I got a 99 B.5 Passat..
a couple days ago.. I put water into the car cause the light came on. The next day the check engine light appeared. I drove the car and parked it for a few hours..
When I went back into the car the check engine light still appeared.. And not only that it went into SAFE MODE with all lights highlighted... PRND432..
I unhooked the battery for about an hour. I hooked it back up. I started the car put the selector into drive. CLUNK. Disengaged the parking brake. Drove. It turns out when I shifted to D it went straight to third and stayed there. I turned off the car, restarted it. Still stuck in third. Drove a few miles. Restarted it. No more issues. My guess the tranny went into safe mode, but why?
View 3 Replies1998 Passat 1.8t B5 sedan. OEM fog lights up front. No rear fog lights.
I recently upgraded to a "Euro" light switch to get more flexibility with my lights. Put tape on the TFL pin to disable DRLs in OFF Mode. Put tape on the 56d pin to disable DRLs in CITY LIGHTS (Parking Lights) mode. Completely successful -- no DRLs, just as taping the TFL pin on the original light switch accomplished long ago.
BEFORE I did any taping this time, I installed the Euro switch AS IS and tested all of its modes and physical positions:
(1) OFF: No fog light position available (switch knob will not pull out). As expected and okay.
(2) FULL ON Fog lights come on (but who the hell can see them?!?) when switch knob is pulled out one stop into the fog light position -- and the little front fog symbol on the switch lights up. Again, expected and just fine.
(3) CITY LIGHTS (Parking Lights): The fog lights position is physically available by pulling the switch knob out one stop... BUT THE PARKING LIGHTS DO NOT COME ON (regardless of ignition switch position, emergency hand brake position, etc., etc.) And the little fog light symbol on the switch does not light up. (Not surprisingly, pulling the knob further out to the REAR fog light position does nothing either.)
THIS IS NOT GOOD - since with a Euroswitch one ought to be able to manually select and de-select the fog lights while in CITY LIGHTS (Parking Lights) mode!
How to make my FRONT FOG LIGHTS available in Euroswitch CITY LIGHTS (Parking Lights) mode...?
My auto tranny goes into "safe" mode every so often. It thinks there is something wrong and stays in third gear. The d4 indicator stays on even if another gear is selected (it's indicator light is on too). I changed the fluid (clear, red - in fine condition).
View 14 RepliesWhere I live people on the highway accelerate quickly. I try to stay in the EV range up to 15 mph but, when I do someone is up my rear end.
However, when I accelerate manually in EV mode I can accelerate up to 25 mph with the flow of traffic.
My concern with repeatedly accelerating up 25 mph in EV mode will be harder ( lessen the life ) on the battery or the transmission or the electric motors.
I'm guessing it's safe for the electric motors and the transmission because the plug in prius can accelerate up to 62 mph and it's fine.
However th
So is it 100% safe for the car to repeatedly accelerate out of EV mode?
I have a 2009 SX4 Crossover, which came with a Garmin nuvi 760 ... but which has been customized for Suzuki. I actually already own a "real" Garmin nuvi that we've been using in our other vehicles, so the Suzuki customizations are fairly obvious to me.
For the most part, they are welcome value-adds over a standard Garmin nuvi 760, with one very annoying exception ... and that is the mandatory "Safe Mode".
Suzuki has apparently decided for me that I must always have Safe Mode enabled, by removing the enable/disable option for this in the Suzuki version. A "real" nuvi 760 (and for that matter all other real Garmin nuvis with Safe Mode) has a Safe Mode enable/disable toggle button on the Security settings panel; and that has been removed from this panel in the Suzuki version.
While I understand the safety issues involved with a driver trying to use certain features while the car is moving, did Suzuki forget that they also install a passenger seat up front as well; and that maybe me or my wife, while in the passenger seat, might be trying to look up some location information for us while we are driving through an unfamiliar place looking for things? The only way to get out of Safe Mode is to pull the car over somewhere and stop ... very inconvenient, especially in congested city traffic. This has happened to us a number of times now, and is really getting old.
So I'm just wondering if any way to disable Safe Mode on the Suzuki version of the nuvi 760? Or, what I am actually hoping is that the option to turn toggle it on/off really is still there but just hidden, and that maybe there is a way to un-hide it ...
I had to do some work on the car which required disconnecting the battery, Usually the radio goes into safe mode which I unlock using the 4 digit code. However this time i entered the wrong code and the radio went into 02 safe mode?? Now the radio is not responding at all to any inputs from the buttons, its literally locked. I have disconnected the battery again and left it for a bit hoping it would clear it but no luck it still says 02 safe and I can't enter the code to unlock it.
View 5 RepliesIs it safe to rev the engine while in inspection mode (forced idle). Someone has a question about checking for valve noise in the top thread about common 2G problems in the maintenance discussion, and I unsure about giving advice concerning revving the engine via the throttle motor. I will mention, I suppose, the check engine light will turn on.
View 3 RepliesI have replaced my trans and now I have a problem with it going into fall safe mode. I was told it was to do with a sensor on the transfer case. Could this be my problem? I can turn the truck off and turn it back on and it will shift out, but when I stop and start to take off it goes back into the fall safe mode, staying in high gear.
View 4 RepliesHow to bypass the safe mode feature of the navigation unit? I've found bypass modules on the internet that go for around 200 but was wondering if there's an alternative method that would possibly be DIY and very low cost?
View 2 Replies2001 Accent, 1.5L Automatic with OD, 263,000 km
Transmission goes into Fail Safe Mode but the CEL does not light up and code reader shows no codes. Shifts fine in town,1-2-3-4...4-3-2-1, but on highway when going up inclines (steep), transmission downshifts from Overdrive into 3rd,as i press the accelerator it will downshift into 2nd (as normal), until i reach the top of the incline (3500-4000 rpm) but then as the car levels out on the highway, it will shift back and forth between overdrive and 3rd, (jerky shifting) then finally goes into Fail safe mode, 3000 rpm at 80-90 km/h. Once I shut the car off for a few minutes, the transmission is fine and shifts normally. Fluid levels are good. Why the CEL is not giving code?
There had been a lot of discussion about the engine light coming on and the Engine fail safe mode. A lot of folks said the dealer could not fix it. It happened to me and my dealer fixed it. This is what the dealer did to correct the problem
EEC Tested
Code P2106
Disconnected all wheel speed sensors and reprogramed PCM per SSM 17272 and Ford Hotline
No more problems.....
I was driving down a road tonight and my entire truck shut down, and it said engine safe mode. I lost all power steering and gas, all I had were breaks and electronics. What does that mean?
View 1 RepliesI was driving at 40 -30 mph on a dark street and rammed through a bit of water ( maybe 4" high and 6 feet across). So right after i got these tranny codes and my tranny went to safe mode kicking hard when shifting:
P0705
Transmission Range Sensor Out Of Self Test Range Or Shorted To Ground
P1783
Transmission Over Temperature Condition
P0712
Transmission Fluid Temperature Sensor Circuit Input Low
P1702
Transmission Concern
Luckily I was a block away from home. So i assumed all those sensors shorted with water ( I thought they were all water proof...hmm) so i let them dry.
So the codes went away and the truck seamed fine for 2 weeks until i felt the tranny kicking again into gears yesterday. So today i went on a test drive and it was fine at first until it went into safe mode again with only 2 codes:
P0705
Transmission Range Sensor Out Of Self Test Range Or Shorted To Ground
P1702
Transmission Concern
So, that means the other sensors dried out and i destroyed the TRS? and if so would it malfunctioning cause the tranny to go into safe mode or could there be some other issue?
We have a 2006 Passat, 30K miles, live in northeast on a Great Lake. We bought it used in 5/07 with 11K miles on it. The other day, a whole mess of warning lights came on, and the car went into "limp mode." The dealership diagnosed corroded wires where they connect to the throttle valve controller. We usually keep our cars for years, and we've never had corroded wires before. Is this a typical problem of VW's? The service mgr said he'd seen about 6 come in in the last year, but I don't know if that's a lot or a few compared to other brands. We're getting ready to shop for cars again, and we'd consider a new Jetta, but not if it can't go out in the rain. Also, if the wires corroded once, what will keep them from corroding again? Should we expect this to keep happening?
View 2 RepliesJust wondering if it's possible to have the driving lights/fogs to turn on with the headlights when the switch is in AUTO? We prefer to just leave the switch in AUTO mode, but it defeats the purpose of even having the front driving lights as they are never used.
View 3 RepliesPower's out due to the storm here in New England, so I couldn't scan it yet. My wife's 4-Motion automatic '09 Tiguan has a CEL that started yesterday. Also, intermittently, all of the gears in the display are highlighted as though they have all been selected (P/R/D/S etc). I drove it this morning and it seemed to drive OK, but I don't drive it that often so I couldn't tell if it was shifting differently.
View 7 RepliesI am new to tuning vdubs i just got chipped and i am wondering what the max safe rpm is i am just curious cause when driving hard i keep it below the factory tachs redline (6000 or 6500 rpm i think) and i'd like to know how hard i can push her. I want to go with some friends to a drag strip so i can time in and have something to compare to for when i am done dropping cash into my car..
'01 Passat 1.8t 5 speed manual APR 91 octane chip
Is it safe to drive my Car my CEL came on and the code is po411. I know what it most likely is but before i take it to the mechanic and everything is it safe to drive.
View 1 RepliesI have noticed that when driving in EV mode when the car switches over to HV mode the Eco icon always lights up! Of course you can select Eco, or Power mode manually, but when it does this automatically, after the EV battery charge is used up, it keeps showing the Eco icon being lite not HV.
View 1 RepliesSo i've been searching for ways to remove the bumper/door chrome trim to change to black but cannot find anything about the b5 or 5.5. What i'm trying to do is get the chrome to black but cannot figure out a safe way to remove them to either wrap in black vinyl, paint or just replace with black strips. I'm not trying to completely remove them just get the chrome to black. Its an 03
View 10 Replies