Passat (B5) :: CEL And Error Code P1476
Dec 11, 2009
I have this error code on my VW 1999 passat 1.8T automatic car. How to resolve it. My friend reset it and CEL went off for few days and now it came back again. How to resolve it??
View 2 Replies
Dec 11, 2009
Advertisement
Avalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
Passat (B5) :: Getting Error Code 0012?
It happened to passat. Once I hit about 75mph on highway I get a stop engine (oil presser low light). It flashes than goes off once I lower my speed. I checked all fluids are normal. It throws a 12 code an says oil passage blocked, cam positioning sensor, skipped timing chain. These are what the code says could be wrong with it. The car runs fine with no hesitation at idle or normal city driving. I have already flushed the oil with cleaner, and still getting the light.
View 5 RepliesPassat (B5) :: OBD-II P1818 Error Code - Faulty TCM?
I was able to borrow an OBD-II scanner to read the error code(P1818) currently displayed. I was wondering if the P1818 Error Code is related to a faulty Transmission Control Module (TCM).
View 1 RepliesPassat (B5) :: Pulled Over Error Code P0741
My cousin's B5 wagon automatic 1.8T ('00) was shaking and vibrating intermittently. I took it down to Autozone and borrowed an OBD2 scanner. This is what it said (only one code, and the CL was off, although it comes on intermittently):
P0741 - Torque Converter Performance or Stuck Off
Passat (B5) :: Error Code P0491 Detected
The CEL tripped yesterday and this is the code autozone pulled. WHat does it mean.
View 3 RepliesPassat (B5) :: 2000 - CEL Came On - Getting Error Code P1176?
Check engine light is on... Then about 2 mins into driving Emissions Workshop comes across the dash.. i Ran the code it says
P1176 Oxygen sensor correction limit attained (bank 1)
What exactly does that mean in other words. also what is bank 1? im not sure what oxygen sensor it is out of the 4 of them.
i have a 2000 30v 4motion.
Passat (B6) :: Error Code P0016 After Oil Change
P0016 - Crankshaft Position | Camshaft Position Correlation
Bank 1 Sensor A
2006 Passat - 3.6L V6
Here is my issue: I was lazy and waited a bit too long to get my oil changed. I finally did 3 days ago. I have been very busy so I decided to take it to a local mechanic to let them take care of it. They flushed the oil, ran other oil through it with a new oil filter, flushed that, then put in new synthetic oil with another new oil filter. They also replaced the air filter.
Everything was fine for 2 days.
Then, while I was driving in stop and go traffic, the "EPC" and "Engine Malfunction" lights came on. There was also a loss of power and the car seems to wait too long to shift gears.
So, I took it back to the mechanic who had it a few days prior. He pulled the code from it (posted at the top), and cleared the code from the car. That mechanic told me that I need a "cam position indicator sensor". He also claimed that what he did had nothing to do with this issue. I decided to check with the dealer. He cleared the code and I left. After clearing the code, the car drove fine for most of that day, then it returned.
I spoke with the VW dealership's shop manager and he said that he does not believe that is the issue at all and asked me to bring it in. He also mentioned a clogged oil line as being the potential culprit.
Passat (B5) :: CEL On With Code 1476 - Error Reappears After Clearing
I have VW 1999 V6 Turbo Passat automatic Sedan.
It's Check Engine Light [CEL] is ON for a while. The code comes as 1476. The mechanic tried to erase the error, but CEL comes back after 60-100 miles. Clearing the codes works for awhile but Error reappears.
The code is for "EVAP Leak detection pump Malfunction/Insufficient Vacuum".
The local mechanic is not sure what to do about it and suggests me to visit the Dealer/showroom. After last time visit to the VW Dealer/ Mechanic, I am sacred to go again, due to exorbitant cost of the last repair. I don't think it was justified.
What should I do now? Where to start?
Passat (B5) :: Whistle When Accelerating / Error Code P0411
I have this whistling noise that developed after re installing my stock airbox. Seems to have just started right after installation. Cant seem to pinpoint what is going on. I also had a error code come u p(p0411). 1.8t b5.5 passat ...
View 2 RepliesPassat (B5) :: 1998 - Error Code P0411 / Misfire On Cylinders 1 And 3
So i got a 98 passat sedan used and was told it read a p0411 code. The person at autozone told him it was a cam sensor. The sensor was replaced. I know now from the manual that codes reads for sec. Air injection system , incorrect flow. It could be the vacuum lines. Now lets say it is the vacuum lines. Their is a misfire on cylinders 1-3.
View 4 RepliesPassat (B5) :: Misfire Detected - Error Code P0322 And P0302
I bought my first VW about 3 months ago (so excited!) It's a 2003 Passat, 5 spd, 1.8t. I've had one thing happen so far (until yesterday). On 4 separate occasions when I'd go to start it, it would crank for a few seconds before it would start. Then once it was running the EPC light would turn on. It seemed to be running normally but I turned it off and restarted it and it started normally and the light extinguished (the first three times). The last time (about a week and a half ago) it kept doing it each time I started it, and upon starting probably the 4th time in a row the MIL came on. I drove it about a mile, turned it off for a few minutes, then turned it back on and it started normally with no malfunction lights on. It's been normal since then. Until yesterday...
Yesterday as I'm accelerating from a stop light (I think I was in 3rd) all of the sudden the engine started running really rough and the MIL came on. I turned around and drove about 2 miles back to where I started at about 20mph. The MIL would be steady while coasting and flash while pressing the accelerator. I got a hold of a diagnostic computer and it came up with 3 codes...
1) P0322 Ignition/Dist Engine Speed Input Circuit No Signal
2) P0302 Cylinder 2 Misfire Detected
3) P0302 Cylinder 2 Misfire Detected PENDING
Passat (B5) :: Check Engine Light Came On - Read Error Code?
2003 1.8t passat wagon. 50k miles... The check engine light came on today. Oil and engine temp are fine. Can most shops plug in and diagnose? Can I get one of those code readers at Advanced Auto parts to read the error code?
View 5 RepliesPassat (B6) :: Check Engine Light On (Error Code 4608)
What is the meaning or the fault concerning 4608. The above error code was reported on the computer diagnose machine and it referred me to look into the vehicle ownership manual book BUT its rather unfortunate that i could not find that book. So, what to tackle or replace on the engine to enable the check engine lite go off.
View 17 RepliesPassat (B6) :: Engine Error Code P2181 / Coolant System
If I am not mistaken this error code means that I have a coolant system issue. I've checked both of my radiator fans and they both spin, so it makes me think that its the thermostat issue. If I am correct, any link to a replacement part? Or better yet a DIY? I've searched and no dice.
View 12 RepliesPassat (B6) :: 2007 - Error Code Of P0171 System Too Lean
I have an 07 passat with a 2.0 4 cyl turbo and I have an error code of P0171 system too lean (bank1) but engine seems to run just fine, what this code means, am wondering if it is something I can fix or if it needs to go to the shop??
View 2 RepliesPassat (B5) :: Check Engine Light - P0118 Error Code
I got a P0118 error code on my car. Looked up some things and most people were saying change coolant temperature sensor. I changed it 2 days ago and have not had a chance to clear the CEL. Its still on now, guy at Autozone would not clear it, said it was against company policy.
Will this turn off automatically once problem corrects itself? I went to Autozone and had them rescan the error, this time another code poped up P0444, EVAP(Evaporative Emission System)Evaporative Emission Control System Purge Control Valve Circuit Open. What this can be?
Passat (B5) :: Getting Error Code P3081 - Coolant Temp Sensor?
P3081. What the hell is this code. I think it is a coolant temp. sensor issue.
View 3 RepliesPassat (B5) :: 2001 - Getting Error Code P0343 While Using Scan Tool?
2001.5 1.8t, I have this p0343 code when I used the scan tool at murrays or oreileys whatever the h they are now (it means something like cam angle sensor high input). The t-belt was due for service a while ago , am I looking at a sensor problem or a wiring problem or a timing/engine problem? How should I check and where? I hear the timing belt can be a pain on the 1.8s, I have done a mk4 trans and a bit of other stuff but I do have a lot going on right at the moment and I'm not sure if I have time. I have a feeling if I take it in for service they will probably find blow through from the turbo and pull the engine because of "sludge".
View 2 RepliesPassat (B6) :: Radio Turning Randomly Off - Error Code Triggered By Low Voltage
I had this problem for a while. My radio is always on when I stop the engine in my 2008 Passat. But lately, the next day when I started the car the radio was sometimes off.
Well, apparently the random turn off was an indicator that my battery was slowly getting bad and not holding a full charge. Yesterday my engine light came on and when I took the car to the service department they found out that the error code was triggered by low voltage.
At the end, they changed the battery. This is the first time I am changing the battery on this car since I got it in 2008. So 5 years on single battery is pretty good I assume.
Passat (B5) :: 2004 V6 Difficult To Start Occasionally - P3081 Error Code
I have a 2004 Passat V6. Couple of weeks ago the check engine light went on. I went to AutoZone and checked. The code read P3081 (low engine temperature). I knew it might be caused by bad coolant temp sensor or T-Stat sensor. I also experienced that the engine would not start occasionally (prior and post the light on).
My question is that whether the low engine temperature can cause the difficulty to start the engine? How can I figure out which sensor is bad?