Passat (B5) :: Engine Not Revving When Letting Clutch Out
Jan 29, 2012
Pretty nice condition 2003 1.8t Passat 5 speed yesterday with 45k miles. nice price, mint interior, only a few minor blemishes on the bumpers.
Anyways, I was noticing that the gas pedal needs to be pushed in about half half before the car wants to move. I do not believe it was the clutch going bad as the engine wasn't revving when i was letting the clutch out, it just didn't seem to move until the gas pedal was half way down. again, no clutch slippage, engine was not revving.
View 7 Replies
Advertisement
Today I started my car (in the garage so it wasn't too cold) and everything was fine. The car warmed up in a couple minutes and I was off.
As i was driving, I noticed that my shifting was horrible. It felt like i was burning the clutch and not releasing the clutch smoothly in general.
I then noticed that when i pressed in the clutch ready to take the next gear, the engine would raise the rpm's about 500-1000 revs before coming down.
I started to wait till the revs came down to shift and that seems to work.
Why would the engine be revving itself higher the second after i push the clutch in. My dealer can't take me until Wednesday so I don't know what to do.
View 46 Replies
I'll start out by stating that I failed to get new transmission fluid, which definitely caused the issue. So let's go back to December 26th. Check engine light came on, and I assumed it was for the oil (which has never happened before, suspicious). So I changed the oil, and took it for a test spin. Well, a mile later, I was going up a hill, and the clutch started slipping. Yes, I know, it's an auto, but I know the feeling of a clutch slipping... no power, engine revving up, jolting forward when slip stops. At this point, I drive it home without much incident, a few slips and I part it but don't drive it again. Checked the engine, and transmission fluid was out. Filled it back up, seemed to take care of the problem of slipping, but now there's a new problem...
The new problem is the following. Every once in a while, going uphill or applying full power in first gear, the clutch will slip. Also, this happens 99% of the time, first gear to second gear is a bit of a jolt, not much more than normal, but it's noticeable. And the transmission is kind of loud too, first gear sometimes sounds like there's a marble in there. Is this a rebuild? Will it work itself out?
View 3 Replies
My wife drives a 2004 passat 4 motion 1.8 T that for a couple of days has been acting up. By acting up I mean it will turn over but won't start. When this happens and after letting the key out of the start position, the epc and cel light will stay on. After letting it sit for a while it will start.
View 2 Replies
Normally I'm pretty good about searching and finding info, but there doesn't seem to be a lot out there for these trannys. In any case, when I hopped in my 20th to move it today, I got this grinding noise when letting out the clutch. The car won't go move in reverse or any of the forward gears. Idles fine, sounds fine when in neutral or when the clutch is depressed. It just grinds when you let the clutch out. Seems like I can select each gear OK. Linkage feels normal.
View 2 Replies
The car runs fine clutch has pressure and everything. I can idle with the clutch pressed down and put into reverse and every gear BUT if I put it in a gear and start to let the clutch out I can hear a clanking or something flying around in there and it doesn't really want to go anywhere and I don't want to really let the clutch all the way out in gear or let it out for too long and screw anything else up worse..
View 2 Replies
I have a 2001 F-150 4.2L 2WD LS with 102k miles. At 95k miles, the clutch slave cylinder started leaking fluid. So, I had my local garage replace it. And while they were at it, put in a new clutch. That is when the trouble started.
I cannot let the clutch out like I used too. When letting out the clutch from a dead stop,the rear end now shakes, shutters, and if it is really bad, the rear end starts bouncing. To minimize the shakes, I have to keep the engine below 1000rpm until the clutch/1<sup>st</sup> gear is fully engage. It is worst when there is a load on the truck like going uphill, or a sharp turn for a dead stop. After the truck gets rolling, I don’t notice the problem when shifting gears.
I have been babying it for 7k miles and it has not improved. What is wrong? Did I get a bad clutch job?
View 8 Replies
Started up my truck today, accel pedal didn't want to move, after giving it some more force it eventually became "unstuck". Now, the real issue I'm having is from a dead stop, in 1st gear, as I'm letting out the clutch the truck boggs down as if I'm not trying to accelerate. I'm giving it as much as I normally would as I'm letting out the clutch but the motor will either die or take a couple seconds before it starts to go. Once I'm moving I don't notice any problems clutching through gears. The check engine light IS on now, however I don't have any diagnostic gear or really any tools for that matter. 1998 2.4L 5-speed...
View 2 Replies
Just had the unfortunate scene of seeing the engine light go on but I knew something has been up for a couple weeks just couldn't figure it out but today when I came to a stop my car starts revving slightly without me doing anything and when in park the rpms just increase slightly not alot.
View 6 Replies
I have just changed my clutch and machined my flywheel on my 1.5ltr 16v dohc 2000 lc accent. I used all the correct trans fluid and refilled and bled the clutch fluid. It takes of from lights like a new car but if you put your foot down around 40kph it revs out a bit and does so through all gears untill you reach a bit of speed. What is going on?
View 11 Replies
I just brought my gti in for the 20K oil change etc... I have noticed something weird... when I accelerate hard or have been driving for a while, and then shift into neutral or push in the clutch, the engine revs up to almost 2K, then back down to 1K once or twice, then finally settles to 700rpm's. It doesn't do it cold, or when I have the AC running.
I have no CEL's, and the dealer just said they ran a fault check, and it was clear. I do have an APR exhaust and a K&N intake (I think stage1 tune)... I asked about the PCV valve, and they said that would throw a code... They said they could do additional diagnostics out of warranty, since they think it has to be part of my aftermarket stuff.
I don't know if it's related, but if I really jump on it, in 5th gear or so, I can hear the car losing a little rpm's then around 4K just for a second, then it's goes back to normal... This only happened once or twice, so maybe it was just in my head...
View 8 Replies
I ran over a parking stone last summer, ripped the plastic undercarriage a little, but alignment was fine, wasn't that bad, etc. I took the car to the shop last week for a strange whistle/squeal on acceleration and letting off the gas (PCV valve under recall) and they stated that my radiator support was broken, and the radiator was hanging there to the tune of 750 bucks.
View 1 Replies
My girlfriend said her 2008 GX has been acting weird recently. When in park, if the engine is revved, the RPM's don't drop after letting off the gas. The RPMs do eventually drop but it takes a few seconds and it doesn't do it smoothly. The vehicle also maintains a pretty constant speed while driving and letting off the gas with very little deceleration. Is this normal for this vehicle or could something be wrong with it?
View 5 Replies
I have a 1999 Camry. I just spent $1250 (half of it borrowed) to have some basic maintenance, diagnosis, and serious repair work done. More than half of the serious (translate: expensive) work involved replacing a charcoal canister and installing a thermostat. The check engine light had been on for at least 10 years. And I had a gas pumping problem by way of the pump shutting off after only pumping a few cents worth of gas. Needless to say it was a royal PIA to fuel up my car. As far as the check engine light, a friend would clear the code so I could have it inspected.
Then more than 2 years a shop took out my thermostat because a hose had sprung a leak and they rigged up a temporary hose until they could order the part. I never went back because I couldn't afford it. I know it wouldn't have been a terribly expensive repair, but at the time it was more than I could afford. So for almost 3 years I have driven with out a thermostat and also couldn't get it inspected.
Fortunately I was finally able to get the necessary repair on my car--replacing the charcoal canister and thermostat--so that it could be inspected. I picked the car up yesterday and everything felt fine and the car ran fine.
Today I drove it about 12 miles from my home, made 3 back-to-back errand stops of not more than 15-20 minutes each and everything seemed fine. Nothing felt or sounded out of the ordinary. Then when I was leaving my 3rd stop, the car would not start unless I gave it gas. And it wouldn't stay started unless I gave it gas. In other words, the car would go, but as soon as I would take my foot off the gas to press the brake to put it in gear, the engine would die. There was no problem restarting it as long as I gave it gas, but I could not let off the accelerator at all or it would immediately die.
The car would go just fine, but if I let off the gas for any reason, even if I was driving 40 miles an hour on the street and let up completely off on the accelerator, the rpms would immediately drop to 0 and the engine would immediately die---no noise, no shuttering, no nothing---just die. This problem occurred almost the whole 12 miles back to my home. Then when I got about a mile and a half away, it went back to behaving completely normal and did not die when I let off the gas.
View 10 Replies
What is wrong with my Passat: once a week my car fails to start. When clutch is pressed and ignition key is turned I can hear relay under dash is clicking and nothing happening. It does not sound to me as starter (I hope). After a few seconds and few attempts car starts normally. I checked which relay is clicking and it was Relay # 53 (starting interlock relay), which linked to a clutch switch. Replaced this relay and after a week problem repeated.
View 2 Replies
I have a 2014 Passat TDI with a 6 speed manual. When the clutch pedal is depressed between upshifts, there is an audible groaning sound and a vibration in the clutch pedal. The dealer replaced the throwout bearing but the problem persisted. They then replaced the entire transmission and the noise/vibration is still there. The noise follows engine RPM. Is this normal for the TDI powertrain? The dealer had never encountered the noise but they did find another car on the lot with the same noise.
View 2 Replies
2001 F150 5.4 4x4 148K... I recently replaced the intake manifold on this truck and when the engine revs it wants to continue at high RPMs for about 10 seconds after letting off the throttle. When driving, it almost wants to go faster and the gas mileage is really bad. Had some codes come up and took it to AZO and had them checked. P0171 & P0174. Guess I need to do some testing on the MAF and injectors.
View 2 Replies
My 2.8 v6 2000 has been acting wierd when shifting it kind of feels like the clutch is slipping its through acceleration so when the rpm's are climbing it feels like it is slipping but than above 3 rpms it accelerates with no problem, when it feels like it is slipping the check engine light blinks, obviously telling you to stop driving, but than the check engine light goes back to a solid warning and stops blinking. just had my oil changed and after that my check engine light came on solid, now it is sluggishly bumpy when accelerating and feels like the clutch is not catching,Wish i knew what it could be.
View 2 Replies
I have a 2007 Passat with >120k miles on it. For the last month or so, occasionally when I start the car up, the EPC (I think it stands for Electronic Power Control) light and the Check Engine (the engine sign) light comes on. When I hit the gas, it barely goes past 20 and seems to be revving really high (almost redlining) before it finally accelerates. Needless to say, this is not a good thing; especially when it happens on the freeway.
I called around to a few mechanics but they all want to see the car and run the computer codes on it before they even tell me what's wrong with it; which I am loathe to do just yet because I don't want them to charge me an extra $100 for a diagnostic for a repair I may not even get done with that mechanic. Meanwhile I'm driving around feeling like I should put my feet on the ground like Fred Flintstone to gain speed.
In the research I've done online, I've seen that it may be an issue with the throttle wire or some other wiring issue.
View 1 Replies
I've got an unknown issue with my 07 Accent (1.6L):
There is a low tone noise coming from near the upper area of the engine. It sounds like air or fluid traveling through a hose. The tone of the noise has recently become progressively louder, so that it is noticeable over normal road noise when driving. The noise does not fluctuate in tone or intensity with changes in RPM. However, the tone changes to a higher pitched frequency, almost like a hiss, when the clutch is fully engaged and held to the floor, both when in gear and when not in gear.
What the cause may be? And potentially required maintenance?
View 4 Replies
I have a 2007 Passat with >120k miles on it. For the last month or so, occasionally when I start the car up, the EPC (I think it stands for Electronic Power Control) light and the Check Engine (the engine sign) light comes on. When I hit the gas, it barely goes past 20 and seems to be revving really high (almost redlining) before it finally accelerates. Needless to say, this is not a good thing; especially when it happens on the freeway.
View 5 Replies
