The other day i noticed that when i make a sharp turn left or right i hear a clicking noise. If the clutch is engaged it clicks and if its not then it does not click. It is also louder when i turn right... I am thinking CV axle!
View 4 RepliesSo the Jetta developed a new noise lately that sounds just like what can be head on this video.
The spring-clicking kinda noise only happens when i make a sharp right turn at low speed and seems to be coming from the driver's side. So i though bad outer cv joint.
Well, I put on a brand new OEM unit last night and noise is still there.
Sometime when I make a sharp turn (such as turning out of a parking lot) I hear a "pop or click" noise coming from the front end. I cant tell whether this is normal or not and I wanted to know if this was a sign of anything serious. The car only has 70k miles and is in pretty good shape. Still stock suspension.
View 8 RepliesI'm having 4WD problems with my Yukon, but the dealer keeps telling me there's nothing wrong with it (this has been going on for 2 winters now), which is either code for, "let's wait until it's extended warranty expires, so we don't have to pay for it," or "the computer says nothing is wrong, so that's all we're going to look at." When it's in 4WD, anytime I make a sharp turn or even turn a corner there's a grinding noise in the front, if I try to back up, it will only go as far as one revolution of the tires then stop (I have to take it out of 4WD to backup), eventually the "Service 4WD" light comes on, but apparently nothing gets recorded on the computer. It has 32,000 miles on it.
View 6 RepliesMy nissan sentra 2011 has been displaying this particular problem where it jerks when I make a sharp right turn. It only happens when I've just started the car and once I get it warmed up that problem doesn't happen. It happens randomly too. I hear a clunking noise and I think it might be the gears but could it be something else? The jerking stops when I press the brakes and wait for 1-2 seconds before accelerating again. What would be the worst case and best case scenario.
View 9 RepliesJust to start off im new to the camry family.I have a 2007 camry se. Well the the problem I am having is when i make a sharp turn or hit on the brakes hard my oil light flashes. Didn't know if this is a big problem or something small. the light flashes and goes rite back off.
View 14 Replies09 stx 2wd 4.6L- I have a 2.5'' leveling kit and 33'' bfg a/t tires. The problem is when I make sharp turns, or turn and go over small bumps. Whats happening is something seems to catching or rubbing it kind of jerks towards the opposite of where I am turning and causes the traction control to slow my truck (sucks on tight off-ramps/ u-turns). this happens at pretty much any speed although it gets worse as speed increases. At first I thought it was the steering stoppers but don't have any wear on them, tires do not rub anywhere. My dealer and a local off road shop cant figure it out...
View 9 RepliesI've been hearing a clicking/knocking noise when i make turns recently and was wondering if it could just be hums in need of replacement... I have a 2002 Passat, so I think its a bit early for it to go but ya never know. If they are the hubs, what causes them to wear out so quick and around how much they'd be to replace (in parts...labor varies). The noise is only when I turn, no noise at all when driving straight.
View 2 Replies2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
I have a 2010 Subaru Forester and it has started to make a weird noise when I make slow and sharp turns, like when I am pulling out of a driveway or entering a parking spot. It is not exactly a knocking noise, it is similar to the one when a small piece of rock is stuck on the tire threads, but it is in the center of the car.
View 3 RepliesI have a 2013 Avalon hybrid that is almost 1 yr old.
I have recently notice a single "pop" noise that seems to be coming from the rear when I turn right with a sharp turn.
I have looked in the trunk and under the vehicle but I cannot find where it is coming from.
I just got my 2013 a few months ago and this just started. I'm a little heavier than most people (230lbs), but I don't think that is the problem.
Sometimes when I make a turn (not hitting a bump) or go over a bump, I hear a clicking sound from underneath my seat (towards the rear)... Tried adjusting the seat and messing around with a few settings, but the "clicking" sound persists....?
This is my first VW and I have a strange clicking noise when I turn left or right and especially after a turn and the steering wheel turns back to center. Taken it in twice and no one can figure it out. I have never heard this before on any car. What this may be?
View 4 RepliesWe have an '07 wagon that recently started exhibiting the following: When doing a sharp turn left or right you can hear a rotational shhhhusshhhing sound... shussshhh *pause* shusshhh *pause*.. etc. Its obviously linked to the front wheels since going straight does not produce the sound. Brakes and rotors have 13k on them; dealer has checked out the car and says everything looks good and the bearings are fine.
Could this be CV joints or something similar? Where to look? This is not a thud thud thud (which I have heard before when another car of ours needed new cv joints). Safety is main concern, don't want bearings freezing while driving..
I first thought it was just a cold thing, but now it's not starting at all in a warmed garaged. The electrical system seems to go in and out, makes this crazy clicking kind of noise, and eventually will make the dashboard lights go entirely, the message system saying then the breaks have failed, pull over, etc., On a cold morning it won't crank, and when it finally does it will immediately shut off. Once I finally overcome it, the electrical system clicks and clicks, and eventually will lose dashboard lights and functions... no turn signal, nothing.
If I can get driving for 15 minutes or so without the electrical interference happening, it will run fine like normal and I can restart the car fine the rest of the day... but the next morning (especially if cold) I go through the process again.
Now it's just not cranking at all...it's clicking, but it sounds like a louder clicking than a dead battery... it's like the electrical system is overriding it entirely and won't let me get the car started at all.
Other symptoms: when I get the key near the ignition (not putting it in) the clicking of the electric system starts. Interior lights flicker, etc. Today it won't start.
I have 35k on my 2009 camry, (past warranty). All of a sudden in the last few days when I make a sharp left turn (like into a parking spot) I hear a grinding noise from my car. Not really a full on grinding, but like a quiet fart can muffler noise. No issues with alignment, driving straight, or sharp right turns.
View 5 RepliesI have a 2013 Santa Fe with a 2.0T. A couple of days ago, I heard a squealing noise when I make a sharp turn to the left, like maybe a power steering belt would do. This has continued and I have also noticed that the AC fan almost completely dies at the same time. Car has 6,000 miles.
View 3 RepliesAt 120k miles, my 2003 Camry LE 2.4L started to make some noise when making sharp right turn at low speed (below 5mph) going forward. It sounds like the tire rubbing the fender or somewhere, not metallic, and it's periodic, at 2-3Hz or so. It comes from somewhere on the driver side but I'm not sure. The car doesn't make noise when turning at stop or backing up or going straight, and the noise seems to disappear if turning at higher speed (maybe the turn is not sharp enough).
First I suspect the tire is rubbing the fender. But after inspection, no rubbing marks can be found, and there seems no rubbing when the car is parked and the wheel turn all the way to the right. Then I suspect a bad CV axle. But the boots seem in good shape with no leaking grease, and there's no noise when backing up.
On cold mornings if I do a sharp right turn (Left turns just naturally are not sharp, so I don't know if it's both ways). I get a rumbling noise in the transaxle. It sounds like a rumble, if it's limit slip noise it's pretty bad. It does not seem to be a problem in the summer. Dealer found nothing but if they don't do it while it's cold they won't hear it.
View 2 Replies2004 Jeep Wrangler Sport 5-speed Bought used 2yrs ago. 76,000 miles Only seems to happen after driving for more than an hour. When I either back into my driveway or turn sharp into a parking sport, mostly to right, I get a bumping sound, like something rubbing. My mechanic has replaced the sway bar links, front rotors, axle yoke, had a front differential leak so seal was replaced, and am still getting the sound. Tires Bf Goodrich All Terrain Do not do off road.
View 4 RepliesI have a binding and clicking-ish noise at low speed. Is that a sign of a bad axle?
View 3 Replies