Here are the vitals: Passat, 2000, 1.8T, 39.000miles.
Here is the problem: Brake light will come on, flashing. ABS light on, fix. After 30/45 sec the brake light and the ABS light will turn off.( I do get the "STOP" message) The ASR/EDL warning light will remain on until I turn the engine off.
Next time I turn the car on, and after what appear to be a "drive circle" the "phenomena" repeats it self.
So I just bought a 2000 Passat v6. It's not my first VW so I do know a few things but here is my problem.
The abs light is on and the brake light is flashing and in the little display in the middle, it says brake fault stop see owners manual.
Was I told it's a abs sensor?
2001 01 1.8t... Hoping this isn't a bad ABS module. When I bought the car, I was told it was a bad wheel sensor in the drivers side. But, the funny part about this is its not on all the time, sometimes it doesn't even come on and the dash is normal.
View 3 Repliesi just installed a electronic boost gauge in my 98 passat. I wired it to the headlight switch but now when i turn on my car.. about 10 seconds later the ABS light comes on and the brake light flashes. Why this is happening?
View 2 Replies1999 Passatt ... My ABS system is shot and the "ABS BRAKE!" lights flash constantly, as long as car is on. I have been told to not replace the ABS system as it's incredibly pricey. I was told by another owner that he had heard there was a way to have this blinking stop pretty easily.
View 1 RepliesSo my girlfriends passat is starting to have some problems. It looks like a light show on the dash. When driving it, every now and then (a lot more now) the tach goes dead, and the oil and brake light flash, and it starts beeping. The car also has a ABS light on but that has been on for a long time.
So far I've checked both the oil and brake fluid levels, and checked all the fuses. Everything is good there. It just seems funny that they all go at once. I figure maybe one of the plugs to the cluster is loose giving everything a zero reading? I need to buy a vag cable and software some time that's for sure.
So while driving my mom's 99 passat, after a few miles it gives six loud beeps, the BRAKE light comes on, the oil pressure warning light starts flashing, the ABS light flashes, and the tach sits at zero.
Brakes still work, havent tested ABS. there's no noticeable change in performance. I'm assuming this is the CCM and ABS modules on their last breaths.
I changed the bulb in my driver side brake light - routine -done a zillion bulb changes on my car. This time however the dashboard lights up every time I brake!! What gives? Something to do with the brake pedal triggering the brake light button in the footwell area under the dash? Its a 2000 Passat 1.8T sedan - manual tranny.
View 5 RepliesI have a 2000 Passat w V6 thats in the shop at the dealers. The ABS/Brake light in the dash is coming on. The dealer says I need a new sensor in the ABS module. This sensor cost $700 plus about $400 in labor. Seems very pricey to me. My question is, could I buy a used ABS module and replace the bad one with the bad sensor myself? Where could I get a used or new ABS module at a good price? Is it hard to change out?
View 6 RepliesBrake warning light came on. Diagnosed as bad abs module. Mechanic replaced twice. One shell sensor continues to read not turning while it is turning. Mechanic has check continuity, it's fine. Seems to have a short. He cannot find where it is and next step is ripping out much interior to track tiny wire. Will not pass state inspection with brake warning light on.
View 6 RepliesI have a 99 Passat; 5-speed V6. My tachometer would go out intermittently and at the same time the oil and brake light would start flashing and the ABS light would come on solid. There would be no noticeable difference in performance. When the tachometer would come back on line the lights would go go. Now the tachometer appears to be down permanently and the dash lights above are in the same state as above. Still no noticable difference in performance. What may be wrong?
View 3 RepliesI took my 2000 passat 1.8t to a couple of places and both say that my abs and brakes are fine even though there is a flashing light that says brake lights failure and abs light. The brake lights do work. Is there a way for me to clear the code?
View 4 RepliesMy alternator went today, driving and the battery came on .. was concerned but was still on my way, abt 5 miles from my house the abs light and brake lights starting flashing and beeping .. and then caput .. the car shuts off .. figured it was the alternator, cuz thats whats logically made sense .. talk to vwvortex and if so how much do these type of jobs cost ??
View 18 RepliesSo I have a 1.8 5spd wagon which flooded out the comfort control module. I got another CCM but I still have a flashing oil pressure light. a flashing brake warning, a solid ABS light and an airbag light. The tach doesn't work and the MFD only occasionally works. Before I replace the ABS module I would like to eliminate anything else that might be in common with all these systems, is there a hidden fuse anywhere or a relay?
I tried unplugging the ABS module and it didn't change anything, do I need to code the CCM it has the same numbers on it but even after replacement the power windows still don't work even though the door locks, mirrors, and dome light on all but the drivers door ( I assume the micro switch is bad)work now, also the car starts.
Had a small brake fluid leak from my right-rear wheel, so I took it into a local place called Wheel Works. They said the right-rear caliper needed to be replaced, so I told them to go ahead.
Two days after I pick up the car, the ABS light and brake warning lights start flashing intermittently. They'd come on at random times, and then turn back off. After about 2 weeks of this, the warning lights are now on all the time.
I've read elsewhere on these forums that the ABS module on our cars can go bad and might need to be rebuilt. But is it possible that the mechanic caused this problem when he was working on the brakes to replace my caliper? Could it be something more minor than the ABS module? I now have reason to believe this mechanic is shady, so I'm hesitant to bring it back there.
It was discovered last night that the third brake light (or Center High Mounted Stop Lamp/CHMSL) on our SF flashes a few times before going solid when I brake. I did a little searching and it seems that it is not legal in TX, so I guess I get to put in a call to the dealer today.
From what the interwebs say, it seems to be something dealers do as an added "safety feature" (and I even found research that shows it does get attention better than solid lights). There's a lot out there about people wanting to install this feature, and there are companies that do this for you. But I've never seen it on the road myself, and to be honest, it's kind of annoying. And the TX code is not the clearest, but I think it's saying "no flashing lights unless you're a bus."
Here's what I found from the TX transportation code:
(c) A person may not operate a motor vehicle equipped with a red, white, or blue beacon, flashing, or alternating light unless the equipment is:
(1) used as specifically authorized by this chapter; or
(2) a running lamp, headlamp, taillamp, backup lamp, or turn signal lamp that is used as authorized by law.
(d) A vehicle may be equipped with alternately flashing lighting equipment described by Section 547.701 or 547.702 only if the vehicle is:
(1) a school bus;
(2) an authorized emergency vehicle;
(3) a church bus that has the words "church bus" printed on the front and rear of the bus so as to be clearly discernible to other vehicle operators;
(4) a tow truck while under the direction of a law enforcement officer at the scene of an accident or while hooking up to a disabled vehicle on a roadway; or
(5) a tow truck with a mounted light bar which has turn signals and stop lamps in addition to those required by Sections 547.322, 547.323, and 547.324, Transportation Code.
I just swapped out my 2014 IS350 F sport for a 2015. The 2014 rear brake light in the rear window would flash when you hit the brake pedal about 5 times and then remain steady. I really liked this feature and now my new 2015 does not do this. I don't see how to turn this on or off in the settings. Both cars are 350 F Sport models - AWD, NAV Etc.
I have seen several other new model IS's and none of them have ever done this. My neighbor has a 250 Non-F Sport. So I assumed it was a 350 or F Sport thing.
----My 2014 had 20,000 miles and needed tires. The lease payoff was low enough that the dealer bought it out and put me in a new one for the same price. I got a different color plus cooled seats and a few other small differences (And went from black to white).
2004 v8 phaeton. I have the brake warning light flashing, and the message
BRAKE. BRAKE FLUID. STOP CAR. Have checked the level, O.K. And have tried to flush the system by bleeding the brakes. no positive results.
When I am driving around, my brake light will appear flashing for several seconds then it goes off. What is that about?
View 8 RepliesWhen I press on the brakes the brake lights up in the cluster?
View 3 RepliesSo my brake light was flashing and my abs light and traction light came on...i got codes for a faulty abs module and G85 steering angle sensor. I replaced the module and I cleared the codes and they cleared except the steering angle sensor and now the traction light is stuck on? Do i have to zero point calibrate with a vagcom?
View 4 Replies