Passat (B5) :: 98 1.8T Stumbles And Almost Dies - Total Loss Of Power
Jun 24, 2009
Driving the 98 Passat this morning everything fine. Then total loss of power, give it any gas and it stumbles and almost dies. Idles fine, can rev it in park or nuetral. Starts and idles fine, give it gas and it starts to move thens just dies down. If leave foot on accelerator, will move at idle pace but stumble with no power whatsoever. No "check engine" light. DOn't have a VAG tester but do have OBDII. Haven't checked if any stored codes. Will an OBD code be stored an not light up the CEL?
View 5 Replies
Advertisement
After installing new struts and springs, I have now lost power steering. The car was fine after the strut install, but after driving a bit, the power steering quit. Can this be related the install, or completely unrelated?
View 10 Replies
I drive a 2007 Prius, I just purchased it about four months ago. Today after filling up with gas I drove about 60 miles and suddenly three lights on my dash came on. The all system light (the red triangle), the check engine light as well as the VSC or VCS what ever way it goes, my electric batter was also low on charge having only one bar(my car is not a plug in, the battery is recharged by the engine) then the car lost all boost and while pressing on the gas it was not accelerating. I pulled over and put it in park so the battery could charge. It charged to half way, however the lights stayed on.
My car then started running really rough, I am still in park at this time. I put some gas stabilizer in my tank because I thought maybe I got some bad gas. I left my car sit for about five minutes before turning it back on. All the lights were off except my check engine and my car started running normal. Then about three minutes later all the lights came back on and the car started running jerky again. When I push the gas to move I can, however I've only gone about four feet because it is running so rough.
View 6 Replies
The other day I was driving down the 710 I-CA at around 80mph but as soon as I got on the east ramp for the 105 fwy I lost total power as the engine had just cut off and my check engine, battery, and oil lights went on so I came down the ramp in neutral. As soon as I stopped I popped the hood and saw that everything was ok I tried to restart the engine but it didn't work.
At the time the starter would crank the engine so I thought that the alternator was the problem. I had it towed home and changed the alternator but now when I try to start it all I get from it is a single crack from the starter and no crank. I tried to move the engine by hand and it wouldn't budge. I opened the engine thinking if could be that the timing chain broke but it is completely intact. My car is an 04 Toyota Matrix XR with a 1ZZ-FE engine....
View 9 Replies
I recently had the high and low pressure tubes on my power steering fail causing a total loss of fluid. After about a week of living with manual steering, I brought it in and had the tubing replaced. Everything worked fine, though the steering felt a bit sloppy to me. Today, on my way home from a 100 mile trip, the car decided that turning left just wasn't something it wanted to do.
So to turn left, I would have to back up and turn the wheels to the right. Not exactly an efficient way to drive in traffic. Do I try to get the car back into my mechanics place to see if he can fix it for a reasonable amount, or should just bite the bullet and look for a newer car? BTW when I had brought the car in for the tubing replacement, they showed me where the bracket holding the strut on the left had begun to crack, probably from driving without the power steering. 1998 Malibu LS ....
View 3 Replies
1965 F100 300cid electrical drain...
I am attaching a link to my thread in the 1960's truck forum : [URL] .....
With my limited skill level, I have given up! It could very likely be something I am doing wrong with the diagnoses/troubleshooting.
Basically, When I turn the key to start the truck, I get a clicking solenoid at best and what appears to be a total loss of power. Not even the dome light will come on. The starter is new as is the solenoid.
View 2 Replies
We have a 2011 Santa Fe we got last October. We have had four different instances where the vehicle suddenly stalled out. The first was within a few weeks of purchase and was blamed on a loose battery negative post that prevented the battery from recharging correctly. When we called the dealership service department we were told that we were not driving it long enough to recharge the battery and that the battery light would go out once it recharged. Well all the lights went out when the car died going through an intersection at night with my wife at the wheel.
The second through fourth issue is that without warning there is a total loss of acceleration then the engine light comes on. The first time this happened my wife was able to steer off the road and after a few minutes was able to restart and drive the car home. I then drove the car about a mile when it happened to me. The car was towed to the dealership where they said there was a required software update. Really?? After that it drove fine for about a month then stalled when my wife was merging onto a freeway.
The dealership checked and found three active codes: P2106 Forced Limit Power, P2110 Force Limit RPM and P0638 Throttle Actuator Control Range. They also checked TSB updates and found (12-FL-004) for ECM. They also called Tech Line and recommended change of Throttle Body Assembly. This is all under warrantly. We got the car back yesterday.
View 5 Replies
I have a 2007 F350 6.0 Diesel. Truck starts and runs great for about 10 miles and then loses power and slows down til it dies, it does this without any kind of warning and does not rattle or anything. If i let it sit for about 15 min it will start right up and drive fine for another 10 miles or so and do the same thing.
It did the same thing in December but would not restart at all and the ficm was the cause at that time so i went ahead and replaced the ficm just to eliminate it. I also replaced the fuel pump and the ipr and icp valves are good. The only engine code has to do with the fuel level sensor and that has been on for a year. The egr was recently replaced, the hpop is putting out the psi that it is supposed to and there are not any internal air leaks.
View 2 Replies
Well I replaced the spark plugs on my 2000 ranger 2.5 l . Because the tabs for cylinder 3 and 4 I had to take of the intake. After all this i go to start it and it runs fine. When I drive it up the street it starts knocking and stumbles and dies. Now it runs with some sort of knock. Should I take it to a mechanic?
View 6 Replies
Ole girl finally let me down, or I let it down at 224,000mi. Started just fine one early cold morning and in about 30 seconds started stumbling and down for the count she went. Acts like it wants to run but will only stumble.
Checked inertia switch (ok) and all vacuum lines/caps appear to be fine. I was kind of due for new set of plugs/wires and a fuel filter. Replaced all didn't see any problems with the old when pulling. She will run for a few seconds, but stumbles and not smooth while running. Checked fuel pressure KOEO 40psi steady. I can hear fuel pump charge system per as usual.
Seeing as it is super cab checked for chafing on wiring to fuel pump under cab. Looks fine. I've heard tell could be alternator, which seems odd to me. Wondering if it would be worth pulling it off and taking it in for a bench test? Maybe I missed something. I know the intake gasket is suspect.
View 14 Replies
I have a 2007 LS460 L. It has recently started losing electrical power in fraction of a second intervals. The map data sometimes works or displays an error on the screen. The radio has been functioning but now is also starting to flash off intermittently. Now when this happens it feels like the engine dies and ALL electrical is off and then power resumes. This affects steering, engine power and brakes. My wife drives this car and loved it until now.
View 6 Replies
I have a 2001 f250 super duty extended cab with the v10. Over the past week it has been running fine and it will all of a sudden lose power and dies. I've been able to start it back up once right away and a few times it started up after a few hours of messing with it.
So, after the truck dies it will crank and crank but will not start. We have checked fuel pressure and nothing. Then we applied direct current to the fuel pump and it turns on. Then we applied direct current to the fuel pump slot in the fuse box and got a fuel pressure reading of 40 psi. But when we crank we have no pressure.
When we apply direct current to the fuel pump slot in the fuse box the truck will only crank and not start.
View 11 Replies
My partner's SEL (not Premium) with 2.5L sometimes stumbles/"hiccups" from a stop with the air conditioner on. For example, starting off at a traffic light. My partner now says it happens usually while sitting stopped with the ac on.. It's just a momentary hiccup-type thing, but the engine doesn't stop. I have to say, I've ridden in the car with him quite a bit in traffic and it hasn't done that while I've been in the car.
View 2 Replies
I have a 2007 Chev Tahoe. Description of Problem: Past month engine light came on. Then some days for a short time will go off. When light is on the auto start wont work. Battery has been drained so today I changed the battery and have a total electrical power system failure. Zero power to anything. Last month I put a scanner on it but i didnt save the code. It was related to a "throttle body module" i think. Have been reading about the BCM also so im at a complete loss...
View 4 Replies
I have 57K miles on my 1.8t. It runs great except for the first start of the day. About half of the time, first thing in the morning it runs rough for the first 30 seconds. Like it is running on 2-3 cylinders. Then it sorts out and runs great the rest of the day. I took it to my dealer where they charged me $200 to replace the spark plugs. I would prefer to fix this myself if I can.
View 2 Replies
I am having issues with loss of power, feels like engine is not getting air. Wondering if their are any fixes or tests I could attempt myself. Car facts:
2007 b6 2.0t .... 107,xxx miles
Have not cleaned intake manifold yet - on my to do list
P-flo intake (thinking of changing/ changing filter
Can follower/timing belt serviced recently
View 14 Replies
2001.5 V6 Tiptronic ... A few times in the last couple of months I've felt what I think is a quick lapse in power, like 1 sec. or less. I say "think" because sometimes a bump in the road, traction related, or some other perceived issue can feel strange, especially when cruising along on a smooth cruise-controlled drive.
Each time this has occurred I've been in cruise control, freeway driving, relatively low speeds (65 MPH) . No other signs of anything wrong, chimes, flickering lights, vibration, nothing.
I can't be sure this time around but it seems in the past it's been on the same stretch of freeway, perhaps the same spot. In other words perhaps just a subtle anomaly in the road ...
View 6 Replies
My 2001 VW Passat 1.8T manual transmission is experiencing loss of power/hesitation during acceleration. Occasionally the check engine light will blink for about 10 seconds during this time. My valve cover gasket blew about 7 months ago. I had it replaced along with 2 ignition coils. Since then I have had replaced the other 2 coils and spark plugs because of this recurring problem. I have also replace the mass airflow sensor for the second time. The diagnostic check continually shows misfires in different cylinders for which I again tried replacing the coils. I have also received the codes for "fuel mixture too lean" as well as for too rich. What could be causing this?
View 4 Replies
I have VW99 Passat 1.8L Turbo, automatic with 170K on it.
My car shop changed engine oil yesterday with 4 QTS of Mobile 5W40. Now, when I check my dipstick today, on level surface, the oil level is way too high on dipstick kink [the cross-hatched mark]. I run the engine, shut it off, and let it set for 3 min, but still the level is too high above the Mark. It wets the dipstick almost till the top of its Head.It was reading High when I first checked it, this morning, before starting my car.
It seems the oil is 'overfilled' or showing over filled; and the engine is about to throw it out from "filler cap" where Dipstick goes in the engine. I saw him using 4 cans 1 QTS oil, which I bought, into my car. They did change the "oil filter" at the same time?
Now, my car looses power while driving. When I accelerated from a stop/light, car slows down or limps. The car suffered a sudden loss of power.It runs awful for about a mile but smoothed out after acceleration.It feels like the car is running out of gas for a few seconds, then all of a sudden it kicks in. The car still drives ok though - No error messages/warnings on dash,CEL, no smoke, no hissing. I actually don't see engine oil thrown out or leaking though.
I don't know if the shop drained the "intercooler" while changing the oil, also I know nothing about its importance to my power loss issue. The net search manual/states "The engine oil, above the level, can be drawn into the crankcase ventilation system, and enter the atmosphere via the exhaust system". But it does says about damaging the engine/car.
Should I be worried about the damage to the engine?
View 8 Replies
Ok, so I have my VR6, and I have a 2.0T as well. My 2.0T feels MUCH faster than my VR6, and I don't think it's normal. What's happening is when I put the gas pedal to the floor, the car almost acts like it wants to die, the RPM's go all the way down, and there is complete power loss for a few seconds. Then all of a sudden, all the power is there at once. Weird, right? For some reason I keep thinking it's related to the transmission. It almost feels like the car has no idea what gear to be in and doesn't know to downshift or something.
View 14 Replies
Air blowing noise that sounds like a disconnected turbo or hose. Loss of power accelerating and downshifting.
View 4 Replies
