Passat (B5) :: Increasing Oil Smell When At Idle After Engine Is Warm
Jan 26, 2009
After almost 9 years, 130K miles on my 2000 GLX wagon 5-sp., for the last 6 months I'm noticing an increasing oily "smell" when at idle after the engine is warm. Other posts suggest it might be a leak in rear cam seals or valve cover gasket dripping small amounts of oil down on the exhaust system. There's been no visible oil leak when the car is parked and it does NOT "use" oil between every 5K changes. Is replacing the valve cover gaskets a job within the reach of a moderately experienced DIYer?
View 3 Replies
Advertisement
I have a question about smelling burning oil. I have a 2005 passat 1.8t (4 motion) with 80,000 miles. Once in a while I smell what smells to be burning oil. It usually happens when the car is warm and sits and idles for a min. like when you would be at a stop sign and doesn't last long. There doesn't seem to be any blue smoke coming from the exhaust either....
View 5 Replies
Acquired a 1997 Subaru Legacy a few weeks ago. Drive it for a prolonged time in the heat, at speed, and you can smell warm coolant from the engine compartment. And the temperature gauge hovers in the middle of the dial, no matter what.
My wife explained the smell away by guessing she'd spilled coolant when she topped it up. But it's been weeks since she did that. Also - this sucker drinks coolant. I'm guessing every 2-3 days I'm adding another gallon.
It occurs to me that ... maybe .. a leak on top of a pipe so the coolant doesn't drip out, but the loss of pressure (from the hole) causes the fluid to boil and flash out? This might explain the 'higher than I'd like to see' operating temperature.
View 5 Replies
Whenever my Passat is at idle I smell gas and it gets stronger the longer I'm stationary.Would this be part of that gas tank recall earlier this year or something else? VW didn't send me a recall notice on this.
99 Passat 1.8T
View 7 Replies
Here's what's done to the car so far:
Evoms CAI
Autotech HPFP Insert
UM Fully Loaded Stage 2
Magnaflow Catback
R8 Coilpacks
Now my problem lies in the fact that the car has an unusual "loping" idle once it's warmed up. I noticed it very slightly when I first installed the catback simply because that exhaust is louder than stock. Now with the tune it seems to be even more noticible and ocasionally the engine will stumble upon a warm startup. I've pulled up VCDS and looked at the timing measuring blocks during idle and it varies between 0 and 13.5 BTDC/ATDC, the lowest the revs go is about 700 and the the car idles most of the time at about 800. A few hundred miles ago there was a code for Fuel pressure too high (P0088) and an o2 sensor reading too rich (P2271), I saved said codes and cleared them and they have not returned.
View 8 Replies
Recently I have been experiencing some rough and low idles with my 1MZ-FE 05' Camry. The car runs idles perfectly fine and drops to the correct idle when cold, however if the engine has been running at normal temperature and started again soon after the idle drops extremely low until the throttle is opened.
I have cleaned the throttle body with with throttle body cleaner a number of times, although I haven't taken the IAC valve out and cleaned it separately. I have also heard that the Engine Coolant Temp valve may be going bad. Could my symptoms fit this?
I had a dodgy EGR sensor not long ago that was giving me rough idles on a cold start, however I managed to mitigate that problem a by cleaning simply removing the sensor and giving it a quick clean. I don't think that this is the cause but I can't be sure.
I haven't had the spark plugs or fuel filter changed in a while although I'm unsure that these would be the problem if the idle was rough and low only when the engine was warm.
View 12 Replies
Here's another idle problem. I have a 1992 aerostar, 3.0 2wd with 245,000 kms.
I have been working on this van for weeks now getting it ready for summer. I have done a complete tune up consisting of wires, plugs, rotor, cap, pcv and all filters including gas, air and oil. I have checked the vacuum hoses as best as I could and all seem fine.
Here.s the problem. I start the van and it idles great. The engine doesn't move. After a few minutes it slows down a bit and starts to shake. Once it is completely warm and has been driven for an hour, it shakes noticeably. It has lots of power and gets good mileage. It never has a starting problem and never seems to be close to stalling. I am suspecting it is one of the various pollution control items such as the MAF, IAC or 02 sensor. Is there a way to check them at home?
While under the van, I noticed a cable that goes from the transmission into the firewall. A bracket holding it in place broke and the cable was rubbing against the exhaust pipe and burned through. Could this be related? I taped up the cable and tied it up and away from the pipe.
View 14 Replies
I have a 1986 Celica GT-S with 50,000 original miles on it. Car starts perfectly fine in the morning, runs fine, no issues. Problem happens when the engine is warm, and I let it cool off for about 10 minutes or so, at that point, when I try and turn the engine over, it would sometimes turn over and idle very rough, or sometimes it would die and I have to give it gas to keep the engine running. Once I am able to get it in gear and drive, the engine rpm would recover and go back to normal. I have new NGK wires, denso iridium spark plugs.
View 2 Replies
My 1994 volvo 240 stalls at idle when the engine is warm. It's happening more frequently as the weather gets colder, I'm not sure if that's a coincidence. The car is an automatic and I'm wondering if it could be something as simple as low transmission fluid.
View 1 Replies
I purchased an '08 F150 about 6 months ago, and have a problem that two mechanics haven't been able to solve. The truck has a 5.4L engine. Unfortunately, I bought from an auction and the 30 day warranty expired before I realized the problem.
After a longer drive (30 minutes to work) the engine is warm, and I always back into my parking spot or driveway. In low gear, it begins to idle very rough and the engine shakes. If I leave it long enough, it will stall. Usually I pop it into neutral, give it some gas, and its fine. I just bought a camper trailer, so I'll need to use the lower gear when backing up.
So far, the engine has been flushed twice, the solenoid replaced and phaser replaced. The second mechanic has recommended I contact a dealer, but haven't had luck with them with my previous Explorer. What it could be? I will be getting the diagnostic paperwork this week.
View 14 Replies
Morning are getting colder engine runs at 1100 to warm up OK I understand that. But after running around town and engine is warm, I checked again, still at 1100 RPM. Shouldn't it be lower or is that what the batteries need?
View 1 Replies
I have a '03 Civic DX 5 speed. It has 128000 miles on it. I've notice now that it is getting colder, my engine ticks when it is warm - I can hear it at idle and low rpms, but not at higher rpms. It sounds perfect when it's cold, but once it is warm, it has a "tic-a-tic-a-tic-a-tica..." sound. Tom and Ray talked about a Dodge Dakota that made the same sound when the engine was cold (about 8 episodes ago). So what does it mean if it only does it when warm?
View 9 Replies
98 Honda Accord with 2.3L has 354,000 miles on it and up until recently ran like it was still new. Have developed erratic idle speeds. When it is cold it idles around 1100-1200 rpm. When the radiator fans are on or the A/C compressor is on it runs around 800-900 rpm. These are normal speeds and great. However, when the engine is warm/hot, in PARK, radiator fans are off, and A/C compressor kicks off, the idle speed drops to what appears to be about a rough idling 500 rpm's and the engine can barely stay running. I've attempted to look for the obvious. I own the Honda Shop Service manual if there is a particular component or most likely suspect area I should start at.
View 6 Replies
I got a 87 Toyota Celica 1600 GT, with a TVIS 4A-GE engine in.
My problem: when i just start the engine cold, it revs to 2500 RPM, and stays there for 1-2 minuttes and then falling to about 1500 RPM, and when the engine is completely warm my idle is about 1000 RPM.
first i think that 2500 RPM cold is a bit to much, and i dont know what to do with it. but my biggest problem is when the engine is fully warmed up, and i rev it to lets say 3000 RPM and then lets the gas of, the engine falls to about 500 RPM sometimes it stalls but if it not stalls then it would slowly gain some RPM and then it goes up to 1000 RPM again.
How can i prevent the engine falling that much when i let the gas off? it's quite annoying when i drive the car and comes to a stop it sometimes stall.
View 2 Replies
Had the front end axle replaced due to a boot that was ripped on the CV joint. Three months later the front end is vibrating while increasing speed and passing. The shop is telling me its my transmission?! Doesn't sound right to me. So i take it to another shop and they say its the axle. Okay its under warrenty but the other shop says its the transmission.
View 10 Replies
I have a 2003 Toyota Echo 1.5. About a year ago the cel went off and on intermittently and I got a p0511 code. For the past few months, the light has stayed on steadily except for a 2 week period when it stayed off. When the cel is on , the car idles slightly low for about a second just after start up. When the engine is warm, it idles steadily about 400 rpm above normal idle. When the cel is not on, the idle is perfect both at start up and when the engine is warm. I did take off the IAC and cleaned it, but it already looked spotless inside and seemed to operate smoothly.
View 2 Replies
Still showing the same codes (per repairman) and still having the intermittent rough idle at low speeds when the engine is warm. It has been so intermittent that I could almost live with it.
So repair guys first replaces the VCT's and runs fine until warmed up and the problem reoccurs with the same codes. He replaces both cam phasers and tensioners today and still same problem and same codes which point to the VCT and cam phasers.
Truck has 80k, city driven, oil changed every 3k or so. Burns ethanol and still runs great at speeds over 10 mph even when this problem appears.
View 9 Replies
Have a lot more smoke from the tail pipe when they are running their tow tune vs their street tune? For me it seems like a lot especially right now being cold out but I still notice a haze at idle when the engine is warm. Also can smell a difference.
Getting a ficm tuner from php tomorrow so interested to see what that does for things.
View 7 Replies
Is is best to check the oil in the FSI 2.0T when the engine is warm or cold?
View 2 Replies
I just wondering is that normal that my 2006 gS450H not increasing engine RPM when in P or N accelerator pedal is like dead when driving all OK....
I have tech stream software 2 errors are about solar sensor circuit that's it (did full health check). In live data it show accelerator position if I press more down it show accelerator position change but no increase in RPM??? I tested other GS450H and then RPMs increased somehow in P position. Also 2 days ago did MOT then also RPMs increased they tested emissions.
View 2 Replies
I have an 03 Passat Wagon, 2.8L V6. My wife is getting ready for a big drive tomorrow, about 13 hours. Right now after reaching the operating temperature and then shutting off the coolant is boiling. The temp gauge never goes beyond 190 so it is not overheating but it is getting really warm in the engine compartment.
History: I noticed a couple of days ago that the expansion tank was badly discolored and had some corrosion inside. I know it was because I inadvertently mixed the green stuff with it about 2 months ago. I know it was stupid, but that was before I realized how stupid. Yesterday I drained the coolant and flushed it about 4 times. I couldn't flush it completely because I couldn't get at the drain next to the transmission fluid pan. I just drained it from the front outlet.
I refilled the system by disconnecting the expansion tank and holding it up until fluid came out of the hole on the hose going into the firewall. Then I was going to bleed it from the bleeder screw in the rear coolant pipe (as listed in Haynes manual) but could not find it. I even have the photo in the book to guide me and it is not there. Since I couldn't find it I skipped to the bleeder valve by the serpentine belt. I bleed that and hooked it all back up.
Now my fluid boils. I know it isn't the expansion tank cap because I took the one from my Jetta and put it in and it does the same thing. I put the cap from the Passat in the Jetta and it doesn't cause that coolant to boil. After driving today for a half hour the engine compartment felt superheated. Even the fenders were hot to the touch. It is almost 90 outside but it still felt unusually hot in the engine compartment. I would like for my wife to drive this on her road trip instead of the Jetta, but I can't let her do that with this problem.
I think I must not have bleed the system very well. The heater works and the temp gauge never goes above 190.
View 9 Replies
