I drive a 02 Passat GLS 1.8t 5 speed and whenever i down shift to slow down it feels like the clutch will catch and then slip and catch and then slip!?!?! the car will "jerk" really hard when this happens and the front end will drop..
View 1 RepliesTook my car to the dealer for it's 80K service and asked them to check the tranny because it's been slipping (hesitation) during upshift and occasionally banging into gear during downshift. I figured they would suggest the BG tranny fluid flush but got a call from the service advisor saying they found the fluid to smell burnt and it was black. 1999Pazzat V6...
View 8 Replies2002 Escape XLS 2.0L 4-cyl 5MT FWD. Slipping Clutch.
I've read here n there that the Escape clutch is a poor design & others have reported that a clutch repair doesn't solve their shuddering problem. After putting off the job for a while, I'd like to replace the clutch.
Here's a topic from here : Manual Transmission shudder / fill & drain access?
I have an 04 2.7 litre V6 AWD Santa Fe with 189235 KM , with a Shiftronic transmission, recently, while in "d", the transmission would feel like its slipping or perhaps trying to down shift, its hard to tell what it's doing really, but if you then slapped it over into shiftronic, it would operate fine, no slipping, locks into gear strongly, indicating that its not mechanical, but related to the computer controlling "drive" function of the transmission, I flushed the transmission just after the symptoms arrived (using the correct SP3 fluid) and this made no difference, the old fluid, although ready to be changed, was not burnt or blackend. I thought of getting it reflashed ( read it online) but I am not sure it will work, especially if its like a sensor or something.
View 3 RepliesI just recently bought an 06 Santa Fe with a 2.7l v6. It was a rebuild. It had been hit in the left wheel. The lot put a new fender, suspension parts, axle, etc. It only has 25k actual miles.
We took it on a 100 mile trip today. I noticed if I am going up hill and it has to downshift, it feels like it looses power. The car continues to slow... Like the tranny is slipping. I stopped at Walmart and found the tranny fluid wouldn't even register on the dipstick. I bought Valvoline max life tranny fluid that matches the sp3 specs in the manual. I had to add almost 3 quarts before it was full. I think they may have forgot to add fluid back to replace what leaked out after they replaced the axle It didn't seem to work though when I continued to drive. After I stopped and let it cool about 30 minutes, it did seem a little better.
I guess my question is should I replace the tranny fluid? If so, what should I replace it with? Is there anything else what could be causing this now?
Transmission (V-6) is slow on the upshift; and jerky on the downshift. Going uphill, the transmission does not want to downshift into a lower gear unless the accelerator is heavily depressed. So, 6th gear at like 45 mph uphill, then finally downshift into 4th with jerk downshift.
As car comes to a stop, right about 2 or 3 mph, the rpm's drop from idle to about 400; sometimes once sometimes twice. It feels like it's going to stall. Have had all the software updates.
I recently bought a 2002 VW Passat 2 weeks ago. I love the car and the drive, but the acceleration is excellent at times, and very slow at times. Also the car gives me a stutter step every once in a while while at low speeds....I bought the car in Mass so I have 13 days left for the dealer warranty. What it is?
View 3 RepliesI have a 1998 C class RV that the downshift from overdrive is sloppy and slow when the button is pressed to release the OD or to put it back into overdrive mode. It seems to pause and then kick in or out of OD. Is this a common problem with E4OD transmission? What will fix it, fluid change? Solenoid replacement?
View 5 RepliesI've been driving manual 12 years, all my driving life, and been in 10+ manual vehicles during that time, including a 10+ year stint in a 1.8T Passat with a 5-speed.
In all that time, and all those experiences, I've never replaced a clutch, damaged a clutch, or had one problem. In fact, I consider myself a very good operator of the manual transmission.
This is preface to my current situation. 2009 Tiguan (early build) 2.0T 6M, driving at 57mph in 6th gear - downshift to 4th to pass a truck and WHAM. Grinding, confusion, and then the clutch pedal stuck straight to the floor. Glide to a stop on the side of the bayou road.
Totally immobile vehicle. Impossible to shift into gear, or get the pedal off the floor except by pulling. Smell of acrid smoke.
VW dealership says "we're doing a courtesy warranty repair" on the clutch, flywheel and bearings, as if it's my fault. Impossible. This is a mechanical defect if I ever saw one.
I have a 2001 f250 with a 7.3. What is the operation of the clutch fans on these trucks. Sometimes when pulling my camper and the truck downshifts it will roar like a sob. Other times I will hear it but like it is an electric fan. Then there are times you hear it and then the noise goes away. Can this fan be heat operated.
View 3 RepliesIn 2006 I purchased a 2004 5-speed manual shift Nissan Xterra 4x4 with 19k miles on it, it looked and ran like new.I live in Florida, during the Summer of 2010 I noticed that when I accelerated from a standing start (like at a traffic light) as I shifted through gears 1-4, at some point the RPMs would rev up but the car was accelerating very slow. The only time this doesn't happen is in 5th gear or in 4WD-high or 4WD-Low. This problem is not consistent, it happens occasionally but enough times that I've had to alter the way I accelerate to avoid this problem, ie accelerate very very slowly.
I have taken my Xterra to my local Nissan dealer, twice, they cannot replicate this problem no matter what they do; drive it cold, drive it hot, fast, slow, cold weather, hot weather, no matter, they can't replicate the problem.
I have read here and there on the 'net (we all know the 'net never lies) that the transfer case on 4WD's can act squirrelly or could even be a simple case of replacing the transfer case fluid.
Why this "slippage" is happening and how can it be fixed? This is of concern only because if I have to accelerate hard (like when a locomotive is looking to T-bone me) I'd like the Xterra to get up and go rather than pause and reflect over the lilies of the field while Thomas the train is bearing down on me.
I just had a new clutch installed yesterday. Bully stg3 with flywheel. My 2012 R has 22k. I had to change it since my stock clutch was slipping at 3000rpm with the Unitronic stg1+.
The second I start the car and stay on neutral, give a little gas I hear a super loud grinding noise. It stop when I press the clutch. On idle I don`t hear nothing and when I drive everything is fine until I release the clutch and when I don`t press the gas.
The shop said they never heard anything that loud and they confirm that everything was installed correctly. Other then the noise the clutch is fine and works very well.
So i have a 05 1.8t gti... just bought it about 3 months ago and it has a stage 2 south bend clutch... the car has only 68k on it and the clutch is slipping already... it was driving fine then about a week ago all hell broke loose and it's slipping bad... now for my question what performance clutch is recommended? I have a giac tune and its pushing about 21 boost... . would a 2.0 performance clutch work on the 1.8t?..
View 12 RepliesWell the clutch started slipping finally, not sure if it was the weather change on the drive from here to PA but I slip 5 and 6th wot 4-5k rpms. Have some coin set away because I knew it was going to happen sooner or later did some searching and I'm curious to here the verdict on the RSR clutch how many miles and how its holding up as well as whatever else you are running. Will probably keep the car 2+ for quite a while so not really worried about 3+ power.
View 24 RepliesMy wife was driving my Stage 1 R last night (by herself) and she ran into an issue where when she tried to leave from a red light, the clutch was slipping through the first three gears and she could barely get up any speed. She pulled over, let the car sit for a few minutes and then started going again with no issues.
She drove home about 5 miles and told me about what happened. The car smelled like burning clutch, but when I took it out for a quick test drive, everything seemed fine.
I am at around 5000 miles and have never had any issues before and I don't ever do high-rpm launches. So, could this have been a fluke or a sign of the clutch/pressure plate issues people have been having?
Well I was hoping it was just a fluke the one time it slipped about a month ago, but my clutch is now officially toast. If I'm between 3-4k RPM and punch it in just about any gear I'm getting slip. Trying to pass a car on the highway, and I'm getting slip. I do not launch my car, I simply like to play in the 3-4k rpm powerband as I love the torque. Apparently spirited driving while remaining in the peak torque range of the engine will kill the stock clutch. God only knows how long the OEM clutches will last with people that drive their R like a racekar... 3200 Miles, Stage 1+ ....
View 24 RepliesI have an issue that I thought was a slipping clutch, but my dealer says it isn't. If I'm cruising at highway speed (stg1 gti)say around 65 and I get on to pass the revs will surge, but there will be no apparent acceleration to go with it. The dealer said it isn't the clutch because there is a standard test they do where it would be jerky in 2nd. Could this be a DV or something?
View 24 RepliesI went stg.1 at 1000 miles & stg.2 around 6000
miles, then K04 I'm at a little over 6400 miles & my clutch slips in 4th & 5th gear. I never got the chance to install my APR inner cooler. I really hope the Southbend stg.2 endurance setup works well so I can move on to the suspension. This hobby can get expensive but the car is a blast to drive! It never fails to put a smile on my face & has definitely taken the smile off other drivers faces when they realize they can't get by me.
So I have a stage 2 endurance clutch and light weight flywheel on my car. I had not really gotten on it of late until yesterday. I was getting on the highway and really got on it. When I hit third gear it felt like my clutch was slipping. I have only had it on the car for like six months and about 10,000 miles. It could be worn out all ready? And after the incident yesterday I pushed the clutch in and held it to let it cool down a bit after it did it held fine even in higher Rpms didn't feel like any kind of slipping. Pulled very strong. This morning after having all night to cool off (and I mite just still be freaked out a bit) but it seemed to feel different, like a possible slip at 3,000 Rpms but again I mite just be freaking out about nothing. What does a master cylinder or slave cylinder going out feel like?
View 1 RepliesSo my clutch started to slip in 4th when I first got my apr stage 1 tune at 24k miles. now 600 miles later it's slipping in 3rd. put it back to stock mode and it doesn't slip in any gear.
My question, if I replace my clutch with an OEM sachs what are the chances of it slipping again? From what I understand the golf R uses the same clutch disk and pressure plate as the gti so why is mine slipping so early? luck of the draw?
I prefer oem because it is a lot quieter and I do not plan to mod any further than stage 1. I'm still running the stock airbox.
I have a 2005 Prius with 110,000 mi. Sometimes when I accelerate the ICE (gas engine) simply spins (as if the clutch was slipping in a convention car) and there is little acceleration and the gas engine doesn't shut off when coasting or braking as it always has in the past. The battery screen shows it is not charging when this happens and is at 1 bar (purple). then sometimes the hybrid battery gauge will go from 1 bar to fully charged (green) in under a minute or 2 and then show discharging just as fast which isn't possible. It goes away after a restart sometimes but then happens again soon. Is it the TP sensor, Hybrid battery computer or ? I have gotten all kinds of codes including P0a93, P0a80, P1400, P040a.
View 14 Replies