Alright so my check engine light had came on today and i got home and scanned it and got 2 codes which were ... P0B33 AND ALSO P1136
What codes are these ? and what is causing them to give me a CEL ? and how could i fix the problem ?
My girlfriend has a 2000 B5 and it's been throwing a p1136 (Fuel trim too lean: probably a vacuum leak) and p1113 (B1, S1, pre-cat O2 sensor) for about two weeks now. How long can she feasibly leave this stuff before doing any real damage?
I just don't have time to check her manifold for vacuum leaks for at least a few months (summer) or deal with the O2 sensor. I mean she doesn't need to get it inspected until Nov 2007, so, all she has to put up with is that really annoying beeping and "emissions workshop" lightshow every time she starts her car up.
Shop said o2 sensor and they just want to replace one. I can get universals for around 80 each, will they work if this is in fact the problem?
View 1 RepliesI just had my check engine light come on and checked the codes and they were P1136 running rich at idle and P1250 low fuel level. My fuel level is 3/4 full and I just installed a K&N panel filter in the airbox. While I was installing the filter I also cleaned the mass airfow sensor and then cleared the codes. The codes have come back after 2 days.
View 4 RepliesAs title states, I scanned my gti and got P0420 (nothing new here) and P1136. I did some searching and looks like vacuum leak can cause this, however I also read that it'll affect my idle. I replaced MAF 2 years ago with a brand new OEM one, my idle is NOT rough, at all.
View 1 RepliesWhere to go at this point. I've had like three different shops tell me my cel is throwing no code. I have reset the battery, the gas lid is shut tight. Just a regular stock 99 passat 1.8t with 177k on it.
View 5 RepliesCan dealership diagnostic tools read ABS/ASR fault codes, or if those codes are even stored?
View 1 RepliesI just got a 2000 V6 Passat Wagon. The CEL light was on when I got it though I bought it knowing this. The battery was bad when I got it and I replaced it. After installing the new battery . . .. . starting worked only intermittently. It got worse and at one point I had to hold the key to the start position for about 5 seconds before the starter would even engage. Now it won't start at all. I pulled the codes (shown below) when I first got it but did not give it much credence . . . I wanted to clear the codes and drive it and re-look at the codes. . . . but I have not been able to drive it.
Other observances. . .. not sure if they are related to the car not starting:
Windows, sunroof do not roll up/down while electronic locks work. The driver side window was down when I got it and I read somewhere on this forum to use the key to raise it. . .. it worked. Alarm does not work. Radio works. . . . I found it odd that though the battery was taken out for more than 12 hrs. . . . The radio code was not required. Dome light works intermittently.
I have checked every fuse and they are all good.
Engine Codes:
18032P1624MIL Request Sign.active
18011P1603Internal Control Module Malfunction
18010P1602Power Supply (B+) Terminal 30 Low Voltage
16684P0300Random/Multiple Cylinder Misfire Detected
16690P0306Cyl.6 Misfire Detected
16686P0302Cyl.2 Misfire Detected
Transmission Codes:
17142P0758Shift Solenoid B Electrical
18158P1750Power Supply Voltage Low Voltage
Driving home car started sputtering like crazy. vag com'd it and this is what i got from the scan!
Friday,06,April,2012,16:16:02:36785
VCDS Version: Release 11.11.2 (x64)
Data version: 20120126
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Chassis Type: 3C0
Scan: 01 02 03 08 09 0F 15 16 17 19 1C 25 42 44 46 52 53 56 62 72
[Code] ....
I have 2001 Passat new body and 2.8L v6 engine light came on with bunch of codes p0491, p0492, P0455, P0300, P0304, P0306, P0305 .....
View 2 RepliesAddress 01: Engine
17965 - Charge Pressure Control: Positive Deviation
P1557 - 35-10 - - - Intermittent
18021 - MIL Control Circuit: Open or Short to Plus
P1613 - 35-10 - - - Intermittent
Address 02: Auto Trans
00526 - Brake Light Switch-F
27-00 - Implausible Signal
Address 15: Airbags
01217 - Side Airbag Igniter; Driver Side (N199)
32-10 - Resistance too High - Intermittent
00532 - Supply Voltage B+
07-10 - Signal too Low - Intermittent
Address 46: Central Conv.
00849 - S-contact at Ignition/Starter Switch (D)
25-10 - Unknown Switch Condition - Intermittent
00943 - Heated Exterior Mirror; Driver Side (Z4)
35-00 - -
00914 - Window Regulator Switch; Rear Left; Driver (E53)
27-10 - Implausible Signal - Intermittent
00930 - Locking Module for Central Locking; Rear Left (F222)
27-10 - Implausible Signal - Intermittent
[URL]
So my check engine light came on (2000 Passat 1.8T) and I have one of the generic code readers and got this:
1. P0102
Powertrain: Mass Air Flow (MAF) Sensor Circuit Low Frequency
2. P1137
Powertrain: HO2S Bank 1 Sensor 2 Lean System or Low Voltage
Now last time I had the car in they said I needed to have my throttle cleaned, but I just didn't have the time then. Could this be the reason or am I looking at bad sensors? It's weird, because the car isn't really driving any differently. I have had one side effect though, my turn signals won't come on and the hazard lights will come on, but not always. All the interior lights, headlights, brake lights are working fine.
So one day when I was driving, the CEL comes on, and then I go to autozone to get my free diagnosis. I got codes: P0441 and P0171
My engine is running fine and everything else seems to be in order. However, I have to get a new canister purge valve and new oxygen sensors, in order to be in the clear.
For the Oxygen sensors, I have AN IDEA of where they're located; somewhere underneath the car, by the catalytic converter (the converter is in between the two connectors, apparently). I have yet to do this and would like some opinions on what to do for it.
For the Canister Purge Valve, I have no clue where to look. I pop open the hood and I notice a diagram with labels. Great, but there are just too many other pieces to look at...I do not know if it is visible as soon as I pop open the hood, or if I have to dig deeper, or even if I have to remove the fancy plastic thing that covers the engine.
Does this mean i need new injectors? wiring harness? whats the deal here?
View 2 RepliesCodes P0491 and P0492 ... The Air pump works, so what's the problem? Perhaps the combo valve? If so how do I check this?
View 1 RepliesMy 2.0T CEL flashes on start up for about one minute as the motor shakes and sounds like an exhaust leak, then it levels off and runs fine and light goes off. No codes recorded. I have changed plugs and coils and PCV valve.
View 5 RepliesP0302
P0301
P1545
P1300 X2
I have no clue what is wrong but I have an exhaust leak and when I am accelerating I can hear the loud shhh sound like the turbo is leaking but I still have power like normal.
Where do I start, 97 Passat VR6 Wolfsburg Edit, 01M trans with AAA engine. 140000 miles. Here is what it is doing! Starts and runs fine.....until I stop, turn the car off, let the fans cool the engine, and then try to start it up again. Then All breaks loose. Car is running rich, almost dieing, sputtering, throws ALL sorts of engine and transmission codes. Everything from MAF sensor to misfire to trans solenoids, I mean the codes are all across the board.Then I can take my generic scanner and reset the CEL and all is good for a couple of miles.
Now, here is what I have done to the car:Tranny: new synthetic oil and filter, removed, cleaned and replaced the valve body with new solenoids, and complete wiring harness, NEW Transmission Control Module. All new 3 New trans sensors, 1 Trans Speed Sensor and 2 other sensors, g38 and g68 i think.
Engine: New, Bosh,Synthetic Oil and filter, New Ignition Switch and Key and tumbler.New Valve Cover Gasket,Bosh, Plugs and New Bosh Plug Wires., Brand New Vw ignition, Brand New Bosh, Auxiliary Water Pump and rubber gromets. New tires,...Pulled floor pan carpet out and dried up mat after the rain where my daughter left the passenger side window and sunroof open. I will try to drive it today without turning any of the lights on the dash on to see if possibly I have an electrical issue with the dash and lights or something.
98 passat 1.8t has the abs light on and the exclamation point. Scanned it using vad. Nothing showed up in the scan. Also turbo whistles under load. And trans slips. Nothing showing up on vad.
View 3 RepliesAs I said before I thought my emissions valve was bad because the car wouldn't start after a fill up but the coils were bad too so I took them in to be replaced first since I didn't have a CEL for the valve. The CEL went away till today and when I pulled them I got these 3
P 0441 EVAP emission purge flow fault (why it wouldnt start after a fillup)
P 0171 System Too Lean (Bank 1) (probably from when it started like crap)
P 0299 Turbo underboost
The third one is the one that's getting me. Ive had the evap core go bad in nearly all of my VW's so im familiar with the codes that go along with it, is the 0299 a part of it as well?
So I have my CEL light on error codes are P0036 & P0141.... how do I fix it??
View 1 Replies