New owner of a 2005 Passat GLS TDI.
For some reason, the Hazard switch clicks a few times after using the turn signals (randomly), or while driving it will start clicking for a few seconds. The lights do not flash. it is only the audible sound coming from the hazard switch area.
Where does that sound come from? the hazard switch? Would replacing the switch with a new one fix it?
My neighbors 02 250 6.8l the turn signal/hazard relay is clicking with key off, sounds exactly like a turn signal when truck is off and switches are not engaged. Here's the weird thing, if you hit the brakes the relay stops clicking, if you engage the turn signal or the hazards the lights on the dash are in time with the relay as it should be, but when the turn signal switch or hazards are turned off the relay keeps clicking except when you hit the brakes. Also the turn signal will work with ignition off, if you pull the relay out the turn signals and hazards are inoperable but the brake lights still work. I swapped in a new relay and same thing...
View 8 RepliesI've blown my turn signal fuse for 3 times until the relay burned out. Now I have had cleaned turn signal switch (with CC) from all of the old stuff in there and replaced hazard switch. But it happens again! After 5 minutes driving, both fuses (7,5 AMP for turn signals and 15 AMP hazard) blown out. I'm afraid there are some shorts in wirings.
I'm looking for the wiring diagrams or any other users experience in this matter... Where shall I start from?
There was a water leakage behind and under drivers seat. I removed trims etc. to lift the carpet to take the Comfort Module for checking as there were some weird thing in overall car electric systems (central locking, saloon lightnings, electric windows and dropping gauges on instrument panel. I found a small amount of water in container, where the module is placed, but on the electric parts weren't any water marks... Also it's impossible to connect to the CCM via vag-com.
Example, if I'm turning the wheel to the left with the left turn signal on there will be a LOUD click, click, click ect. sound from the column. The sound is louder than the turn signal relay and can be heard with the radio on.
Today is the third time I've brought it in to have fixed and now they tell me it is "normal". They came to the conclusion that it is "normal" because two other trucks on their lot make a noticeable clicking sound and one is just as loud as mine. However, My truck JUST STARTED making the noise a few months ago and was quiet when I originally bought it.
I know this is not a big problem ,but it is annoying and I want it fixed. Anyways, my Ford dealer had bailed out on me so how do I fix it myself?
Can you hear the column switch clicking ALOUD in your truck?
My 05 Malibu classic is making the turn signal clicking noise constantly which then causes the warning chime to start going off. I have replaced the turn signal assembly three times and each time it fixes it for a short time then it starts again.
View 4 RepliesI have a problem with turn signal. When I switch it on it blinks one or two times, and then stops. It is for both directions. Where might be a problem? The switch or relay?
View 4 RepliesMy turn signal relay clicking and stuttering randomly. When turn or warning signal used it operates normally with absolutely no problem and sounds healthy. But when not used and supposed to be quite - it goes again. When stuttering - there is absolutely no indication other than clicking sound that something is wrong.
View 11 RepliesThe turn signals and hazard lights on my nissan sentra are working some times and all of a sudden they stop working. The problem is occuring almost every day. What could be the problem?.
View 4 RepliesI have a 1998 Ford F150. The turn signals do not work nor the hazard flashers. When I trun on the hazard flashers(they do not come on) the turn signals will then work. Checked all fuses both under dash and in the engine compartment. With flashers turned on and using the turn signals, the relays located in engine compartment are working. It appears that the only way for the turn signals to work is to recieve power through the hazards.
View 2 RepliesThe turn signals/hazard flasher on my 99 Sebring Jxi stopped working a couple of weeks ago. When I use the signal lever or press the hazard flasher switch, you don't hear any click of the flasher relay, and the lights (front and rear, and on the dash) don't light up at all.
So far, I have:
* Checked the fuse
* Replaced the flasher
* Replaced the turn signal switch
* Replaced the flasher AGAIN (mechanic says that if there was a problem with the turn signal switch, it can burn out the flasher)
* Checked the fuse AGAIN, and even replaced it (even though it's the same fuse for the wiper/washer, and that's still working)
I asked my mechanic about it, and he said that a bad ground can also cause problems. The big question is: where do I begin to look?
I have a 2003 V10 Excursion with an electrical problem. The right turn, right brake and right hazard light do not work but the flasher makes the clicking noise. When the right turn signal is on, the right front turn signal light works but is at double speed. The right rear light does not work. Same when brake and hazard are applied.
I checked the bulb socket with a multi meter and have no current. I also checked my trailer plug and have all functions work. Fuses were checked also for the brake circuit and were all ok.
My Jetta has had an off-and-on clicky turn signal sound without turn signals or hazard lights actually blinking. I put up with it for a while, but recently it's been more clicky than not. I'm aware this is a common problem. I had already tried the cleaner spray "trick" which made the problem worse if anything. Today, I removed my signal stalk as described here and gave it a cleaning. After re-assembling, the clicky problem didn't go away, and now the high beams are always on (even with the key out of the ignition, and the car isn't running). I temporarily dealt with this by pulling fuses 18 and 19 for high beams. It's an ok short-term workaround. Low beams still work fine.
I'm considering replacing the hazard signal relay, but a while ago I messed up while trying to use ghetto removal keys to pull my radio.
I have a chevrolet optra 2007 and the hazard lights won't work unless the turn signal (left or right) is switched on at the same time. Turn signals work perfectly fine.
View 7 Replies1994 Econoline E350. All the other lights work but on the front right the turn signal light flashes but the Hazard lite will not flash. I check for power at the wire at the light and there is none.
View 6 RepliesThe right turn signal on my 1998 Ford Explorer recently stopped working. The flasher was making a horrible buzzing sound when I tried to signal right, but worked fine signaling left.
I just replaced the flasher, which has cleared up the buzzing noise when trying to signal right. The flasher clicks like it's supposed to, but the lights still do not flash.
Here's a summary of the current symptoms:
-Hazard lights work fineFlasher clicks; interior indicators flash; exterior lights flash
-Left right signal indicator works fineFlasher clicks; interior indicators flash; exterior lights flash
-Right turn signal does not work
-Flasher clicks
-Interior indicator stash off; exterior lights stay off
What to check next???
I have been reading threads all day. Noone seems to have exactly the same issue so I'm just looking for some clarification. Turn signals dont work but lights work as "parking lamps" and internal climate lights are not illuminating either. Also, my blinkers making the clicking noise but much faster when the turn signal bulbs are not flashing. I had a radio issue but that is resolved. Where do I start? Do I go right for the hazard relay? I read somewhere there was an ignition relay that could potentially be causing all of this?
View 7 RepliesI've got a 2001 f150 supercrew 4x4 with the 4.6. I plugged in trailer lights and now I have no brake, turn signal, or hazard lights. I've checked fuses and none are blown.
View 8 RepliesI have a 1998 VW Passat: The windows go down by themselves
Door locks are clicking
Hazard lights are flashing
The car isnt always running while this is happening, key is not in the ignition. Car can be unlocked or locked and it still happens.
needed to replace the turn signal switch on my 91 caprice. when reassembling i could not seem to get the steering locking mech to engage the way it should. I would like a diagram or photo illustration of the correct position of those parts.
View 7 RepliesGot this weird problem that the turn signal switch clicks by itself, randomly. And it gets worse these couple days. So I decide to take it apart to take a look.
Cleaned it up and it works like new now.
Took some photos .....
I just bought a 98 passat sedan v6 four days ago. When I purchased it the turn signals and hazards were working. I was driving yesterday and they went out all of the sudden. Thought it was the fuse at first, changed it, still not working. I bought a turn signal flasher relay, but the repair manual doesn't tell me which one it is so I can change it.
View 2 Replies