Passat (B5) :: 2001 - Airbag Control Module Does Not Match Vehicle
May 21, 2013
Looking for instructions how to 'match' the Airbag control module with VAGcom? Bought a 2001 Passat 1.8T manual, found code:
01224 - Control Module Does Not Match Vehicle
35-00 - -
Full scan below. Note: bad ABS module removed and sent out for repair (that's why is does not show up in scan, and triggers other code).
Also need to look into crash sensor. Is that the one bolted to the floor under the front seats under carpet? Part number?
VCDS Version: Release 11.11.5 (x64)
Data version: 20121222
Friday,17,May,2013,18:13:04:36008
Chassis Type: 3B - VW Passat B5
Scan: 01 02 03 08 15 16 17 19 35 36 37 46 47 55 56 57 58 75 76 77
Mileage: 184990km/114947miles
[Code] ....
View 1 Replies
Advertisement
I recently received an airbag fault light so I figured that I would scan the module for error codes. This is what I came up with:
Control Module Part Number: 3D0 909 601 C
Component and/or Version: 05 Airbag 8.4E++H01 0352
Software Coding: 0012341
Work Shop Code: WSC 31414
Additional Info: 7L0959339B BF-Gewichtsens. 005 0006
Additional Info: Geraet 00000
2 Faults Found:
01217 - Side Airbag Igniter: Driver Side (N199)
001 - Upper Limit Exceeded - Intermittent
01316 - ABS Control Module
004 - No Signal/Communication - Intermittent
Has scanned the car while had the airbag fault present and if so, is this the usual harness that needs to be changed?
View 11 Replies
Need coding info for 2010 Jetta sedan 2.5 Air bag control module. The part # is 1K0 909 605 AD/004, Component # Airbag VW8R 036 8900. I am using a Vag-Com version 10.6 ....
View 1 Replies
The MRS Control Module (that makes the airbags function) on my 2001 Mini CooperS (with only 66,000 miles on it) has failed and going to get it repaired. The dealer said it is really rare for the MRS to fail...
View 1 Replies
I have a 2002 F350 7.3 Powerstroke with approximately 200,000 miles. Recently I have been having an issue with what I am told is my airbag control module heating up to the point it is too warm to touch when I am pulling a heavier load. It is located just under the dash on the center hump. I removed the black plastic cover revealing the module itself in order to determine that indeed is where the heat and smell of hot electrical equipment is originating from. It gets too hot to touch when pulling a heavy load and making the motor work...once I lighten up on it or am not pulling it immediately cools back down. If it is an option I would just disconnect it but I havent yet for fear of creating more of a problem.
View 1 Replies
2004 f150 - Airbag light was flashing. Received recall letter. Dealer replaced a wiring harness. Dealer did not confirm functionality of airbag prior to leaving shop. Light continues to flash. New diagnostics from dealer says error code 1885 - the control restraint module needs replacing in P&L. Does the code match the fix? Can a novice mechanic replace the module?
View 2 Replies
Car model: Elantra XD 2000
some time back, due to fault in the alternator, the voltage raised to around 17V in my Elantra. After this, the Air Bag light remained ON. Got it scanned from a shop and they said the system is functioning properly but the control unit does not work. The part ID is : 95910-2D300
I have two questions:
1. Does repairing this unit is possible?
2. I checked in e-bay (UK) but the exact part is not available. Are there any alternative part numbers that I can use instead of this exact one?
View 1 Replies
Had I to break into my gas cap, replacing the module? is it ok to buy a used one? My door locks quit working too. the same module right?
View 1 Replies
I need to locate the part number, so that I can order from salvage. Where this is located on a 2000 Passat?
View 3 Replies
I have a problem with the Bold-Sport camera, but am not sure if it is the radio, the camera, or even possibly a fuse. I get a fault code with vcds that says the rvc control module intermittent/no signal. Once I clear the code, and put my car in reverse with the headlights on, the camera does not work, or works for a second, and shuts off. If i turn the exterior lights off, the camera seems to function normally. As soon as I turn exterior lights back on, camera no longer displays again. I have been having some problems with the rns-510, so am assuming it could be the radio, but am not too sure. The problem I have with the radio is that sometimes not all the interior light hard buttons light up. I will post up a pic as soon as I can.
View 3 Replies
Need to check and not sure where it is!
View 2 Replies
I own a 1997 Passat VR6, dealership scanned and found that cruise control module needs to be replaced, but I want to do it on my own!! What is the location of the CC module.
View 2 Replies
I have the below multi-function steering wheel installed on my 2008 Passat. The steering wheel came out of a 2010 CC and the buttons do not currently work.
Which steering wheel control module would I need and what is the price on that?
Besides the steering wheel control module and programming via VCDS/VAGCOM, do I need anything else for this to work?
View 2 Replies
I drive a 2002 Santa Fe with 121k miles. Last week the red brake light came on in the dash that usually indicates the parking brake is activated, though it was not. Checked fluids, brakes worked fine, so I took it to the dealership to have it looked at.
They claimed "the ABS control module was leaking" and needed to be replaced in it's entirety...almost $2000, and they said that is the reason my brakes felt spongy when applied. I agreed they did. I decided to decline letting them fix it since my brakes had worked fine beforehand.
Upon picking up the car I notice the red indicator light is still on, and now the brakes need to be applied all the way to the floor to have any stopping power at all. It seemed to get worse after 2 days, I checked the brake fluid and it was empty! So I replaced the fluid, yet the brakes still function VERY poorly.
View 1 Replies
I have a 2013 VW Passat TDI SE DSG and I was trying to do some tweaks. I found this fault code yesterday and cleared it. I scanned it again this morning and it popped up again. I searched and did not foud anything. No check engine light.
Saturday,16,November,2013,10:32:21:13221
VCDS -- Windows Based VAG/VAS Emulator
VCDS Version: Release 12.12.0 (x64)
Data version: 20130910
[Code] ....
View 5 Replies
I have just replaced the abs ecu and have cleared the codes, thought all was gonna be good but now two code are still coming up they are:
01044 Transmission control module - incorrectly coded
00778 Steering angle sensor-G85
View 2 Replies
How to fix SES P0670?? I understand there's a whole procedure on checking fault.
P0670:GPCM Glow plug control module control line failure. Open/grounded circuit, open/shorted GPCM, failed PCM
But how did you resolve problem? replaced GPCM, found open circuit, short --if so where?-- or replaced with updated harness.
(4C3Z-12B568-AA connector upgrade kit as in picture)???
View 14 Replies
Is there a way with VCDS to adjust the speedometer reading to match my GPS? The reason I am asking is that I have the wrong winter tire size on my car (205-55-R16) and the difference is 15km/hr more the I really drive.
View 6 Replies
Where the SRS/Airbag module/unit is located?
View 1 Replies
On the way to lunch today, I stopped at a store and ran in for about 10 minutes. When I get back in my 'egg, I notice that the steering wheel airbag module has "popped" or "sprung" out of place. Instead of being flush, it is now sticking out and creating quite the safety hazard, I'm sure.
View 15 Replies
I recently brought it in for the air bag recall. They replaced both front airbags.
Now they say I need a controller module. Does that mean the air bags won't deploy in a crash?
Are the deployed on impact electrically or mechanically?
View 3 Replies
