Passat (B5) :: 2003 - P0421 And P0431 Codes - Slight Miss At Idle
May 27, 2012
2003 passat wagon 2.8l v6 with p0421 and p0431...a slight miss as well...
Cold start up is fine and initial driving. After car warms, there is a slight shutter at idle (just occasionally) and upon acceleration with low rpms. (It really feels like a miss) Went to AutoZone and came back with the codes above. I thought it might need a new coil but now I am not really sure. I want my performance back but seriously doubt cats are bad at the same time.
View 3 Replies
Advertisement
I just bought a 2002 2.8L Passat 4Motion. On the way home, the check engine light came on. My friend lent me his generic brand diag tool to scan that check engine light. It came up with two codes. The first one was:
P0421
Warm Up Catalyst Efficiency Below Threshold (Bank 1)
The second code was:
P0431
Warm Up Catalyst Efficiency Below Threshold (Bank 2)
What this means or what I need to do to fix it? Is it a matter of cleaning something or replacing something? If it's something I can figure out, I'll do it on my own. Mistakenly, I erased the code and now the light is gone--thought I was deleting the code from the handheld unit. I can't open my hood.
View 2 Replies
I just bought a 2000 VW passat with 63k. I had it for a week and check engine light came on. 30 v engine ....
p0431 /16815 bank 1 below threshold??
p0421/16805 bank 2 below threshold??
Cat? or 02 sensors???
View 3 Replies
2003 F150 5.4 72852 miles
I have a Rough Idle & sometimes a hesitation or stumble on acceleration. I cleaned the MAF & IAC motor & Air & Fuel Filters are new. I got a 20890 scanner & ran test 6 53 as suggested in many posts by BlueGrass. Here are My results & what They Convert to.
1 00F5 .3675
2 0051 .1215
3 0000
4 0000
5 00A3 .2445
6 0000
7 0000
8 0000
I'm guessing the cop's are ok & probably need plugs? I was hoping to just swap a coil. Too cold to do plugs & truck won't fit in my garage.
View 3 Replies
Early 99 7.3. Runs ok has a slight miss at idle however every injector when unhooked makes a change. Has white and blue smoke From the exhaust. Has enough blow by to blow the oil cap off as your unscrewing it. My question is, I know engine restore is bad for these trucks but I can't afford to rebuild the engine. If I run the restore and then clean the IRP once the truck dies is this going to mess anything else up. Do you think it will by me a few months to save up for a rebuild
View 9 Replies
I have a 2001 Excursion with the V-10. Two weeks ago, the upper nipple on the radiator cracked and I overheated. Was towed home and replaced the radiator with a quality aftermarket one. I then drove to the whiz wash and cleaned the antifreeze off of the engine.
Immediately I noticed a slight "miss" when cold, particularly when backing out of my driveway. I have no lights on the dash and it is throwing no codes. The miss gets much better (almost gone) when the truck is warmed up.
View 2 Replies
Woke up to go to work and it started up with a rough idle, got a block down the road and it had a slight miss under acceleration. Guessing its a bad coil, I've got a spare featured I'd play I I mini miny moe when I get home unless.
View 5 Replies
I have a 2013 F150 4x4 with a 6.2 and it has a slight miss at idle. It's done this since new and over the 20kms it has now I've been given the round around on it from 2 different dealers. I'm told there is no code so they can't do anything. I'm thinking maybe a coil? Or perhaps injector?
View 6 Replies
Im a newbie to the Camry's. Picked up from a relative a 07 Camry for $5k. It has 103K on it.
It has an issue to where it has some codes and the check engine light on with P0018, P0019, P0300, P0302, P0306 codes. They just all cam eup al lof a sudden while driving. Slight miss at idle which is the misfire codes but I can't pinpoint the issue for the P0018 and P0019 codes.
View 14 Replies
I bought a 04 FX-4 a couple months ago with 102k on it. Brought it back to selling dealer, they replaced #1/#6 coils, its ran great till this past week. Again it has stumbled a couple times this week. It only seems to have the miss at idle (comes and goes) take off from light, within 50 feet its running like a champ again. I cleared the codes (disconnect battery)and now it seems my idle is not steady, it fluctuates. Is the idle a product of the codes?
View 2 Replies
I posted a while back about my 04 5.4 having an issue at idle. I did all the normal things like replace coil, spark plug, etc etc. No change to the issue. It still acts as though it's misfiring on a cylinder and I get codes P0306 and P0316. Finally took it to ford and had a diagnostic check ran. Everything on the top end was in working order. The tech even put a known working coil on 6 and nothing changed. I was told that it's either an intake or valve issue on that cylinder. But no definite answer to problem.
Fast forward to yesterday. I got a wild hair at lunch and went out and started truck. Pulled injector plug off of 6. No change to the way it was running. I did the same for 5, 7, 8, 1, and 2. All of which made a big difference in the way it ran. It was obviously misfiring with no fuel to cylinder. This gave me the idea to swap 5 and 6 when I got home to see if the issue followed the injector from 6. I did NOT. I pulled the plug on 5 and got the obvious change in the way it ran. So there is definitely something going on at cylinder 6 that I cannot figure out.
PCM, bad intake, bad valve? I'm not rich so a trip to ford for repair is gonna have to wait. Truck seems to run fine when driving except for slight hesitation during acceleration.
View 3 Replies
On a 2000 F-350 with 5.4 engine, where does the vacuum line enter the cab? I got a truck in with no vacuum signal to the heat controls, and it has a slight miss at idle. Both of these are signs of a vacuum leak, but i can not find the line going into the cab.
View 5 Replies
I have a 2004 Ford F250 with 174,000 miles the truck has a slight miss a rough idle one hot or pulling I have 2 codes nut no light when I go into the ford oem feature in my scanner a PO 272 and a PO404 .. Where to start?
View 4 Replies
2005 Escape 3.0 with 160k miles. Slight miss under cruise, goes away under slight throttle. No service history known about vehicle. Best to replace spark plugs and coils with Motorcraft parts? And the intake gaskets too? Suggestions for correct plugs?
View 14 Replies
I just purchased a 2003 F250 Super Duty with the 6.8L V10 It has really high miles on it as it was a landscaping companies fleet truck. I'm sure that it was pretty well serviced as it has 300K miles on it and it's still running pretty decent.
I picked up the truck and I have to get the smog done soon. It idles with what I can only describe as a slight miss and it runs and drives great. seems to have plenty of power for the miles that's on it.
There is no active CEL on but I scanned the OBDII system and found a P0171 Lean bank 1 code in the pending codes list of the scanner. I guess this year engine doesn't have an EGR Valve or DPFE sensor because I've looked high and low for it and there non existent on this engine.
I've checked for vacuum leaks by spraying brake cleaner or carb cleaner all over the place and it makes no difference and all the vacuum lines and connections look okay.
When it's running It does sound like a vacuum leak right behind the top of the plastic throttle body but I can't find it, I don't know if this big *** engine just sucks that much air or what.
Like I said I need to smog this thing soon and I don't want it to fail if it's missing or has another issue. The fuel injectors look new and one coil pack looks like it's a replacement...
View 14 Replies
It's happened since new, I figured maybe it would work itself out, but it hasn't. On the first start up of the morning, It will start fine, rev up and as it is reving down it will chugg, miss, and shake, for about 5 seconds or so until it reaches idle. If I put it in gear while it does it, the whole car will lurch and shake. It operates fine after that.
View 1 Replies
It says warm up catalyst below threshold (bank 2). Is this just an o2? and is it upstream or downstream if it is? When I scan other cars at work it normally says system is too lean/rich for o2's.
View 2 Replies
I recently inherited a 99 Expedition 5.4 with 90k miles. I'm trying to fix it up so I can sell it. Like the title states, the truck runs rough but there's no check engine light on. I did some research and ended up replacing the PCV elbow and that made it run better for a while but now it's back like it was. It won't die, just a really rough idle and a miss while driving. I imagine it's probably a (or a few) coil pack(s), but I have no way of knowing which one(s) to replace. I would think that would illuminate a CEL though. I'm also having problems with the AC. Upon inspection, I found that the compressor clutch assembly was completely gone from the front of the compressor. I replaced the whole clutch assembly, then voided the system of Freon and refilled it to spec, still no cold air. The compressor clicks on and off like it's low on Freon but it can't be. I'd just sell it as is but in south Louisiana a working AC is a huge selling point!
View 1 Replies
I just purchased a 2005 elantra with 133k on it and she runs fine other than a slight erratic idle. And by slight I mean it will jump about 50-100 rpm idling and every blue moon it will jump up to 250 rpm sitting there. After idling for a while my CEL came on with the following codes.
P0507 idle air control rpm high
P0506 idle air control rpm low
P0170 fuel trim malfunction bank 1
P0121 throttle position sensor
What could be causing this? I took the iac off and cleaned it with maf cleaner but it didn't work.
View 9 Replies
Alright so I have an 03 5.4 with 144000 miles. once it warms up to temperature it has a miss and low end power is low and no fuel mileage gets 12 to 13 if I'm lucky. From idle to 3000 rpm its doggy get it over 3000 rpm it runs great. All new plugs and coil packs. What it could be. When the motor is cold it runs great has most its power.
View 3 Replies
I just installed glow plugs, ucvh, stage 2 rosewood injectors, t500, ipr and gear head tunes. I have out 97 miles on the truck since all this was installed and the truck seems to run okay but has a rough idle and sounds like there is a mis? What should I look into first?
View 12 Replies
