 f-250 4x4 with the 460 and a E4od. So when I bought the truck I drive it two hours home and when I got into town it started shifting really hard and searching for gears. So I flushed it and installed a new oil filter because the oil in it was brown. Very brown. And smelled awful. So it shifts good, but what's happening now is that it shifts good in drive when it wants to.
In the morning it works great but when I get in it to leave after school it shifts really late (around 2900 rpm) and hard. So I put it in first and then into second but when it's time for third and I put it in drive it shifts back to first. But if I stop shut it off for a few minutes and turn it back on it works fine. It only does this after it's been sitting in the school parking lot all day. I replaced the mlps but not the connector due to I didn't have time at the moment. Could it be the tps? Something mechanical?
i have an 06 passat in manual, to put things short i was racing a friend last year on the highway and went from 5th to 4th at 120 thinking it was 6th and let the clutch grab ...needless to say i messed up the clutch and 2nd 4th and 6th gear felt like i was shifting into oatmeal if the RPMs were too high, BUT they would still grab.
thinking i only messed up the clutch setup, i went and got a clutch masters stage fx300 stage 3 kit with the steel flywheel (plan on going big turbo by summer)
after the shop installed the clutch, im getting the same results, better grabbing from the clutch in all gears EXCEPT FOR 6TH! 6th wont engage at all
so now im thinking i actually damaged the actual gears.
My buddy's 2001 7.3L F350 has had 3 transmissions. Rebuilt and used. Once the new trans is in he goes like 15 miles and then is starts shifting hard and grinding gears. What this could be?
View 8 RepliesI need to know if this is considered "normal" behavior of the transmission. This cold morning while driving in traffic the car just jerked really hard while shifting from 3rd to 2nd and as described in other threads its like someone rear ended the car.
It has only 2650 km, it's a 2012 2.4 6sp automatic 4wd Santa Fe, should I waste my time going to the dealer? It only happened once, no engine light no nothing. Could it be just a "glitch" in the ECM? I read some other threads before posting, but they were a bit older. Has experienced such a shifting bang under low speed with so little mileage?
It only happens sometimes, but definitely everyday. I have an 06 Passat 1.8T and when i'm accelerating and it shifts gears from 1 to 2 it sounds like i have a really bad blow off valve, yet i don't. I can't see anything noticeable under the hood. I am thinking its the turbo inlet pipe.
View 3 RepliesMy car is less than 2 months old and randomly in low gears the car will jerk or lurch when shifting gears. Is this common or does this need to be looked at?
View 18 Replies2003 Passat 1.8t FWD.
My buddy is having a wierd issue that just recently started after it's gotten cold out. The car would not start for him so he had me look at it. Attempting to start there's no sound from the starter at all. Battery is fine. When I shift in and out of a few gears, the starter engages and the car starts. Stop the car. Attempt to start it again and nothing. Shift through the gears some more and the car almost starts but quickly dies. Shift some more, start, running like a champ.
What is it about shifting through the gears that allows the starter to engage and the car to run again?
When I used to change gears in my car it would feel smooth and precise, but just today when i was shifting in to 2nd, my gears started to feel clunky and like they were getting caught up on something. It feels like I'm not even engaging a gear when i put it into gear. Its so effortless and i don't get that secure feeling that i know i am in gear anymore.
View 4 RepliesAfter driving around hard for a couple minutes I got home and the car smelled like something is burnt then I went out to drive normally to get the smell out but didn't work. Then I realized my gears were hard to move into especially 1st, 2nd, 3rd. Its hard to change into those gears now. what could be the reason? What do i need to do for my gears to move smoothly again? I just got this car, my first.
View 5 Replies