Passat (B5) :: Engine Will Not Crank / Turn Over
Mar 6, 2013
2001 V6, 5sp .... Engine will not crank/turn over.
Dealer initially thought broken timing belt. They looked again today (through an inspection hole) and belt was still in place and under tension but some teeth seemed to be missing. They THINK it could be a seized water pump that caused this (there was otherwise no indication of a seized water pump). Cams/belts do not move when you try to start it. Dealer said engine would need to be replaced or the damage repaired from trying to start it and causing whatever internal damage this causes..heads, valves, etc. that's where it stands now.
View 3 Replies
Advertisement
When I crank the engine when it's cold, it cranks fine. Case in point: first thing in the morning and in the afternoon when I'm leaving the office to come home. However, if I crank the engine when it's already warm it takes significantly longer to turn over. It really doesn't feel like it wants to crank at all and pumping the gas pedal doesn't work with things even though its second nature from my old carburetor days. The fact that it only acts up when the engine is warm befuddles me! I remember reading something like this awhile ago and the culprit was a clogged "box that dissipates gases". It's a 2003 Passat with the 1.8 turbo. The car has been maintained according to the service schedule and runs like a champ with 100,349 on the odometer.
View 3 Replies
So I have noticed a couple things about my stereo that puzzle me. I have the Dynaudio NAV system w/6 CD changer in the glove box.
1. I had the doors done with Dynamat and it definitely sounds better but the problem is that if I crank it I have to turn the Bass way down otherwise it distorts. Now correct me if I am wrong but shouldn't the amp and speakers be perfectly matched so this doesnt happen.
2. I have the AUX input button on, screen and I can select it but there is no jack in my glove box where all the literature says it is supposed to be. My VW/Audi service manager printed out a build sheet and it doesnt seem to be on there.
View 13 Replies
My 99 Passat 1.8t broke down on me last night... my front motor mount is missing and my motor snaps back from time to time but last night i think it went back all more than normal and as soon as it snapped back the motor cut off and won't turn over... it will crank and crank but not turn over. i looked for any loose wires or anything possible that could be out of place and couldn't really see anything out of the ordinary... There are 3 sensors right next to the power steering reservoir that aren't connected but don't look like they were connected, need to identify those sensors.
View 2 Replies
99 Saturn SL2 Idling pulley broke as i turned into driveway....replace pulley the next day but now have a problem, engine will turn over but wont crank. what might i have broke or pulled loose while replacing the pulley?
View 1 Replies
I have a 1997 Pontiac sunfire the other week I was driving and it stopped on me the engine would crank but quickly turn off but everything inside the car would still be on k was told I needed a new cat and got that and a new muffler put on. This morning I went to leave for work and the same thing happened again! I was told it could be the fuel pump or fuel filter but it doesn't act weird while driving it. What could this be?
View 1 Replies
Intermittent problem, occurred 4 times during past 4 weeks, always during wet/rainy/damp weather. Three times when car was sitting overnight, once at work in parking lot after a 12 hour work shift. Each time, the engine started 5 or 6 times then died like someone turned the key off two seconds after the engine started. Then the engine would not crank or turn over, just some clicking near the relay box under the hood. Lights, power windows, etc. all work fine. Battery voltage OK. Jump starting or battery charger makes no difference. Note: With key in "run" position, no display to odometer though all idiot lights light up like normal.
1st time, after about 15-20 minutes, car started. 2nd time, towed to my mechanic (who thought security system lock out) then a second tow to dealer. Dealer found power into power distribution center but none out. Replaced PDC. Car worked fine for 1 week. Same problem twice since repair. First post repair failure I had van re-towed to dealer. Of course, it started for them. Left overnight 2 more nights. Started for them every time. They say it is a "problem with computers" but they don't know exactly what. They also say the Alarm set Dash light is coming on with the rest of the dash lights and that is a no-no. 2nd post repair failure happened this morning. Tried locking door to reset alarm. No change. Locked doors, opened rear hatch. Lights flashed but horn did not sound. When car is working and I do that (open hatch with other doors locked), in addition to lights flashing, horn beeps! I also disconnected the positive battery terminal, waited 10 minutes, reconnected and attempted restart. No change. Car still won't start and odometer display does not work.
Van has 110,000 miles. Otherwise in fantastic shape and runs great (though only gets about 20MPG). Owned van for 2 months and have driven about 7,000 miles. 1st problem I've encountered (other than a very uncomfortable drivers seat - feels like a spring is sprung!)
View 14 Replies
I have a 1997 Pontiac sunfire the other week I was driving and it stopped on me the engine would crank but quickly turn off but everything inside the car would still be on k was told I needed a new cat and got that and a new muffler put on. This morning I went to leave for work and the same thing happened again! I was told it could be the fuel pump or fuel filter but it doesn't act weird while driving it. What could this be?
View 7 Replies
I have an automatic 2006 GLS Accent that is having a few problems. The engine will crank, but doesn't turn over right away. It might take a few tries, but will always start. This happens intermittently. Sometimes it will do it first thing in the morning, or sometimes it will happen later in the day after several start ups.
It has recently starting stalling while coming to a stop or sitting idle at a traffic light. This is also an intermittent problem. Always starts back up after a few tries.
The check engine light is not on. I have not taken it to a mechanic yet since it doesn't always do it, and will most likely be tricky to diagnose. What the problem might be? I was thinking it might be a crankshaft sensor?
View 4 Replies
Pulling into work this morning I noticed my check engine light was flashing. The car (1997 Buick LeSabre, aka The Rolling Couch) was still running and everything seemed normal. I turned off the car and then went back out 3 hours later and tried to start it. It would not start, and the symptom is not one I've had any luck Googling. When I turn the key, it makes a sound, but it's not a click. It's the normal sound when ignition starts, but the engine does not crank at all or turn over. It just makes a single ignition sound and then nothing. Could this be a belt? The starter? I have not taken it anywhere or pulled the error code yet.
View 13 Replies
Fuel Pump and Fuel Pump Relay replaced after 115,000 miles. On occasion, engine will turn over but not crank ... wait 10 minutes and the engine will start. No security light (passlock) or engine trouble codes displayed or recorded. Once the engine starts, it runs smoothly and normally. Problem of starting did not occur until the fuel pump and relay were replaced.
View 4 Replies
I am working on a 2000 f-150 XLT 5.4L 4x4 Automatic. It tries to crank over but acts like its stuck. things done: New starter, new battery, fixed connections. I can turn the crank counter clock wise but won't turn clock wise. Not sure if i should say the engine is bad or could trans be stuck? Heard 5.4L's have timming chain issues. Is that true? Point me in a direction and i'll go forth.
View 14 Replies
I have an 02 f150 5.4 4x4, drowned it a while back, thought i had hydro lock, crank can be turned by hand though as far as i can with a wrench, so internals seem to be fine, no bent or broken rods that i could tell, ripped everything apart cleaned it up put it back together, new fuses, new ignition relay, new starter, alternator and battery as well, turned the key to on and got all my electronic stuff back up, turned to start and it all goes dark, which i assume is because at that point its sending power to the starter, but the starter didn't turn or crank the engine...
So question being when i put my new starter on is it possible that i might have crossed a wire or something that would cause it to not crank? and due to the fact that I had water in it, and had hydro locked it, all my plugs are out, now I know that spark is needed for the engine to run, but shouldn't be needed just for the crank to turn right? question being is that once i fix the wires on my starter, I am looking for initial crank before start up, so do i need to put a plug or two back in and hook them up to make it crank? or will it crank without them? and yes I did replace all my fluids as well.
View 8 Replies
I was putting in a subwoofer earlier today, and after I put everything back together, I turned the ignition to ON just to test out the system, and all the electronics worked fine.
However, when I went to crank the engine, nothing would happen, not even a click or crank. I tried jump starting the car, and it would crank and crank and crank, but wouldn't go on. All the electronics still worked fine, but the EPC light, CEL, and battery light would be solid. While cranking, the battery light would occasionally flicker.
View 7 Replies
I have a 2007 Passat 2.0t Sedan. My wife broke the front engine mount this morning and now it will crank, but will not start. Put my code reader on it and it is throwing camshaft position sensor, misfire cyl. 4, fuel rail pressure low, and Mass Air Flow sensor codes. It looks like the insert of the mount is wedged against the belt. Would the engine mount being broken cause any of these codes for some reason? and would the mount against the belt cause it to not start?
View 6 Replies
A month ago I got into my truck in the morning and when I turned the key to Run everything lit up like normal and after the glow plugs warmed up, I turned the key and there was about a two second delay between me turning the key and the engine cranking over.
The next couple times I tried starting the truck that same morning I had to try to start it a couple times because it wouldn't try to crank over the first couple times but it would always eventually start.
It's been continuing to give me problems but never stopped running once it was started and then this morning I tried starting it for 45 minutes with no luck.
What I have tried so far is:
Resetting batteries
Jumping the truck
Checked to see if the starter is getting power. ( I put wire testers on it while someone else started and I didn't get a good reading even when it did start. New starter was put in 9 months ago.)
I also made sure wire going to starter wasn't corroded
Battery terminals are also not corroded
Checked fuses
Tried starting truck with fan clutch disconnected
Cussing at it
Tapping starter with a hammer while trying to start it
Also, everything sounds perfectly normal when I turn the key, it just doesn't even try to turn over.
View 7 Replies
so all of a sudden when I turn the key it seems to have an extremely long crank to turn over, almost like im holding it down to long, i can turn it quick and let it go and it will catch, hold it longer than normal and let it go and it will still catch...took it to the dealer and had them scan the car but there are no codes/faults coming up......its been doing it for a week now and today it won't start at all, it just keeps on cranking but won't turn over but yet I still have codes or faults....battery is good cuz I had it tested as well.
View 11 Replies
Drove my passat today no problems, then trying to leave work, lights all come on but the engine wont turn over. New passat with push in key to start.
View 7 Replies
After I have been driving and turn the engine off there is one 'Beep' sound and the light above the left visor turns on. The only thing that will turn the light off is if I put the visor back up. It stays on in all other positions. Opening the little mirror window on the visor does neither turn on or turn off the light. I posted this before but forgot to mention the 'Beep' that sound when I turn the car off. what does that mean?
View 2 Replies
So, my dad's 2000? B5 V6 Tiptronic won't start reliably. He says that when he turns the key, all the electronics come on, but the engine does not turn over. It sounds to me like the starter motor is dead. Does that sound right?
I looked around Vortex but I couldn't find any DIY for this. Does one exist? Or is it so straight forwards that I should just go for it in the driveway? I changed one in my 96' Jetta 2.0 and one of the bolts went into the motor mount, the engine almost fell on me.
View 1 Replies
Check engine light came on after a car wash yesterday. I'm sure there is nothing wrong with the car and i recently had an oil change done. i use full synthetic oil too and always get it done on time. Is there a way for me to clear the engine light myself?
View 8 Replies
