Passat (B5) :: Error Code P0491 Detected
Sep 5, 2008
The CEL tripped yesterday and this is the code autozone pulled. WHat does it mean.
View 3 Replies
Sep 5, 2008
Advertisement
Passat (B5) :: Misfire Detected - Error Code P0322 And P0302
I bought my first VW about 3 months ago (so excited!) It's a 2003 Passat, 5 spd, 1.8t. I've had one thing happen so far (until yesterday). On 4 separate occasions when I'd go to start it, it would crank for a few seconds before it would start. Then once it was running the EPC light would turn on. It seemed to be running normally but I turned it off and restarted it and it started normally and the light extinguished (the first three times). The last time (about a week and a half ago) it kept doing it each time I started it, and upon starting probably the 4th time in a row the MIL came on. I drove it about a mile, turned it off for a few minutes, then turned it back on and it started normally with no malfunction lights on. It's been normal since then. Until yesterday...
Yesterday as I'm accelerating from a stop light (I think I was in 3rd) all of the sudden the engine started running really rough and the MIL came on. I turned around and drove about 2 miles back to where I started at about 20mph. The MIL would be steady while coasting and flash while pressing the accelerator. I got a hold of a diagnostic computer and it came up with 3 codes...
1) P0322 Ignition/Dist Engine Speed Input Circuit No Signal
2) P0302 Cylinder 2 Misfire Detected
3) P0302 Cylinder 2 Misfire Detected PENDING
Passat (B5) :: Engine Light On - Code Is P0491
The dealership wants to charge me just to "diagnose" it. I'd like to figure it out myself if at all possible. what it is?
View 1 RepliesGolf V R32 :: P0160 - O2 Error Code Detected
My r32 mk5 is throwing that code.
I replaced new o2 sensor with oem new one.post cat on driver side.
I have erased dtc and drove 15 miles dtc came back again.
Now i have replaced catalysator on driver side and same thing again.
Prius (Gen 3) :: Check Engine Lights Up - No Error Code Detected
My car is a Prius Plus 2012.
One day, I decided to go to a mechanic to clean the EGR pipe. Only the pipe, not the whole EGR. It was an extremely simple operation a mechanical one, not electrical etc. Starting from that day, when I go with the car, from time to time, check engine lights up. For a fraction of a second to up to 2 seconds then it disappear.
The car behave itself without a problem. But still the on-off check engine is really annoying.
So a went to the dealer. Put the car on tester.
Result: no code error !
I went to another garage , put another tester on the car, no error..
How can I actually see what the error is if nothing is stocked in the ECU of the car?
Phaeton :: Code 01583 - Leak In System Detected / Level Fault Error
In the past few weeks I have seen an intermittent "Level Error-Workshop". However every suspension function has worked perfectly, and no height was lost even while sitting at the airport for a week.
How to track down the leak. I can see a tank pressure of about 13 PSI. Is that about right. I did a raise / lower while VCDS was connected and there was a pressure drop to about 11.7 PSI but no level error. What is the correct range of tank pressure settings?
Address 34: Level Control Labels: 3D0-907-553.lbl
Part No: 3D0 907 553 C
Component: LUFTFDR.-CDC- 3C3V0 1122
Coding: 0005521
Shop #: WSC 01065 000 00000
VCID: 2757057592F60B6
1 Fault Found:
01583 - Leak in System Detected
000 - - - Intermittent
Passat (B6) :: CEL Came On / Code P0442 - No Leak Detected
My CEL came on and I took it in to dealer. They replaced the EVAP line and purge valve. My CEL came on again that same week and supposedly it detected a small leak (sporadic, same code as previous), they ran test and did not detect any leaks. They finally told me that I might have to replace the canister if CEL comes on again for same code.
View 3 RepliesPassat (B5) :: P0322 Crankshaft Sensor Code Detected
My car is an AUG 1.8t with 153K miles and it has been running great since the timing belt change last summer. It died while driving it earlier today. I pulled a P0322 code which looks like it's for a crankshaft position sensor. I cleared the code.
After the car sat for about an hour I was able to restart the car and drive the car two miles back to my house. On the way back I felt the engine shudder and got an Engine Workshop warning, no CEL. I scanned anyway and found a pending P0322. Once I shut the car off it cranks but will not start.
Passat (B5) :: CEL Codes P0491 And P0492
Codes P0491 and P0492 ... The Air pump works, so what's the problem? Perhaps the combo valve? If so how do I check this?
View 1 RepliesAvalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
Venture :: DTC P1860, 0758, 755, 740 Error Codes Detected
My van stumbling upon acceleration. Well now I am getting the following codes and the van barely has enough power to move. The codes are: P1860 Enhanced: Tcc Pulse width modulation sol ckt electrical, P0758 Shift sol B ckt electrical, PO755 Shift Sol B malfunction, PO740 TCC ckt malfunction
View 7 RepliesGolf IV / Jetta IV :: Car Won't Go Into Boost, 2 Error Codes Detected
I was having an issue with my car not going into boost so I plugged my code reader in and it had 2 codes 1 was p1200 n249 malfunction and the other was diverter valve malfunction so I did the quick easy one and got a new factory diverter valve but it still doesn't go into boost and still reads p1200 n249 what do I need to replace or should I do the n249 bypass it's a bone stock jetta 5 speed.
View 5 RepliesFord - Mustang :: 2007 - Car Won't Go Over 3800 RPM / Error Codes Detected
I bought a gorgeous red 4.0L V-6 Mustang very cheap last week because it needed a clutch. I would not even pull the car. Little did I know that the clutch kit, including the slave cylinder and flywheel, was over $600. (But that's another story.)
The car runs now, but will not go over 3800 RPM in any gear. It had NINE codes, which they cleared. I was told that they primarily pointed to the MAF sensor. I cleaned it with the recommended aerosol. I have driven it 20 miles, and the MIL has not returned, but the little wrench symbol has. The Manual says to take it to the dealer (of course). The car seems to run fairly well, with the exception of the low rev limit. It is a "fly by wire" set up, with electronic throttle.
The cleared codes were P0102, P0113, P0135, P0141, P0155, P0161, P0403, P0443, and P0446. They actually repeated on Autozone's scanner. (My six year old Actron won't link to this car for some reason.
Ford F-150 - 1997-2003 :: Error Codes - Misfire Detected On Cylinders 2 / 5 And 6
My wife and I received her father's 2002 F150 4.2 5 speed 2 wheel drive truck after his passing. He purchased new plug wires and wanted to replace them. So, this weekend I put in new plugs, plug wires, changed the air filter, and changed the oil and filter. Started up and ran really rough. Threw my code reader on after taking it around the block and found the following codes...
P0316 Misfire detected in first 1000 revs,
P0302 Cylinder 2 misfire,
P0305 Cylinder 5 misfire,
P0306 Cylinder 6 misfire.
New plugs were Motorcraft plugs, but had skinnier center compared to the ones that came out of truck.
Where do I start? What do I do? I am really confused as I have changed plugs and wires before and always had vehicle run better or same as before change.
Passat (B5) :: CEL And Error Code P1476
I have this error code on my VW 1999 passat 1.8T automatic car. How to resolve it. My friend reset it and CEL went off for few days and now it came back again. How to resolve it??
View 2 RepliesPassat (B5) :: Getting Error Code 0012?
It happened to passat. Once I hit about 75mph on highway I get a stop engine (oil presser low light). It flashes than goes off once I lower my speed. I checked all fluids are normal. It throws a 12 code an says oil passage blocked, cam positioning sensor, skipped timing chain. These are what the code says could be wrong with it. The car runs fine with no hesitation at idle or normal city driving. I have already flushed the oil with cleaner, and still getting the light.
View 5 RepliesGolf VI R :: Engine Error Codes - Random / Multiple Cylinder Misfire Detected
I recently found these codes. My car is APR 1+. The car seems to run fine so I'm not sure what is going on. I changed the plugs at ~60K miles and now have 72K miles.
Address 01: Engine (CRZ) Labels: 06F-907-115-CDL.clb
Part No SW: 5K0 907 115 M HW: 8P0 907 115 B
Component: 2.0l R4/4V TFSI 0020
Revision: 5BH20--- Serial number:
Coding: 0403010A180F0160
[Code] ....
Passat (B5) :: OBD-II P1818 Error Code - Faulty TCM?
I was able to borrow an OBD-II scanner to read the error code(P1818) currently displayed. I was wondering if the P1818 Error Code is related to a faulty Transmission Control Module (TCM).
View 1 RepliesPassat (B5) :: Pulled Over Error Code P0741
My cousin's B5 wagon automatic 1.8T ('00) was shaking and vibrating intermittently. I took it down to Autozone and borrowed an OBD2 scanner. This is what it said (only one code, and the CL was off, although it comes on intermittently):
P0741 - Torque Converter Performance or Stuck Off
Passat (B5) :: 2000 - CEL Came On - Getting Error Code P1176?
Check engine light is on... Then about 2 mins into driving Emissions Workshop comes across the dash.. i Ran the code it says
P1176 Oxygen sensor correction limit attained (bank 1)
What exactly does that mean in other words. also what is bank 1? im not sure what oxygen sensor it is out of the 4 of them.
i have a 2000 30v 4motion.
Passat (B6) :: Error Code P0016 After Oil Change
P0016 - Crankshaft Position | Camshaft Position Correlation
Bank 1 Sensor A
2006 Passat - 3.6L V6
Here is my issue: I was lazy and waited a bit too long to get my oil changed. I finally did 3 days ago. I have been very busy so I decided to take it to a local mechanic to let them take care of it. They flushed the oil, ran other oil through it with a new oil filter, flushed that, then put in new synthetic oil with another new oil filter. They also replaced the air filter.
Everything was fine for 2 days.
Then, while I was driving in stop and go traffic, the "EPC" and "Engine Malfunction" lights came on. There was also a loss of power and the car seems to wait too long to shift gears.
So, I took it back to the mechanic who had it a few days prior. He pulled the code from it (posted at the top), and cleared the code from the car. That mechanic told me that I need a "cam position indicator sensor". He also claimed that what he did had nothing to do with this issue. I decided to check with the dealer. He cleared the code and I left. After clearing the code, the car drove fine for most of that day, then it returned.
I spoke with the VW dealership's shop manager and he said that he does not believe that is the issue at all and asked me to bring it in. He also mentioned a clogged oil line as being the potential culprit.