Passat (B5) :: 2000 - Torque Converter Part Number?
Nov 14, 2007
My torque converter is on the way out so I need to look for a new one. I'm pretty new at the transmission thing but I was told by my indy that my torque converter is on the way out. My problem is that I can't find the part number for my torque converter. I have a 2000 1.8t tip ATW.
View 3 Replies
Advertisement
As the title implies I need the part # for the OEM VW Stretch bolt that holds the Torque Arm insert in place. I've had the mount on my car for a few months now and I've grown tired of it.
I re-used the OEM bolt the first time and I think I'm better off replacing it as it may not be wise to unbolt it and re-torque it for a third time. Looking for the part # for the stretch bolt? I believe it's 21mm.
View 2 Replies
Pulled 3 starters at the junkyard to replace one that has a bad solenoid. Have a 2002 Buick Regal LS with 3800 series II engine. Found some on 3100 engines and one from a 3800. My starter has about 10 teeth on the gear that engages the flywheel. Some of the ones I pulled had smaller gears with only about 8 teeth.
Why the difference? Also one GM Delco starter was slightly longer (about 1/2 inch) than mine and had a small black hollow tube about 1 inch long at the rear of the starter and at the bottom. It fell off when I touched it. Looks like it might be a drain hole in case some water gets in to the starter. What is this really for?
View 1 Replies
I need the PASSAT B5 shift knob part number...
View 1 Replies
I have a 2001 passat and I want to get a new remote, where do I locate the part number for my remote?
View 4 Replies
I am looking for the orange side blinker (not the bumper marker) that came on the older B5 passats. I would like to know what the model number is for this part.
View 3 Replies
What is the part number for the rear hatch strut for the new passat wagons? i need the part # for the ones that has the remote hatch closing. I want to put those struts on my mk5....
View 7 Replies
What is the part number of the auto hold switch.
View 13 Replies
Have a 2004 hyundai accent and I think I am having problems with the torque converter locking up in a timely fashion. It typically takes 15 to 20 minutes when I am driving on the highway. Is this normal for it to take that long? My gas mileage is terrible (22 mpg last fillup) and I am thinking its related to this.
View 7 Replies
I was driving my 7.3 down the road and it started acting like the trans was slipping, it revved up and tried kicking down a couple times and when I slowed down and went to speed back up it just had no power coming through the trans to the wheels it just revved. I put it in neutral and it idled up for about 5 seconds. I put it in park n shut it down. I fired it back up after looking everything over and it moved about half mile down the road and no power to the wheels again. The trans is full of fluid, is there a sensor that could of went bad or just the torque converter or the entire thing shot? Only owned my truck 6 months has a trans and motor swap already from previous owner. 180k on current motor n Trans. 382k on my truck. t6 4" turbo back banks exhaust only mods I know of.
View 11 Replies
What is the part number for the drivers side aluminum tranny bracket(automatic)? Or a how to to remove it, cuz mine is fractured badly and needs replaced.
View 3 Replies
2000 Explorer 4.0 dohc avd. 150k miles. The torque converter lock-up function has started to drop out. It can happen after some miles and will light a warning light in the dash that the manual states as "contact tech" or something like that. Everything gets back to normal with just a "blip" to "off-position for the ignition switch and might stay normal for all between 5 minutes to several hours. Seems to me it is an electrical issue. Dirt, sensors?
Runs and shifts fine other than this. Only thing I have noticed is that the temp gauge reads pretty low but I think this started earlier and I understand that the temp gauge has its own sensor. Where to start looking?
View 6 Replies
I have a 2000 Passat with the 2.8L engine. The flexible pipe which is part of the catalytic converter is leaking and the only way to replace it is to replace the catalytic converter. VW refused to assist with the repairs because the car has 96000 mi on it. Emission warranty is 8/80000. How I can replace only the flexible pipe without the cat. because it's still good.
View 3 Replies
I recently purchased this truck so I don't have any history on it. It's the V10 motor, automatic, 4 wheel drive, with a crew cab. I took it to Advance Auto to have them read codes and it came back with torque converter solenoid fault and 2 other codes related to that part. I didn't get to see the actual code numbers.
I've talked to 2 transmission shops and they said they could throw a solenoid pack into it, but that it might not even fix it. The truck drives fine, shifts fine, the tranny oil looks and smells fine, so I'm tempted to not worry about it until something else happens.
The truck has 217,000 miles on it...
View 10 Replies
I'd like to get the VW part number(s) for:
Touareg DVD NAV Unit
Touareg NAV Antenna
DVD Map Disks
View 11 Replies
My driver's seat is broken. Specifically the part in the middle that lets one adjust the front to back position and it's connection to the front bottom of the seat. I'm hoping this isn't all one unit as I'd rather not buy a new seat.
I can edit the pictures to point out what's wrong if it's not obvious.
View 2 Replies
Is the 25th AE part number, 1J1-941-017N, for the passaenger side the same for the 20th AE. My gut tells me yes, but i can't find it on a search.
View 6 Replies
I've started retrofitting foglights into my mother's 2012 Tiguan (S 4motion). All of the parts were dealer ordered, but twice now they've sent me the wrong switch. The mounting/locking mechanism is the wrong size (too large on the new switches). In addition, the second switch had an "auto" selection.
The original part number was 3C8941431F C1F-T shown on the left here:
The two part numbers they have shipped so far are:
3C8-941-431-G-XSH and 3C8-941-431-E-XSH
I need a standard headlight switch, no auto, with fog (front only is fine).
View 5 Replies
The MDI cable that came with my car is way too short.. What is the part number or where I can get a longer version of this cable?
View 4 Replies
I need to get the part number of the wire harness connector that clicks into the right abs sensor connector. The code for the connector is A4 but I wasn't able to find any info about it online. This is for a 2009 Toyota Prius. car got into an accident and the wire harness connector was cut.
See the attached pics.....
View 5 Replies
What is he abs unit bottom bracket part number...
View 3 Replies