Passat (B5) :: Strong Jerk And Car Shudders When Move Shifter From P To R
May 18, 2009
I ran into a new one with my 2000 1.8T Auto. When pulling out of my garage when I move the shifter from P to R, I felt a very strong jerk and the whole car shudders. Same from R to D. I drove straight to AAMCO which was the nearest repair shop. Although the drive was smooth (no additional noises etc) the acceleration was noticeably slow.
Recent work on the car:
-Timing belt replacement 3 months back.
-Battery replacement last night.
Engine light is on and came on 2 days back.
View 13 Replies
Advertisement
I'm experiencing a weird problem with my 09 Santa Fe (just under 15k miles). A few times, while in slow and heavy traffic (and ONLY then) I experience a hard jolt or jerk. The 1st time it happened I thought someone had hit me in the rear but that was quickly ruled out.
I suspect this has something to do to do with the tranny. Though it occurs maybe once or twice monthly, I am beginning to have concerns and suspect that the problem will get worse with time.
View 7 Replies
Our 2001 mazda 626 has begun to run rough(shaking the car) when idling at a stop sign or stop light and once that begins when we push on the gas to move from 1st to second there is a huge jerk. If the air conditioning is on it is worse. It is an automatic.
View 3 Replies
I drive (or more recently used to drive) a 2002 VW Jetta which has been having extreme difficulty running correctly during moist weather. Initially, upon start-up, I will note a severe problem.... it seems as if it's shaky, very shaky, and does not want to move. Upon trying to move it ignoring it's obvious signs, it does not want to take when I push in the gas....seeming to jerk or move incredibly slow. Usually feeling as if I can barely get it to move a 10 yards or so before being too nervous to push it any further. These issues seem to exist far far far more frequently in wet or moist weather (even a day or 2 after it has rained).
The car has always been well taken care of. What are the possible causes, then I might have some better luck requesting services upon calling mechanics around the area.... I am currently in college, away from home, and I absolutely cannot afford to get "nickle-and-dimed" by the dealership over every possible minor detail which could POSSIBLY need some tuning-up. It currently has just over 100,000 miles and has never had any major replacements.
View 5 Replies
So after owning my R for just over a week I've noticed that when I accelerate hard or let off the throttle the shifter seems to move quite a bit. Is this normal with the stock mounts or is it something I should have looked at? I know the stock mounts are rubber to aid in isolating the vibration of the engine but it seems like the shifter moves a little more than I would expect.
View 1 Replies
Corolla '04: I have to press the brake pedal extremely hard to get the shifter to move out of the Park position.
View 5 Replies
What this may be. 2004 Accent Automatic. We just purchased recently for my daughters fist car. Today when leaving the house the car stays in first gear, you can move the shifter through the gears but it wont shift up. Reverse is fine. Checked the oil level in Neutral when hot and it was ok. Hooked up my code reader and there are no Codes. Car only has 85,000 KM on it.
View 5 Replies
I need removing the console on a 2005 Malibu Max. The switch on the shifter will not move the transmission down to 2nd or 1st gear. There was a post by "shadow5599" on 05-05-2009 stating that this problem was caused by a broken wire in the harness under the console leading to the shifter +/- switch. He said it was easy to fix but the console needed to be removed. Later on the same day he posted that he had just posted the instructions on how to remove it. I'm a first time user on this site and I haven't been able to locate those instructions.
View 1 Replies
Experienced problem with the Automatic locks on the doors? The doors on my camry lock as soon as I move the shifter out of park. The owners manual indicates that I can get the doors to lock automatically at 20 km/hr. I have tried following the instructions in the manual to make this happen but without any success.
View 14 Replies
2000 VR6 automatic. Yesterday my car was stuck in park couldn't move the shifter . Figured it was the brake sensor switch when the brake is engaged food pedal lights do not go out, I replaced it this morning but still won't work I've been driving it around in limp mode?
View 4 Replies
I have a 2004 2.0L Jetta with a 5 Speed manual transmission.
When shifting into third gear sometimes I push the shifter forward and it does not want to move all the way forward. It feels like I am pushing the shifter knob against a wall, or more accurately the bottom of the shift that pulls the cables feels like it is hitting a wall. If I pull it back out and press it in hard it will go into place sometimes.
This also solves the problem: While the shifter is mid shift into third, at the wall/ at the point of resistance, I let off the clutch slightly to give the flywheel some friction. This rolls the transmission a bit and allows third gear to slide into place.
I have experience with a MK4 Audi TT 1.8T that cam with a 6-SPD and it at had a 1-2 and 2-3 synchronizer issue (The one where the nipples are worn and it grinds at higher RPMS because they can no longer make a firm handshake). The issue I am experiencing is not that.
Could it be the transmission cables? Could it be some other cogs in the transmission? - If so does this mean I need to buy a used one? My car has 180K miles on it with the original clutch.
View 5 Replies
Here is what I have:
2009 Santa Fe 3.3L AWD
70k KMs / 43k Miles
Temp has been very cold, -20C / -4 F
Car starts up without any problems. Try to put car in Reverse and the shifter is very hard to move, if it moves at all. When I am able to get it into Reverse, I then try to put it in Drive and it does not "engage" the "D" and the car behaves like its in Neutral. Moving the shifter back to Park, Neutral, Drive is very difficult and sometimes it will not go into Park. The dash lights do not illuminate the selected P, R, N, D.
However, once the car is warmed up (no longer on C on the temperature gauge) I can with a little effort move the shifter freely (but more effort than it should take) and the car behaves normally. Gear shifts are smooth and in general it is operating normally.
The dash lights do illuminate the selected P, R, N, D. I've checked the Trans fluid level and it appears to be normal and was planning to change it this w-e but I'm no longer sure it will work. Even if it has never been changed.
Also note that I have recently changed a wheel/hub bearing due to a noise that sounds a lot like loud tires on a highway. The bearing change did not eliminate the noise and I assumed that I've changed the wrong one. The noise does not appear to be coming from the Trans, but I cant be 100% sure. The noise is speed related and occurs only after about 20KM/h 16MPH. Unsure if they are related..
View 3 Replies
Got in to go to work this am, and the gear shifter was difficult to move. What to check?
I drove 70 miles to work and didn't seem like any issues with the transmission shifting.
Got in to go to lunch and it seems even more difficult to move...
Shifting back and forth in the selector seems to loosen things up a little.
A friend move the selector while I looked at the linkage and the bracket that support the cable is flexing while shifting between gears....More likely a transmission issue or something with the linkage?
View 24 Replies
Drove to work in 6" of snow in 4H with no issues. Shifted back into 2H for drive home as roads were clear with no issues. Went to shift into 4H moments ago and floor shifter will not move!
View 1 Replies
This morning as I get in to drive my kid to school (2005 2.7 2 wd auto) as I go to put it in reverse I noticeably have to pull it with some force. I have never had to "force it" before, it had always switched gears with ease. This time it felt very stiff but had no issues going into gear. After I dropped my son off at school I went through the gears up and down and it felt very stiff (at this point i have no issues with starting it or P).
At lunch I go out to get something to eat and when I go to start it up it won't start. I try and try and nothing. All the lights came on, it's not a battery issue at all (brand new). But after 10 tries it starts, so I'm pretty happy. Then I go to put it in gear (reverse) I can not press in the button on the side of the gear shift. It will not go in. I press with all my might and it wont budge. But again, after about 10 good tries at it goes in and I can then select my gear but still feels very stiff.
After stopping again I didn't shut off the engine and dicked around with the shifter basically figured out that my car is not recognizing Park. On the instrument panel each gear lights up but not P. It gets very stiff when trying to put it in P but it doesn't actually go into P. If I put it in P (or really the further up it will go) and shut off the car, it won't start again. I can start it up in N and only N.
View 9 Replies
I have a 09' 4cyl automatic engine with 54k.
About 30min ago when when I parked the shifter would not move past neutral into reverse and go into park. I can go from D into neutral or the next slot over for manual shifting. Naturally this causes a problem as you can't take the key out of the ignition if its not in park.
I took a screw driver and popped open the cap for the shift release button and used that to move it into park. Turned car off, back on, etc etc seemed fine. So when I tried moving it into reverse and it wouldn't budge. It instead would make a electronic click or snap coming form the steering column but more back toward the engine. Like more into the dash area but back in it. It would make this noise every time I attempted to move it but it wasn't a continuous sound. Just once with each jerk to the side to move it out of park.
So the car works fine except for this. I used it with the screw driver/shift release to unlock it and it drives fine. Goes into reverse and back in park but if I move it into neutral or drive it will not go back into reverse or park.
View 1 Replies
My 1996 Buick Park Avenue had problems finding reverse. You would have to move the shifter in and out of reverse and get it in just the right spot to go into reverse. once it is going in reverse you can hear a slight ticking sound like the park gear isn't totally disengaged. now it is nearly impossible to find reverse and when you put it in neutral its like it is in park.
View 2 Replies
So lately this has been getting worst. You have to step on the brake before you can shift out of park. Well lately I have to step on the brake a few times before the safety will let you get into gear.
View 7 Replies
My 2004 expedition wont go into any gear the shifter will not move I changed the stop light brake switch and a 30 amp buss fuse I found blown and also the check engine light is on now too this was after I parked it I also changed a 30 amp buss fuse I found blown out but it still don't work the only way I can get it into gear is to push the little button under steering wheel...
View 2 Replies
My cousin has a 2007 Ford Taurus with the pushrod 3.0L. It has the console shifter and it is hard to move the shift lever into Park from Reverse. The shifer moves out of park and to every other gear with normal effort. The gear indicator correctly displays the shifter position. It drives/shifts perfectly fine. The only problem is that it is hard to move the shifter from Reverse into Park. It feels like there is a rubbery, or somewhat mushy threshold/resistance that needs to be overcome with a moderate amount of effort to get the shifter into park. Once the shifter is in Park it feels normal meaning you don't have to hold or force the shifter to stay in park.
It is frustrating because it seems most other people have a problem with the shfiter being hard to move from Park to Reverse or Neutral, but she is having the opposite issue. Will it hurt the car to keep shoving the shifter into park when necessary without getting it fixed?
View 3 Replies
The transmission is a Six-speed MQ350 transmission in an MKIV 337 GTI.
I was driving last week and ran over a large snow chunk, heard it hit the underside of my car. A mile down the road my foot is resting on the clutch pedal at a stop light, and the clutch slowly went to the floor. It was still drivable, barely. The clutch came about an inch off the floorboard, but still caught. So i pull into the parking lot ahead of me, and was barely able to move the shifter left to right nor would the shifter go into gear. There were no fluids coming from under the car, nor could i see anything that looked wrong. I turned off, back on again. nothing. I then pulled the clutch pedal up from the floor and it went back to normal. Everything seems normal now, but the shifter seemed a little sticky yesterday from left to right.
View 6 Replies
