Passat (B5) :: Spinning Noise From Transmission When Shifting From 1st To 2nd
Mar 20, 2009
I've been getting a spinning/whirring noise from the transmission when shifting from 1st to 2nd. It only lasts a few seconds, and seems to occur between 1st and 2nd. Since the transmission is still covered under warranty, I went to a dealer. I knew I needed a new clutch, so I had to let the dealer do the clutch replacement in order to get to the transmission. Once inside, they found my release bearing in several pieces, as well as "damaged gears." VW agreed to replace the transmission, but I still have the spinning noise. The car has 96K miles.
View 1 Replies
Advertisement
My cluch is almost 2 years old and gets treated with kid gloves , I shift low in the RPM's And accelerate slow for smooth shifting and fuel savings (17mpg avg.). But as of yesterday I can here the gears wind up after I push the clutch in. No problems with power or gear handling , Just the sound of the gear(s) (low dry rev/wind sound) No visible leaks , Clutch has oil at the step mark. Also - I can Make The Trans create the same sound if I keep the clutch petal in and rev the engine.
View 3 Replies
It has been raining, finally, in bay area, thats the good part. The scary part is that, today I was driving normal close to 15mph and took a left turn at a traffic light and the car spun out. This was the second time in couple of months. Both times it had rained for long periods, road was not water logged.
First time had spun out of control on right turn and second time on left turn. Tires are close to 30K old. Wheels aligned 6k back, rotated 1k back. And passenger side CV makes clicking noise occasionally. Do not remember, the CV making the noise around the time of spin out on both occasions.
2000 Passat 64Kmiles.....
View 5 Replies
So yesterday after running an errand I got home, after having dinner I was about to head out and, SURPRISE! The car wouldn't start... The engine doesn't turn, no lights on the gauges when inserting the key, no clicks.... the battery seems fine, as the radio works, the anti-theft/alarm works well, the 2nd key behaves the same way.
This morning, I called VW road side, the tow truck they sent couldn't take the car because it is in a tight spot and we can shift the car to neutral. We tried resetting the ECU by disconnecting the battery without success... What to do??
View 2 Replies
I've got 95k miles on my 2001.5 and have been noticing that the transmission seems to shift pretty hard. Today it seemed like it was hardest in the 3rd to 2nd downshift. I got it checked out a couple of months ago and the dealer said it was the throttle body (which I haven't cleaned yet).
View 5 Replies
I have the 2000 passat 1.8L 4 cylinder with the tiptronic shifting. The car has been shifting less smoothly both upshifting and down. I have noticed that if you are going fast and slow suddenly, say for a light and the downshifting does not go smoothly the vehicle can lurch/jump even if the brakes are firmly applied.
What may be causing this issue. I recently sold my MKIV which was a great car and we are now starting to have small problems with this passat with 104,000 miles on it. It does not intuitively feel that the tranny is worked over yet, but I would like to avoid any expensive repairs/replacement. I have done everything from suspension, door replacement, clutches and timing belts on other vw's. So I am hoping to tackle this myself.
View 5 Replies
I've been noticing that my 2012 Passat TDI with 125,000 miles, hasn't been shifting to 6th gear when driving down the highway. I've actually noticed it's one gear too low even when driving down city streets. We have been experiencing extreme cold weather in Pennsylvania, so perhaps that's a factor.
If I manually shift to 6th gear, it stays in gear, but it appears that the engine RPMs are a bit lower than usual as well, but I could be wrong there.
View 2 Replies
Today when i started driving my car this morning the tiptronic just stopped working....I can shift into the manual column, but when I try to change gears, it just does nothing. I can't even tell if it works intermittently. It shifted up when i was trying to shift down in a few cases. When this would happen, the gear numbers would still pop up on the dash to tell me what gear i was in. Sometimes when I slide it into the manual column, it just remains in "auto mode" if you wil entirely.
The numbers don't pop up on the dash signaling manual mode, and trying to shift does nothing. I even had one moment where it was in "manual mode" when the selector was actually still in the automatic mode. There doesn't seem to be any rhyme or reason. Sometimes it goes into manual but just wont shift, and sometimes it wont even switch to manual mode. What would cause this? It seems like such an odd problem, I would assume it's electrical...
View 2 Replies
I have a 2007 Passat wagon 4 motion V6 and what the problem is I am getting a rough shift between 3-4 gear sometimes, usually on a slow acceleration. I have had the valve body replaced which worked for a couple of months until the problem returned. I then had the transmission replaced which worked a little but the rough shifting is still present at times. The car still has warranty and not even the dealership knows what to do?
View 12 Replies
I bought my '07 Passat 2.0T Wagon as a CPOVW 6 weeks ago. It had 4700 miles on it. I complained about the transmission having a delayed engagement when shifting into reverse and drive. (it drives normally however with positive shifts and is very enjoyable) I was told it was normal and not to worry. (could it be designed-in to soften the engagement?).
This week I noticed a light "thunk" in the right front when re-applying power while coasting below 40 MPH. I never noticed it before but I usually strive for smooth driving so that may be why. I've had other Aisin Warners but they were in Volvos. I got out of a '99 Volvo Cross Country because I didn't trust the driveline. Am I going down the same road?
View 14 Replies
The first thing is that suddenly there's a clunk type noise from the transmission when shifting in to or out of 2/3/4. Also, when I'm in one of those gears, letting off the throttle and then re-applying lightly causes the clunk noise. However, I haven't noticed any actual performance difference, just the new noise. It's loud enough that I can hear it over the radio at a reasonable volume, and it may or may not be my imagination but I think I can feel it through the floor of the car.
The next thing is that in the mornings, the car seems to have trouble getting in to gear from a stop. So I'll pull up to a light, then stop, and if I take off the brake and get immediately on the throttle, the car will lurch pretty bad, even if it's only a little throttle. I've found that if I let off the brake, and wait specifically to hear/feel the transmission kick in, there's no lurch and everything is fine.
Also, on that same note, sometimes when I let off the brake at these times, the car nearly stalls. It hasn't stalled yet but it's felt close a few times.
As well, from a cold start, there is what feels like an absolute ton of engine braking in second gear, I can feel the car pulling back immediately after I let off the throttle, and this seems strange and new as well.
View 8 Replies
I just had all the plugs and wires replaced on my car. The mechanic said this (MAY) fix the problem.I am still having a problem with the car shifting very hard,and make grinding noise coming from the rear. It sounds like the transmission is falling out! Does it maybe the clutch sensor. I have had it to 2 shops and analyzed, and they have no clue.
View 4 Replies
So My 2002 only has 27k miles so I'm hoping it's nothing out of the ordinary. I understand that the transmission will make some noise in shifting but I'm noticed a pretty solid "clank" when I shift especially from Park to Drive or Park to Reverse. Just wondering if other drivers have a similar experience? I remember my last car had a sort of "ratchet" sound in shifting and I've grown accustomed to this "clank" now, but just wondering of others have the same clank? If not normal, what should I look into? Also before it's recommended, I know it's not the brake caliper clips as the "clank" occurs before actual vehicle movement.
View 5 Replies
Overall, my wife and I like the car. It feels solid, and so far we have about 950 miles on it. Today though, something weird happened.
I was driving, and we were getting on the freeway after crossing an overpass, so it the on-ramp was one of those sweeping, downhill, 270 degree curves to the right. Nothing out of the ordinary.
So I let off the gas, and I'm taking the turn, and there was this "thump!" noise - almost as though the transmission was shifting. The car shuddered. Then it did it again.
It was disconcerting, almost reminiscent of our wacky dual-clutch transmission issues we had with our 2011 Ford Fiesta. Now granted, its a bit of conjecture since I don't know what could have caused it. I wasn't going quickly enough where any stability control mechanism (ESC) should have kicked in... so I'm not sure what else could have caused it. Undoubtedly I'll be testing it again to see if I can reproduce it, but its got me concerned.
View 43 Replies
Our Rv makes a strange "clank" noise whenever we shift into drive. It is a 87 Ford Econoline 350 with the 460 7.5l. The noise is from the back of the Rv kind of near or in the rear differential. It just started over this past weekend.
We live in Alaska and the mechanics are 3 hours away - do you think we would be able to make it to the mechanics and not have to get a tow? How long we could go without fixing the problem?
View 3 Replies
So I need to get this top nut off the strut and as you can see the strut mount is just dangling there, the spring is compressed and everything is ready to be removed - even when I use pliers to hold the shaft tight from behind the strut mount, the nut still spins freely, but refuses to come loose. It spins freely in either direction - won't tighten, won't loosen.
The strut has barely 4k on it so I didn't think the threads were the problem, rather the nut itself I assumed.
View 8 Replies
I posted awhile back about a loss of power and hard shifting in the transmission. I thought I had it fixed, well I kind of did...... Replaced the IWE that had locked in solid. I replaced both, added some transmission fluid, new front brakes, and a new belt back in July/August. Truck was fine for a few thousand......
Well it's back. Now I have a noticeable whine in the cab. I haven't pin pointed it yet. It is only audible when the truck is running from 35-50 mph. It is not RPM dependent, it doesn't change when I take it in or out of four wheel drive. It isn't there when the truck isn't moving.
The truck has 61,000 on it. I bought it with 35,000 on it because I wanted a vehicle that wouldn't nickel and dime me. Something I could climb in and not worry about making home.
Well here I am less than 30,000 miles later and I have had issues with the fuel controller under the bed, brake calipers sticking, IWE's, new shocks, broken front coil spring, recall for the airbag, tie rods, ball joints, power window regulator, and now what appears to be a transmission.
I come from a long line of "FORD" guys, but I am seriously considering something else. This 04-08 model has to be one of the worst pickups ever built by ford.
Are the newer ones any better? Other than routine maintenance a vehicle shouldn't have to be touched before 61,000.
View 4 Replies
I have a 15 Passat and when shifting to reverse. I get a gear or a bearing like noise, not actual gears grinding.
And when I pump my clutch it goes without saying there no issues at all. So now I pump the clutch and go into reverse. The car has 6k only, should I bring in for service or it's me.
View 11 Replies
I was cleaning my passat the other day and I took my air filter out, however I didn't disconnect the wires and hoses on top of the box, I just raised the top cover up and pulled the filter out and cleaned it and checked it and put it back in, I also took out the cabin filter out and cleaned it and put it back in too, then I started the car and took it for a ride and the car started over heating, it keeps giving me STOP CHECK COOLANT warning and the temperature rises all the way to max RED.
I check the coolant level is at level and the radiator fans are spinning, however I noticed the lower hose that goes from reservoir to the radiator is cooler than the other hoses, what could be the problem? The water in the reservoir is hot too, could this be from a faulty thermostat? a sensor? or somewhere I read there is a fuse somewhere in the engine bay? I'm not too familiar with these 1.8t engines, the temp sensor was acting funny before too like sometimes it would go all the way to zero and stay there and go up and go down to zero and then raise, which I think there might be a bad connection or bad sensor.
I forgot to add the car is a 2003 1.8T.
View 14 Replies
So I just replaced my oil pump and i am reassembling my front end and I just cant get my passenger side engine mount bolt to stop spinning so i can get the nut on (the mount underneath the car) , I have no clue how to stop the spinning
View 1 Replies
So far I've been through 1 set of tires (after 12,000 miles), stepper motor, new cd changer, trouble with TPMS system and more Now that my stepper motor is replaced (dealer said he wasn't aware of any widespread trouble with this part, what a joke) I hear a humming noise, constant from rear axle area, drowned out by engine while driving. Noise sounds like a fan spinning or electronic interference you might get if your cell phone is close to a computer or tv with volume off. I don't recall this noise previously although I rarely drive this car it's my wife's.
View 5 Replies
