Passat (B5) :: Exhaust Broke Between The Turbo And Cat
Jul 2, 2011
So about 30 minutes ago my exhaust broke between the turbo and cat. I guess I could weld it back but the pipe is a little rusty. Should I just get a turbo back and call it good and if so what brand and where do I get one for a 01 passat 1.8t
View 1 Replies
Advertisement
What are the repercussions of my turbo leaking, and how do I fix it? Could this cause white smoke to blow out of my exhaust when i take off after the car idles for about 10 minutes, the smoke goes away, but if I let it idle again for about 10 minutes it blows out more smoke. Also the oil consumption is really high, obviously due to the oil leak, is the turbo bad, do I need to change it?
View 2 Replies
I have a 2013 F250 6.7 w/ 96000. I ran over a log and tore the rear section of the exhaust. I was told to buy the OEM version or do the DPF/EGR Delete.
I don't have a lot of $$$$, so which way do I go. Whats the least expensive Delete.
View 14 Replies
Well i had an exhaust leak on this F250 and so I started torquing the bolts on the manifold to the head. (45 ft.lbs) A couple were very loose so I was thinking "Great, this may fix my problem!"
My first mistake was probably the Harbor Freight Tools torque wrench.
I am on the driver side, second from the rear and then bang! I see a gaping hole where the bolt used to be. Bolt on the floor. I cant see up in the hole to the head, I think it broke flush with the head.
View 14 Replies
1991 740 Turbo
200k
all stock
Now days I hear exhaust gas leak from inside engine room when the motor is fully warmed up and ran for some time. The other day I put seafoam treatment in the car and I saw white smoke coming from the turbo charger area.
Is exhaust gas leak from the turbo charger common? What are the possible cause for this?
View 6 Replies
I have a leak between the turbo and the exhaust manifold. The golden clamp (c-clamp? v-clamp?) broke, and now there is a gap between the two. The dealership doesnt cover it under powertrain warranty (my car has passed regular warranty) but worst of all they do not sell the clamp on its own.
I posted a link to a picture below, it isn't my turbo.
[URL] .....
View 1 Replies
I have a 2000 golf 1.8t 4 door Looking to make my car a little bit louder than the stock system. I am looking at getting a new downpipes from neuspeed. I don't know if I should go ahead to and get a new ecu, I don't have a ton of plans for the car just want to make it a fun daily.
View 4 Replies
Thinking back, this may have started Saturday.... or may be earlier. Saturday I noticed smoke out the exhaust when I would let off the throttle, like coming up to a stop sign, or getting off an off-ramp. Didn't think that much of it. Yesterday I notice its worse, so I'm looking at my Quadzilla monitor on the way home and I'm seeing ZERO psi of boost.....
Is it possible I lost my turbo and my Excursion still motored down the highway towing 7,000 lbs. with the cruise @ 65 and the truck never skipped a beat ??
Got it home so I could unload the trailer...... at this point is there any harm in running the truck to get the trailer into the back yard to get the trailer put away and get the truck in my driveway to work on it? Tried to do some reading here last night and it looks like plenty of others have lost a turbo and (apparently) not sent shrapnel into their engine.
I assume I can find a disassembly / assembly video on Youtube on removing a turbo from a 7.3. Can the Riffraff turbo rebuild be done by a guy who is mechanically inclined, but by no means a diesel mechanic ?? What other parts will I need in the process?
View 14 Replies
Had a bad turbo on my 07 F550 with a 6.0. Replaced it today and took her for a ride. Started smoking and oil was spitting out of the weep hole in the muffler. A lot of smoke. The truck was smoking before I replaced the turbo too but I didn't have any oil coming out of the weep hole. I'm hoping it is just oil that had been passed into the exhaust by the bad turbo that is now being burnt off and pushed out by the new turbo. Does this sound plausible?
View 1 Replies
I have a 2011 that does not currently have the complete factory exhaust system on it and no muffler. With the nice weather I have been driving around with the windows down and hear a noise out of the exhaust that sounds like tires spinning on wet pavement when I let off the throttle or at some shifts of the transmission. Boost seems normal, and don't hear any noise while under load. I think it is just the VGT closing and making the noise. With deleted sys heard this noise in exhaust?
View 4 Replies
I've been mulling over the idea of doing a muffler job on my 2002 f350 7.3 cc short bed. I do tow on and off for work and dual material for work. I am thinking of upgrading the exhaust because I noticed a couple small leaks in the muffler and I'd like to lower the egt's for the truck so it breath a bit smoother. I'm not a fan of the really high pitched sounds I've heard on some I want it deep and heavy sounding. The turbo is fine for now but eventually I'll need to know what to upgrade to once it starts to wear out. I don't plan on doing dumb chips or tunes because it's not a toy truck but a work and daily driver.
View 10 Replies
So, I just got my turbo back from my pal Ruben at SoCal Porting (does good work fast and inexpensive) and, I have a question about the exhaust housing with the EBPV.
Is there a gasket that goes between the turbine housing and the adapter that the down pipe mounts to? And, if so, what is the part number for it? If it's steel to steel cool. If not, I'd prefer to put the OEM gasket in there versus permatex or something similar.
Pic of the compressor housing with a little port work....
View 3 Replies
I have 07 F350 6.0 never heard this out of any of my 6.0s. it's almost a whine but can hear it w turbo and out of empty exhaust. Almost like a supercharger noise stumped almost leaning towards actuator for turbo? Noise got real loud swapped turbos used same actuator noise is there but much quieter.
View 1 Replies
I have been smelling raw exhaust in the cab, especially when the weather is colder and when standing still.
I took it to the dealer and in the process of fixing minor coolant and oil leaks on the turbo, they located a small exhaust leak with visible soot on the back side of the turbo.
They tell me that there is no way to repair it and that only Ford can rebuild or repair these turbos.
2011 SD 6.7
View 14 Replies
I have an exhaust leak between the manifold and turbo ( in the flex part of the pipe) on my 2008 6.4 f250 would this create rough idle when at operating temp?
View 2 Replies
For a while now, I have been hearing a very high pitch whistle noise from the turbo/exhaust area. Everybody told me it was an exhaust leak, but I never could pin point the leak. While I was under the truck last weekend I found the flex joint on the passenger side up pipe was broken a leaking.
I ordered a Dorman replacement pipe that comes with a new gasket and hardware.
I will be the first to admit, I am not a fan of Dorman parts... BUT, this pipe is really nice. It looks identical to the pipe being sold on Dieselsite.com, it doesn't have the scoop inside to direct exhaust gas to the EGR cooler and it comes with all the mounting hardware.
[URL] ....
Once I got the turbo down pipe out of the way and soaked the bolts with penetrating oil, I had the broken up pipe off in 30 minutes.
View 8 Replies
I got a CEL this morning and the car was driving rough, tach bouncing at idle so I popped the hood and the plastic funnel that the oil cap screws into was completely broken off from the top of the engine. I was picking little slivers of plastic from it out of the hole in the pic. Fortunately the oil cap actually screwed into the spot where the plastic cylinder had broken out of. Not sure if that's by design but it worked and the car drove ok after.
View 6 Replies
Iv got a 2000 passat 1.8t and the shift linkage bracket broke, so i got a new one but my problem is how do i get the linkage cable off the old one, and onto my new one. Is the cable supposed to be able to break into two parts.
View 2 Replies
I was checking the oil this morning before getting ready to drive (for an hour) to the in-laws for Christmas, and the Effing orange plastic dipstick tube broke about halfway down. Now I'm afraid to drive for an hour at highway speeds, for fear that a lot of oil might come out of that compromised Effing orange plastic dipstick tube part -- would you all agree that I should not drive the car? Figures this would happen on Christmas Eve when nothing is open.
View 6 Replies
In my 2001 Passat, the handle / compartment above the handbrake has a problem - it can be rotated (as to reveal the compartment), but when I want to put it back to horizontal position, I can't, it always leaves a distance of 4-5 cm. I took out the black compartment to see what's inside, and I found out that it gets stuck because when I push the handle down, it doesn't rotate the shaft that holds the teeth (which are in charge of the several "steps" in the handle position) down so that the handle will be able to be put to a full horizontal position. Also, I found a orange-yellow-semi transparent plastic thingy near the teeth of the compartment part, and it was loose, it appears to be broken. Looking for a detailed (exploded) view of the part assembly (like in a Haynes manual)?
View 2 Replies
Looks like my timing belt broke. I was taking my car out of the parking lot, and heard the warning chime. I tried to look at the warning light, I think it was the malfunction one. I heard a belt/ fan snap. The engine stalled and I dint try to resart the engine. I had it towed to the dealership and am waiting to hear from them. The engine dint make mucg of a noise but sorta just died. Does this sound like a timing belt? I am worried abt the damage. how much would it cost if it was a timing belt? my car only had 73k miles on it. It is a 2001.5 1.8t.
View 5 Replies