The vehicle is a 2001.5 Passat 4 Motion V6. 120,000 miles on the Passat.
The original Cats were replaced 1 month ago after a service station deemed them dead. When the vehicle failed emissions.
The codes were p0430 and P0420 and P411.
Before that about a year ago The O2 sensors were replaced.
After 2 new catalytic converters were installed. The vehicle is still throwing p0420 and p0430 codes.
I have recently picked up a 2005 F350 with the 5.4, which has 212k on it. Has a check engine light on for P0420 and P0430, as well as some kind of a 'ignition coil 'D'', I forgot which code it was as I deleted them at first to see which would come back. After driving it, the P0420 and the P0430 came back, but not the other, yet probably. I'm guessing the misfire due to the ignition coil caused the cats to go bad and the 420/430 codes, unless these codes are coincidental and the cats went due to high mileage.
Either way, I'm pretty sure I will need to replace the cats and was wondering what is the cheapest route. Should I get individual cats and have a shop weld them on? Should I go to Advance Auto parts or Auto Zone and get the whole pipe with the cats attached to them already and then get them installed? I anything will involve welding, I would have to bring it in to a shop. Also, in regards to the ignition coil misfire, what a good way to check which one it is?
I bought this truck (2011 F-350 6.2l) used a month ago with 125000 miles on it. Of course the MIL light came on as soon as the ink dried. The codes read PO420 & PO430 and my local Ford Service said replace the cats. I said what is the cause of the failure, ford said here is a list of possible causes but it's not reading other codes so they don't know what caused the failure.
Well, I went ahead and replaced both catalytic converters, all four O2 sensors, and I replaced all sixteen spark plugs. Guess what, the MIL light is back on not 24 hours later reading PO420, PO430, and now PO620 and PO645. So I just went back to Ford today and all they did was cleared the codes and told me to call if the light comes back on. They said my PCM is up to date but why it's now reading GENCOM code or AC Clutch code.
I recently went to my mechanic after living with a very small leak right between the catalytic converters and the transmission for about 4 months. (it dropped a dime-sized mark about once every 5 days.) he said it was the rear output seal on the transmission but wouldnt touch it since there was no easy way to get to it and didn't want to drop the whole exhaust system. so off to vw dealership (wow, i guess a lot of people complained because they replaced everyone there and they're more friendly and efficient. my car usually sat there for 3 weeks before they even looked at it. (appointment mean nothing to those people.) but after dropping off my car i got a call within an hour telling me it was a cracked ventilation hose. they ordered the part and repaired it within a week (another first.) i also had them change the trans fluid and filter and the car ran smoother and a lot better and i checked for 2 weeks for leaks and none were there but within the past week, it's back and leaking the same way. the puddle is about the size of a penny so back to vw on monday.
View 1 Replies'05 GLX, 55k miles. Got an MIL light last week and it showed a P0421 code. Took it to the dealer and they replaced the right bank catalytic converter. That was last Friday. Fast forward to Weds. of this week. MIL comes back on and mileage drops noticeably, but power doesn't seem affected. Back to dealer, they end up replacing the other cat. Does this seem normal? I'm trying to figure out what may have led to this. Car is basically stock. I do my own oil changes (never overfill) and swapped out the spark plugs at 45k miles with Bosch Iridiums. [IMG] [URL] .....
View 4 RepliesGetting multiple CEL's for the catalytic converters and cylinder misfires. Looking for threads that address these particular codes ie. 0431, 0421, 0300. 0303, 0306. I have a feeling that these are being caused from a vacuum leak and/or needing a reflash for the ECU.
View 3 RepliesIt came on 2-3 miles after a cold start. 3.6 with 137,000 miles. What's next? First car I've owned that uses very little oil between oil changes.
View 1 RepliesThe catalytic converters are very hot and the one upper left, when looking into the engine, is even red. The engine runs less than 10 minutes a the converters become very hot. I think when the engine run another 30 minutes, then I have a firework.
And that's not all. If the engine is idling, it's everything o. k. But if accelerates over 2.500 RPM, then it smokes as a locomotive. The smoke is white, dense and it smells like unburned fuel.
So I ask, are the converters blocked and I need to change them, or is the engine before death?
I have some rust building on the heat shield of my cats on my 2001 Nissan Frontier.. I had a weld done to keep it from rattling after replacing the OEM muffler. It there anything I can put on it to retard the rusting process on the shield and will that affect my emissions?
View 4 RepliesMy son-in-law has a 2006 Honda Accord with over 160,000 miles on it. About 8 months ago, the check engine light came on. The code said the down stream oxygen sensor was bad. He took it to a Honda dealer and they replaced the sensor and now the check engine light is back on with the same code. Can the catalytic converter have gone bad and can it have made the oxygen sensor go bad too?
View 5 RepliesMy Equinox had problems from when I bought it used at 23K miles. The evap hose recall was installed wrong and broke. The traction control went out and shut down my car in mid-drive (twice). Computer modules went bad. Timing chain had to be replaced. Then is was using 3 or more quarts of oil before reaching 3000 miles after an oil change, with no puddles on the ground. I received a letter from GM after it reached 120k miles, but the dealership was good enough to replace the whole engine anyway due to "problems" with this year and model. The catalytic coverters were bad at the time but not replaced though the "disappearing oil" from the bad engine seems to have caused that. What can I do to get this resolved without having to spend $1500-$2000 of my own money, that I don't have right now? (oh, one wheel hub assembly has just gone bad too)
View 5 RepliesA few weeks back I got my ARK exhaust installed with no problems. Due to some personal reasons I had it removed and my stock exhaust reinstalled by a different shop over this past weekend. I've been driving it fine for the past few days but today I noticed the CEL on with codes P0420 and P0430. I hit up the shop to see what was up and he told me he didn't touch anything that should have caused this. What should I do....
View 3 RepliesSo I was getting p0420 and p0430. I installed new hi flow cats on and did coil pack 1 & 3 since I was getting misfires there. Erased the codes after all the installs and they stayed off. It's been a little over a month later since the installs and my CEL came back on, scanned it and I'm getting same 2 codes again
View 10 RepliesWe bought the 2010 RX350 a couple of weeks ago and have gotten these codes twice.. I have a good scanner and know what the codes say about Cat's bank 1 and 2 operating below threshold. I know some of you are going to say replace the cat's, others are going to say replace the sensors and neither should be the problem... If it were a cat or sensor, then they would not come in at the identical same time... It has to be something common such as a throttle body, charcoal canister, or another item upstream of the cat's... Not the gas cap either...Maybe a vacuum hose..
View 14 RepliesI took my car to get inspected today and it was rejected because of P0420 and P0430: Both Catalyst system efficiency below... My check engine is also on.
I have the full Meisterschaft exhaust installed (+midpipe) PPE headers and K&N intake. Whats the problem and how can I get this fixed so I can pass the inspection?
I have a 2013 F350 Crew Cab Long bed xl with 128000 miles on it. I just barely bought it from a small dealer and had a check engine light come on for the cats.(P0420 and 0430)
I have spoke with the dealer and he assured me that he would replace the cats. He stated he had O2 sensors replaced and thought he had fixed the problem. Not sure if he replaced all sensors or just the fronts.
He has been avoiding calls lately and will not return my messages. Anyways, My question is what should I be looking for to prevent future cats from going bad. I just ordered a bluetooth OBD 2 scanner and bought the Torque Pro App.
I am not new to working on trucks but they have all been 1995 and older and i am new to anything scanner wise and do not know what I should be monitoring. If I can't get this guy to replace the cats I want to monitor everything to make sure the cats are bad.
BTW, Fuel Mileage is at best 12.3 with an extremely light foot, Driving normal it drops off to about 11.8-12. Is this a normal MPG in these trucks? I have seen post about people getting close to 16 unloaded not smashing throttle?
On another note, I just remembered that my traction control light will come on with no wheel spin at times after starting the truck and driving away.
My truck just started running really loud when it's cold and the leak goes away when it warms up to operating temperature.I did a little bit of investigating and I have found where the leak is coming from at the end of the exhaust manifold where the donut gasket meets the catalytic converters. It appears that the bolts rotted that hold the system together at the gasket. What should I do to repair this? I don't really want to replace the whole manifold because I know I'll break a stud off in the engine because everything is pretty rusty down there. I even took some pictures of the problem....
View 3 RepliesDoes this mean the DPF is shot? I believe its integral with the cat. whats worth checking first?
View 2 RepliesTitle says it. Cat is done. Threw code p0420 and am experiencing hesitation at WOT. Already replaced my front o2 (cbfa) and now I'm debating whether or not to get a new downpipe. I daily the car and am wondering if keeping the car as is for a while will damage anything. Cts turbo has a sale for a catless downpipe.
View 5 RepliesI checked out a 2006 Prius yesterday a guy is selling. It had the CEL on (not sure why somebody would try and sell a car with that, but anyway). He said that it's because they get gas at a station that consistently doesn't tighten the gas cap enough but by the time the tank is down to 1-2 bars the light always goes away. Although I don't doubt his story, I absolutely doubted the cause. So I took it to get the code pulled and it was P0420, which is catalytic converter threshold below efficiency.
View 15 RepliesMy check engine light has been coming on and off and it seems to show P0420 for catalytic converter. The light stays off for about a week and it'll come on for a day or two and off again.
Wouldn't a failed converter stay failed? Can P0420 be triggered by loose/bad gas caps?