So i cant figure out how to remove the radiator side of the upper radiator hose. I pulled out the pin but i cant remove the hose.
Do I just pull it straight out? Or do I twist and pull? I dont want to break the connection.
I smelled antifreeze when walking by my fiances Sonata, so I popped the hood and saw there was a small leak from the upper radiator hose, where it meets the thermostat housing. I adjusted the stock clamp, but the leak was much worse.
I swapped it out for new clamp that you can tighten, and all is well again. But, what I noticed when I had it off was that the metal neck of the housing was really corroded. Only 15,000 on the car, so I was surprised to see that the corrosion on the metal had already built up causing the leak (pushing the hose away from the housing). I scraped and scuffed to get it clean again, but just wanted to give you all the heads up in case you notice a leak in the same area. The antifreeze tested good and is really clean.
1991 Toyota Celica 2.2 liter standard water is boiling in upper radiator hose what could be the possible cause of this problem I have changed radiator and cap, water pump, radiator hoses and have flushed the system. could crossed hoses from engine to heater control valve and heater core cause this problem?The head has been checked and no exhaust gas was found in radiator fluid ...
View 4 RepliesAfter chasing the smell of coolant for a couple weeks, discovered that the upper radiator hose was leaking at the engine. Based on my schedule and drive schedule, and unfamiliar location this last week, I took my truck to the last people I wanted to - the Ford dealer, where they attempted to charge for the hose replacement. During this time I discovered the nature of how these hoses work and asked the tech why they don't just replace the O-rings ... "Ford Motor Company wants to sell you a new hose with labor" - a direct quote from the Ford tech. And that is why Ford is the LAST place I want to go for repairs I cannot perform. I kept the old hose - any spot where you can get the O-rings alone?
View 5 RepliesNoticed this past month on colder days my upper hose is collapsed, typically a symptom of a bad radiator pressure cap.
This hose is connected from the water pump to the radiator. The radiator is connected to the Degas bottle which has a nonstandard radiator cap.
Do these plastic caps vent the same way a typical cap does?
Cap for 2011 Ford F-350 Super Duty|9C3Z-8101-B
This weekend while towing a light load I noticed my FWT and EOT starting to climb rapidly, EOT reached 260 FWT I think about 240. I exited the interstate to find I had a busted radiator hose. I replaced the hose and filled the system with distilled water, but didn't add antifreeze at this time. The system wasn't completely empty.
I noticed once back on the road my EOT seemed to be higher than normal but FWT seemed to be normal. Could the lack of antifreeze cause a greater delta between FWT and EOT? I have seen articles which state do not use Ford Premium Gold Coolant, but to use CAT EL-1 coolant instead. Which should I use?
1992 3.0L V-6 RANGER
New thermostat
New Water Pump
I noticed the other day that the Upper radiator hose gets Sucked Flat when RPM is higher than Idle BAD it completely collapses IDK how it can circulate the coolant very well in this Condition. If the hoses have ever been changed But the Upper hose Really gets sucked flat. I've seen this a few times on vehicles that have been shutdown But they have always expanded upon startup and are fine....
The Lower Looks Fairly Old and only partly collapses under higher RPM.... I am going to change the Upper hose at a Minimum as its really Bad and probably a lot older than I am thinking and really Soft. I am just wondering if the radiator could be plugged up causing some of this.. Or anything else I should check into????
2004 4.6 V8 Trition ,two wheel drive, STX Pickup. By removing the bottom radiator hose, will that allow all engine coolant to be drained from engine? If not, about how much coolant will remain in the engine in terms of quarts or percentage of total vehicle coolant capacity?
View 1 RepliesI have 98 passat V6 and the lover radiator hose is leaking at the connector between radiator and the hose. Do I need to change the whole hose or is there maybe an o-ring that should be changed? How hard is to remove the hose? Do I have to go to the dealer?
View 2 RepliesI picked up a used 99 Passat with 79000 miles. I just changed the oil and found the pan pretty well sludged up - typical from what I read on the forum. I noticed the coolant looked pretty diluted - so I drained and filled with 50/50 mix. After starting I felt for the upper and lower hoses heating up and the lower one never did. I guess I should have tested this out before draining and refilling - also typical. Question is - is this a thermostat issue? My Haynes manual says if the top hose becomes hot the thermostat is operational. Heater has plenty of heat, temp gauge stays pegged at 190 degrees top dead center of the gauge.
View 5 RepliesI just replaced the engine in my F--150 with one from a van that had only 60K miles on it. It still runs rough and misses. Not as bad as the earlier engine that had dropped a valve. While trying to find the problem, I moved a large vacuum? hose at the rear of the engine maybe 1 inch diameter and it nearly fell off the barb at the back It is also connected at the other end to some type of small metal can. When I pulled on this it fell off and the engine died.
Also need the smaller 5/8 in diameter hose at front of air intake tube. I need a size or a pert number for this hose as I cannot crawl back onto the motor very many times due to a spinal problem. I would like to get this hose and then get under the firewall only one time. I am having issues with this truck, bought is used at auction running rough. Replaced engine with one that was supposed to be a good one, but it runs rough again..
I need to add that New platinum [plugs were installed and the coils were off the old engine that had maybe 50 miles on them and were from NAPA. I only hope htis hose is my problem. However I cannot find any part number or anything on it...
I have a 2008 Camry SE with JBL. I was wondering how do you remove the front upper speakers that are in the dash. I looked around but everyone show the front door removal not the upper speakers.
View 4 RepliesI'm in the process of changing the wheel bearing and took the brakes, disconnected the sway bar, and other large bolt but can't get the upper control arm disconnected because once the nut gets to a certain point, the ball joint starts spinning with it. Tried holding the bolt at the bottom with vice grips and it still turns. I'm thinking I might have to take off the whole A arm if I can't get this nut off.
View 1 RepliesI'm trying to remove the upper control arm on a 2004 F-150 2WD. I took the wheel off, and it looks like I can't get the bolts off that attach to the frame off without taking out the shock and "coil over"? Is this the case, or is there another way to do this?
View 9 RepliesI have an '08 250SD diesel. The upper hose that goes onto the water pump has a leak. Is it usually just the Oring or the hose plastic fitting?
View 2 RepliesI have an 03 super duty with the 6.0, came back from vacation with my 5th wheel in tow. Lost the upper turbo hose twice on way home. Managed to get it rigged and made it home and parked it. a week later went to uncouple and move the truck and had some very strange issues. Started fine but could barely make it up driveway (no trailer at this point). No power, felt like when turbo hose came off. Got it moved and checked turbo hose and all was good?? Went out a couple days later and no start.
Checked all relative fuses and relays and all checked good. Jumped starter solenoid and starter worked fine. turned key on and jumped quick connect on right side of engine compartment to battery and it fired right up and ran. Jiggled shifter around in park and neutral and nothing. BTW I always here the relay clicking and swapped with one of the others just to be sure, same thing. After looking on the internet for a day and a half thought maybe a NSS in the tranny but I think I have the 5R110 that does not apply??
My upper radiator outlet broke off when we were removing the upper hose(plastic tank) . is there any way to repair this ? I was laid off and cant afford a new radiator right now. but with it being the outlet I don't hold much hope...
View 3 RepliesI am in the process of installing a 6" pro comp lift on my 04 supercrew 4x4. Things were going good until I got to the upper strut bolts. Trying to remove the 3 nuts, one came off on the passenger side. The other 2 just spin, the bolt and nut. Haven't tried the drivers side yet. The only idea I had was making a notch in the top with a dremel tool and small cutting wheel for a screwdriver but my dremel tool smoked..
View 5 RepliesWell I was fueling the truck today and I opened to hood to check it out and noticed that there was no pressure in the cooling system by squeezing the upper hose. I did have a spare degas bottle cap and removed the old one slowly and replaced. I have been driving over 30 minutes and it is close to 100 degrees.
I then drove on down the road, the truck is not getting hot. I stopped to look at some running boards and the truck was running and then I came home and still no pressure, the truck is still running, I removed the cap and no pressure, I then removed the small hose going to the top of the degas tank and no coolant came out. I turned the truck off and disconnected the upper hose and some coolant did come out.
Is this normal? The truck runs just fine, just has me worried. I just bought the truck and the previous owner recently replaced the water pump, T-stat, hoses, etc. All parts were bought at O'Reilly. So everything looks good.
It doesn't look anything like the illistration in my Haynes book.Where are the bolts located and how many?
View 14 RepliesOk I have a 97 f150 4.6L. My radiator has been bad for a while. With brown rust color. I replaced my radiator, thermostat, new upper and lower hoses. Everything runs great but I have no heat. I flushed everything including the heater core. Core is not leaking into cab, and both heater hoses are cold. What should I do next FYI heat worked great until 5 days ago.
View 14 Replies